Comparative environmental analysis of waste brominated plastic thermal treatments

The aim of this research activity is to investigate the environmental impact of different thermal treatments of waste electric and electronic equipment (WEEE), applying a life cycle assessment methodology. Two scenarios were assessed, which both allow the recovery of bromine: (A) the co-combustion of WEEE and green waste in a municipal solid waste combustion plant, and (B) the staged-gasification of WEEE and combustion of produced syngas in gas turbines. Mass and energy balances on the two scenarios were set and the analysis of the life cycle inventory and the life cycle impact assessment were conducted. Two impact assessment methods (Ecoindicator 99 and Impact 2002+) were slightly modified and then used with both scenarios. The results showed that scenario B (staged-gasification) had a potentially smaller environmental impact than scenario A (co-combustion). In particular, the thermal treatment of staged-gasification was more energy efficient than co-combustion, and therefore scenario B performed better than scenario A, mainly in the impact categories of "fossil fuels" and "climate change". Moreover, the results showed that scenario B allows a higher recovery of bromine than scenario A; however, Br recovery leads to environmental benefits for both the scenarios. Finally the study demonstrates that WEEE thermal treatment for energy and matter recovery is an eco-efficient way to dispose of this kind of waste.     

Anoxic-aerobic treatment of the liquid fraction of cattle manure

Cattle manure from a dairy farm was treated in order to reduce its pollution potential. The manure came from a farm with 120 cows kept in stables in a free stall barn. As pretreatment, the manure is usually filtered on the farm using a screw press separator with a 0.5 mm mesh. Approximately 70% of the total filtered volume passes through the screen, thus constituting the liquid fraction. This fraction, with a composition of around 64,500 mg COD/l, 5770 mg total-N/l and 800 mg total-P/l, was subjected to centrifugation followed by a two-step biological treatment (anoxic-aerobic) to reduce organic matter (COD), nitrogen and phosphorus compounds. Centrifugation led to the following removal efficiencies: 35% total solids, 60% COD, 75% total phosphorus and 20% total nitrogen (mainly organic nitrogen). With the subsequent anoxic-aerobic treatment, average removal efficiencies of 85% for COD, 90% for total phosphorus and 75% for total nitrogen were achieved.     

Aging and compressibility of municipal solid wastes

The expansion of a municipal solid waste (MSW) landfill requires the ability to predict settlement behavior of the existing landfill. The practice of using a single compressibility value when performing a settlement analysis may lead to inaccurate predictions. This paper gives consideration to changes in the mechanical compressibility of MSW as a function of the fill age of MSW as well as the embedding depth of MSW. Borehole samples representative of various fill ages were obtained from five boreholes drilled to the bottom of the Qizhishan landfill in Suzhou, China. Thirty-one borehole samples were used to perform confined compression tests. Waste composition and volume-mass properties (i.e., unit weight, void ratio, and water content) were measured on all the samples. The test results showed that the compressible components of the MSW (i.e., organics, plastics, paper, wood and textiles) decreased with an increase in the fill age. The in situ void ratio of the MSW was shown to decrease with depth into the landfill. The compression index, Cc, was observed to decrease from 1.0 to 0.3 with depth into the landfill. Settlement analyses were performed on the existing landfill, demonstrating that the variation of MSW compressibility with fill age or depth should be taken into account in the settlement prediction.     

Reusing fly ash in glass fibre reinforced cement: a new generation of high-quality GRC composites

New composite materials based on an alkali-resistant glass-fibre reinforced cement (AR-GRC) system are being developed by using fly ash (FA) produced at coal thermoelectric power plants, and fluid catalytic cracking catalyst residue (FC3R) from the petrol industry as cement replacement materials. These wastes are reactive from the pozzolanic viewpoint, and modify the nature and the microstructure of the cement matrix when a part of the Portland cement is replaced in the formulation of GRC. Several microstructural and mechanical aspects are being studied for AR-GRC systems. The behaviour of composites exposed to ageing shows that the pozzolanic activity of the ground FA added in high amounts and its mixture with the FC3R increase the flexural strength and no evidences of strength decay are observed. Additionally, the fibres due to the high alkalinity of the cementing matrix can be deteriorated. Fibres in the control (only Portland cement) and FC3R containing composites were attacked, whereas composites with FA and their mixture with FC3R show that the fibres have not been attacked, due to the pozzolanic activity of replacing materials that reduce the calcium hydroxide content in the cementing matrix.     

