Experimental thermal storage research of organic binary phase change materials in building environment

This paper aims to reveal the heat transfer mechanism of low-temperature phase change material (PCM) and design PCM heat storage device in building heating environment. Firstly, low-temperature binary PCMs of lauric acid and stearic acid are prepared, and their thermal properties are investigated by DSC. Then, shell and tube latent heat thermal energy storage units are conducted, and heat transfer experiments are carried out to analyze the heat transfer mechanism of PCM. The results demonstrate that natural convection plays an important role in heat transfer process, and the heat storage efficiency of PCMs can be significantly enhanced by increasing the fin width and improving the inlet heat transfer fluid (HTF) temperature. Furthermore, some proposals are put forward to guide the design of PCM storage device in building heating environment.     

Investigation of titanium liquid/gas diffusion layers in proton exchange membrane electrolyzer cells

In a proton exchange membrane electrolyzer cell (PEMEC), liquid/gas diffusion layer (LGDL) is expected to transport electrons, heat, and reactants/products to and from the catalyst layer with minimum voltage, current, thermal, interfacial, and fluidic losses. In addition, carbon materials, which are typically used in PEM fuel cells (PEMFCs), are unsuitable in PEMECs due to the high ohmic potential and highly oxidative environment of the oxygen electrode. In this study, a set of titanium gas diffusion layers with different thicknesses and porosities are designed and examined coupled with the development of a robust titanium bipolar plate. It has been found that the performance of electrolyzer improves along with a decrease in thickness or porosity of the anode LGDL of titanium woven meshes. The ohmic resistance of anode LGDL and contact resistance between anode LGDL and the anode catalyst play dominant roles in electrolyzer performance, and better performance can be obtained by reducing ohmic resistance. Thin titanium LGDLs with straight-through pores and optimal pore morphologies are recommended for the future developments of low-cost LGDLs with minimum ohmic/transport losses.     

羟基乙叉二膦酸镀铜废液的处理及Cu~(2+)的高附加值资源化回收

采用Na BH4还原法将羟基乙叉二膦酸(HEDP)镀铜废液中的Cu~(2+)制备成纳米铜粉,并采用聚丙烯酰胺(PAM)对还原反应后的废液进行絮凝处理。研究了n(Cu~(2+))∶n(Na BH4)、还原反应温度、还原反应时间及PAM添加量对废液中剩余Cu~(2+)质量浓度的影响,并对回收的纳米铜粉进行了XRD和TEM表征。实验结果表明:当n(Cu~(2+))∶n(Na BH4)=4∶6、还原反应温度为50℃、还原反应时间为2 h时,废液中剩余Cu~(2+)质量浓度降低至1.1 mg/L,Cu~(2+)还原率达99.99%;可获得粒径为20~45 nm的近球型、高纯度、由多晶组成的纳米铜粉;当PAM添加量为10 mg/L时,废液中剩余Cu~(2+)质量浓度降至0.35 mg/L以下,达到GB 21900—2008《电镀污染物排放标准》(小于0.5 mg/L)的要求。     

粗石英砂层厚度及倾角对核废物处置库顶盖毛细屏障效应的影响

毛细屏障作为核废物处置库顶盖的工程屏障之一,已经在国内外得到了广泛应用.采用箱体实验方法,研究了非饱和稳定流条件下粗石英砂层厚度和倾角对毛细屏障效应的影响.结果表明,随着粗石英砂层厚度的增大,水分的相对绕流量增大,毛细屏障效应增强;随着粗石英砂层倾角的增大,其表面积水减少,水的横向流动能力增强,毛细屏障效应增强.     

重金属元素在冻土与融土中迁移的对比试验

随着寒区经济的发展,冻土地区的矿山开采活动不断加剧,随之产生的重金属污染问题也越来越严重.冻土地区生态环境脆弱,一旦受到破坏就很难恢复.针对此问题,室内模拟了尾矿矿渣在冻土与融土中的填埋及其对填埋场周边土体的影响,通过检测填埋场各处土壤的温度、含水量以及重金属元素的含量,发现温度和水分对重金属元素的迁移影响很大.土壤温度越低,重金属元素的迁移越慢;在温度梯度的作用下,重金属元素均随着水分从土体的暖端向冷端迁徙并聚集于冻结锋面.重金属元素在冻土中的迁移比融土中慢,表明冻土环境不利于重金属元素的迁移.在土壤质地、温度和含水量等相同的情况下,Zn的迁移性较强,Pb和Cu的迁移性相对较弱.     

