Toxicity of the mosquito control insecticide phenothrin to three life stages of the grass shrimp (Palaemonetes pugio)

Phenothrin is a synthetic pyrethroid used as a contact insecticide in mosquito control programs. This study compared the toxicity of phenothrin to adult, larval and embryonic grass shrimp (Palaemonetes pugio) and examined oxidative stress responses in adult and larval grass shrimp. The adult 24-h LC50 was 0.341 μg/L (95 % confidence intervals 0.282-0.412) and the 96-h LC50 was 0.161 μg/L (95 % CI 0.128-0.203 μg/L). The larval 24-h LC50 was 0.50 μg/L (95 % CI 0.441-0.568) and the 96-h LC50 was 0.154 μg/L (95 % CI 0.139-0.170 μg/L). In the presence of sediment, the 24-h LC50 was 6.30 μg/L (95 % CI 5.00-7.44 μg/L) for adults and 0.771 μg/L (95 % CI 0.630-0.944) for larvae. The sublethal biomarkers glutathione and lipid peroxidase (LPx) were examined after 96-h phenothrin exposure at five concentrations, and there were no statistically significant differences in these levels in adults or larvae compared to controls. There was a significant downward trend in larval LPx levels. This research confirms that phenothrin is highly toxic to grass shrimp and suggests that both adult and larval grass shrimp are appropriate life stages for risk assessments.     

The use of failure mode and effects analysis to construct an effective disposal and prevention mechanism for infectious hospital waste

In recent times, the quality of medical care has been continuously improving in medical institutions wherein patient-centred care has been emphasized. Failure mode and effects analysis (FMEA) has also been promoted as a method of basic risk management and as part of total quality management (TQM) for improving the quality of medical care and preventing mistakes. Therefore, a study was conducted using FMEA to evaluate the potential risk causes in the process of infectious medical waste disposal, devise standard procedures concerning the waste, and propose feasible plans for facilitating the detection of exceptional cases of infectious waste. The analysis revealed the following results regarding medical institutions: (a) FMEA can be used to identify the risk factors of infectious waste disposal. (b) During the infectious waste disposal process, six items were scored over 100 in the assessment of uncontrolled risks: erroneous discarding of infectious waste by patients and their families, erroneous discarding by nursing staff, erroneous discarding by medical staff, cleaning drivers pierced by sharp articles, cleaning staff pierced by sharp articles, and unmarked output units. Therefore, the study concluded that it was necessary to (1) provide education and training about waste classification to the medical staff, patients and their families, nursing staff, and cleaning staff; (2) clarify the signs of caution; and (3) evaluate the failure mode and strengthen the effects.     

Changes in fungal population of fly ash and vinasse mixture during vermicomposting by Eudrilus eugeniae and Eisenia fetida: documentation of cellulase isozymes in vermicompost

Fly ash (FA) and vinasse (VN), two industrial wastes, are generated in huge amounts and cause serious hazards to the environment. In this experiment, different proportions of these two wastes were used as food for two epigeic earthworms (Eisenia fetida and Eudrilus eugeniae) to standardize the recycling technique of these two wastes and to study their effect on fungal especially cellulolytic fungal population, cellulase activity and their isozyme pattern, chitin content and microbial biomass of waste mixture during vermicomposting. Increasing VN proportion from 25% to 50% or even higher, counts of both fungi and cellulolytic fungi in waste mixtures were significantly (P ? 0.05) increased during vermicomposting. Higher cellulase activity in treatments having 50% or more vinasse might be attributed to the significantly (P ? 0.05) higher concentration of group I isozyme while concentrations of other isozymes (group II and III) of cellulase were statistically at par. Higher chitin content in vinasse-enriched treatments suggested that fungal biomass and fungi-to-microbial biomass ratio in these treatments were also increased due to vermicomposting. Results revealed that Eudrilus eugeniae and Eisenia fetida had comparable effect on FA and VN mixture during vermicomposting. Periodical analysis of above-mentioned biochemical and microbial properties and nutrient content of final vermicompost samples indicated that equal proportion (1:1, w/w) of FA and VN is probably the optimum composition to obtain best quality vermicompost.     

