中低温厌氧处理城市污水污泥颗粒化的研究

用高径比为3：1的UASB反应器分别在35℃和室温条件下处理模拟城市污水,研究了污泥的颗粒化过程.比较了在不同温度、浓度下形成的颗粒污泥的特征.水温为9～25℃,进水浓度为100～200 mg COD/L,水力上流速度（Vup）在0.013～0.11 m/h的4^#UASB反应器在60 d内在形成了成熟的颗粒污泥.研究表明,进水中低的有机物浓度,低的Ca^2＋、Mg^2＋浓度和低的Vup没有抑制颗粒化进程.     

垃圾堆放发酵机理与应用工艺研究

对垃圾的发酵机理进行了实验研究,对渗沥液的析出量及其酸碱度、堆酵后垃圾热值的变化以及堆内温度的变化进行了观测,并对堆酵过程的机理进行了初步分析,给出了垃圾堆酵应用工艺的建议.     

A triple-continuum approach for modeling flow and transport processes in fractured rock

This paper presents a triple-continuum conceptual model for simulating flow and transport processes in fractured rock. Field data collected from the unsaturated zone of Yucca Mountain, a repository site of high-level nuclear waste, show a large number of small-scale fractures. The effect of these small fractures has not been considered in previous modeling investigations within the context of a continuum approach. A new triple-continuum model (consisting of matrix, small-fracture, and large-fracture continua) has been developed to investigate the effect of these small fractures. This paper derives the model formulation and discusses the basic triple-continuum behavior of flow and transport processes under different conditions, using both analytical solutions and numerical approaches. The simulation results from the site-scale model of the unsaturated zone of Yucca Mountain indicate that these small fractures may have an important effect on radionuclide transport within the mountain.     

Application and evaluation of two air quality models for particulate matter for a southeastern U.S. episode

The Models-3 Community Multiscale Air Quality (CMAQ) Modeling System and the Particulate Matter Comprehensive Air Quality Model with extensions (PMCAMx) were applied to simulate the period June 29-July 10, 1999, of the Southern Oxidants Study episode with two nested horizontal grid sizes: a coarse resolution of 32 km and a fine resolution of 8 km. The predicted spatial variations of ozone (O3), particulate matter with an aerodynamic diameter less than or equal to 2.5 microm (PM2.5), and particulate matter with an aerodynamic diameter less than or equal to 10 microm (PM10) by both models are similar in rural areas but differ from one another significantly over some urban/suburban areas in the eastern and southern United States, where PMCAMx tends to predict higher values of O3 and PM than CMAQ. Both models tend to predict O3 values that are higher than those observed. For observed O3 values above 60 ppb, O3 performance meets the U.S. Environmental Protection Agency's criteria for CMAQ with both grids and for PMCAMx with the fine grid only. It becomes unsatisfactory for PMCAMx and marginally satisfactory for CMAQ for observed O3 values above 40 ppb. Both models predict similar amounts of sulfate (SO4(2-)) and organic matter, and both predict SO4(2-) to be the largest contributor to PM2.5. PMCAMx generally predicts higher amounts of ammonium (NH4+), nitrate (NO3-), and black carbon (BC) than does CMAQ. PM performance for CMAQ is generally consistent with that of other PM models, whereas PMCAMx predicts higher concentrations of NO3-, NH4+, and BC than observed, which degrades its performance. For PM10 and PM2.5 predictions over the southeastern U.S. domain, the ranges of mean normalized gross errors (MNGEs) and mean normalized bias are 37-43% and -33-4% for CMAQ and 50-59% and 7-30% for PMCAMx. Both models predict the largest MNGEs for NO3- (98-104% for CMAQ 138-338% for PMCAMx). The inaccurate NO3- predictions by both models may be caused by the inaccuracies in the ammonia emission inventory and the uncertainties in the gas/particle partitioning under some conditions. In addition to these uncertainties, the significant PM overpredictions by PMCAMx may be attributed to the lack of wet removal for PM and a likely underprediction in the vertical mixing during the daytime.     

废水除磷技术的研究与发展

目前 ,人们越来越重视污水除磷技术。本文介绍与评述了化学和生物两种除磷方式及其除磷机理和工艺 ,并着重介绍了生物除磷的现状、发展和研究动向     

混凝-生物接触氧化法处理城市污水的研究

采用混凝-生物接触氧化法处理生活小区废水,考察了不同混凝剂用量对COD、NH4-N、SS、TP的去除效果,同时研究了生物接触氧化法对COD、NH4-N等的去除以及耐冲击负荷能力.结果表明,随混凝剂用量的增加,COD、SS、TP的去除率随之增加,生物接触氧化法具有较高的抗冲击负荷能力,最大NH4-N去除负荷达到0.55 kg/(m3·d),最大有机去除负荷达到4.32 kg/(m3·d)     

含重金属水处理污泥的固化和浸出毒性研究

工业危险固体废物在进行安全填埋前需要进行固化稳定处理。针对电镀厂和皮革厂含重金属的水处理污泥 ,用不同比例的水泥、粉煤灰进行固化稳定处理。考虑酸雨环境 ,浸出实验采用TCLP标准。电镀厂污泥单独固化时 ,其浸出液中铜离子浓度由 78 0mg/L下降到 1 5mg/L ;镍离子浓度由 2 2 4 5mg/L下降到 2 2 2mg/L ,高于危险废物允许进入填埋区 15mg/L的控制限值。电镀厂污泥与皮革厂污泥混合后固化 ,浸出液毒性明显降低。铜离子的浸出浓度降低到1 98mg/L ,镍离子降低到 4 10mg/L ,总铬降低到 0 4 0mg/L ,各项指标均低于国家危险废物允许进入填埋区的控制限值 ,可安全填埋。     

Effects of EDTA and low molecular weight organic acids on soil solution properties of a heavy metal polluted soil

A pot experiment was conducted to study the effects of EDTA and low molecular weight organic acids (LMWOA) on the pH, total organic carbon (TOC) and heavy metals in the soil solution in the rhizosphere of Brassica juncea grown in a paddy soil contaminated with Cu, Zn, Pb and Cd. The results show that EDTA and LMWOA have no effect on the soil solution pH. EDTA addition significantly increased the TOC concentrations in the soil solution. The TOC concentrations in treatments with EDTA were significantly higher than those in treatments with LMWOA. Adding 3 mmol kg(-1) EDTA to the soil markedly increased the total concentrations of Cu, Zn, Pb and Cd in the soil solution. Compared to EDTA, LMWOA had a very small effect on the metal concentrations. Total concentrations in the soil solution followed the sequence: EDTA > citric acid (CA) approximately oxalic acid (OA) approximately malic acid (MA) for Cu and Pb; EDTA > MA > CA approximately OA for Zn; and EDTA > MA > CA > OA for Cd. The labile concentrations of Cu, Zn, Pb and Cd showed similar trends to the total concentrations.     

大量三价铬中微量六价铬的分离和测定

研究了大量 Cr( )中微量 Cr( )的分离和测定方法 ,该方法灵敏度高 ,干扰少 ,摩尔吸光系数为 1.6× 10 5L /( m ol·cm )。最佳线性范围 0～ 1.0 m g/L ,检出限为 0 .0 0 2 m g/L。     

白腐菌对芳香族化合物的降解途径

白腐菌 (Whiterotfungi)是目前所发现的对芳香族化合物有很强降解能力的一类微生物。本文探讨了降解芳香族化合物的白腐菌种及其代谢化合物的主要类型 ,分析了对不同化合物的不同代谢途径 ,同时展望了其应用前景