秸秆还田方式对东北农田土壤NH3挥发和N2O排放的影响

秸秆还田是有效利用资源、增加土壤有机质含量和培肥地力的有效措施,但也会影响土壤NH₃挥发和N₂O的排放.探索不同秸秆还田方式对NH₃挥发和N₂O排放的影响对于减少土壤氮素损失和保护生态环境具有重要意义.采用田间小区试验,利用Los Gatos Research（LGR）超便携NH₃分析仪和密闭式静态箱-气相色谱法探究不同秸秆还田方式下土壤NH₃挥发和N₂O排放的特征,试验设4个处理（覆盖还田,即表面覆盖玉米秸秆,0~20和20~40 cm土壤分层扰动后填回,记为JG0-0;常规还田,即秸秆与0~20 cm土壤混合,20~40 cm土壤扰动后填回,记为JG0-20;深还田,秸秆与20~40 cm土壤混合,0~20 cm土壤挖出后填回,记为JG20-40;对照处理,即无玉米秸秆还田,0~20和20~40 cm土壤分层扰动后填回,记为CK）.结果表明:①相比于CK,不同秸秆还田方式均显著降低了土壤NH₃挥发量,增加了土壤N₂O排放量.与CK相比,JG0-0、JG0-20和JG20-40处理下土壤NH₃累积排放量分别减少了12.38%、9.87%和5.73%;土壤N₂O累积排放量分别增加了30.19%、82.82%和36.53%,其中JG0-0和JG20-40处理之间无显著性差异.②JG20-40处理下玉米产量显著高于其他处理,比CK增加了23.15%,JG0-0处理下玉米产量高于CK和JG0-20处理,但并未达到显著水平.③对于NH₃和N₂O这两种气体的总累积排放量,各处理间均达到显著性差异.与CK相比,JG0-0、JG0-20和JG20-40处理下NH₃和N₂O总累积排放量分别增加了16.67%、52.08%和22.92%.④不同秸秆还田方式下的氮素气态损失率均高于CK,JG0-0、JG0-20和JG20-40处理下氮素气态损失率分别比CK增加了17.50%、52.50%和22.50%.因此,综合考虑土壤NH₃挥发量、N₂O排放量和玉米产量等因素,JG0-0处理优于JG20-40、JG0-20处理.      

Adjusting sowing date and cultivar shift improve maize adaption to climate change in China

Mitigation and Adaptation Strategies for Global Change - This study investigates the impact of climate change on spring and summer maize (Zea mays) yield and evaluates several adaptation measures...     

Nanoencapsulation of hexavalent chromium with nanoscale zero-valent iron: High resolution chemical mapping of the passivation layer

Solid phase reactions of Cr(Ⅵ) with Fe(0) were investigated with spherical-aberration-corrected scanning transmission electron microscopy(Cs-STEM) integrated with X-ray energy-dispersive spectroscopy(XEDS). Near-atomic resolution elemental mappings of Cr(Ⅵ)–Fe(0) reactions were acquired. Experimental results show that rate and extent of Cr(Ⅵ) encapsulation are strongly dependent on the initial concentration of Cr(Ⅵ) in solution. Low Cr loading in nZⅥ(1.0 wt%) promotes the electrochemical oxidation and continuous corrosion of n ZⅥ while high Cr loading(1.0 wt%) can quickly shut down the Cr uptake. With the progress of iron oxidation and dissolution, elements of Cr and O counter-diffuse into the nanoparticles and accumulate in the core region at low levels of Cr(Ⅵ)(e.g., 10 mg/L). Whereas the reacted n ZⅥ is quickly coated with a newly-formed layer of 2–4 nm in the presence of concentrated Cr(Ⅵ)(e.g., 100 mg/L). The passivation structure is stable over a wide range of pH unless pH is low enough to dissolve the passivation layer. X-ray photoelectron spectroscopy(XPS) depth profiling reconfirms that the composition of the newly-formed surface layer consists of Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxides with Cr(Ⅵ) adsorbed on the outside surface. The insoluble and insulating Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxide layer can completely cover the n ZⅥ surface above the critical Cr loading and shield the electron transfer. Thus, the fast passivation of nZⅥ in high Cr(Ⅵ) solution is detrimental to the performance of nZⅥ for Cr(Ⅵ) treatment and remediation.     

