Brominated flame retardants in dust from UK cars--within-vehicle spatial variability, evidence for degradation and exposure implications

Polybrominated diphenyl ethers (PBDEs), hexabromocyclododecanes (HBCDs), and tetrabromobiphenol-A (TBBP-A) were measured in a preliminary study of dust from passenger cabins and trunks of 14 UK cars. Concentrations in cabin dust of HBCDs, TBBP-A, and BDEs 47, 85, 99, 100, 153, 154, 183, 196, 197, 202, 203, 206, 207, 208, and 209 exceeded significantly (p < 0.05) those in trunk dust. Sampling cabin dust thus appears to provide a more accurate indicator of human exposure via car dust ingestion than trunk dust. Elevated cabin concentrations are consistent with greater in-cabin use of BFRs. In five cars, while no significant differences (p > 0.05) in concentrations of HBCDs and most PBDEs were detected in dust sampled from four different seating areas; concentrations of TBBP-A and of PBDEs 154, 206, 207, 208, and 209 were significantly higher (p < 0.05) in dust sampled in the front seats. Possible photodebromination of BDE-209 was indicated by significantly higher (p < 0.05) concentrations of BDE-202 in cabin dust. In-vehicle exposure via dust ingestion to PBDEs, HBCDs and TBBP-A exceeded that via inhalation. Comparison with overall exposure via diet, dust ingestion, and inhalation shows while in-vehicle exposure is a minor contributor to overall exposure to BDE-99, ΣHBCDs, and TBBP-A, it is a significant pathway for BDE-209.     

Residues and dissipation kinetic of abamectin,chlorfenapyr and pyridaben acaricides in green beans (Phaseolus vulgaris L.) under field conditions using QuEChERS method and HPLC

Abstract

The current study estimated the dissipation rates of abamectin, chlorfenapyr and pyridaben acaricides in pods of green beans (Phaseolus vulgaris L.) under field conditions in Egypt. Pesticides were extracted and cleaned-up by QuEChERS method and were analyzed by HPLC. The dissipation of these acaricides followed the first order kinetics model with half-life (t_1/2) values 1.00, 3.50 and 1.50?days for abamectin, chlorfenapyr and pyridaben, respectively. The lowest residues, at different time intervals of field application rate of each pesticide, were observed with abamectin followed by pyridaben and then chlorfenapyr. Pre-harvest intervals (PHIs) were 10.00, 13.50 and 6.00?days for abamectin, chlorfenapyr and pyridaben, respectively and were below the established European maximum residue limits (EU MRLs) 10–14, 14–21 and 7–10?days after application, respectively. If the fresh pods will be consumed after harvest, it is expected that the presence of these pesticides in the food will have a negative impact on human health. Therefore, the elimination of the residues of these harmful pesticides must be carried out.     

First inter-laboratory comparison exercise for the determination of anticancer drugs in aqueous samples

The results of an inter-laboratory comparison exercise to determine cytostatic anticancer drug residues in surface water, hospital wastewater and wastewater treatment plant effluent are reported. To obtain a critical number of participants, an invitation was sent out to potential laboratories identified to have the necessary knowledge and instrumentation. Nine laboratories worldwide confirmed their participation in the exercise. The compounds selected (based on the extent of use and laboratories capabilities) included cyclophosphamide, ifosfamide, 5-fluorouracil, gemcitabine, etoposide, methotrexate and cisplatinum. Samples of spiked waste (hospital and wastewater treatment plant effluent) and surface water, and additional non-spiked hospital wastewater, were prepared by the organising laboratory (Jo?ef Stefan Institute) and sent out to each participant partner for analysis. All analytical methods included solid phase extraction (SPE) and the use of surrogate/internal standards for quantification. Chemical analysis was performed using either liquid or gas chromatography mass (MS) or tandem mass (MS/MS) spectrometry. Cisplatinum was determined using inductively coupled plasma mass spectrometry (ICP-MS). A required minimum contribution of five laboratories meant that only cyclophosphamide, ifosfamide, methotrexate and etoposide could be included in the statistical evaluation. z-score and Q test revealed 3 and 4 outliers using classical and robust approach, respectively. The smallest absolute differences between the spiked values and the measured values were observed in the surface water matrix. The highest within-laboratory repeatability was observed for methotrexate in all three matrices (CV?≤?12 %). Overall, inter-laboratory reproducibility was poor for all compounds and matrices (CV 27–143 %) with the only exception being methotrexate measured in the spiked hospital wastewater (CV?=?8 %). Random and total errors were identified by means of Youden plots.     

