Impact of the mixing boundary layer on the relationship between PM2.5 and aerosol optical thickness

The purpose of this paper is to study the relationship between columnar aerosol optical thickness and ground-level aerosol mass. A set of Sun photometer, elastic backscattering lidar and TEOM measurements were acquired during April 2007 in Lille, France. The PM2.5 in the mixed boundary layer is estimated using the lidar signal, aerosol optical thickness, or columnar integrated Sun photometer size distribution and compared to the ground-level station measurements. The lidar signal recorded in the lowest level (240 m) is well correlated to the PM2.5 (R² = 0.84). We also show that the correlation between AOT-derived and measured PM2.5 is significantly improved when considering the mixed boundary layer height derived from the lidar. The use of the Sun photometer aerosol fine fraction volume does not improve the correlation.     

Arsenic removal from water employing heterogeneous photocatalysis with TiO2 immobilized in PET bottles

Arsenic oxidation (As(III) to As(V)) and As(V) removal from water were assessed by using TiO₂ immobilized in PET (polyethylene terephthalate) bottles in the presence of natural sunlight and iron salts. The effect of many parameters was sequentially studied: TiO₂ concentration of the coating solution, Fe(II) concentration, pH, solar irradiation time; dissolved organic carbon concentration. The final conditions (TiO₂ concentration of the coating solution: 10%; Fe(II): 7.0 mg l⁻¹; solar exposure time: 120 min) were applied to natural water samples spiked with 500 μg l⁻¹ As(III) in order to verify the influence of natural water matrix. After treatment, As(III) and total As concentrations were lower than the limit of quantitation (2 μg l⁻¹) of the voltammetric method used, showing a removal over 99%, and giving evidence that As(III) was effectively oxidized to As(V). The results obtained demonstrated that TiO₂ can be easily immobilized on a PET surface in order to perform As(III) oxidation in water and that this TiO₂ immobilization, combined with coprecipitation of arsenic on Fe(III) hydroxides(oxides) could be an efficient way for inorganic arsenic removal from groundwaters.     

Microbial community dynamics in a chemolithotrophic denitrification reactor inoculated with methanogenic granular sludge

Denitrification is applied in the tertiary treatment of wastewater to reduce nitrogen pollution. Fluorescence in situ hybridization (FISH), catalyzed reporter deposition (CARD)-FISH, cloning, and scanning electron microscopy (SEM) were applied to follow the evolution of the microbial composition and structure of granular sludge in chemolithotrophic denitrifying bioreactors fed with nitrate and thiosulfate. FISH oligonucleotide probes for the chemolitoautotrophic denitrifiers Thiobacillus denitrificans and Thiomicrospira denitrificans were designed and their utility tested. CARD-FISH and cloning data showed that bacterial diversity in the biofilms changed during the reactor operation. Chemoorganotrophic fermentative Gram-positive strains in the phyla, Actinobacteria and Firmicutes, were dominant in the methanogenic inoculum, both in terms of biodiversity and in number. Other significant phyla were Bacteroidetes and Chloroflexi. After 6 months of operation, Proteobacteria became dominant (83% of the clones). The diversity of Gram-positive bacteria was partially maintained although their abundance decreased notably. After 110 d of operation, the abundance of Tb. denitrificans cells increased considerably, from 1% to 35% of total DAPI-stained cells and from no isolated clones to 15% of the total clones. Tm. denitrificans only represented a minor fraction of the microorganisms in the sludge (1-4% of the DAPI-stained cells). These findings confirm that Tb. denitrificans was the dominant chemolitoautotrophic denitrifying microorganism in the bioreactors. The Archaeal diversity remained almost unchanged and it was represented mostly by Methanosaeta soehngenii. SEM results indicated a considerable loss in the integrity of the sludge granules during the operation, with risk of sludge buoyancy.     