Management of MSW in Spain and recovery of packaging steel scrap

Packaging steel is more advantageously recovered and recycled than other packaging material due to its magnetic properties. The steel used for packaging is of high quality, and post-consumer waste therefore produces high-grade ferrous scrap. Recycling is thus an important issue for reducing raw material consumption, including iron ore, coal and energy. Household refuse management consists of collection/disposal, transport, and processing and treatment - incineration and composting being the most widely used methods in Spain. Total Spanish MSW production exceeds 21 million tons per year, of which 28.1% and 6.2% are treated in compost and incineration plants, respectively. This paper presents a comprehensive study of incineration and compost plants in Spain, including a review of the different processes and technologies employed and the characteristics and quality of the recovered ferrous scrap. Of the total amount of packaging steel scrap recovered from MSW, 38% comes from compost plants and 14% from incineration plants. Ferrous scrap from incineration plants presents a high degree of chemical alteration as a consequence of the thermal process to which the MSW is subjected, particularly the conditions in which the slag is cooled, and accordingly its quality diminishes. Fragmentation and magnetic separation processes produce an enhancement of the scrap quality. Ferrous scrap from compost plants has a high tin content, which negatively affects its recycling. Cleaning and detinning processes are required prior to recycling.     

Maternal transfer of brominated flame retardants in zebrafish (Danio rerio)

In many species reproduction and embryonic development have been shown to be sensitive to environmental contaminants. Understanding embryonic exposure to environmental contaminants is thus highly important. In this study concentrations of brominated flame retardants (BFRs) were measured in zebrafish eggs after parental exposure for 42 days via the diet. Zebrafish were exposed to two doses of eleven structurally-diverse BFRs. Eight BFRs were detected in the female zebrafish and maternal transfer to eggs was evident for all eight compounds. The highest concentrations in eggs were observed for hexabromocyclododecane (HBCD) and 2,4,4'-tribromodiphenyl ether (BDE 28), followed by 2,2',3,4,4',5',6-heptabromodiphenyl ether (BDE 183) and tetrabromobisphenol A 2,3-dibromopropyl ether (TBBPA DBPE). Five potential BFR metabolites were tentatively identified in female fish and maternal transfer was observed also for these compounds. The lipid adjusted concentrations in eggs were significantly higher than the concentrations in female fish for several of the BFRs. Further, the results showed a generally higher transfer in the lower exposure level and also indicated a dependency on the physico-chemical properties of the compounds.     

Mechanical Property Characterization of Plasticized Sugar Beet Pulp and Poly(Lactic Acid) Green Composites Using Acoustic Emission and Confocal Microscopy

Sorbitol and glycerol were used to plasticize sugar beet pulp-poly(lactic acid) green composites. The plasticizer was incorporated into sugar beet pulp (SBP) at 0%, 10%, 20%, 30% and 40% w/w at low temperature and shear and then compounded with poly(lactic acid) (PLA) using twin-screw extrusion and injection molding. The SBP:PLA ratio was maintained at 30:70. As expected, tensile strength decreased by 25% and the elongation increased. Acoustic emission (AE) showed correlated debonding and fracture mechanisms for up to 20% w/w plasticizer and uncorrelated debonding and fracture for 30–40% sorbitol and 30% glycerol content in SBP–PLA composites. All samples had a well dispersed SBP phase with some aggregation in the PLA matrix. However, at 40% glycerol plasticized SBP–PLA composites exhibited unique AE behavior and confocal microscopy revealed the plasticized SBP and PLA formed a co-continuous two phase system.