Effects of permethrin exposure on antioxidant enzymes and protein status in Mediterranean clams Ruditapes decussatus

The effects of permethrin (PER) on a panel of antoxidant enzymes; superoxide dismutase (SOD), catalase (CAT) and glutathione S-transferase (GST) and indices of protein oxidation status (carbonylation and free thiols) were determined in digestive gland and gills of the clam Ruditapes decussatus. Animals were exposed to 100 ppb PER for 2 days. These enzyme activities increased significantly in digestive gland (p?<?0.05) after PER treatment and oxidative modification of proteins was detected in both gill and digestive gland extracts using redox proteomics. PER exposure significantly reduced the amount of protein free thiol groups in digestive gland rather than in gill, when compared to controls. Conversely, digestive gland showed significantly higher levels of carbonylated proteins than gill after PER exposure. Some proteins were successfully identified by mass spectrometry of tryptic peptides. Our data suggest that digestive gland of R. decussatus can be used as a model tissue for investigating environmental risk of PER contamination.     

Distribution and ecological risk of polychlorinated biphenyls (PCBs) and organochlorine pesticides (OCPs) in surface sediments from the Bizerte lagoon,Tunisia

Polychlorinated biphenyls (PCBs) and organochlorine pesticides (OCPs) were determined in 18 surface sediment samples collected from Bizerte lagoon, Tunisia. The total concentrations of ten PCBs (∑PCBs) and of four OCPs (∑OCPs) in the sediments from this area ranged from 0.8 to 14.6 ng g^?1 dw (average value, 3.9 ng g^?1 dw) and from 1.1 to 14.0 ng g^?1 dw (average value, 3.3 ng g^?1 dw), respectively. Among the OCPs, the range of concentrations of dichlorodiphenyltrichloroethane and its metabolites (DDTs) and hexachlorobenzene (HCB) were 0.3–11.5 ng g^?1 dw (1.9 ng g^?1 dw) and 0.6–2.5 ng g^?1 dw (1.4 ng g^?1 dw), respectively. Compositional analyses of the POPs indicated that PCB 153, 138 and 180 were the predominant congeners accounting for 60 % of the total PCBs. In addition, p,p′-DDT was found to be the dominant DDTs, demonstrating recent inputs in the environment. Compared with some other regions of the world, the Bizerte lagoon exhibited low levels of PCBs and moderate levels of HCB and DDTs. The high ratios ΣPCBs/ΣDDTs indicated predominant industrial versus agricultural activities in this area. According to the established guidelines for sediment quality, the risk of adverse biological effects from such levels of OCPs and PCBs, as recorded at most of the study sites, was insignificant. However, the higher concentrations in stations S1 and S3 could cause biological damage.     

Are deep eutectic solvents benign or toxic?

In continuation of investigation for environmentally benign protocol for new solvents termed deep eutectic solvents (DESs), it is herein reported results concerning the toxicity and cytotoxicity of choline chloride (ChCl) based DESs with four hydrogen bond donors including glycerine, ethylene glycol, triethylene glycol and urea. The toxicity was investigated using two Gram positive bacteria Bacillus subtilis and Staphylococcus aureus, and two Gram negative bacteria Escherichia coli and Pseudomonas aeruginosa. The cytotoxicity effect was tested using the Artemia salina leach. It was found that there was no toxic effect for the tested DESs on all of the studied bacteria confirming their benign effects on these bacteria. Nevertheless, it was found that the cytotoxicity of DESs was much higher than their individual components (e.g. glycerine, ChCl) indicating that their toxicological behavior is different. For our best knowledge this is the first time that toxicity and cytotoxicity of DESs were studied. The toxicity and cytotoxicity of DESs varied depending on the structure of components. Careful usage of the terms non-toxicity and biodegradability must be considered. More investigation on this matter is required.     

Electrochemical oxidation of herbicide bifenox acid in aqueous medium using diamond thin film electrode

The electrochemical oxidation of bifenox acid was studied at a boron-doped diamond thin film by cyclic voltammetry and galvanostatic electrolysis. The course of the electrolysis was monitored by measurement of chemical oxygen demand (COD) and by gas chromatography/mass spectrometry (GC / MS) analysis. It was found that exhaustive electrolysis leads to degradation and, ultimately, to mineralization of the starting herbicide. The degradation intermediates were identified showing that the oxidation process begins with the fragmentation of the molecule followed by reactions involving the hydroxyl radical, which is generated by the discharge of water. The study of the effect of current density and concentration showed that the degradation efficiency increases with decreasing current densities and increasing concentrations. The whole results were interpreted in a mechanistic scheme involving two oxidation pathways, the first is a direct oxidation at the electrode and the second uses hydroxyl radical as mediator of the oxidation. Finally, a kinetic study based on spectrophotometric measurements showed that the degradation process is pseudo first order.     