GC/MS法测定润滑油基础油中多环芳烃

对润滑油基础油中多环芳烃的气相色谱/质谱(GC/MS)测定方法进行了研究,探讨了样品的提取,固相萃取柱净化等前处理方法,同时也对仪器测定条件进行了优化.结果表明,在检测润滑油基础油中多环芳烃时,经优化的GC/MS法的加标回收率和精密度均达到较满意的水平.     

丝素/SiO_2杂化膜固定化多酚氧化酶处理模拟含酚废水

粗马铃薯多酚氧化酶固定于丝素/SiO2杂化膜上,从而得到丝素/SiO2杂化膜固定化多酚氧化酶.并用于处理模拟含酚废水.丝素/SiO2杂化膜在水中的溶失率小于丝素膜在水中的溶失率.所得丝素/SiO2杂化膜固定化多酚氧化酶的最适宜pH为7.4.相对于游离多酚氧化酶.该酶具有较好的热稳定性、贮存稳定性及重复使用性.研究表明,丝素/SiO2杂化膜固定化多酚氧化酶有实际处理含酚废水的可能.     

颗粒化序列间歇式活性污泥反应器工艺处理化粪池污水

在序列间歇式活性污泥反应器(SBR)中成功培养出适应化粪池污水水质的好氧颗粒污泥.并将其应用于化粪池污水的处理.在好氧颗粒污泥培养的第15天左右,SBR中开始出现细小的颗粒,然后微生物在其上繁殖生长使颗粒逐渐增大而成熟;在第24天时,SBR中絮状活性污泥已基本实现了颗粒化.培养出的好氧颗粒污泥对化粪池污水有稳定的处理效果,在进水完全为化粪池污水时,COD、NH_4~+-N、TN的平均去除率分别为77%、61%、47%.但是,由于化粪池污水COD较低,因此无法维持较高的生物量,在后期的稳定运行过程中MLSS始终维持在2 500 mg/L左右.好氧颗粒污泥的同步硝化反硝化作用是其稳定脱氮的保证.     

污水低氧脱氮机制及其应用研究进展

阐述了污水低氧脱氮的基本原理,即抑制或去除亚硝酸盐氧化菌(NOB),同时保留氨氧化菌(AOB),并保持其活性;探讨了污水低氧脱氮实现途径;详细介绍了几种典型的污水低氧脱氮工艺(短程硝化(SHARON)工艺、厌氧氨氧化(ANAMMOX)工艺、好氧反氨化(DEMON)工艺、低氧自养硝化反硝化(OLAND)工艺、甲烷营养型硝化反硝化工艺和亚硝酸盐型完全自养脱氮(CANNON)工艺)的应用研究进展;最后对污水低氧脱氮处理工艺的工程运用进行了展望.     

Measurement of the vertical profile of atmospheric SO2 during the heating period in Beijing on days of high air pollution

This paper reports altitude-resolved concentrations of sulfur dioxide (SO₂) and particulate matter up to 10 microns in diameter (PM₁₀) in the planetary boundary layer of major urban centers during extreme pollution episodes. The concentration of SO₂ was observed continuously from November 24, 2004, to December 4, 2004, in Beijing during the heating period. Fluorescence SO₂ analyzers were used to measure the atmospheric SO₂ concentrations. Four SO₂ analyzers were placed at 4 different levels (8 m, 47 m, 120 m, and 280 m) of the 325-m high meteorological observation tower of the Institute of Atmospheric Physics (IAP), Chinese Academy of Sciences. A maximal SO₂ concentration of 172.3 ppb was measured during this pollution episode, and SO₂ concentration increased with altitude and reached its maximal value at ～50 m. The study also analyzed the meteorological situation before, during, and after the pollution episode.