Reduction of tar using cheap catalysts during sewage sludge gasification

Solid-fuel conversion or gasification study of sewage sludge and energy recovery has become increasingly important because energy recovery and climate change are emerging issues. Various types of catalysts, such as dolomite, steel slag and calcium oxide, were tested for tar reduction during the sewage sludge gasification process. For the experiments on sewage sludge gasification reactions and tar reduction using the catalysts, a fixed bed of laboratory-scale experimental apparatus was set up. The reactor was made of quartz glass using an electric muffle furnace. The sewage sludge samples used had moisture contents less than 6%. The experimental conditions were as follows: sample weight was 20 g and reaction time was 10 min, gasification reaction temperature was from 600 to 800°C, and the equivalence ratio was 0.2. The quantity of catalysts was 2–6 g, and temperatures of catalyst layers were 500–700°C. As the reaction temperature increased up to 800°C, the yields of gaseous products and liquid products increased, whereas char and tar products decreased, showing effects on gas product compositions. These results were considered to be due to the increase of the water-gas reaction and Boudouard reaction. In the case of experiments with catalysts, dolomite (4 g), steel slag (6 g) and calcium oxide (6 g) were used. When the temperature of catalysts increased, the weight of the tar produced decreased with different cracking performances by different catalysts. Reforming reactions were considered to occur on the surface of dolomite, steel slag and calcium oxide, causing cracking of the hydrocarbon structure, which eventually showed reduced tar generation.     

COMPLEX I and II Model Performance Evaluation in Nevada and New Mexico

The COMPLEX I and COMPLEX II Gaussian dispersion models for complex terrain applications have been made available by EPA. Various terrain treatment options under IOPT(25) can be selected for a particular application, one of which [IOPT(25) = 1] is an algorithm similar to that of the VALLEY model. A model performance evaluation exercise involving three of the available options with both COMPLEX models was carried out using SF⁶ tracer measurements taken during worst-case stable impaction conditions in complex terrain at the Harry Allen Plant site in southern Nevada. The models did not reproduce observed concentrations on an event by event basis, as correlation coefficients for 1-h concentrations of 0-0.3 were exhibited. When observed and calculated cumulative frequency distributions for 1-h and 3-h concentrations were compared, a close correspondence between observations and concentrations calculated with COMPLEX I, IOPT(25) = 2 or 3 was noted; both options consistently overestimated observed concentrations. With IOPT(25) = 1, upper percentile (maximum) values in the calculated frequency distribution exceeded the corresponding IOPT(25) = 2 or 3 value by roughly a factor of 2, and observed values by 2.5-5. COMPLEX II typically produced maximum values 2-4 times as great as COMPLEX I for the same terrain treatment option. From these results it is concluded that: 1) the physically unrealistic sector-spread approach used in VALLEY and COMPLEX I under stable impaction conditions is a surrogate for wind direction variation, and 2) the doubling of the plume centerline concentration due to ground reflection under terrain impingement conditions that is included in IOPT(25) = 1 is inappropriate.

These findings were found to be consistent with an analysis of noncurrent observed and calculated SO₂ χ/Q frequency distributions for 1, 3, and 24 hours near the Four Corners Plant in New Mexico. The comparison involved a four-year calculated χ/Q data set and a two-year observed χ/Q data set at the worst-case high terrain impact location near the plant.     

Revised relative potency values for PCDDs, PCDFs, and non-ortho-substituted PCBs for the optimized H4IIE-luc in vitro bioassay

While the World Health Organization 2,3,7,8-tetrachlorodibenzo-p-dioxin (TCDD) equivalency factors are useful estimates of relative potencies of mixtures when conducting risk assessments, they are not useful when comparing the results of bioassays such as the H4IIE-luc to concentrations of TCDD equivalents calculated from instrumental analyses. Since there are thousands of dioxin-like compounds (DLCs), one use of screening assays is to determine if all of the aryl hydrocarbon receptor (AhR) active DLCs in a mixture have been accounted for in instrumental analyses. For this purpose, bioassay-specific relative potency (ReP) values are needed. RePs of 21 polychlorinated dibenzo-p-dioxins, polychlorinated dibenzofurans, and dioxin-like polychlorinated biphenyls that exhibit effects mediated through the AhR were determined by use of the H4IIE-luc assay. Different values of RePs are derived, depending on the statistical, curve-fitting methods used to derive them from the dose–response relationships. Here, we discuss the various methods for deriving RePs from in vitro data and their assumptions and effects on values of RePs. Full dose–response curves of 2,3,7,8-TCDD and other representative DLCs were used to estimate effective concentrations at multiple points (e.g., EC20-50-80), which were then used to estimate ReP of each DLC to 2,3,7,8-TCDD.     