A classification tree based modeling approach for segment related crashes on multilane highways

Introduction

This study presents a classification tree based alternative to crash frequency analysis for analyzing crashes on mid-block segments of multilane arterials.

Method

The traditional approach of modeling counts of crashes that occur over a period of time works well for intersection crashes where each intersection itself provides a well-defined unit over which to aggregate the crash data. However, in the case of mid-block segments the crash frequency based approach requires segmentation of the arterial corridor into segments of arbitrary lengths. In this study we have used random samples of time, day of week, and location (i.e., milepost) combinations and compared them with the sample of crashes from the same arterial corridor. For crash and non-crash cases, geometric design/roadside and traffic characteristics were derived based on their milepost locations. The variables used in the analysis are non-event specific and therefore more relevant for roadway safety feature improvement programs. First classification tree model is a model comparing all crashes with the non-crash data and then four groups of crashes (rear-end, lane-change related, pedestrian, and single-vehicle/off-road crashes) are separately compared to the non-crash cases. The classification tree models provide a list of significant variables as well as a measure to classify crash from non-crash cases. ADT along with time of day/day of week are significantly related to all crash types with different groups of crashes being more likely to occur at different times.

Conclusions

From the classification performance of different models it was apparent that using non-event specific information may not be suitable for single vehicle/off-road crashes.

Impact on Industry

The study provides the safety analysis community an additional tool to assess safety without having to aggregate the corridor crash data over arbitrary segment lengths.     

Performance of photocatalytic reactors using immobilized TiO2 film for the degradation of phenol and methylene blue dye present in water stream

TiO2 thin film photocatalyst was successfully synthesized and immobilized on glass reactor tube using sol-gel method. The synthesized TiO2 coating was transparent, which enabled the penetration of ultra-violet (UV) light to the catalyst surface. Two photocatalytic reactors with different operating modes were tested: (a) tubular photocatalytic reactor with re-circulation mode and (b) batch photocatalytic reactor. A new proposed TiO2 synthesized film formulation of 1 titanium isopropoxide: 8 isopropanol: 3 acetyl acetone: 1.1 H2O: 0.05 acetic acid (in molar ratio) gave excellent photocatalytic activity for degradation of phenol and methylene blue dye present in the water. The half-life time, t1/2 of photocatalytic degradation of phenol was 56 min at the initial phenol concentration of 1000 microM in the batch reactor. In the tubular photocatalytic reactor, 5 re-circulation passes with residence time of 2.2 min (single pass) degraded 50% of 40-microM methylene blue dye. Initial phenol concentration, presence of hydrogen peroxide, presence of air bubbling and stirring speed as the process variables were studied in the batch reactor. Initial methylene blue concentration, pH value, light intensity and reaction temperature were studied as the process variables in the tubular reactor. The synthesized TiO2 thin film was characterized using SEM, XRD and EDX analysis. A comparative performance between the synthesized TiO2 thin film and commercial TiO2 particles (99% anatase) was evaluated under the same experimental conditions. The TiO2 film was equally active as the TiO2 powder catalyst.     

Uranium bioassay and radioactive dust measurements at some uranium processing sites in Egypt--health effects

The safety of radiation workers in the uranium mining industry requires close and continuous monitoring of their working conditions. In this study, external radiation surveillance, radioactive dust monitoring and the bioassay of uranium were carried out in some processing sites. As dust represents one of the most important sources of radiation exposure in mills and mines, dust monitoring and bioassays were performed for a sample of workers on the production lines. The concentration of uranium in air ranged from 22.6 x 10(-7) to 11.1 x 10(-5) Bq cm-3, and the exposure levels ranged from 1 to 80 microSv h-1. Laser fluorimetric determination of uranium in urine samples showed concentrations in the range 8.4-29.2 micrograms L-1. Renal function parameters, such as serum creatinine and urea, and hematological parameters were determined in an attempt to correlate them with radiation exposure and the health status of the workers. Urine specimens collected from workers at the ore crushing and separation site showed elevated concentrations of uranium (up to 29.2 micrograms L-1) and a strong correlation between these concentrations and the registered serum creatinine. The mean uranium excretion in the investigated group was more than 20 times the occupational exposure decision level for urine uranium of 0.8 microgram L-1.