A simple and efficient multi-residue method based on QuEChERS for pesticides determination in palm oil by liquid chromatography time-of-flight mass spectrometry

In this study, a rapid, specific and sensitive multi-residue method based on acetonitrile extraction followed by dispersive solid-phase extraction (d-SPE) clean-up was implemented and validated for multi-class pesticide residues determination in palm oil for the first time. Liquid-liquid extraction followed by low-temperature precipitation procedure was evaluated in order to study the freezing-out clean-up efficiency to obtain high recovery yield and low co-extract fat residue in the final extract. For clean-up step, d-SPE was carried out using a combination of anhydrous magnesium sulphate (MgSO(4)), primary secondary amine, octadecyl (C(18)) and graphitized carbon black. Recovery study was performed at two concentration levels (10 and 100 ng g(-1)), yielding recovery rates between 74.52% and 97.1% with relative standard deviation values below 10% (n?=?6) except diuron. Detection and quantification limits were lower than 5 and 9 ng g(-1), respectively. In addition, soft matrix effects (≤±20%) were observed for most of the studied pesticides except malathion that indicated medium (20-50%) matrix effects. The proposed method was successfully applied to the analysis of suspected palm oil samples.     

Indoor radon measurement and effective dose assessment of 150 apartments in Mashhad,Iran

Environmental monitoring and indoor radon measurement are important for public health, to estimate the cancer risk of respiratory system and, if necessary, to suggest proper methods that reduce indoor radon level. In this research, indoor radon concentration in the air has been measured in 150 apartments in Mashhad city. The result demonstrates about 94.7% of apartments have radon concentration less than 100 Bq/m³, taken by WHO as the action level, and 5.3% have the concentration higher than this level. As well as, annual radon dose has been assessed using the equation for annual effective dose calculation introduced by United Nations Scientific Committee on the Effects of Atomic Radiation.     

Environmental monitoring model for a drainage basin obtained through spectral analysis of time series

The quality of results of an environmental monitoring plan is limited to the weakest component, which could be the analytical approach or sampling method. Considering both the possibilities and the fragility that sampling methods offer, this environmental monitoring study focused on the uncertainties caused by the time component. Four time series of nutrient concentration at two sampling points (PB1 and PB2) in the Ribeir?o Garcia basin in Blumenau, Brazil, which were significantly correlated to the spatial component, were considered with a 2-hour resolution to develop efficient sampling models. These models were based on the time at which there was the highest tendency toward adverse environmental effects. Fourier spectral analysis was used to evaluated the time series and resulted in two sampling models: (1) the SMCP (sampling model for critical period) that operated with 100% efficiency for registering the highest concentration of nutrients and was valid for 83% of the studied parameters; and (2) the SMGCP (sampling model for global critical period) that operated with 83 and 50% efficiency for PB1 and PB2, respectively.     

The morphological structure of leaves and the dust-retaining capability of afforested plants in urban Guangzhou, South China

Purpose

Air pollution is a serious health problem throughout the world, exacerbating a wide range of respiratory and vascular illnesses in urban areas. The mass artificial plantation is very helpful to absorb dust and reduce pollution for conservation of the urban environment. The foliar surface of plants is an important receptor of atmospheric pollutants. Therefore, selection of suitable plant species for urban environment is very important.

Methods

The dust-retaining capability of urban trees in Guangzhou was determined at four different types of urban area, and the morphological traits of their leaves such as wax, cuticle, stomata, and trichomes were observed under a scanning electron microscope.

Results

It was determined that the dust-retaining capability of any given tree species is significantly different in the same place. Of the four studied tree species in the industrial area (IA) and commercial/traffic areas (CTA) type urban areas, the highest amounts of dust removed by Mangifera indica Linn was 12.723 and 1.482?g/m², respectively. However, in contrast, the equivalent maxima for Bauhinia blakeana is only 2.682?g/m² and 0.720?g/m², respectively. Different plant species have different leaf morphology. The leaf of M. indica has deep grooves and high stomata density which are in favor of dust-retained, and thus, their dust-retained capability is stronger, while B. blakeana has the cells and epicuticular wax with its stomata arranging regularly, resulting in poor dust catching capability. Leaf size was also shown to be related to dust capture for the four studied tree species.

