Mitigating nutrient leaching with a sub-surface drainage layer of granulated tires

Markets for scrap tires have expanded since the early 1990s with the development of value-added applications such as tire-derived fuel and crumb-rubber-amended asphalt. Granulated tires have also displayed the ability to adsorb volatile organic compounds, indicating that the rubber material can be a useful filter media. Sand-based root zones, typically used for golf course putting green and athletic field construction, lack sufficient cation exchange capacity to restrict nitrogen and phosphorus migration through the root zone and into sub-surface drainage systems. Therefore, the adsorptive properties of tire rubber for retaining nitrogen and phosphorus were studied when applied as a distinct sub-surface drainage or intermediate layer in golf course putting greens. A statistically significant reduction in the concentration of nitrate in leachate was achieved by replacing traditional pea gravel with equally sized granulated tires for the drainage layer media, although the mechanism of nitrate mitigation remains unclear. The results indicate that using granulated tires as a drainage layer or fill material beneath sand-based root zones does not compromise the function of the profile or quality of the vegetation while creating an environmentally beneficial and value-added option for scrap tire reuse.     

Removal of organic matter and nitrogen from river water in a model floodplain

A significant improvement in river water quality cannot be expected unless nonpoint-source contaminants are treated in addition to the further treatment of point-source contaminants. If river water is sprayed over a floodplain, the consequent water filtration through the sediment profile can simultaneously remove organic matter and nitrogen in the water through aerobic and denitrifying reactions. This hypothesis was tested using lysimeters constructed from polyvinyl chloride (PVC) pipe (150 cm long, 15 cm in diameter) packed with loamy sand floodplain sediment. Water was applied to the top of the lysimeters at three different flow rates (48, 54, and 68 mm d(-1)). Concentrations of NO3 and dissolved oxygen (DO), chemical oxygen demand (COD), and redox potential (Eh) in the water were measured as functions of depth after the system reached steady states for both water flow and reactions. At the rate of 68.0 mm d(-1), a reducing condition for denitrification developed below the 5-cm depth due to the depletion of O2 by organic matter degradation in the surface oxidizing layer; Eh and DO were below 205 mV and 0.4 mg L(-1), respectively. At a depth of 70 cm, COD and NO3-N concentration decreased to 5.2 and 3.8 mg L(-1) from the respective influent concentrations of 17.1 and 6.2 mg L(-1). Most biodegradable organic matter was removed during flow and further removal of NO3 was limited by the lack of an electron donor (i.e., organic matter). These results indicate that the floodplain filtration technique has great promise for treatment of contaminated river water.     

Does the selection of ISO 14001 registrars matter? Registrar reputation and environmental policy statements in China

This study investigates the relationship between characteristics of environmental policy statements and the reputations of ISO 14001 registrars who had performed certification audits of firms operating in mainland China. Three characteristics of environmental policy statements were examined: (1) The conformance of the policy to strict interpretations of the international standard; (2) The policy statement's adherence to the good practice guidelines specified in ISO 14004; and, (3) Self-reported evaluations of the policy statement's effectiveness as implemented. Data from 106 facilities in Beijing, Shanghai and Guangzhou reveal that registrar quality has a relatively weak, positive relationship with conformance to both ISO 14001 standards and to ISO 14004 guidelines, but no relationship was observed with the self-reported data. Additional findings are that the use of foreign registrars is significantly associated with the adoption of ISO 14004 guidelines and that conformance with ISO 14001 standards is somewhat higher for international joint ventures and foreign-owned firms than for state-owned enterprises.     

