Variation of the Relative Humidity of Air Released from Canisters after Ambient Sampling

ABSTRACT

Dalton's law of partial pressures and the hypothesis that water vapor equilibrium in a canister is identical to that established above liquid water are used to predict the variation of the percent relative humidity (%RH) of air released from canisters used in ambient air sampling, typically 6-L canisters pressurized with 18 L of air. When (and if) the water vapor partial pressure in a canister exceeds its saturation vapor pressure, water vapor condensation begins and the condensation rate equals the sampling rate of water vapor into the canister. Under constant temperature conditions, the air subsequently released from the canister is less humid than the original sample, following the relationship %RH = 100% (6 L/V_s) for V_s> V_r, where V_s is the residual air volume (referenced to atmospheric pressure), and V_r is shown to depend on the %RH of the ambient air sample. V_r is the residual air volume at which water is completely removed (except for adsorbed water vapor) from the canister wall. For V_s < V_r, the predicted %RH is constant and equal to its value at V_r. Experimental values agree reasonably well with predictions at both high (90%) and low (34%) RH. However, experimental values are often slightly displaced (usually towards lower values of %RH) for mid-range %RH (61%) and variations in %RH near V_r change from canister to canister.     

A game theoretic approach to multimodal communication

Over the last few decades the animal communication community has become increasingly aware that much communication occurs using multiple signals in multiple modalities. The majority of this work has been empirical, with less theoretical work on the advantages conferred by such communication. In the present paper, we ask: Why should animals communicate with multiple signals in multiple modalities? To tackle this question we use game theoretic techniques, and highlight developments in the economic signaling literature that might offer insight into biological problems. We start by establishing a signaling game, and investigate signal honesty under two prevailing paradigms of honest communication – costly signaling and cheap talk. In both paradigms, without further constraint, it is simple to show that anything that can be achieved with multiple signals can be achieved with one. We go on to investigate different sets of possible constraints that may make multiple signals and multimodal signals in particular more likely to evolve. We suggest that constraints on cost functions and bandwidths, orthogonal noise across modalities, strategically distinct modes, multiple qualities, multiple signalers, and multiple audiences, all provide biologically plausible scenarios that theoretically favor multiple and multimodal signaling.     

EFFECTS OF CLIMATIC CHANGE ON THE THORNTHWAITE MOISTURE INDEX1

ABSTRACT: The Thornthwaite moisture index is a useful indicator of the supply of water (precipitation) in an area relative to the demand for water under prevailing climatic conditions (potential evapotranspiration). This study examines the effects of changes in climate (temperature and precipitation) on the Thornthwaite moisture index in the conterminous United States. Estimates of changes in mean annual temperature and precipitation for doubled-atmospheric CO₂ conditions derived from three general circulation models (GCMs) are used to study the response of the moisture index under steady-state doubled-CO₂ conditions. Results indicate that temperature and precipitation changes under doubled-CO₂ conditions generally will cause the Thornthwaite moisture index to decrease, implying a drier climate for most of the United States. The pattern of expected decrease is consistent among the three GCMs, although the amount of decrease depends on which GCM climatic-change scenario is used. Results also suggest that changes in the moisture index are related mainly to changes in the mean annual potential evapotranspiration as a result of changes in the mean annual temperature, rather than to changes in the mean annual precipitation.     

HYDROLOGIC EFFECTS OF CLIMATE CHANGE IN THE DELAWARE RWER BASIN1

ABSTRACT: The Thornthwaite water balance and combinations of temperature and precipitation changes representing climate change were used to estimate changes in seasonal soil-moisture and runoff in the Delaware River basin. Winter warming may cause a greater proportion of precipitation in the northern part of the basin to fall as rain, which may increase winter runoff and decrease spring and summer runoff. Estimates of total annual runoff indicate that a 5 percent increase in precipitation would be needed to counteract runoff decreases resulting from a warming of 2°C; a 15 percent increase for a warming of 4°C. A warming of 2° to 4°C, without precipitation increases, may cause a 9 to 25 percent decrease in runoff. The general circulation model derived changes in annual runoff ranged from ?39 to +9 percent. Results generally agree with those obtained in studies elsewhere. The changes in runoff agree in direction but differ in magnitude. In this humid temperate climate, where precipitation is evenly distributed over the year, decreases in snow accumulation in the northern part of the basin and increases in evapotranspiration throughout the basin could change the timing of runoff and significantly reduce total annual water availability unless precipitation were to increase concurrently.     

Managing petroleum refining wastes by thermal desorption

The U.S. Environmental Protection Agency has developed regulations under the Hazardous and Solid Waste Amendments (HSWA) of 1984 to restrict the land disposal of hazardous wastes. As a result of the regulations, all hazardous wastes to be placed on the land must meet treatment standards based on the performance of the best demonstrated available technology (BDAT) identified for individual waste classifications. The Marathon Oil Company is currently evaluating innovative technologies for managing listed waste materials, with a focus on waste minimization and recycling. Remediation Technologies, Inc. (ReTeC) has conducted testing on wastewater treatment sludges from three Marathon refineries using a proprietary thermal desorption technology. The results from these tests have demonstrated that the technology has the ability to consistently meet BDAT treatment standards, while preferentially separating and condensing residual moisture and oils from the material.     