Seasonal variation and size distribution of biogenic secondary organic aerosols at urban and continental background sites of China

Size-resolved biogenic secondary organic aerosols(BSOA) derived from isoprene and monoterpene photooxidation in Qinghai Lake, Tibetan Plateau(a continental background site) and five cities of China were measured using gas chromatography/mass spectrometry(GC/MS). Concentrations of the determined BSOA are higher in the cities than in the background and are also higher in summer than in winter. Moreover, strong positive correlations(R2= 0.44–0.90) between BSOA and sulfate were found at the six sites,suggesting that anthropogenic pollution(i.e., sulfate) could enhance SOA formation,because sulfate provides a surface favorable for acid-catalyzed formation of BSOA. Size distribution measurements showed that most of the determined SOA tracers are enriched in the fine mode( 3.3 μm) except for cis-pinic and cis-pinonic acids, both presented a comparable mass in the fine and coarse( 3.3 μm) modes, respectively. Mass ratio of oxidation products derived from isoprene to those from monoterpene in the five urban regions during summer are much less than those in Qinghai Lake region. In addition, in the five urban regions relative abundances of monoterpene oxidation products to SOA are much higher than those of isoprene. Such phenomena suggest that BSOA derived from monoterpenes are more abundant than those from isoprene in Chinese urban areas.     

高速铁路选线对生态环境的影响分析研究

高速铁路选线要充分考虑对生态环境的影响,在路基、桥涵、隧道等形式通过环境敏感点时,要从工程技术和生态环境保护的角度出发,避免高速铁路建设和运营对当地的水资源环境、自然保护区造成破坏。根据高速铁路周边的环境信息,在路基填土高度上结合地形、地质和水文自然特征确定合理的填土高度。在高速铁路跨越生态保护区和湖泊等线路中,贯彻生态选线的原则,准确确定桥涵净空,在工程设计、施工上采用系列的生态保护措施。     

绿色建筑的节能环保设计思路分析研究

绿色建筑具有透光好、保温性与通风性好等优点,为了实现节能减排,提高宜居性,进行绿色建筑的节能环保设计,考虑低碳节能效果,在建筑外墙使用抹整体式保温系统,楼顶使用现浇整体式保温系统进行建筑的保温墙设计,考虑建筑的通风性,建筑使用通透性的设计方案,设计空中楼顶花园,提高隔热防晒效果的同时,提高绿化覆盖面积。合理布局楼高和楼间距,提高建筑的采光性,设计景观生物廊道,采用底层架空式结构实现自然通风和采光,实现绿色建筑的节能优化设计。     

Analysis of pollutant levels in central Hong Kong applying neural network method with particle swarm optimization

Air pollution has emerged as an imminent issue in modernsociety. Prediction of pollutant levels is an importantresearch topic in atmospheric environment today. For fulfillingsuch prediction, the use of neural network (NN), and inparticular the multi-layer perceptrons, has presented to be acost-effective technique superior to traditional statisticalmethods. But their training, usually with back-propagation (BP)algorithm or other gradient algorithms, is often with certaindrawbacks, such as: 1) very slow convergence, and 2) easilygetting stuck in a local minimum. In this paper, a newlydeveloped method, particle swarm optimization (PSO) model, isadopted to train perceptrons, to predict pollutant levels, andas a result, a PSO-based neural network approach is presented. The approach is demonstrated to be feasible and effective bypredicting some real air-quality problems.     

