Quantification of emission factor uncertainty

Emissions factors are important for estimating and characterizing emissions from sources of air pollution. There is no quantitative indication of uncertainty for these emission factors, most factors do not have an adequate data set to compute uncertainty, and it is very difficult to locate the data for those that do. The objectives are to compare the current emission factors of Electric Generating Unit NOx sources with currently available continuous emission monitoring data, develop quantitative uncertainty indicators for the Environmental Protection Agency (EPA) data quality rated emission factors, and determine the possible ranges of uncertainty associated with EPA's data quality rating of emission factors. EPA's data letter rating represents a general indication of the robustness of the emission factor and is assigned based on the estimated reliability of the tests used to develop the factor and on the quantity and representativeness of the data. Different sources and pollutants that have the same robustness in the measured emission factor and in the representativeness of the measured values are assumed to have a similar quantifiable uncertainty. For the purposes of comparison, we assume that the emission factor estimates from source categories with the same letter rating have enough robustness and consistency that we can quantify the uncertainty of these common emission factors based on the qualitative indication of data quality which is known for almost all factors. The results showed that EPA's current emission factor values for NOx emissions from combustion sources were found to be reasonably representative for some sources; however AP-42 values should be updated for over half of the sources to reflect current data. The quantified uncertainty ranges were found to be 25-62% for A rated emission factors, 45-75% for B rated emission factors, 60-82% for C rated emission factors, and 69-86% for D rated emission factors, and 82-92% for E rated emission factors.     

On-farm bioremediation of dimethazone and trifluralin residues in runoff water from an agricultural field

Bioremediation is the use of living organisms, primarily microorganisms, to degrade environmental contaminants into less toxic forms. Nine biobeds (ground cavity filled with a mixture of composted organic matter, topsoil, and a surface grass) were established at Kentucky State University research farm (Franklin County, KY) to study the impact of this practice on reducing surface runoff water contamination by residues of dimethazone and trifluralin herbicides arising from an agricultural field. Biobed (biofilter) systems were installed at the bottom of the slope of specially designed runoff plots to examine herbicides retention and degradation before entering streams and rivers. In addition to biobed systems, three soil management practices: municipal sewage sludge (SS), SS mixed with yard waste compost (SS + YW), and no-mulch rototilled bare soil (NM used for comparison purposes) were used to monitor the impact of soil amendments on herbicide residues in soil following natural rainfall events. Organic amendments increased soil organic matter content and herbicide residues retained in soil following rainfall events. Biobeds installed in NM soil reduced dimethazone and trifluralin by 84 and 82%, respectively in runoff water that would have been transported down the land slope of agricultural fields and contaminated natural water resources. Biobeds installed in SS and SS+YW treatments reduced dimethazone by 65 and 46% and trifluralin by 52 and 79%, respectively. These findings indicated that biobeds are effective for treating dimethazone and trifluralin residues in runoff water.     

Dissipation, half-lives, and mass spectrometric identification of endosulfan isomers and the sulfate metabolite on three field-grown vegetables

Endosulfan 3 EC, a mixture of α- and β-stereo isomers, was sprayed on field-grown pepper, melon, and sweet potato plants at the recommended rate of 0.44 kg A.I. acre(-1). Plant tissue samples (leaves, fruits, or edible roots) were collected 1 h to 30 days following spraying and analyzed for endosulfan isomers (α- and β-isomers). Analysis of samples was accomplished using a gas chromatograph (GC) equipped with a mass detector in total ion mode. The results indicated the formation of endosulfan sulfate as the major metabolite of endosulfan sulfite and the relatively higher persistence of the β-isomers as compared to the α-isomer. The initial total residues (α- and β-isomers plus endosulfan sulfate) were higher on leaves than on fruits. On pepper and melon fruits, the α-isomer, which is the more toxic to mammals, dissipated faster (T(1/2) = 1.22 and 0.95 d, respectively) than the less toxic β-isomer (T(1/2) = 3.0 and 2.5 d, respectively). These results confirm the greater loss of the α-isomer compared to the β-isomer, which can ultimately impact endosulfan dissipation in the environment. Additionally, the higher initial residues of endosulfan on pepper and sweet potato leaves should be considered of great importance for timing field operations and the safe entry of harvesters due to the high mammalian toxicity of endosulfan.     