Conclusions

The dust removal capacity of individual tree species should be taken into account in the management of greening plantation in and around an urban area. It was also shown that temporal variation in dust accumulation occurred over the 28-day observation period and this was discussed. Furthermore, spatial contrasts in dust accumulation were evidenced by the data. This reflected the differing pollution loadings of the four urban-type areas. The highest amount of dust accumulation was associated with the industrial area in which shipyard and steelworks occurred whilst the lowest dust accumulation was associated with the grounds of the University which was the control area.     

Bacterial stimulation of copper phytoaccumulation by bioaugmentation with rhizosphere bacteria

Copper contaminated areas pose environmental health risk to living organisms. Remediation processes are thus required for both crop production and industrial activities. This study employed bioaugmentation with copper resistant bacteria to improve phytoremediation of vineyard soils and copper mining waste contaminated with high copper concentrations. Oatmeal plant (Avena sativa L.) was used for copper phytoextraction. Three copper resistant bacterial isolates from oatmeal rhizosphere (Pseudomonas putida A1; Stenotrophomonas maltophilia A2 and Acinetobacter calcoaceticus A6) were used for the stimulation of copper phytoextraction. Two long-term copper contaminated vineyard soils (Mollisol and Inceptisol) and copper mining waste from Southern Brazil were evaluated. Oatmeal plants substantially extracted copper from vineyard soils and copper mining waste. As much as 1549 mg of Cu kg?1 dry mass was extracted from plants grown in Inceptisol soil. The vineyard Mollisol copper uptake (55 mg Cu kg?1 of dry mass) in the shoots was significantly improved upon inoculation of oatmeal plants with isolate A2 (128 mg of Cu kg?1 of shoot dry mass). Overall oatmeal plant biomass displayed higher potential of copper phytoextraction with inoculation of rhizosphere bacteria in vineyard soil to the extent that 404 and 327 g ha?1 of copper removal were respectively observed in vineyard Mollisol bioaugmented with isolate A2 (S. maltophilia) and isolate A6 (A. calcoaceticus). Results suggest potential application of bacterial stimulation of phytoaccumulation of copper for biological removal of copper from contaminated areas.     

Sorption kinetics and equilibria of organic pesticides in carbonatic soils from South Florida

A batch reactor was used to determine sorption kinetic parameters (k2, F, and K*) and the equilibrium sorption coefficient (K). The two-site nonequilibrium (TSNE) batch sorption kinetics model was used to calculate the kinetic parameters. Two probe organic pesticides, atrazine [2-chloro-4-ethylamino-6-isopropylamino-s-triazine] and diuron [3-(3,4-dichlorophenyl)-1,1-dimethylurea] were studied using three carbonatic soils from South Florida (Chekika, Perrine, and Krome), one noncarbonatic soil from Iowa (Webster), and one organic soil (Lauderhill) from South Florida. Carbonatic soils contained more than 600 g kg(-1) CaCO3. Sorption is initially very fast up to 3 h and then slowly reaches equilibrium. All soil-chemical combinations reached sorption equilibrium after about 24 h and all sorption isotherms were linear. The sorption kinetics data were well described by the TSNE model for all soil-chemical combinations except for the marl soil data (Perrine-Atrazine), which were better described by the one-site nonequilibrium (OSNE) model. Diuron, with higher K, undergoes slower sorption kinetics than atrazine. The Lauderhill soil containing organic carbon (OC) of 450 g kg(-1) exhibited slowest sorption kinetics for both pesticides. An inverse relationship between k3 and K was observed for atrazine and diuron separately in Chekika, Webster, and Lauderhill soils but not in Perrine and Krome soils. The sorption kinetic parameters were used to distinguish the sorption behavior between atrazine and diuron and to identify differences between soils. Normalizing the sorption coefficient (K) to OC showed that atrazine and diuron had K oc values in carbonatic soils that were a third of reported literature values for noncarbonatic soils. Using existing literature K oc values in solute transport models will most likely underestimate the mobility of atrazine, diuron, and other neutral organic chemicals in carbonatic soils.     