Analysis of spatial and seasonal distributions of MODIS aerosol optical properties and ground-based measurements of mass concentrations in the Yellow Sea region in 2009

Satellite-retrieved data on aerosol optical depth (AOD) and Ångström exponent (AE) using a moderate resolution imaging spectrometer (MODIS) were used to analyze large-scale distributions of atmospheric aerosols in East Asia. AOD was relatively high in March (0.44?±?0.25) and low in September (0.24?±?0.21) in the East Asian region in 2009. Sandstorms originating from the deserts and dry areas in northern China and Mongolia were transported on a massive scale during the springtime, thus contributing to the high AOD in East Asia. However, whereas PM10 with diameters ≤10 μm was the highest in February at Anmyon, Cheongwon, and Ulleung, located leeward about halfway through the Korean Peninsula, AOD rose to its highest in May. The growth of hygroscopic aerosols attendant on increases in relative humidity prior to the Asian monsoon season contributed to a high AOD level in May. AE typically appears at high levels (1.30?±?0.37) in August due to anthropogenic aerosols originating from the industrial areas in eastern China, while AOD stays low in summer due to the removal process caused by rainfall. The linear correlation coefficients of the MODIS AOD and ground-based mass concentrations of PM10 at Anmyon, Cheongwon, and Ulleung were measured at 0.4~0.6. Four cases (6 days) of mineral dustfall from sandstorms and six cases (12 days) of anthropogenically polluted particles were observed in the central area of the Korean Peninsula in 2009. PM10 mass concentrations increased at both Anmyon and Cheongwon in the cases of mineral dustfall and anthropogenically polluted particles. Cases of dustfall from sandstorms and anthropogenic polluted particles, with increasing PM10 mass concentrations, showed higher AOD values in the Yellow Sea region.     

Evaluation of the use of diffusive air samplers for determining temporal and spatial variation of volatile organic compounds in the ambient air of urban communities

The Houston-Galveston metropolitan area has a relatively high density of point and mobile sources of air toxics, and determining and understanding the relationship between emissions and ambient air concentrations of air toxics is important for evaluating potential impacts on public health and formulating effective regulatory policies to control this impact, both in this region and elsewhere. However, conventional ambient air monitoring approaches are limited with regard to expense, siting limitations, and representative sampling necessary for adequate exposure assessment. The overall goal of this multiphase study is to evaluate the use of simple passive air samplers to determine temporal and spatial variability of the ambient air concentrations of selected volatile organic compounds (VOCs) in urban areas. Phase 1 of this study, reported here, was a field evaluation of 3M organic vapor monitors (OVMs) involving limited comparisons with commonly used active sampling methods, an assessment of sampler precision, a determination of optimal sampling duration, and an investigation of the utility of a simple modification of the commercial sampler. The results indicated that a sampling duration of 72 hr exhibited generally low bias relative to automated continuous gas chromatography measurements, good overall precision, and an acceptable number of measurements above detection limits. The modified sampler showed good correlation with the commercial sampler, with higher sampling rates, although lower than expected.     

Quantifying Long-term Environmental Regulatory Risk for Brownfields: Are Reopeners Really an Issue?

Brownfields are potentially contaminated sites that often present economic development opportunities that require financing. State environmental voluntary clean-up programmes (VCPs) offer closure letters as a way for developers to obtain assurance that their clean-up was completed properly and is 'bankable'. However, there is still fear among lenders about the potential for these closed remediated sites to be reopened and therefore negatively affect the value of the real estate as collateral. While it is believed to be an infrequent act, there has been no comprehensive study of reopeners, and therefore of the effectiveness of VCPs available. This study seeks to quantify the incidence of reopeners in the USA through a systematic inventory of VCP administrators. The authors initially find that among the 46 states with VCPs, only 12 cases were reopened out of 11 497 closed environmental cases, a reopener rate of between 0.1% and 0.2%. However, reopener rates may increase with more vigorous enforcement and over the passage of time. This information means that brownfield deals can go forward with confidence, and that the risk of reopeners can now be quantified, allowing cheaper insurance and more assurance that negative outcomes can be avoided.