Modeling the dynamics of DDT in a remote tropical floodplain: indications of post-ban use?

Significant knowledge gaps exist regarding the fate and transport of persistent organic pollutants like dichlorodiphenyltrichloroethane (DDT) in tropical environments. In Brazil, indoor residual spraying with DDT to combat malaria and leishmaniasis began in the 1950s and was banned in 1998. Nonetheless, high concentrations of DDT and its metabolites were recently detected in human breast milk in the community of Lake Puruzinho in the Brazilian Amazon. In this work, we couple analysis of soils and sediments from 2005 to 2014 at Puruzinho with a novel dynamic floodplain model to investigate the movement and distribution of DDT and its transformation products (dichlorodiphenyldichloroethylene (DDE) and dichlorodiphenyldichloroethane (DDD)) and implications for human exposure. The model results are in good agreement with the accumulation pattern observed in the measurements, in which DDT, DDE, and DDD (collectively, DDX) accumulate primarily in upland soils and sediments. However, a significant increase was observed in DDX concentrations in soil samples from 2005 to 2014, coupled with a decrease of DDT/DDE ratios, which do not agree with model results assuming a post-ban regime. These observations strongly suggest recent use. We used the model to investigate possible re-emissions after the ban through two scenarios: one assuming DDT use for IRS and the other assuming use against termites and leishmaniasis. Median DDX concentrations and p,p′-DDT/p,p′-DDE ratios from both of these scenarios agreed with measurements in soils, suggesting that the soil parameterization in our model was appropriate. Measured DDX concentrations in sediments were between the two re-emission scenarios. Therefore, both soil and sediment comparisons suggest re-emissions indeed occurred between 2005 and 2014, but additional measurements would be needed to better understand the actual re-emission patterns. Monte Carlo analysis revealed model predictions for sediments were very sensitive to highly uncertain parameters associated with DDT degradation and partitioning. With this model as a tool for understanding inter-media cycling, additional research to refine these parameters would improve our understanding of DDX fate and transport in tropical sediments.     

Distribution of seven heavy metals among hot pepper plant parts

The main objective of this investigation was to monitor concentrations of seven metals (Cd, Pb, Ni, Mo, Cu, Zn, and Cr) in the fruits, leaves, stem, and roots of Capsicum annuum L. (cv. Xcatic) plants grown under four soil management practices: yard waste (YW), sewage sludge (SS), chicken manure (CM), and no-much (NM) bare soil. Elemental analyses were conducted using inductively coupled plasma mass spectrometer. Pb and Cd concentrations in soil amended with YW, SS, and CM were not significantly different (P < 0.05) compared to NM soil, whereas Mo and Cu concentrations were significantly greater in YW compared to SS, CM, and NM treatments. Concentrations of Cd in the fruits of plants grown in NM soil were greater compared to the fruits of plants grown in other treatments. Total Ni concentration (sum of Ni in all plant parts) in plants grown in NM bare soil was greater than in plants grown in SS-, YW-, and CM-amended soils. Values of the bioaccumulation factor indicated that pepper fruits of plants grown in YW, SS, and CM did not show any tendency to accumulate Pb, Cr, and Ni in their edible fruits.     

Repellency and oviposition deterrence of wild tomato leaf extracts to spider mites,Tetranychus urticae Koch

Glandular trichomes on the leaves of wild tomato, Lycopersicon hirsutum f. hirsutum Mull, also known as Solanum habrochaites (Solanaceae) synthesize and accumulate high levels of methyl ketones (MKs). The potential of using MKs as alternatives to synthetic acaricides for controlling the twospotted spider mite, Tetranychus urticae Koch, is explored in this study. Plants of L. hirsutum accession LA 407 having high concentrations of MKs were grown from seeds under greenhouse conditions. The main objective of this investigation was to conduct bioassays that are quick and easy to implement, consistent over time (repeatable) with the ability to utilize small amounts of test material for testing repellency and fecundity (number of eggs laid by a female mite) of MKs in pure forms and in LA 407 crude extracts. Four MKs (2-tridecanone, 2-undecanone, 2-dodecanone, 2-pentadecanone) and their mixture were screened for their repellency and ability to alter fecundity of spider mites. All MKs repelled spider mites at the two periods tested. Following spraying of tomato leaf extracts prepared in ethanol (ethanol extracts), average number of eggs laid per female mite on bean leaf discs dropped from 0.8 to 0.3 and from 0.9 to 0.3 at 4 and 24 h after exposure representing 65 and 68% reduction, respectively. However, spraying of tomato leaf extracts prepared in water (water extracts) reduced number of eggs laid per female mite from 1.7 to 0.7 and from 2.6 to 0.9 at 4 and 24 h after exposure representing 60 and 67% reduction, respectively. We concluded that all MKs have repellent and egg laying deterrence activities against spider mites. This investigation suggests that ethanol and water extracts of LA 407 have a potential for repelling female spider mites and reducing their laid eggs which might be explored under field conditions for managing populations of spider mites, which could reduce reliance on synthetic acaricides.     