SOIL MOISTURE SENSORS FOR CONTINUOUS MONITORING1

ABSTRACT: Certain physical and chemical properties of soil vary with soil water content. The relationship between these properties and water content is complex and involves both the pore structure and constituents of the soil solution. One of the most economical techniques to quantify soil water content involves the measurement of electrical resistance of a dielectric medium that is in equilibrium with the soil water content. The objective of this research was to test the reliability and accuracy of fiberglass soil-moisture electrical resistance sensors (ERS) as compared to gravimetric sampling and Time Domain Reflectometry (TDR). The response of the ERS was compared to gravimetric measurements at eight locations on the USDA-ABS Walnut Gulch Experimental Watershed. The comparisons with TDR sensors were made at three additional locations on the same watershed. The high soil rock content (≥45 percent) at seven locations resulted in consistent overestimation of soil water content by the ERS method. Where rock content was less than 10 percent, estimation of soil water was within 5 percent of the gravimetric soil water content. New methodology to calibrate the ERS sensors for rocky soils will need to be developed before soil water content values can be determined with these sensors.     

Evaluation of a chemical stabilization process

Environmental Resources Management (ERM) performed an evaluation of a biosolids chemical stabilization process known as BIO*FIX®, marketed by Bio Gro Systems, Inc., of Annapolis, Maryland. The purpose of the evaluation was (1) to assess major characteristics of the process and its final product, (2) to determine the quantity and final disposition of all components in the incoming biosolids, and (3) to determine if the process conforms to new regulations promulgated and administered by the U.S. Environmental Protection Agency (EPA) titled “Standards for the Use or Disposal of Sewage Sludges” (40 CFR Part 503). The BIO*FIX® chemical stabilization process involves the addition of calcium oxide (CaO) to dewatered biosolids at rates that achieve the pathogen reduction and vector attraction reduction requirements of the 503 program while creating a marketable end product used as an agricultural amendment. ERM's project involved the testing of four process streams in order to create a mass balance on the process. Laboratory analyses were performed on samples of the dewatered biosolids, the chemically-stabilized end product, and the scrubber water effluent. The primary components of concern tested in the above process streams were ammonia, metals, odorous compounds, particulate matter, and organic matter. Through the tests described in the article, ERM drew the following conclusions: (1) The major gaseous pollutant resulting from the BIO*FIX® process is gaseous ammonia. The total gaseous ammonia released from the product depends on the ammonia nitrogen content of the biosolids, and pH and temperature levels reached in the process. Additional ammonia is emitted when the end product is loaded in trucks and stored. Any gaseous ammonia remaining in the end product after processing will slowly dissipate over time. (2) Other potential odor pollutants such as hydrogen sulfide (H₂S) and mercaptans were found to be below detectable levels in the uncontrolled exhaust gas. (3) Metals were not found in the exhaust gas in any detectable quantities. They would not be expected to volatilize during the process. Particulate matter emissions were found to be very low. (4) The pathogen reduction and vector attraction reduction requirements of the 40 CFR 503 regulations were met or exceeded. (5) Finally, through observations and tests, ERM found that the BIO*FIX® chemical stabilization process provides for a simple, viable, and effective conversion of biosolids into a beneficial use product in compliance with all pertinent regulations.     

Ecologically derived guidelines for managing two New Zealand lakes

Lakes Manapouri and Te Anau, in Fiordland National Park, became the center of a major controversy after the New Zealand government offered their water resource to an overseas aluminum smelting consortium for electricity generation. Although the scheme proceeded, the lake levels were not raised as originally proposed. Rather, government sought guidelines to optimize hydroelectric potential while maintaining ecological stability of the vulnerable, largely forested, glaciated lakeshores. Guidelines were derived by relating the vegetation zonation to the natural lake-level fluctuations recorded daily for 37 years. Ahigh operating range in the upper third of the lakes' natural ranges, based on flood tolerances of the woody shoreline species, restricts both duration and frequency. Alow operating range (ca. lower third) safeguards stability of shoreline sediments by limiting drawn-down rates, duration, and frequency. Themain operating range (ca. middle third) has few limitations. These guidelines, which allow utilization of ca. 93% of the water resource, have now been verified by instances of flooding and draw-down rates that exceeded the natural rates recorded earlier. The guidelines were officially accepted by the government in 1977 as a basis for managing the valuable multiple resources of these two lakes and their environs, and they were formalized in legislation in 1981. The details and merits of the guideline approach are discussed.     

Construction of guilds for habitat assessment

This article outlines a procedure for developing guilds for use in habitat assessment studies. It is based on a matrix constructed around layers of vegetation and other physical features of the environment used by vertebrate species for feeding and breeding. Modifications to permit inclusion of other life requirements such as cover are discussed. Examples are used to illustrate how species are assigned to guild cells based on their use of habitat, and how the association between a species and its environment does not have to be direct to influence the species' placement within the matrix.