Air concentrations of PCDD/Fs, PCBs and PCNs using active and passive air samplers

The concentrations of polychlorinated dibenzo-p-dioxins and furans (PCDD/Fs), polychlorinated biphenyls (PCBs) and polychlorinated naphthalenes (PCNs) were determined in air samples collected at four sampling sites located in two zones of Barcelona (Spain): near a municipal solid waste incinerator (MSWI) and a combined cycle power plant (3 sites), and at a background/control site. Samples were collected using high-volume active samplers. Moreover, 4 PUF passive samplers were deployed at the same sampling points during three months. For PCDD/Fs, total WHO-TEQ values were 27.3 and 10.9 fg WHO-TEQm(-3) at the urban/industrial and the background sites, respectively. The sum of 7 PCB congeners and the Sigma PCN levels were also higher at the industrial site than at the background site. In order to compare active and passive sampling, the accumulated amounts of PCDD/Fs, PCBs and PCNs in the four passive air samplers, as well as the total toxic equivalents in each sampling site were also determined. To assess the use of PUF passive samplers as a complementary tool for PCDD/F, PCB and PCN monitoring, sampling rates were calculated in accordance with the theory of passive air samplers. PUF disks allowed establishing differences among zones for the POP levels, showing that they can be a suitable method to determine POP concentrations in air in areas with various potential emission sources. Although both particle and gas phase were sorbed by the PUFs, data of gas phase congeners are more reproducible.     

Estimating the environmental impact of micro-pollutants in the low Ebro River (Spain): an approach based on screening toxicity with Vibrio fischeri

The aim of this study was to assess the likely impacts on the ecosystems due to agricultural, human, and industrial activities carried out in an ecologically important area of the Ebro River (Spain). For it, a screening site specific ecological risk assessment was conducted. Considering the presence of high levels of potentially toxic substances, such as metals and chlorinated organic compounds, aqueous and organic extracts were used to assess toxicity in sediments by using the photo-luminescent bacteria Vibrio fischeri (Microtox) as screening response variable. Sediment samples collected during 2005-2006 in the last course of the Ebro River and its Delta have been analyzed. Toxic responses have shown strong relationships to the levels of pollutants in the area. Moreover, various sites presented some toxicity level, probably because of other factors associated with reducing environments into the sediments. Results indicate that Microtox bioassay is an appropriate tool to perform risk assessment studies at screening level.     

Soil vapor extraction in sandy soils: influence of airflow rate

Airflow rate is one of the most important parameters for the soil vapor extraction of contaminated sites, due to its direct influence on the mass transfer occurring during the remediation process. This work reports the study of airflow rate influence on soil vapor extractions, performed in sandy soils contaminated with benzene, toluene, ethylbenzene, xylene, trichloroethylene and perchloroethylene. The objectives were: (i) to analyze the influence of airflow rate on the process; (ii) to develop a methodology to predict the remediation time and the remediation efficiency; and (iii) to select the most efficient airflow rate. For dry sandy soils with negligible contents of clay and natural organic matter, containing the contaminants previously cited, it was concluded that: (i) if equilibrium between the pollutants and the different phases present in the soil matrix was reached and if slow diffusion effects did not occur, higher airflow rates exhibited the fastest remediations, (ii) it was possible to predict the remediation time and the efficiency of remediation with errors below 14%; and (iii) the most efficient remediation were reached with airflow rates below 1.2 cm(3)s(-1) standard temperature and pressure conditions.     

Concentrations of PCDD/PCDFs in plasma of subjects living in the vicinity of a hazardous waste incinerator: follow-up and modeling validation

In 2007, the concentrations of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/PCDFs) were determined in plasma of non-occupationally exposed subjects living near the only hazardous waste incinerator (HWI) in Spain (Constantí, Tarragona County, Catalonia). These data were compared with the levels found in two previous surveys performed in 1998 (baseline) and 2002. The current mean PCDD/PCDF concentration in plasma was 9.36pg I-TEQg(-1) of lipid (range: 1.76-23.44pg I-TEQg(-1) of lipid). It means a significant reduction of the mean PCDD/PCDFs levels in plasma in comparison to the concentrations found in 1998 and 2002 (27.01 and 15.70pg I-TEQg(-1) of lipid, respectively). This important decrease agrees well with the notable reduction in the dietary intake of PCDD/PCDFs recently noted for the population of the same area (210.1pg I-TEQd(-1), 63.8pgWHO-TEQd(-1), and 27.8pgWHO-TEQd(-1), in 1998, 2002 and 2007, respectively). The current data were also used to predict theoretical PCDD/PCDF concentrations in plasma by executing a single-compartment empirically-based pharmacokinetic model on the basis of the daily intake of these pollutants by the local population.     