Environmental levels of sediment-associated tri-n-butyltin chloride (TBTCl) and ionic regulation in flounders during seawater adaptation

The effects of exposure to sediment-associated tri-n-butyltin chloride (TBTCl) were examined in the euryhaline European flounder, Platichthys flesus (L.). The effects were quantified by measuring the changes in sodium efflux; Na⁺/K⁺-ATPase activity; and the numbers, areas, and distribution of chloride cells in the gills of freshwater-adapted fish, following a rapid transfer to seawater. Following the transfer to seawater, the Na⁺/K⁺-ATPase activity and the sodium efflux were significantly increased in the control group but remained unchanged in the TBTCl-exposed group. The normal morphological changes to the gill epithelium associated with seawater adaptation, which involve chloride cell distribution, took place in the control group but were significantly inhibited or delayed in the TBTCl group. The results presented in this study lead to the conclusion that environmental concentrations of tri-n-butyltin chloride in sediments are capable of significantly disrupting both the physiological and the morphological components of iono-regulatory functions of an estuarine flatfish.     

Chromosomal and nuclear characteristics of deep-sea hydrothermal-vent organisms: correlates of increased growth rate

A range of tissue and cell types from adult and juvenile stages of vent- and non-vent-dwelling deep-sea and shallow-water organisms were compared for signs of cell division, in preparation for a cytogenetic study of the different groups. Virtually all the Mid-Atlantic Ridge (MAR) vent species (bresiliid shrimp, bathymodiolid mussel, branchipolynoid polychaete, and a range of small gastropods) showed an abundance of metaphase chromosome spreads, indicating a generally high intrinsic rate of cell division, irrespective of their phylogenetic group. In comparison, similar tissues and life-history stages (i.e. gonad, developing eggs and gill) from two deep-sea bathypelagic crustaceans, Hymenodora and Gnathophausia, failed to yield any convincing evidence of cell division. This indicated that rates of growth and reproduction in the rest of the deep sea are extremely low. While much has been written about the contrasting growth rates of vent versus non-vent organisms, this is the first direct evidence of differences in cell-division rate between vent and non-vent species, which undoubtedly reflects contrasting conditions relating to food availability and temporal stability in these two deep-sea environments. The cells of shallow-water marine invertebrates (Mytilus, Nucella, Littorina, Pomatoceros and Crangon), based on the results of previous cytogenetic investigations, occupy an intermediate position with respect to their cell-division kinetics. When chromosome numbers, DNA content and nuclear diameters were compared between vent and non-vent species, this showed that no change had occurred in these characters since the time of vent colonisation. Representative chromosome spreads from hydrothermal-vent organisms are shown here for the first time.     

Spatial and temporal pattern in seagrass community composition and productivity in south Florida

We document the distribution and abundance of seagrasses, as well as the intra-annual temporal patterns in the abundance of seagrasses and the productivity of the nearshore dominant seagrass (Thalassia testudinum) in the south Florida region. At least one species of seagrass was present at 80.8% of 874 randomly chosen mapping sites, delimiting 12,800 km² of seagrass beds in the 17,000-km² survey area. Halophila decipiens had the greatest range in the study area; it was found to occur over 7,500 km². The range of T. testudinum was almost as extensive (6,400 km²), followed by Syringodium filiforme (4,400 km²), Halodule wrightii (3,000 km²) and Halophila engelmanni (50 km²). The seasonal maxima of standing crop was about 32% higher than the yearly mean. The productivity of T. testudinum was both temporally and spatially variable. Yearly mean areal productivity averaged 0.70 g m⁻²day⁻¹, with a range of 0.05–3.29 g m⁻² day⁻¹. Specific productivity ranged between 3.2 and 34.2 mg g⁻¹ day⁻¹, with a mean of 18.3 mg g⁻¹ day⁻¹. Annual peaks in specific productivity occurred in August, and minima in February. Integrating the standing crop for the study area gives an estimate of 1.4 × 1011 g T. testudinum and 3.6 × 10¹⁰ g S. filiforme, which translate to a yearly production of 9.4 × 10¹¹ g T. testudinum leaves and 2.4 × 10¹¹ g S. filiforme leaves. We assessed the efficacy of rapid visual surveys for estimating abundance of seagrasses in south Florida by comparing these results to measures of leaf biomass for T. testudinum and S. filiforme. Our rapid visual surveys proved useful for quantifying seagrass abundance, and the data presented in this paper serve as a benchmark against which future change in the system can be quantified. Received: 30 January 2000 / Accepted: 24 July 2000