Emission rates and comparative chemical composition from selected in-use diesel and gasoline-fueled vehicles

Emission samples for toxicity testing and detailed chemical characterization were collected from a variety of gasoline- and diesel-fueled in-use vehicles operated on the Unified Driving Cycle on a chassis dynamometer. Gasoline vehicles included normal particle mass (particulate matter [PM]) emitters (tested at 72 and 30 degrees F), "black" and "white" smokers, and a new-technology vehicle (tested at 72 degrees F). Diesel vehicles included current-technology vehicles (tested at 72 and 30 degrees F) and a high PM emitter. Total PM emission rates ranged from below 3 mg/mi up to more than 700 mg/mi for the white smoker gasoline vehicle. Emission rates of organic and elemental carbon (OC/EC), elements (metals and associated analytes), ions, and a variety of particulate and semi-volatile organic compounds (polycyclic aromatic hydrocarbons [PAH], nitro-PAH, oxy-PAH, hopanes, and steranes) are reported for these vehicles. Speciated organic analysis also was conducted on the fuels and lube oils obtained from these vehicles after the emissions testing. The compositions of emissions were highly dependent on the fuel type (gasoline vs. diesel), the state of vehicle maintenance (low, average, or high emitters; white or black smokers), and ambient conditions (i.e., temperature) of the vehicles. Fuel and oil analyses from these vehicles showed that oil served as a repository for combustion byproducts (e.g., PAH), and oil-burning gasoline vehicles emitted PAH in higher concentrations than did other vehicles. These PAH emissions matched the PAH compositions observed in oil.     

Estimating Floodwater Depths from Flood Inundation Maps and Topography

Information on flood inundation extent is important for understanding societal exposure, water storage volumes, flood wave attenuation, future flood hazard, and other variables. A number of organizations now provide flood inundation maps based on satellite remote sensing. These data products can efficiently and accurately provide the areal extent of a flood event, but do not provide floodwater depth, an important attribute for first responders and damage assessment. Here we present a new methodology and a GIS‐based tool, the Floodwater Depth Estimation Tool (FwDET), for estimating floodwater depth based solely on an inundation map and a digital elevation model (DEM). We compare the FwDET results against water depth maps derived from hydraulic simulation of two flood events, a large‐scale event for which we use medium resolution input layer (10 m) and a small‐scale event for which we use a high‐resolution (LiDAR; 1 m) input. Further testing is performed for two inundation maps with a number of challenging features that include a narrow valley, a large reservoir, and an urban setting. The results show FwDET can accurately calculate floodwater depth for diverse flooding scenarios but also leads to considerable bias in locations where the inundation extent does not align well with the DEM. In these locations, manual adjustment or higher spatial resolution input is required.     

INTEGRATING SOCIAL BENEFIT COST ACCOUNTING INTO WATERSHED RESTORATION AND PROTECTION PROGRAMS1

ABSTRACT: Successful watershed management requires consideration of multiple objectives and the efficient use of scarce public and private resources. One way to address these multi-faceted issues is through Social Benefit-Cost Accounting (SBCA). SBCA is a systematic method of addressing complex social and economic issues relevant to proposed watershed management projects. Benefits of using this technique include: benefits and costs of watershed projects are better understood; politically sensitive issues tend to be put into perspective; and stakeholders' interests are placed on a level playing field. An example from Bogota, Colombia demonstrates how SBCA can be used to value the benefits and costs of a proposed project. By addressing the benefits and costs to all stakeholders, the design of watershed management programs can be improved to achieve goals in a cost-effective manner.     

Halton iterative partitioning: spatially balanced sampling via partitioning

A new spatially balanced sampling design for environmental surveys is introduced, called Halton iterative partitioning (HIP). The design draws sample locations that are well spread over the study area. Spatially balanced designs are known to be efficient when surveying natural resources because nearby locations tend to be similar. The HIP design uses structural properties of the Halton sequence to partition a resource into nested boxes. Sample locations are then drawn from specific boxes in the partition to ensure spatial diversity. The method is conceptually simple and computationally efficient, draws spatially balanced samples in two or more dimensions and uses standard design-based estimators. Furthermore, HIP samples have an implicit ordering that can be used to define spatially balanced over-samples. This feature is particularly useful when sampling natural resources because we can dynamically add spatially balanced units from the over-sample to the sample as non-target or inaccessible units are discovered. We use several populations to show that HIP sampling draws spatially balanced samples and gives precise estimates of population totals.     

