Coupled solar photo-Fenton and biological treatment for the degradation of diuron and linuron herbicides at pilot scale

A coupled solar photo-Fenton (chemical) and biological treatment has been used to remove biorecalcitrant diuron (42 mg l(-1)) and linuron (75 mg l(-1)) herbicides from water at pilot plant scale. The chemical process has been carried out in a 82 l solar pilot plant made up by four compound parabolic collector units, and it was followed by a biological treatment performed in a 40 l sequencing batch reactor. Two Fe(II) doses (2 and 5 mg l(-1)) and sequential additions of H2O2 (20 mg l(-1)) have been used to chemically degrade the initially polluted effluent. Next, biodegradability at different oxidation states has been assessed by means of BOD/COD ratio. A reagent dose of Fe=5 mg l(-1) and H2O2=100 mg l(-1) has been required to obtain a biodegradable effluent after 100 min of irradiation time. Finally, the organic content of the photo-treated solution has been completely assimilated by a biomass consortium in the sequencing batch reactor using a total suspended solids concentration of 0.2 g l(-1) and a hydraulic retention time of 24h. Comparison between the data obtained at pilot plant scale (specially the one corresponding to the chemical step) and previously published data from a similar system performing at laboratory scale, has been carried out.     

Use of electrochemical technology to increase the quality of the effluents of bio-oxidation processes. A case studied

In this work, it has been studied the use of conductive-diamond electrochemical oxidation (CDEO) as a refining technology to assure the quality of the effluents of door manufacturing processes (DMP). To do this, the raw effluents of these factories have been treated by a combination of physicochemical, biological and CDEO treatments. CDEO was found to be a feasible alternative to the refinement of a wooden DMP waste. It can successfully decrease the organic load of the effluents of the biological oxidation with low energy requirements. In addition, in case of incidents in the biological process, CDEO can treat successfully the effluents of the coagulation process. The effluents of the biological treatment have also been treated by CDEO in order to check the possible use of electrochemical technology to increase the biodegradability of the effluents and their possible recycle to the biological treatment. Unfortunately, electrochemical technology was found to be not adequate to increase the biodegradability of the effluents of a biological treatment. The hard oxidation conditions generated during CDEO do not lead to the accumulation of intermediates but to the almost direct formation of carbon dioxide. Lowering the current density or changing the electrodes can not enhance the biodegradability of the effluents of an electrochemical cell.     

Levels of organochlorine pesticides and polychlorinated biphenyls in the critically endangered Iberian lynx and other sympatric carnivores in Spain

Accumulation of organochlorine compounds is well studied in aquatic food chains whereas little information is available from terrestrial food chains. This study presents data of organochlorine levels in tissue and plasma samples of 15 critically endangered Iberian lynx (Lynx pardinus) and other 55 wild carnivores belonging to five species from three natural areas of Spain (Doñana National Park, Sierra Morena and Lozoya River) and explores their relationship with species diet. The Iberian lynx, with a diet based on the consumption of rabbit, had lower PCB levels (geometric means, plasma: <0.01 ng mL⁻¹, liver: 0.4 ng g⁻¹ wet weight, fat: 87 ng g⁻¹ lipid weight) than other carnivores with more anthropic and opportunistic foraging behavior, such as the red fox (Vulpes vulpes; plasma: 1.11 ng mL⁻¹, liver: 459 ng g⁻¹, fat: 1984 ng g⁻¹), or with diets including reptiles at higher proportion, such as the Egyptian mongoose (Herpestes ichneumon; plasma: 7.15 ng mL⁻¹, liver: 216 ng g⁻¹, fat: 540 ng g⁻¹), or the common genet (Genetta genetta; liver: 466 ng g⁻¹, fat: 3854 ng g⁻¹). Chlorinated pesticides showed interspecific variations similar to PCBs. Organochlorine levels have declined since the 80s in carnivores from Doñana National Park, but PCB levels are still of concern in Eurasian otters (Lutra lutra; liver: 3873-5426 ng g⁻¹) from the industrialized region of Madrid.     

Photoinduced reduction of divalent mercury in ice by organic matter

Reduction of divalent mercury and subsequent emission to the atmosphere has been identified as loss process from surface snow, but its mechanism and importance are still unclear. The amount of mercury that stays in the snow pack until spring is of significance, because during snow melt it may be released to the aquatic environment and enter the food web. Better knowledge of its fate in snow might further assist the interpretation of ice core data as paleo-archive. Experiments were performed under well-controlled laboratory conditions in a coated wall flow tube at atmospheric pressure and irradiated with light between 300 nm and 420 nm. Our results show that the presence of benzophenone and of oxalic acid significantly enhances the release of mercury from the ice film during irradiation, whereas humic acid is less potent to promote the reduction. Further it was found that oxygen or chloride, and acidic conditions lowered the photolytically induced mercury release in the presence of benzophenone, while the release got larger with increasing temperatures.     

