Distribution and bioaccumulation of PAHs in the UNESCO protected natural reserve of Urdaibai, Bay of Biscay

Along 10 campaigns, from June 2002 to September 2004, the concentrations of 16 polycyclic aromatic hydrocarbons (PAHs) were measured in sediments and oysters (Crassostrea sp.) taken from four sites in the Unesco protected natural reserve of Urdaibai (Basque Country, Bay of Biscay). Total PAH concentration ranged from 0.7 to 140 microg kg(-1) (dw) in the case of sediments, and from 300 to 1400 microg kg(-1) (dw) in the case of oysters. During this study, the coast of the Bay of Biscay was severely affected by the Prestige oil spill (November 2002). Presumably, as a consequence of this accident, both spatial and temporal variations of the PAHs, as well as the sources of the PAHs were affected by the oil spill, and this effect was observed in the total concentrations and, especially, in several diagnostic ratios and in multivariate data analysis. Finally, both BAF (bioaccumulation factor) and BSAF (biota-sediment accumulation factor) parameters were calculated to conclude that particulate matter seems to be the most favourable uptake pathway of PAHs in oysters from this estuary.     

Trace element accumulation in woody plants of the Guadiamar Valley, SW Spain: a large-scale phytomanagement case study

Phytomanagement employs vegetation and soil amendments to reduce the environmental risk posed by contaminated sites. We investigated the distribution of trace elements in soils and woody plants from a large phytomanaged site, the Guadiamar Valley (SW Spain), 7 years after a mine spill, which contaminated the area in 1998. At spill-affected sites, topsoils (0-25 cm) had elevated concentrations of As (129 mg kg(-1)), Bi (1.64 mg kg(-1)), Cd (1.44 mg kg(-1)), Cu (115 mg kg(-1)), Pb (210 mg kg(-1)), Sb (13.8 mg kg(-1)), Tl (1.17 mg kg(-1)) and Zn (457 mg kg(-1)). Trace element concentrations in the studied species were, on average, within the normal ranges for higher plants. An exception was white poplar (Populus alba), which accumulated Cd and Zn in leaves up to 3 and 410 mg kg(-1) respectively. We discuss the results with regard to the phytomanagement of trace element contaminated sites.     

Use of an inverse dispersion technique for estimating ammonia emission from surface-applied slurry

Ammonia (NH₃) emission from land application of manure is typically measured using the integrated horizontal flux (IHF) micrometeorological method. However, there are some situations in which alternative techniques (such as an inverse dispersion modelling technique) might be preferable, for example when measuring from large or irregularly shaped source areas. In this study, an inverse dispersion technique using the backward Lagrangian stochastic (bLS) model, with 2 different experimental configurations, was compared with the Integrated Horizontal Flux method (i.e. IHF), which was used as reference technique. Pig slurry was surface-applied at 125 kg N ha^?1 to bare soil on a large plot (80 × 125 m). Cumulative emissions were 19.3, 21.2 and 18.4 kg N ha^?1 from the IHF and the bLS technique (experimental configurations I and II), respectively. Mean flux within each sampling period as estimated by the two techniques compared extremely well, with a slope not significantly different from 1 and r² of 0.99. Although limited in extent, this dataset agree with a previous study in demonstrating the use of the bLS technique with longer period time-averaged concentration measurements.     

Influence of Saharan dust outbreaks and atmospheric stability upon vertical profiles of size-segregated aerosols and water vapor

Vertical profiles of aerosols and meteorological parameters were obtained using a hot air balloon and motorized paraglider. They were studied under anticyclonic conditions in four different contexts. Three flights occurred near sunrise, and one took place in the central hours of the day. The effects of North African dust intrusions were analyzed, whose entrance to the study area took place above the Stable Boundary Layer (SBL) in flight 1 and below it in flight 2. These flights have been compared with a non-intrusion situation (flight 3). A fourth flight characterized the profiles in the central hours of the day with a well-formed Convective Boundary Layer (CBL). With respect to the particle number distribution, the results show that not all sizes increase within the presence of an intrusion; during the first flight the smallest particles were not affected. The particle sizes affected in the second flight fell within the 0.35–2.5 μm interval. Under situations of convective dynamics, the reduction percentage of the particle number concentration reduces with increasing altitude, independently of their size, with respect to stability conditions. The negative vertical gradient for aerosols and water vapor, characteristic of a highly stable SBL (flight 3) becomes a constant profile within a CBL (flight 4). There are two situations that seem to alter the negative vertical gradient of the water vapor mixing ratio within the SBL: the presence of an intrusion and the possible stratification of the SBL based on different degrees of stability.     

