Effects of head restraint and seat redesign on neck injury risk in rear-end crashes

Automobile insurance claims were examined to determine the rates of neck injuries in rear-end crashes for vehicles with and without redesigned head restraints, redesigned seats, or both. Results indicate that the improved geometric fit of head restraints observed in many newer vehicle models are reducing the risk of whiplash injury substantially among female drivers (about 37% in the Ford Taurus and Mercury Sable), but have very little effect among male drivers. New seat designs, such as active head restraints that move upward and closer to drivers' heads during a rear impact, give added benefit, producing about a 43% reduction in whiplash injury claims (55% reduction among female drivers). Estimated effects of Volvo's Whiplash Injury Prevention System and Toyota's Whiplash Injury Lessening design were based on smaller samples and were not statistically significant.     

Prediction of cervical spine injury risk for the 6-year-old child in frontal crashes

This article presents a series of 49 km/h sled tests using the Hybrid III 6-year-old dummy in a high-back booster, a low-back booster, and a three-point belt. Although a 10-year review at a level I trauma center showed that noncontact cervical spine injuries are rare in correctly restrained booster-age children, dummy neck loads exceeded published injury thresholds in all tests. The dummy underwent extreme neck flexion during the test, causing full-face contact with the dummy's chest. These dummy kinematics were compared to the kinematics of a 12-year-old cadaver tested in a similar impact environment. The cadaver test showed neck flexion, but also significant thoracic spinal flexion which was nonexistent in the dummy. This comparison was expanded using MADYMO simulations in which the thoracic spinal stiffness of the dummy model was decreased to give a more biofidelic kinematic response. We conclude that the stiff thoracic spine of the dummy results in high neck forces and moments that are not representative of the true injury potential.     

硬木地板材料和棉花秆的变氧浓度热解燃烧表观动力学的实验研究

本文采用TG-FTIR分析方法深入研究了火场中硬木地板材料和棉花秆变氧浓度燃烧过程,深入分析了氧浓度对纤维物质燃烧表观热失重影响;通过大量的动力学参数计算得出了可燃物的表观活化能与实际氧浓度成线性关系;分析了氧浓度对木材燃烧气体产物的影响,并探索了氧浓度影响热解和燃烧的机理。     

Bhopal disaster—a personal experience

Bhopal Gas Tragedy was the worst industrial accident in the world where several thousand persons lost their lives. It occurred at the Union Carbide plant located inside the city of Bhopal and close to the railway station, at midnight of December 2-3, 1984 due to the leakage of MIC gas which took the local sleeping and floating population unawares.

This paper describes the experience of a transit passenger who reached the Bhopal Railway Station by train at about the same time when the deadly gas leakage occurred.     

Characteristics of large cooking oil pool fires and their extinguishment by water mist

Large cooking oil pool fires, occurring in industrial oil cookers, present a severe hazard to food processing plants due to their size and the large amount of hot oil involved. This paper reports a series of full-scale fire experiments conducted in a large industrial oil cooker mock-up. The characteristics of large cooking oil pool fires and the effect of oil depth and hood position in the oil cooker on fire growth were studied. The use of water mist for extinguishing large oil pool fires and their extinguishing performance under different discharge pressure and with different types of water mist systems were investigated. Experimental results showed that the cooking oil underwent a substantial expansion in volume during heating. The fires developed quickly once the oil auto-ignited. The fire growth rate was affected by the oil depth in the pan and the hood position in the oil cooker. The water mist fire suppression systems effectively extinguished large cooking oil fires and prevented them from re-igniting. Their extinguishing performance was determined by the type of water mist system, discharge pressure and hood position in the oil cooker.     

Differences and similarities of gas and dust explosions: A critical evaluation of the European ‘ATEX’ directives in relation to dusts

Explosive gas mixtures and explosive dust clouds, once existing, exhibit similar ignition and combustion features. However, there are two basic differences between dusts and gases which are of substantially greater significance in design of safety standards than these similarities. Firstly, the physics of generation and up-keeping of dust clouds and premixed gas/vapour clouds are substantially different. This means that in most situations where accidental explosive gas clouds may be produced quite readily, generation of explosive dust clouds would be highly unlikely. Secondly, contrary to premixed gas flame propagation, the propagation of flames in dust/air mixtures is not limited only to the flammable dust concentration range of dynamic clouds. The state of stagnant layers/deposits offers an additional discrete possibility of flame propagation.

The two European Directives 94/9/EC (1994) and 1999/92/EC (1999) primarily address gases/vapours, whereas the particular properties of dusts are not addressed adequately. Some recent IEC and European dust standards resulting from this deficiency are discussed, and the need for revising the two directives accordingly is emphasized.     

Off-site emergency scenario, a case study from a LPG Bottling Plant

After Bhopal disaster, emergency planning in an industrial area has become inevitable. The off-site emergency plan is an integral part of any major hazard control system. Boiling Liquid Expanding Vapour Explosion (BLEVE) leads to fatal consequences. This paper highlights some salient features of the emergency scenario, which ultimately leads to fireball with enormous pressure wave all around.     

Mode choice model for vulnerable motorcyclists in Malaysia

OBJECTIVE: In developing countries, motorcycle use has grown in popularity in the past decades. Commensurate with this growth is the increase in death and casualties among motorcyclists in these countries. One of the strategic programs to minimize this problem is to reduce motorcyclists exposure by shifting them into safer modes of transport. This study aims to explore the differences in the characteristics of bus and motorcycle users. It identifies the factors contributing to their choice of transport mode and estimates the probability that motorcyclists might change their travel mode to a safer alternative; namely, bus travel. METHODS: In this article, a survey of 535 motorcycle and bus users was conducted in seven districts of Selangor state, Malaysia. A binary logit model was developed for the two alternative modes, bus and motorcycle. RESULTS: It was found that travel time, travel cost, gender, age, and income level are significant in influencing motorcyclists' mode choice behavior. The probability of motorcycle riders shifting to public transport was also examined based on a scenario of a reduction in bus travel time and travel cost. CONCLUSIONS: Reduction of total travel time for the bus mode emerges as the most important element in a program aimed at attracting motorcyclists towards public transport and away from the motorcycle mode.