Analysis of BTEX and other substituted benzenes in water using headspace SPME-GC-FID: method validation

The analysis of BTEX and other substituted benzenes in water samples using solid phase microextraction (SPME) and quantification by gas chromatography with flame ionization detection (GC-FID) was validated. The best analytical conditions were obtained using PDMS/DVB/CAR fibre using headspace extraction (HS-SPME) at 50 [degree]C for 20 min without stirring. The linear range for each compound by HS-SPME with GC/FID was defined. The detection limits for these compounds obtained with PDMS/DVB/CAR fibre and GC/FID were: benzene (15 ng L(-1)), toluene (160 ng L(-1)), monochlorobenzene (54 ng L(-1)), ethylbenzene (32 ng L(-1)), m-xylene (56 ng L(-1)), p-xylene (69 ng L(-1)), styrene (35 ng L(-1)), o-xylene (42 ng L(-1)), m-dichlorobenzene (180 ng L(-1)), p-dichlorobenzene (230 ng L(-1)), o-dichlorobenzene (250 ng L(-1)) and trichlorobenzene (260 ng L(-1)). This headspace SPME-GC-FID method was compared with a previously validated method of analysis using closed-loop-stripping analysis (CLSA). The headspace SPME-GC-FID method is suitable for monitoring the production and distribution of potable water and was used, in field trials, for the analysis of samples from main intakes of water (surface or underground) and from the water supply system of a large area (Lisbon and neighbouring municipalities).     

Using improved neural network model to analyze RSP,NOx and NO2 levels in urban air in Mong Kok,Hong Kong

As the health impact of air pollutants existing in ambient addresses much attention in recent years, forecasting of airpollutant parameters becomes an important and popular topic inenvironmental science. Airborne pollution is a serious, and willbe a major problem in Hong Kong within the next few years. InHong Kong, Respirable Suspended Particulate (RSP) and NitrogenOxides NO_x and NO₂ are major air pollutants due to thedominant diesel fuel usage by public transportation and heavyvehicles. Hence, the investigation and prediction of the influence and the tendency of these pollutants are ofsignificance to public and the city image. The multi-layerperceptron (MLP) neural network is regarded as a reliable andcost-effective method to achieve such tasks. The works presentedhere involve developing an improved neural network model, whichcombines the principal component analysis (PCA) technique and theradial basis function (RBF) network, and forecasting thepollutant levels and tendencies based in the recorded data. Inthe study, the PCA is firstly used to reduce and orthogonalizethe original input variables (data), these treated variables arethen used as new input vectors in RBF neural network modelestablished for forecasting the pollutant tendencies. Comparingwith the general neural network models, the proposed modelpossesses simpler network architecture, faster training speed,and more satisfactory predicting performance. This improvedmodel is evaluated by using hourly time series of RSP, NO_x and NO₂ concentrations collected at Mong Kok Roadside Gaseous Monitory Station in Hong Kong during the year 2000. By comparing the predicted RSP, NO_x and NO₂ concentrationswith the actual data of these pollutants recorded at the monitorystation, the effectiveness of the proposed model has been proven.Therefore, in authors' opinion, the model presented in the paper is a potential tool in forecasting air quality parameters and hasadvantages over the traditional neural network methods.     

The organic composition of diesel particulate matter, diesel fuel and engine oil of a non-road diesel generator

Diesel-powered equipment is known to emit significant quantities of fine particulate matter to the atmosphere. Numerous organic compounds can be adsorbed onto the surfaces of these inhalable particles, among which polycyclic aromatic hydrocarbons (PAHs) are considered potential occupational carcinogens. Guidelines have been established by various agencies regarding diesel emissions and various control technologies are under development. The purpose of this study is to identify, quantify and compare the organic compounds in diesel particulate matter (DPM) with the diesel fuel and engine oil used in a non-road diesel generator. Approximately 90 organic compounds were quantified (with molecular weight ranging from 120 to 350), which include alkanes, PAHs, alkylated PAHs, alkylbenzenes and alkanoic acids. The low sulfur diesel fuel contains 61% alkanes and 7.1% of PAHs. The identifiable portion of the engine oil contains mainly the alkanoic and benzoic acids. The composition of DPM suggests that they may be originated from unburned diesel fuel, engine oil evaporation and combustion generated products. Compared with diesel fuel, DPM contains fewer fractions of alkanes and more PAH compounds, with the shift toward higher molecular weight ones. The enrichment of compounds with higher molecular weight in DPM may be combustion related (pyrogenic).