Soil nitrous oxide emissions following band-incorporation of fertilizer nitrogen and swine manure

Treatment of liquid swine manure (LSM) offers opportunities to improve manure nutrient management. However, N2O fluxes and cumulative emissions resulting from application of treated LSM are not well documented. Nitrous oxide emissions were monitored following band-incorporation of 100 kg N ha(-1) of either mineral fertilizer, raw LSM, or four pretreated LSMs (anaerobic digestion; anaerobic digestion + flocculation: filtration; decantation) at the four-leaf stage of corn (Zea mays L.). In a clay soil, a larger proportion of applied N was lost as N2O with the mineral fertilizer (average of 6.6%) than with LSMs (3.1-5.0%), whereas in a loam soil, the proportion of applied N lost as N2O was lower with the mineral fertilizer (average of 0.4%) than with LSMs (1.2-2.4%). Emissions were related to soil NO3 intensity in the clay soil, whereas they were related to water-extractable organic C in the loam soil. This suggests that N2O production was N limited in the clay soil and C limited in the loam soil, and would explain the interaction found between N sources and soil type. The large N2O emission coefficients measured in many treatments, and the contradicting responses among N sources depending on soil type, indicate that (i) the Intergovernmental Panel on Climate Change (IPCC) default value (1%) may seriously underestimate N2O emissions from fine-textured soils where fertilizer N and manure are band-incorporated, and (ii) site-specific factors, such as drainage conditions and soil properties (e.g., texture, organic matter content), have a differential influence on emissions depending on N source.     

Prospects for cost-effective post-combustion CO2 capture from industrial CHPs

Industrial Combined Heat and Power plants (CHPs) are often operated at partial load conditions. If CO₂ is captured from a CHP, additional energy requirements can be fully or partly met by increasing the load. Load increase improves plant efficiency and, consequently, part of the additional energy consumption would be offset. If this advantage is large enough, industrial CHPs may become an attractive option for CO₂ capture and storage CCS. We therefore investigated the techno-economic performance of post-combustion CO₂ capture from small-to-medium-scale (50–200 MWe maximum electrical capacity) industrial Natural Gas Combined Cycle- (NGCC-) CHPs in comparison with large-scale (400 MWe) NGCCs in the short term (2010) and the mid-term future (2020–2025). The analyzed system encompasses NGCC, CO₂ capture, compression, and branch CO₂ pipeline.The technical results showed that CO₂ capture energy requirement for industrial NGCC-CHPs is significantly lower than that for 400 MWe NGCCs: up to 16% in the short term and up to 12% in the mid-term future. The economic results showed that at low heat-to-power ratio operations, CO₂ capture from industrial NGCC-CHPs at 100 MWe in the short term (41–44 €/tCO₂ avoided) and 200 MWe in the mid-term future (33–36 €/tCO₂ avoided) may compete with 400 MWe NGCCs (46–50 €/tCO₂ avoided short term, 30–35 €/tCO₂ avoided mid-term).     

Raptor ecotoxicology in Spain: a review on persistent environmental contaminants

Initial studies on the pressure from environmental contaminants on raptor populations in Spain date back to the 1980s, and they have been carried out from a range of viewpoints using a range of sentinel raptor species. However, there is no national monitoring scheme, and therefore the research carried out has been sporadic both spatially and temporally. The exposure to metals has not varied over time, except in the case of lead, whose concentration in eggs and tissues has diminished. In general, the concentrations of metals detected in raptor samples from Spain are generally low and not sufficient to produce toxic effects. Excepting DDT and DDE, most organochlorine-based pesticides in raptors from Spain have diminished over the last 2 decades. The concentrations of DDE found in the eggs of various species could in part explain problems in the reproductive success of raptors in Spain.     