Use of industrial byproducts to filter phosphorus and pesticides in golf green drainage water

Golf courses are vulnerable to phosphate (PO) and pesticide loss by infiltration of the sandy, porous grass rooting media used and through subsurface tile drainage. In this study, an effort was made to remove PO, chlorothalonil, mefenoxam, and propiconazole in a golf green's drainage water with a filter blend comprised of industrial byproducts, including granulated blast furnace slag, cement kiln dust, silica sand, coconut shell-activated carbon, and zeolite. To test this filter media, two 6-h storm events were simulated by repeat irrigation of the golf green after PO and pesticide application. Drainage flows ranged from 0.0034 to 0.6433 L s throughout the course of the simulations. A significant decrease in the chlorothalonil load for the experimental run (with filter media) was observed compared with the control (without filter media) ( < 0.05). In general, percent reductions in chlorothalonil were very high (>80%) near peak flows. In contrast, filter media was not effective in removing PO, mefenoxam, or propiconazole ( > 0.05). Instead, it appears that the filter blend added PO to the effluent above flow rates of 0.037 L s. Overall, flow rate, the amount of filter media used, and contaminant properties may have influenced the filter media's ability to remove contaminants. More research is needed to determine the optimal blend and configuration for the filter media to remove significant amounts of all contaminants investigated.     

Stakeholder Opinions on the Assessment of MPA Effectiveness and Their Interests to Participate at Pacific Rim National Park Reserve,Canada

As the number of marine protected areas (MPAs) is globally increasing, information is needed on the effectiveness of existing sites. Many protected area agencies however have limited resources and are unable to evaluate MPA effectiveness. An evaluation conducted entirely by the managing agency may also lack credibility. Long-term monitoring and evaluation programs should ideally offer opportunities for participation of diverse groups in the selection of evaluation indicators and their assessment. A participatory approach has the potential to enhance evaluation capacity, to increase credibility and acceptance of results, to strengthen relationships between managers and local stakeholders, and to address more locally relevant information. Using a case study approach, this paper investigates diverse stakeholder groups’ opinions on the design of an evaluation and their interest to participate in an assessment. Respondents were most interested in the assessment of MPA achievements and outcome indicators. Most groups identified a range of government agencies and stakeholders that should participate in an assessment but only half of all respondents were interested to participate in monitoring activities. Most frequently mentioned limitations for more participation were a lack of time and money, but also governance shortcomings such as limited participation possibilities and not paying enough credit to stakeholders’ input. Participation interest was also influenced by occupation, place of residency, and familiarity with the marine environment. Differences exist among stakeholders about suitable evaluators and preferred monitoring partners, which could affect the credibility of evaluation results and affect monitoring activities.     

Locating ‘power’ in wind power planning processes: the (not so) influential role of local objectors

There have been conflicting accounts of the role and influence of local opposition within planning application outcomes for wind power developments. There is an expanding literature that considers public responses to proposed renewable energy developments and much of this suggests that public opposition is a key factor in the slow growth in renewable energy capacity. However, this paper will show that local opposition groups' power over such planning processes is very limited, and in fact extends only so far as delaying an outcome. Through a thematic content analysis of objection letters to one particular proposed wind power development, the key issues raised in connection with the development will be highlighted. Subsequently, these issues will be compared with those discussed in the official report of the planning appeals process, and it will be shown that the concerns of local objectors had little influence over the eventual verdict.     

Allozymes and morphometric characters of three species ofMytilus in the Northern and Southern Hemispheres

Many authors have considered the common mussels in temperate waters of the Northern and Southern Hemispheres to be a single cosmopolitan species,Mytilus edulis Linnaeus, 1758. Others have divided these mussels into several subspecies or species. Samples of mussels were collected from 36 locations in the Northern Hemisphere and nine locations in the Southern Hemisphere. Electrophoretic evidence from eight loci indicates that the Northern Hemisphere samples consist of three electrophoretically distinguishable species:M. edulis from eastern North America and western Europe;M. galloprovincialis Lamarck, 1819 from the Mediterranean Sea, western Europe, California, and eastern Asia; andM. trossulus Gould, 1850 from the Baltic Sea, eastern Canada, western North America and the Pacific coast of Siberia. Mussels from Chile, Argentina, the Falkland Islands and the Kerguelen Islands contain alleles characteristic of all three Northern Hemisphere species, but because they are most similar toM. edulis from the Northern Hemisphere, we suggest that they tentatively be included inM. edulis. These South American samples are morphologically intermediate between Northern HemisphereM. edulis andM. trossulus. Mussels from Australia and New Zealand are similar in allele frequency and morphometric characters toM. galloprovincialis from the Northern Hemisphere. FossilMytilus sp. are present in Australia, New Zealand and South America, which suggests that the Southern Hemisphere populations may be native, rather than introduced by humans. Morphometric characters were measured on samples which the allozyme data indicated contained a single species. Canonical variates analysis of the morphometric characters yields functions which distinguish among our samples of the species in the Northern Hemisphere.