Effects of long-term soil amendment with sewage sludges on soil humic acid thermal and molecular properties

Sewage sludges are frequently used as soil amendments due to their high contents of organic matter and nutrients, particularly N and P. However, their effects upon the chemistry of soil humic acids, one of the main components of the soil organic matter, need to be more deeply studied in order to understand the relation between organic matter structure and beneficial soil properties. Two sewage sludges subjected to different types of pre-treatment (composted and thermally dried) with very different chemical compositions were applied for three consecutive years to an agricultural soil under long-term field study. Thermal analysis (TG–DTG–DTA) and solid-state ¹³C NMR spectroscopy were used to compare molecular and structural properties of humic acids isolated from sewage sludges, and to determine changes in amended soils. Thermally dried sewage sludge humic acids showed an important presence of alkyl and O/N-alkyl compounds (70%) while composted sludge humic acids comprised 50% aromatic and carbonyl carbon. In spite of important differences in the initial chemical and thermal properties of the two types of sewage sludges, the chemical and thermal properties of the soil humic acids were quite similar to one another after 3 years of amendment. Long-term application of both sewage sludges resulted in 80–90% enrichment in alkyl carbon and organic nitrogen contents of the soil humic acid fraction.     

Human health risks of petroleum-contaminated groundwater

BACKGROUND, AIM AND SCOPE: The volatile organic compounds Benzene, Toluene, Ethylbenzene and Xylene (BTEX) are commonly found in petroleum derivatives and, at relatively high levels, can be associated with human health risks. Due to industrial activities, accidental petroleum spills are the main route of soil and groundwater contamination. The aim of the present study was to evaluate the indoor health risks due to tap water consumption contaminated by BTEX. MATERIALS AND METHODS: BTEX indoor exposure can occur through three principal pathways: inhalation, ingestion and dermal absorption. A multiphase and multicomponent model was used to simulate BTEX transport in groundwater. For evaluation of human risks due to the use of contaminated tap water, a mathematical model was elaborated. RESULTS: BTEX concentrations in a drinking well were obtained as a function over time. These concentrations were used to obtain the exposure due to the use of water from the contaminated drinking well. In addition to showing the highest concentration in water, benzene was the compound that remained for a longer period before being completely degraded. For all the evaluated BTEX, oral ingestion was also the main pathway of exposure for adults, whereas the contribution of inhalation and oral exposition in children were seen to be of the same magnitude. The sensitivity analysis of BTEX total dose for adults showed that direct ingestion was the most significant factor, followed by shower time, volume of the shower room, inhalation rate, and shower flow rate. For children, the most significant variable was also direct ingestion, followed by shower time, volume of the shower room, and body weight. DISCUSSION: In the current design situation, there would not be any health risks by the use of BTEX-contaminated water to the general population living in the neighborhood of the petroleum spill. Therefore, no remediation measures in the area of the spill would be necessary. CONCLUSIONS: The present results indicate that the design of a good scenario can perform an accuracy risk assessment. This model can serve as a useful tool for predicting indoor exposure to substances for which no direct data are available, reducing monitoring efforts and observing how different processes affect outcomes. RECOMMENDATIONS AND PERSPECTIVES: These preliminary data allow the establishment of a basis for further investigations focusing on efficiently recovering petroleum from contaminated sites.     

Experimental analysis and modeling of a stormwater perlite filter

This paper presents the study of a mixed porous media composed of expanded perlite and a nonwoven needle-punched geotextile used to reduce the suspended solids load and concentration in urban runoff. Laboratory procedures were designed to quantify the suspended solids removal efficiency and variation in time of filtration rate. Different grain-size distributions of expanded perlite, diverse suspended solids concentrations, and different hydraulic and geometric conditions were tested to determine the most effective filter media. A dimensionless parameter, termed Global Performance Index (GPI), was developed to reach this objective. Measured data were also used to build a dimensional and a regression model to represent the performance of the filter media mathematically. The theory, derivation, and performance of both models are presented and compared with an existent empirical model. The dimensional model better reproduces the observations, becoming a useful tool for the design, operation, and evaluation of commercial porous media filters.