Dietary exposure to PCDD/PCDFs by individuals living near a hazardous waste incinerator in Catalonia, Spain: temporal trend

The levels of polychlorinated dibenzo-p-dioxins (PCDD) and polychlorinated dibenzofurans (PCDF) were measured in foodstuffs randomly acquired in July 2006 in various locations of Tarragona County (Catalonia, Spain), which are near a hazardous waste incinerator (HWI). A total of 35 composite samples, belonging to various food groups (vegetables, pulses, cereals, fruits, fish and seafood, meat and meat products, eggs, milk, dairy products, and oils and fats) were analyzed by HRGC/HRMS. The dietary intake of PCDD/PCDFs was subsequently determined and compared with a previous survey performed in 2002. For calculations, recent data on consumption of the selected food items were used. Total dietary intake of PCDD/PCDFs for the general population of Tarragona County was estimated to be 27.81 pg WHO-TEQ/day, value notably lower than that found in the 2002 study, 63.80 pg WHO-TEQ/day. Fish and seafood (28%), oils and fats (22%), eggs (17%), and dairy products (11%) were the most important contributors to this intake, while pulses (1%), milk (2%), vegetables (3%) and fruits (3%) showed the lowest contribution to total WHO-TEQ. The current PCDD/PCDF intake is also considerably lower than the intake estimated in 1998 for the population of the same geographical area, 210.1 pg I-TEQ/day, when a baseline study was carried out during the construction of the HWI. The present intake is also compared with the dietary intakes of PCDD/PCDFs recently (2006-2007) reported for a number of regions and countries.     

A method for measuring the anoxic biodegradability under denitrifying conditions

A test for assessing the anoxic biodegradability of organic compounds under denitrifying conditions is proposed. The method is based on the recovery and quantification of the CO2 produced, which is evidence of complete biodegradation of the test compound (added as the sole carbon source). The tests were carried out in a mineral medium, with nitrate as electron acceptor. Whole lake sediments, sediment extracts and a commercial inoculum were assayed as a possible inoculum source by means of glucose biodegradability tests. It was found that the sediment extracts constitute a suitable and environmentally-relevant inoculum source, since they add non-significant amounts of carbon to the tests. Two xenobiotic compounds, namely, aniline and phenol, were tested in the aforementioned conditions as well as in a standard aerobic biodegradability test. Both aniline and phenol attained a biodegradation level higher than 60% in a short time period (<28 days) and thus can be considered as readily biodegradable in denitrifying environments. Nevertheless, the kinetics obtained in the anoxic test were slower than in aerobic conditions, and even suggested the accumulation of intermediate metabolites in the case of phenol. The results of this study indicate that the fate of xenobiotic compounds under anoxic conditions differs from that observed in an oxic environment, and therefore it should be considered by standard biodegradability testing procedures.     

Potential application of highly reactive Fe(0)/Fe3O4 composites for the reduction of Cr(VI) environmental contaminants

We describe the use of highly reactive Fe(0)/Fe3O4 composites for the reduction of Cr(VI) species in aqueous medium. The composites were prepared by simple mechanical alloying of metallic iron and magnetite in different proportions, i.e. Fe(0) 25, 50, 75 and 90wt%. While after 3h of reaction pure Fe(0) and pure Fe3O4 showed only a low reduction efficiency of 15% and 25% Cr(VI) conversion, respectively, the composites, in particular Fe(0)(25wt%)/Fe3O4, showed a remarkable activity with ca. 65% Cr(VI) conversion. Kinetic experiments showed a high reaction rate during the first 3h, which subsequently decreased strongly, probably due to a pH increase from 6 to 8. Experiments with composites based on Fe(0)/alpha-Fe2O3, Fe(0)/gamma-Fe2O3 and Fe(0)/FeOOH showed very low activities, suggesting that Fe(oct)2+ in the magnetite structure plays an important role in the reaction. Scanning and high resolution electron microscopies and M?ssbauer spectra (transmission and conversion electron M?ssbauer spectroscopy) indicated that the mechanical alloying process promotes a strong interaction and interface between the metallic and oxide phases, with the Fe(0) particles completely covered by Fe3O4 particles. The high efficiency of the composite Fe(0)/Fe3O4 for Cr(VI) reduction is discussed in terms of a special mechanism where an electron is transferred from Fe(0) to magnetite to reduce Fe(oct)3+ to Fe(oct)2+, which is active for Cr(VI) reduction.