Glucosinolates in collard greens grown under three soil management practices

Glucosinolates (GSLs, β-D-thioglucoside-N-hydroxysulfates) are polar compounds present in varying amounts in members of the Brassicaceae family. They suppress soil-borne pests due to the biofumigant properties of the highly toxic isothiocyanates present in Brassica vegetables. The objectives of this investigation were to: (1) assess variation in GSLs concentrations among collard plants grown under three soil management practices: sewage sludge (SS) mixed with native soil, chicken manure (CM) mixed with native soil, and no-mulch (NM) native soil, (2) quantify GSLs concentrations in collard roots, leaves, and stems at harvest for potential use of their crude extracts in plant protection, and (3) assess myrosinase activity in soil amended with CM and SS mixed with native soil. Separation of GSLs was accomplished by adsorption on a DEAE-Sephadex ion exchange resin using disposable pipette tips filled with DEAE, a weak base, with a net positive charge when ionized and exchange anions such as GSLs (hydrophilic plant secondary metabolites). Quantification of total GSLs was based on inactivation of collard endogenous myrosinase and liberation of the glucose moiety from the GSLs molecule by addition of standardized myrosinase and colorimetric determination of the liberated glucose moiety. Across all treatments, SS and CM increased soil organic matter content from 2.2% in native soil to 4.2 and 6.5%, respectively. GSLs concentrations were significantly greater in collard leaves (30.9 µmoles g^?1 fresh weight) compared to roots and stems (7.8 and 1.2 µmoles g^?1 fresh weight), respectively. Leaves of collard grown in soil amended with SS contained the greatest concentrations of GSLs compared to leaves of plants grown in CM and NM treatments. Accordingly, leaves of collard plants grown in soil amended with SS could play a significant role in sustainable agriculture as alternative tools for soil-borne disease management in conventional and organic agriculture.     

Dynamic Calibration of an Acid Aerosol Analyzer

A method is described for dynamic calibration of an acid aerosol analyzer based on a commercial modification of the Thomas Autometer and manufactured by the Instrument Development Company. This automated instrument removes acid aerosol from an air stream by sonic impaction, and the sulfuric acid collected is determined conductometrically. An all-glass aerosol generator based on the reaction of water vapor with sulfur trioxide vapor released from fuming sulfuric acid was built for the calibration. Air samples were withdrawn for instrument calibration before and after the concentration of the acid aerosol was determined by titration. The apparent particle size as determined by an Andersen sampler ranged from 2.0 microns to less than 0.68 micron and exhibited a sharp peak with mass median diameter at 1.3 microns in the distribution curve. The size of the aerosol, within certain limits, could be controlled by humidity. Data indicated a linear response with an aerosol collection efficiency of 80 percent in the important respirable size range.     

A Method for Checking Instrument Performance at Remote Sampling Sites

This paper describes a quality control technique used by the central headquarters operation of the Continuous Air Monitoring Program in an ejjort to insure valid data production from instruments located at remote sampling stations.

The procedure consists of preparation of 0.10 to 2.00 ppm mixtures of SO₂ or NO₂ in duplicate Mylar bags, each encased in a corrugated paper box.

These mixtures are analyzed during make-up to insure duplication. One box is shipped to the field station where it is analyzed on-site. The control mixture is analyzed in the central lab at the same time. Correlation between measurements indicates the usefulness of this dynamic calibration check.

The techniques used are described and results of the program are presented.