Bioremediation of chlorinated pesticide–contaminated soil using anaerobic sludges and surfactant addition

Methanogenic granular sludge and wastewater fermented sludge were used as inocula for batch tests of anaerobic bioremediation of chlorinated pesticide contaminated soil. Results obtained for both types of biomass were similar: 80 to over 90% of γ -hexachlorocyclohexane (γ-HCH), 1,1,1-trichloro-2,2-bis-(4-methoxyphenyl)ethane (methoxychlor) and 1,1,1-trichloro-2,2-bis-(4-chlorophenyl)ethane (DDT) removed in 4–6 weeks. Residual fractions of these pesticides persisted till the end of the 16-week experiment. DDT was degraded through 1,1-dichloro-2,2-bis-(4-chlorophenyl)ethane (DDD). Accumulation of this product corresponded stoichiometrically only to 34–53% of removed DDT, supposedly due to its further transformations, finally resulting in formation of detected 4,4′-dichlorobenzophenone (DBP). Addition of 0.5 mM Tween 80 nonionic surfactant resulted in about a twofold decrease of γ -HCH and methoxychlor residual concentrations, as well as considerably lower DDD accumulation (7–29%) and higher DBP production. However, 1.25 mM dose of this surfactant applied together with granular sludge brought DDD levels back to that observed for treatments with the sludge alone, also impairing DBP formation.     

Development of controlled release formulations of azadirachtin-A employing poly(ethylene glycol) based amphiphilic copolymers

Controlled release (CR) formulations of azadirachtin-A, a bioactive constituent derived from the seed of Azadirachta indica A. Juss (Meliaceae), have been prepared using commercially available polyvinyl chloride, polyethylene glycol (PEG) and laboratory synthesized poly ethylene glycol–based amphiphilic copolymers. Copolymers of polyethylene glycol and various dimethyl esters, which self assemble into nano micellar aggregates in aqueous media, have been synthesized. The kinetics of azadirachtin-A, release in water from the different formulations was studied. Release from the commercial polyethylene glycol (PEG) formulation was faster than the other CR formulations. The rate of release of encapsulated azadirachtin-A from nano micellar aggregates is reduced by increasing the molecular weight of PEG. The diffusion exponent (n value) of azadirachtin-A, in water ranged from 0.47 to 1.18 in the tested formulations. The release was diffusion controlled with a half release time (t_1/2) of 3.05 to 42.80 days in water from different matrices. The results suggest that depending upon the polymer matrix used, the application rate of azadirachtin-A can be optimized to achieve insect control at the desired level and period.     

Mercury in European Blushers,Amanita rubescens,mushrooms and topsoils: Bioconcentration potential and intake assessment

Total mercury content has been determined in fruiting bodies of European Blushers and topsoils collected from 11 sites across Poland in 2006-2008. Mercury analysis was carried out using a validated analytical method and cold-vapour atomic absorption (CV-AAS). The European Blusher effectively accumulated mercury in fruiting bodies. The mean values of total mercury in caps of European Blushers from background (uncontaminated) areas were from 0.22 to 1.0 (0.067-3.2) and in stipes from 0.16 to 0.65 (0.071-2.7) μg/g dry weight. In topsoil beneath to fruiting bodies, the median Hg concentration at 10 sites in Northern Poland varied between 0.030 and 0.072 (0.0096–0.19) μg/g dw, and in one site in Southern Poland was 0.20 (0.079–0.34) μg/g dw. Data on Hg in European Blushers from different countries were reviewed. The mean concentrations of total Hg in caps of European Blushers from two “pristine” sites in northern part of Poland were ～1.0 μg/g dw. A meal made with 300–500 g of fresh caps of European Blushers collected at such sites (assuming 90% water content in caps) can result in Hg intake of 0.0003–0.0005 mg Hg/kg bm (assuming a 60 kg bm), which is a dose equipotent to a new provisional tolerable weekly intake (PTWI) value set for inorganic Hg.     

Microwave enhanced advanced oxidation process for treating dairy manure at low pH

This study investigated the treatment of dairy manure using the microwave enhanced advanced oxidation process (MW-AOP) at pH 2. An experimental design was developed based on a statistical program using response surface methodology to explore the effects of temperature, hydrogen peroxide dosage and heating time on sugar production, nutrient release and solids destruction. Temperature, hydrogen peroxide dosage and acid concentration were key factors affecting reducing sugar production. The highest reducing sugar yield of 7.4% was obtained at 160°C, 0 mL, 15 min heating time, and no H₂O₂ addition. Temperature was a dominant factor for an increase of soluble chemical oxygen demand (SCOD) in the treated dairy manure. The important factors for volatile fatty acids (VFA) production were microwave temperature and hydrogen peroxide dosage. Temperature was the most important parameter, and heating time, to a lesser extent affecting orthophosphate release. Heating time, hydrogen peroxide dosage and temperature were significant factors for ammonia release. There was a maximum of 96% and 196% increase in orthophosphate and ammonia concentration, respectively at 160°C, 0.5 mL H₂O₂ and 15 min heating time. The MW-AOP is an effective method in dairy manure treatment for sugar production, nutrient solubilisation, and solids disintegration.     

