Flue gas treatability studies: a tool for techno-economic control of industrial air pollution

Air pollution problems in developing countries have gained larger fraction in the last decade especially due to non functioning and non implementation of effective air pollutioncontrol devices in industries. In industrial wastewater management, adequate treatability studies are conducted to arrive at a techno-economic treatment option. However no suchstudies were done for reducing air pollution or emission fromindustries until now in India. Little information was availableabout such studies in other countries. This article provides information about a novel technique known asflue gas treatability studies and to undertake such studies, a pilot scale system is installed in Air Pollution Control Divisionof M/s National Environmental Engineering research Institute, NEERI, Nagpur-20, India. This study is a tool for techno-economicselection of air pollution control systems specially for small/medium scale industrial emissions.     

Biotreatability and kinetics of UASB reactor to mixtures of chlorophenol pollutants

In most natural ecosystems heterotrophic microorganisms encountercomplex mixtures of carbon sources, each of which is present at aconcentration of few micrograms per litre. This study examined the biotreatability and kinetics of an upflow anaerobic sludge blanket (UASB) reactor to complex mixtures of chlorophenols encountered in environmental conditions using on-line and off-line experimental studies. Results indicate that (1) steady-state concentration was quite lower (98.3 mg L^-1) with complex mixture of chlorophenols than steady-state concentration achieved when only 2.4 dichlorophenol (124 mg L^-1) was studied alone on the same reactor; (2) that toxiceffects of chlorophenols increase with increasing concentrationsof toxicant. (Onset of the inhibitory effect occurred at a lowerconcentration in multi-substrate than in single substrate utilization); (3) addition of alternative utilizable substrate can mitigate toxic effects and enhance degradation; (4) the relative concentration of substrate was critical in determiningutilization patterns. HPLC analysis of off-line experimental samples resulted in a steady-state treatment efficiency of68% for COD, 36% for 2-hlorophenol, 40.5% for 4-chlorophenol, 70.7% for 2,4-dichlorophenol, 53.2% for 2,4,6-trichlorophenol and 42% for pentachlorophenol in presence of glucose. Kinetic constant in terms of V _max and K _s were determined. K _s for the five chlorophenols ranged between 0.016 and 0.117 kg m^-3 day^-1 while V _max ranged between 0.056 and 0.244 kg m^-3 day^-1.     

Evaluation of interference to conventional and real-time PCR for detection and quantification of fungi in dust

Advances in polymerase chain reaction (PCR) have permitted accurate, rapid and quantitative identification of microorganisms in pure cultures regardless of viability or culturability. In this study, a simple sample processing method was investigated for rapid identification and quantification of fungal spores from dust samples using both conventional and real-time PCR. The proposed method was evaluated for susceptibility to interference from environmental dust samples. Stachybotrys chartarum and Aspergillus fumigatus were used as test organisms. The sensitivity of detection in pure culture was 0.1 spore DNA equivalents per PCR reaction corresponding to 20 spores ml(-1) in the sample. However, 1 spore DNA equivalent per PCR reaction corresponding to 200 spores ml(-1) in the sample was the lowest amount of spores tested without interference in dust samples spiked with spores of either fungal species. The extent of inhibition was calculated using conventional and real-time PCR reactions containing fungal spores, specific primers, specific probes (for real-time PCR) and various amounts of dust. The results indicate that the extent of inhibition by dust on PCR varies with the type and amount of dust, and number of spores. No interference in the analysis of spiked samples was detected from 0.2 mg ml(-1) of four real-life dust samples at p-value >0.05 using 2 x 10(4) spores for conventional PCR and 2 x 10(5) spores for real-time PCR. However, samples containing >0.2 mg ml(-1) real-life dust compromised the PCR assay. These results suggest the potential usefulness of a simple sample processing method in conjunction with PCR for monitoring the fungal content of aerosols collected from indoor environments.     

Pool of Dust Particles over the Asian Continent: Balloon-borne Optical Particle Counter and Ground-based Lidar Measurements at Dunhuang, China

Measurements of aerosols were made in 2001 and 2002 at Dunhuang (40 degrees 00'N, 94 degrees 30'E), China to understand the nature of atmospheric particles over the desert areas in the Asian continent. Balloon-borne measurements with an optical particle counter suggested that particle size and concentration had noticeable peaks in super micron size range not only in the boundary mixing layer but also in the free troposphere. Super-micron particle concentration largely decreased in the mid tropopause (from 5 to 10 km; above sea level, a.s.l.). Lidar measurements made during August 2002 at Dunhuang suggested the possibility that mixing of dust particles occurred from near the ground to about 6 km even under calm weather conditions, and a large depolarization ratio of particulate matter was found in the aerosol layer. The top of the aerosol layer was found at heights of nearly 6 km (a.s.l.). It is strongly suggested that nonspherical dust particles (Kosa particles) frequently diffused in the free atmosphere over the Taklamakan desert through small-scale turbulences and are possible sources of dust particles of weak Kosa events that have been identified in the free troposphere not only in spring but also in summer over Japanese archipelago. Electron microscopic experiments of the particles collected in the free troposphere confirmed that coarse and nonspherical particles observed by the mineral particle were major components of coarse mode (diameter larger than 1 microm) below about 5 km over Dunhuang, China.     

