An Inexpensive Dual-Chamber Particle Monitor: Laboratory Characterization

Abstract

In developing countries, high levels of particle pollution from the use of coal and biomass fuels for household cooking and heating are a major cause of ill health and premature mortality. The cost and complexity of existing monitoring equipment, combined with the need to sample many locations, make routine quantification of household particle pollution levels difficult. Recent advances in technology, however, have enabled the development of a small, portable, data-logging particle monitor modified from commercial smoke alarm technology that can meet the needs of surveys in the developing world at reasonable cost. Laboratory comparisons of a prototype particle monitor developed at the University of California at Berkeley (UCB) with gravi-metric filters, a tapered element oscillating microbalance, and a TSI DustTrak to quantify the UCB particle monitor response as a function of both concentration and particle size and to examine sensor response in relation to changes in temperature, relative humidity, and elevation are presented here. UCB particle monitors showed good linearity in response to different concentrations of laboratory-generated oleic acid aerosols with a coarse (mass median diameter, 2.1 µm) and fine (mass median diameter, 0.27–0.42 µm) size distributions (average r² = 0.997 ± 0.005). The photoelectric and ionization chamber showed a wide range of responses based on particle size and, thus, require calibration with the aerosol of interest. The ionization chamber was five times more sensitive to fine rather than coarse particles, whereas the photoelectric chamber was five times more sensitive to coarse than fine. The ratio of the response between the two sensors has the potential for mass calibration of individual data points based on estimated parameters of the size distribution. The results demonstrate the significant potential of this monitor, which will facilitate the evaluation of interventions (improved fuels, stoves, and ventilation) on indoor air pollution levels and research on the impacts of indoor particle levels on health in developing countries.     

Risk of polycyclic aromatic hydrocarbon (PAH) exposure from ingested food: the Azerbaijan case study

Risks due to polycyclic aromatic hydrocarbons (PAHs) exposure from food consumption for the population of Azerbaijan were determined using deterministic and probabilistic methods. The guidelines and methods described and presented in the United States Environmental Protection Agency (U.S. EPA) Risk Assessment Guidance for Superfund (RAGS) Part A was used in performing the risk assessments. The current study utilized concentration data from different sources representing international studies performed over the past decade to determine those food products that contribute the most exposure to PAHs through ingestion for the Azeri population. Due to lack of concentration data from middle-Eastern countries, only European countries were considered and used for this analysis. Using the benzo[a]pyrene (BaP) toxicity equivalency factors (TEFs) to adjust the concentrations of the individual PAH compounds to BaP equivalent concentrations, risk analyses were performed. Deterministic risk estimates fell within probabilistic risk estimates. Child risks were consistently four to seven times higher in magnitude than adult risks. Risk potentials determined for the food exposure pathway were also determined to be up to ten times higher in magnitude than risks determined from exposures due to other pathways such as soil contamination. It was observed that three major factors contributed to the variability in the assessment results, which were child and adult body weights, consumption rates of the different food groups, and the variances of the input data. The most prevalent pathways of PAH exposure from the dietary patterns of the Azerbaijani population were determined to be from bread and bakery products, milk and dairy products, and egg products.     

Matrix-immobilized organoclay for the sorption of polycyclic aromatic hydrocarbons and pentachlorophenol from groundwater

Sorbent materials consisting of organoclay immobilized onto the surface of a solid support were evaluated for use in pentachlorophenol (PCP) and polycyclic aromatic hydrocarbon (PAH) remediation of groundwater at a creosote-contaminated Superfund site. Cetylpyridinium-exchanged low pH montmorillonite clay (CP-LPHM) was bonded to either sand (CP-LPHM/sand) or granular activated carbon (GAC) (CP-LPHM/GAC) using the free acid form of carboxymethylcellulose as an adhesive. Effluent from an oil-water separator was eluted through equal bed volumes of composite (4 g 3:2 CP-LPHM/GAC or 13 g CP-LPHM/sand), affinity-extracted, and quantitatively analyzed by GC/MS. PCP, naphthalene, fluorene, phenanthrene, pyrene, and total PAHs were initially reduced by both CP-LPHM/GAC (> or =99%, 61%, 99%, > or =99%, 97%, and 94%, respectively) and CP-LPHM/sand (90%, 70%, 94%, 95%, 93%, and 86%, respectively). Complete breakthrough of naphthalene occurred after approximately 15 h of elution through 3:2 CP-LPHM/GAC and 22 h through CP-LPHM/sand. PCP showed complete breakthrough following 18 h of elution through 3:2 CP-LPHM/GAC and 26 h through CP-LPHM/sand. However, 50% breakthrough was not attained for higher molecular weight PAHs, as fluoranthene, pyrene, benzo[a]anthracene, and chrysene continued to be greatly reduced with both 3:2 CP-LPHM/GAC (98%, 95%, 94%, and 95%, respectively) and CP-LPHM/sand (75%, 73%, 76%, and 78%, respectively) after 48 h of continuous elution. Results confirm prior studies, indicating that these organoclay-containing composites have a high capacity for contaminants found in wood preserving waste. Further, results suggest that the inclusion of CP-LPHM may be useful as part of an effective strategy for groundwater remediation of high concentrations of PCP and PAHs, in particular high molecular weight and carcinogenic PAHs.     