Exposure to sublethal concentrations of Zn(II) and Cu(II) changes biochemical parameters in Leporinus obtusidens

The aim of the present study was to assess the effect of the exposure of Leporinus obtusidens (Piava) to zinc and copper on catalase activity in the liver, delta-aminolevulinate dehidratase (delta-ALA-D) activity in liver, muscle, brain and kidney, and thiobarbituric reactive species (TBARS) in brain, muscle and liver. In addition, hematological parameters were measured in blood. The fish were exposed to 10% and 20% of the derived LC(50) values, 2.3 and 4.6 mg Zn l(-1) and 0.02 and 0.04 mg Cu l(-1), and sampled on days 30 and 45. Exposure to Zn(II) and Cu(II) decreased hematological parameters and also delta-ALA-D activity mainly in liver and kidney at all concentrations tested. Liver catalase activity increased after zinc or copper exposure at all concentrations and exposure times tested. Thiobarbituric reactive substances (TBARS) increased in the brain and liver of the fish exposed to zinc(II) for 45 days at both metal concentrations. In muscle, zinc(II) increased TBARS production at both exposure times and concentrations tested. Copper(II) exposure reduced the TBARS levels in liver at both concentrations and times tested. In brain, there was a decrease in TBARS levels only after 45 days of exposure. In muscle, this decrease was observed after 30 days of exposure at both concentrations. Although zinc and copper are required as microelements in the cells, our results showed that the sublethal concentrations of these metals can change biochemical parameters which may alter normal cellular function. These results pointed out the differential sensitivity of fish tissues to essential, but also toxic and environmentally relevant metals. The alterations of distinct biochemical parameters in fish tissues certainly contribute to the toxicity of Zn and Cu, and are of importance for an area that has been growing and has still been poorly explored in the literature.     

Vertical distribution of acid-volatile sulfide and simultaneously extracted metals in mangrove sediments from the Jiulong River Estuary,Fujian, China

Background Acid-volatile sulfide (AVS) is operationally defined as sulfides in sediment, which are soluble in cold acid, and is reported as the most active part of the total sulfur in aquatic sediments. It is a key partitioning phase controlling the activities of divalent cationic heavy metals in sediment. Methods In order to examine this in mangrove environments, six sites were selected along the Jiulong River Estuary in Fujian, China, which had previously been reported to be polluted by heavy metals. Sediments were sampled from 0–60 cm depth at each site, and the spatial distribution of AVS and SEM (simultaneously extracted metals: copper, cadmium, zinc, and lead) were determined. Results and Discussion The results indicate that the AVS concentrations had a spatial variation, ranging from 0.24 to 16.10 μmol g⁻¹ sediment dry weight. The AVS concentration in the surface layer is lower than that of the deeper sediment, with peak values in the 15–30 cm horizon. There was no correlation between the AVS value and organic matter content or total dissolved salts, but a significant positive correlation of AVS with surface sediment (0–5 cm) moisture content was found. This indicates that water logged sediments tend to have a high AVS value. The amount of SEM was within the range of 0.33–2.80 μmol g⁻¹ sediment dry weight and decreased with sediment depth. Conclusions There was a marked variation in AVS and SEM among different sites studied. AVS concentrations were generally lower in the surface sediments, while SEM concentrations slightly decreased with the depth. Higher concentrations of SEM found in the upper layers of the sediments confirm the earlier suggestions that this study area may suffer from increasing heavy metal pollution. Recommendations and Perspectives When monitoring environmental impacts by using AVS, the micro and large-scale spatial variation as well as vertical distribution need to be estimated to avoid misleading results. Both AVS and SEM concentrations in different sediment layers should be taken into account in assessing the potential impact of heavy metals on the biotic environment.     

Knowledge transfer initiative between molecular biologists and environmental researchers and regulators

A Natural Environment Research Council (NERC) funded Knowledge Transfer (KT) workshop was held in the United Kingdom (UK) to identify the needs and opportunities in the application of molecular biology and ‘omics’ techniques to environmental monitoring and risk assessment. Attendees highlighted a lack of effective communication between end-users and researchers as well as difficulties with data interpretation as reasons behind the slow uptake of molecular biology and omics techniques. A number of promising areas in which new techniques could be implemented at a practical level in the very near future were identified, thereby raising the profile of these recent technologies and providing vital proof of concept work. Molecular taxonomy, bacterial source tracking and pre-screening of chemicals for potential toxicities were all viewed as areas in which omics and molecular techniques could have immediate value, with the aim of reducing cost, increasing efficiency and providing more comprehensive data of improved quality.     

Environmental forensics: an emerging discipline within UK higher education?

Environmental forensics is an established discipline in North America, but has yet to make an impact within Europe and more specifically within the UK. In this paper we explore the reasons for this and explore the nature and fundamental philosophy that underlies this discipline. Case studies can be used to explore the complexity that can be associated with an environmental forensic investigation and we argue that there is a demand for professionals with skills in forensic practice within the environmental sector today. The paper finishes by suggesting that environmental forensics is a discipline of its moment within Europe for which the Higher Education sector must now cater.