Total versus inhalable sampler comparison study for the determination of asphalt fume exposures within the road paving industry

Exposure to asphalt fumes has a threshold limit value (TLV of 0.5 mg m(-3) (benzene extractable inhalable particulate) as recommended by the American Conference of Governmental Industrial Hygienists (ACGIH). This reflects a recent change (2000) whereby two variables are different from the previous recommendation. First is a 10-fold reduction in quantity from 5 mg m(-3) to 0.5 mg m(-3). Secondly, the new TLV specifies the "inhalable" fraction as compared to what is presumed to be total particulate. To assess the impact of these changes, this study compares the differences between measurements of paving asphalt fume exposure in the field using an "inhalable" instrument versus the historically used 'total' sampler. Particle size is also examined to assist in the understanding of the aerodynamic collection differences as related to asphalt fumes and confounders. Results show that when exposures are limited to asphalt fumes, a 1:1 relationship exists between samplers, showing no statistically significant differences in benzene soluble matter (BSM). This means that for the asphalt fume ACGIH TLV, the 'total' 37-mm sampler is an equivalent method to the "inhalable" method, referred to as IOM (Institute of Occupational Medicine), and should be acceptable for use against the TLV. However, the study found that when confounders (dust or old asphalt millings) are present in the workplace, there can be significant differences between the two samplers' reported exposure. The ratio of IOM/Total was 1.37 for milling asphalt sites, 1.41 for asphalt paving over granular base, and 1.02 for asphalt over asphalt pavements.     

Utility of dynamics as indicators of stress in population models

The relationships between the dynamics of environmentally and chemically stressed populations and indicators of the effects of the stressor are explored in a model framework. The physiologically structured population, represented by a system of McKendrick–von Foerster hyperbolic partial differential equations, includes the dynamics of numerous individuals distinguished by ecotype. Chemical uptake of nonpolar narcotics is modeled by first order kinetics. Classical methodologies, frequency analysis and phase space reconstruction, are explored in a search for indicators of magnitude of stress. When these techniques proved generally unsuccessful for the objective of indicator selection in our model setting, summary statistics, as related to bifurcation diagrams, were constructed and appear more useful as indicators. It is concluded that physiological structures generally lead to more feasible measurable indicators of magnitude of stress than do specifics of population dynamics.     

Genetic population structure of the recently introduced Asian clam,Potamocorbula amurensis,in San Francisco Bay

The genetic population structure of the recently introduced Asian clam, Potamocorbula amurensis, in San Francisco Bay was described using starch gel electrophoresis at eight presumptive loci. Specimens were taken from five environmentally distinct sites located throughout the bay. The population maintains a high degree of genetic variation, with a mean heterozygosity of 0.295, a mean polymorphism of 0.75, and an average of 3.70 alleles per locus. The population is genetically homogeneous, as evidenced from genetic distance values and F-statistics. However, heterogeneity of populations was indicated from a contingency chi-square test. Significant deviations from Hardy-Weinberg equilibrium and heterozygote deficiencies were found at the Lap-1 locus for all populations and at the Lap-2 locus for a single population. High levels of variability could represent a universal characteristic of invading species, the levels of variability in the source population(s), and/or the dynamics of the introduction. Lack of differentiation between subpopulations may be due to the immaturity of the San Francisco Bay population, the general purpose phenotype genetic strategy of the species, high rates of gene flow in the population, and/or the selective neutrality of the loci investigated.     

Synthesis and structure-activity relationship of diene modified analogs of<Emphasis Type="Italic"> Matsucoccus</Emphasis> sex pheromones

The biological activity of the Matsucoccus spp. sex pheromones and diene modified analogs has been tested in forests of Israel and Portugal in order to explore the structure-activity relationship of the pine bast scale pheromone/kairomone system. The response of the adult predatory bugs, Elatophilus hebraicus and E. crassicornis and of the brown lacewing, Hemerobius stigma is more selective than that of the conspecific Matsucoccus males. The removal of the terminal methyl group from the diene terminus of both pheromones 1 and 2 eliminates all kairomonal activity but retains moderate pheromonal activity. Addition of a methyl group to the diene terminus of pheromones 1 and 2 sustains full pheromonal and kairomonal activities of the Elatophilus spp. but eliminates entirely the kairomonal activity of H. stigma. Subtle designed alterations in the structure of the diene group, typical of all Matsucoccus pheromones, change the mode of the kairomonal activity markedly.     

Rapid prediction of disinfection by-product formation potential by fluorescence

Recent drinking water regulations have lowered the disinfection by-product standards as well as added new disinfection by-products for regulation. Natural organic matter (NOM) plays a major role in the formation of undesirable organic by-products following disinfection/oxidation of drinking water. It is suspected that most precursors to disinfection by-products are humic, although nonhumic substances are also suspected of contributing to these by-products. Many of the disinfection by-products have adverse health effects in humans (i.e., carcinogenic or mutagenic effects). The primary chlorinated disinfection by-products of concern include trihalomethanes, haloacetic acids, and haloacetonitrile. Fluorescence spectroscopy was used to study humic and fulvic acids. The two fractions of humic substances, humic and fulvic acids, were characterized by a double-peak phenomena in an overlapping fluorescing region. Disinfection by-product formation potentials of humic and fulvic acids have been correlated with total organic carbon, UV absorbance at 254 nm, specific absorbance and fluorescence. River humic and fulvic acid was found to have the highest reactivity to disinfection by-product formation as compared to soil and peat humic and fulvic acid. Fluorescence spectroscopy has shown to be a rapid and predictive tool for disinfection by-products formation potential of humic and fulvic acids.