Contamination of wild-grown edible mushrooms by heavy metals in a former mercury-mining area

The aim of this study was to evaluate the contamination of six edible wild species of mushrooms (Boletus pulverulentus, Cantharellus cibarius, Lactarius quietus, Macrolepiota procera, Russula xerampelina and Suillus grevillei) by heavy metals (Hg, Cd, Pb, Zn, Cu, Ni, Cr, Co, Mn and Fe). Mushroom samples were collected from sites contaminated by emissions from mining and processing of polymetallic ores in operation during the period 1969–1993 in Rudňany, southeast Slovakia. The four study sites spanned up to a 5-km distance from the emission source. The collected mushroom samples were analyzed using Flame Atomic Absorption Spectrophotometry and/or Flame Atomic Absorption Spectrophotometry with graphite furnace. Mercury, Cd and, in some samples, also Pb present the highest risks in terms of contamination of the food chain following subsequent consumption. The content of two metals in the dry matter (dm) of the mushrooms exceeded the limits set by the European Union (EU; Cd: 0.5 mg/kg dm, Pb: 1.0 mg/kg dm). The highest mean contents of the eight metals recorded for S. grevillei were 52.2, 2.15, 107, 104, 2.27, 2.49, 81.6 and 434 mg/kg dm for Hg, Pb, Zn, Cu, Ni, Cr, Mn and Fe, respectively. The highest content of Cd was recorded in M. procera (3.05 mg/kg dm) and that of Co in L. quietus (0.90 mg/kg dm). The calculated weekly intake for Hg, Pb and Cd shows that regular consumption of mushrooms from the studied area poses risks to human health.     

Effect of ozonization in degradation of trifluralin residues in aqueous and food matrices

Abstract

This study investigates the oxidation of trifluralin residues during ozonation in aqueous and food matrices (tomato). Domestic ozonation equipment with average production of 23.9?mg O₃ L^?1 h^?1 was used in the tests. Modern chromatographic systems (SPME-GC-IT/MS/MS and QuEChERS-GC-IT/MS/MS) were applied for extraction and detection of trifluralin residue in fortified samples of ultrapure water, tap water, superficial water and tomato fruit. The samples were submitted to the ozonation process during 0, 5, 10 and 20?min. Treatment at 5?min was able to degrade 71.5% of herbicide trifluralin in surface water. The removal (%) in ultrapure water reached 83.4% after 20?min of ozonation. The degradation of trifluralin in fortified tomato samples (0.025–0.1?mg kg^?1) were conducted with ozonation at 20?min, and it ranged from 84.4 to 92.7%. After treatment, levels of trifluralin in tomato remained within the established MRLs to EU, USEPA and ANVISA (Brazil). The data provided evidence that ozone is effective for removing trace trifluralin from water and foods.     

Clinical effects and cholinesterase activity changes in workers exposed to phorate (Thimet)

Abstract

Phorate (Thimet), an aliphatic derivative of phospnorus is a hignly toxic insecticide. In order to implement the safety measures, the clinical manifestations and cholinesterase (ChE) activity were evaluated before and after 2 weeks of exposure to this insecticide in 40 male tormulators.

The 2 week's exposure reveal signs and symptoms of toxicity in 60% of the formulators. Gastrointestinal symptoms and lowering of heart rate (bradycardia) were more prominent as compared to the neurological symptoms. A significant depression in plasma ChE activity was observed at the end of 1st week (55%) and 2nd week (71%) as compared to the respective pre‐exposure values. A recovery up to 79% of the pre‐exposure activity of this enzyme was noticed 10 days after cessation of the above exposure.     

Persistence and biodegradation of carbaryl in soils

Abstract

The persistence of the methylcarbamate pesticide carbaryl was studied in four soils under flooded conditions. A substantial portion of the pesticide was recovered from all soils even after 15 days of its application, with the recovery ranging from 37% in an alluvial soil to 73% in an acid sulfate soil. The degradation of carbaryl was more rapid under flooded conditions than under nonflooded conditions. A bacterium, Pseudomonas cepacia, isolated from a flooded soil amended with a related methylcarbamate pesticide carbofuran, degraded carbaryl in a mineral medium supplemented with yeast extract.     

A Simple Methodology for the Determination of Back Trajectories

Abstract

This study comprehensively characterizes hourly fine particulate matter (PM_2.5) concentrations measured via a tapered element oscillating microbalance (TEOM), β-gauge, and nephelometer from four different monitoring sites in U.S. Environment Protection Agency (EPA) Region 5 (in U.S. states Illinois, Michigan, and Wisconsin) and compares them to the Federal Reference Method (FRM). Hourly characterization uses time series and autocorrelation. Hourly data are compared with FRM by averaging across 24-hr sampling periods and modeling against respective daily FRM concentrations. Modeling uses traditional two-variable linear least-squares regression as well as innovative nonlinear regression involving additional meteorological variables such as temperature and humidity. The TEOM shows a relationship with season and temperature, linear correlation as low as 0.7924 and nonlinear model correlation as high as 0.9370 when modeled with temperature. The β-gauge shows no relationship with season or meteorological variables. It exhibits a linear correlation as low as 0.8505 with the FRM and a nonlinear model correlation as high as 0.9339 when modeled with humidity. The nephelometer shows no relationship with season or temperature but a strong relationship with humidity is observed. A linear correlation as low as 0.3050 and a nonlinear model correlation as high as 0.9508 is observed when modeled with humidity. Nonlinear models have higher correlation than linear models applied to the same dataset. This correlation difference is not always substantial, which may introduce a tradeoff between simplicity of model and degree of statistical association. This project shows that continuous monitor technology produces valid PM_2.5 characterization, with at least partial accounting for variations in concentration from gravimetric reference monitors once appropriate nonlinear adjustments are applied. Although only one regression technically meets new EPA National Ambient Air Quality Standards (NAAQS) Federal Equivalent Method (FEM) correlation coefficient criteria, several others are extremely close, showing optimistic potential for use of this nonlinear adjustment model in garnering EPA NAAQS FEM approval for continuous PM_2.5 sampling methods.