Low back pain among residential carpenters: ergonomic evaluation using OWAS and 2D compression estimation.

Occupational low back pain (LBP) remains a leading safety and health challenge. This cross-sectional investigation measured the prevalence of LBP in residential carpenters and investigated ergonomic risk factors. Ninety-four carpenters were investigated for LBP presence and associated risk factors. Ten representative job-tasks were evaluated using the Ovako Working Posture Analysis System (OWAS) and ErgoMaster 2D software to measure elements of posture, stress, and risk. Job-tasks were found to differ significantly for total lumbar compression and shear at peak loading (p < .001), ranging from 2 956 to 8 606 N and 802 to 1 974 N respectively. OWAS indicated that slight risk for injury was found in 10 job-tasks while distinct risk was found in 7 of the 10 job-tasks. Seven of the 10 job-tasks exceeded the National Institute for Occupational Safety and Health (NIOSH) action limit of 3 400 N for low back loading. The point prevalence for LBP was 14% while the annual prevalence was 38%.     

Fetal and maternal progenitor cells in co-culture respond equally to erythropoietin

To explore potentially selective growth conditions for fetal cells in cultures from the blood of pregnant women, we investigated if fetal and adult erythroid progenitors with different hemoglobin expression programs are differentially responsive to erythropoietin (EPO). Co-cultures of clonogenic cells from 12-week fetal and adult peripheral blood were established, and the development of erythropoietic cells was monitored using flow cytometric profiles of correlated cellular contents of fetal and adult hemoglobin (HbF and HbA, respectively). Adult nucleated red cells were classified as F+A−, F+A+ or F−A+. All fetal cells were F+A−. The population of F+A− cells was flow-sorted and fetal cells were identified by fluorescence in situ hybridization (FISH) using chromosome-specific probes. Delayed EPO addition revealed that all types of erythroid cells entered the EPO-dependent phase with similar kinetics, beginning at about Day 4. The data suggest that fetal and adult erythroid stem/progenitor cells have the same initial maturation kinetics in culture independent of their hemoglobin chain expression program. Fetal and adult cells with different hemoglobin profiles also showed similar EPO dose–response curves, determined for different intervals during the first 2 weeks of culture. Thus, the kinetics of entry into the phase of EPO dependence, as well as the sensitivity to EPO at various stages of development, are essentially the same for erythropoietic progenitor cells derived from adult and early fetal blood, which rules out the possibility of using the timing or concentration of EPO for the selective growth of fetal cells from the blood of pregnant women. Copyright © 2001 John Wiley & Sons, Ltd.     

Copper lability in soils subjected to intermittent submergence

Reducing conditions in soils can have significant influences on the availability of nutrient and toxic metals, through their remobilization, their release through reductive dissolution of oxide phases, and from the formation of precipitates. In the literature, contrasting results are reported on the effects of temporary waterlogging conditions on the availability of metals. In the present study, changes in the "labile" or "potentially available" pool of copper (Cu) in soils as a consequence of up to three intermittent soil submergence cycles was investigated using isotopic dilution. The soils (an Oxisol and an Inceprisol) selected were amended in the field with both biosolids-Cu and salt-Cu. Intermittent soil submergence was found to have a significant effect on the lability of Cu in soils, with E(total) values generally increasing in all the treatments with the different submergence cycles, the highest lability of Cu observed in the Cu-salt treatment. The presence of nonexchangeable colloidal forms of Cu, influenced by treatments and submergence cycles, was also reported.