Effect of ibuprofen exposure on blood,gill, liver,and brain on common carp (Cyprinus carpio) using oxidative stress biomarkers

Although trace concentrations of ibuprofen (IBP) have been detected in diverse water bodies, there is currently insufficient information on the potentially deleterious effects of this xenobiotic. The present study aimed to determine whether IBP induces oxidative stress in brain, liver, gill, and blood of the common carp Cyprinus carpio. To this end, the median lethal concentration at 96 h (96-h LC₅₀) was determined and the lowest observed adverse effect level was established. Carp were exposed to the latter concentration (17.6 mg L^?1) for 12, 24, 48, 72, and 96 h, and the following biomarkers were evaluated: lipid peroxidation (LPX) and activity of the antioxidant enzymes superoxide dismutase, catalase, and glutathione peroxidase. Results indicated that LPX and antioxidant enzymes’ activity increased significantly (p?<?0.05) with respect to the control group in liver, gill, and blood, while no significant differences occurred in brain. In conclusion, IBP induced oxidative stress on C. carpio, the liver being the organ most affected by this damage.     

Electrochemical advanced oxidation processes: today and tomorrow. A review

In recent years, new advanced oxidation processes based on the electrochemical technology, the so-called electrochemical advanced oxidation processes (EAOPs), have been developed for the prevention and remediation of environmental pollution, especially focusing on water streams. These methods are based on the electrochemical generation of a very powerful oxidizing agent, such as the hydroxyl radical (^?OH) in solution, which is then able to destroy organics up to their mineralization. EAOPs include heterogeneous processes like anodic oxidation and photoelectrocatalysis methods, in which ^?OH are generated at the anode surface either electrochemically or photochemically, and homogeneous processes like electro-Fenton, photoelectro-Fenton, and sonoelectrolysis, in which ^?OH are produced in the bulk solution. This paper presents a general overview of the application of EAOPs on the removal of aqueous organic pollutants, first reviewing the most recent works and then looking to the future. A global perspective on the fundamentals and experimental setups is offered, and laboratory-scale and pilot-scale experiments are examined and discussed.     

Evaluating Environmental Parameters for Minimum Ammonium Losses during Composting of Trimming Residues

Abstract

A neural fuzzy system was used to investigate the influence of environmental variables (time, aeration, moisture, and particle size) on composting parameters (pH, organic matter [OM], nitrogen [N], ammonium nitrogen [NH₄ ⁺-N] and nitrate nitrogen [NO₃ ^--N]). This was to determine the best composting conditions to ensure the maximum quality on the composts obtained with the minimum ammonium losses. A central composite experimental design was used to obtain the neural fuzzy model for each dependent variable. These models, consisting of the four independent process variables, were found to accurately describe the composting process (the differences between the experimental values and those estimated by using the equations never exceeded 5–10% of the former). Results of the modeling showed that creating a product with acceptable chemical properties (pH, NH₄ ⁺-N and NO₃ ^--N) entails operating at medium moisture content (55%) and medium to high particle size (3–5 cm). Moderate to low aeration (0.2 L air/min · kg) would be the best compromise to compost this residue because of the scant statistical influence of this independent variable.     

Influence of particle location on the number of charges per charged nanoparticle at the outlet of a needle charger

This study has investigated numerically the influence of particle location on the number of charges per charged particle in the 10–40 nm size range at the outlet of a needle charger by simulating flow field, electric field, particle charging, and particle trajectory at various conditions. The results show that the total (i.e., diffusion + field charging) number of charges per particle increase with decreasing ratio values of radial location at the outlet of the charger due to the particle position close to the needle tip. It has also been shown that in the outlet region of the charger there is a critical radial location at which the number of charges per particle is a maximum; this critical radial location represents the point at which the charged particle trajectory becomes closest to the needle electrode. The maximum value of number of charges increases with increasing Reynolds number and slightly increases with decreasing applied voltage for particle diameter larger than 20 nm. The maximum number of charges per charged nanoparticle increases with increasing particle diameter. In addition, the minimum ratio value of radial particle location decreases with increasing Reynolds number for various particle diameters.

Implications: In this work, the influence of particle location on the number of charges per charged nanoparticle at the outlet of a needle charger has been investigated using numerical models under different conditions. The results demonstrate that the radial location affects the number of charges per particle at the outlet of the charger. The maximum number of charges increases with increasing particle diameter, and the minimum ratio value of radial particle location decreases with increasing Reynolds number. The numerical models explain and quantify the number of charges on the charged particle in the 10–40 nm size range from the outlet of the needle charger at various conditions.     

Waste materials for activated carbon preparation and its use in aqueous-phase treatment: a review

Commercial activated carbon is a preferred adsorbent for the removal of micropollutants from the aqueous phase; however, its widespread use is restricted due to high associated costs. To decrease treatment costs, attempts have been made to find inexpensive alternative activated carbon (AC) precursors, such as waste materials. Some reviews report the use of waste materials for the preparation of AC; however, these studies are restricted to either type of wastes, preparation procedures, or specific aqueous-phase applications. The present work reviews and evaluates literature dedicated both to the preparation of AC by recycling different types of waste materials and also to its application in various aqueous-phase treatments. It is clear that conventional (from agriculture and wood industry) and non-conventional (from municipal and industrial activities) wastes can be used to prepare AC, that can be applied in various aqueous treatment processes, namely to remove organic pollutants, dyes, volatile organic compounds, and heavy metals. Moreover, high surface areas can be obtained using either physical or chemical activation; however, combined treatments might enhance the surface properties of the adsorbent, therefore increasing its adsorption capacity. It is evident from the revision made that AC prepared from both conventional and non-conventional wastes might effectively compete with the commercial ones. This happens mostly when the activation procedures are optimized considering both the raw material used to produce the carbons and the contaminants to be removed.