Operational characteristics of effective removal of H2S and NH3 waste gases by activated carbon biofilter

Simultaneous removal of hydrogen sulfide (H2S) and ammonia (NH3) gases from gaseous streams was studied in a biofilter packed with granule activated carbon. Extensive studies, including the effects of carbon (C) source on the growth of inoculated microorganisms and gas removal efficiency, product analysis, bioaerosol emission, pressure drop, and cost evaluation, were conducted. The results indicated that molasses was a potential C source for inoculated cell growth that resulted in removal efficiencies of 99.5% for H2S and 99.2% for NH3. Microbial community observation by scanning electron microscopy indicated that granule activated carbon was an excellent support for microorganism attachment for long-term waste gas treatment. No disintegration or breakdown of biofilm was found when the system was operated for 140 days. The low bioaerosol concentration emitted from the biofilter showed that the system effectively avoided the environmental risk of bioaerosol emission. Also, the system is suitable to apply in the field because of its low pressure drop and treatment cost. Because NH3 gas was mainly converted to organic nitrogen, and H2S gas was converted to elemental sulfur, no acidification or alkalinity phenomena were found because of the metabolite products. Thus, the results of this study demonstrate that the biofilter is a feasible bioreactor in the removal of waste gases.     

EPR characterization of the catalytic activity of clays for PCE removal by gamma-radiation induced by acid and thermal treatments

Clays from tidal flat sediments showed efficient catalytic activity in the decomposition of PCE by gamma-radiation. The highest PCE removal of 98.6% was obtained with clays heated to 700 degrees C after acid treatment. The improved catalytic activity was identified by electron paramagnetic resonance (EPR) spectroscopy. The EPR spectra of clays were significantly changed by the acid and thermal treatments. The intensity of a narrow signal at g=2 (signal III) was decreased with increasing thermal treatment temperature and this increased the PCE removal efficiency. The acid treatment completely removed a broad signal at g=2 (signal II), decreased the intensity of signal III, and improved the gamma-radiation treatment of PCE.     

A two-dimensional model for simulating the transport and fate of toxic chemicals in a stratified reservoir

A two-dimensional reservoir toxics model is essential to establishing effective water resources management and protection. In a reservoir, the fate of a toxic chemical is closely connected with flow regimes and circulation patterns. To better understand the kinetic processes and persistence and predict the dissipation of toxic contaminants in the reservoir during a spill or storm runoff event, a toxics submodel was developed and incorporated into an existing laterally integrated hydrodynamics and transport model. The toxics submodel describes the physical, chemical, and biological processes and predicts unsteady vertical and longitudinal distributions of a toxic chemical. The two-dimensional toxicant simulation model was applied to Shasta Reservoir in California to simulate the physico-chemical processes and fate of a volatile toxic compound, methyl isothiocyanate (MITC), during a chemical spill into the Sacramento River in 1991. The predicted MITC concentrations were compared with those observed. The effect of reservoir flow regimes on the transport and fate of the toxic substance was investigated. The results suggested that the persistence of MITC is significantly influenced by different flow regimes. Methyl isothiocyanate is more persistent in the reservoir under an interflow condition due to reduced volatilization from deep layers than under an overflow condition. In the overflow situation, the plume moved more slowly toward the dam and experienced greater dissipation. This analysis can assist in toxic spill control and reservoir management, including field sampling and closure of water intakes.     

Fluctuations of exposure rate at regional radiation monitoring stations in Korea

Based on hourly means of exposure rate between August 2000 and July 2001 at nine Regional Radiation Monitoring Stations (RRMS) in Korea, we analyzed spatio-temporal characteristics of exposure rate. The mean and fluctuations of exposure rates were 99 and 3.8 nGy h(-1), respectively. The hourly exposure rate over 9 RRMS indicated a diurnal pattern with the exposure rates reaching a maximum between 5:00 and 8:00 a.m. in the early morning and a broad minimum between 4:00 and 10:00 p.m. in the afternoon. The fluctuations of exposure rate in the inland areas were less than 3.2 nGy h(-1), and those of exposure rate in coastal areas were larger than 3.9 nGy h(-1). The frequency distribution of exposure rates had one peak around the mean and was to be skewed to the right or positively skewed and its tails were fatter than those of a normal distribution. The interrelations of exposure rates at each station generally decreased with the distance between the stations. Empirical orthogonal function (EOF) analysis showed that almost all (99.9%) of exposure rate fluctuations were described by simultaneous variations. The spatial distribution of the first EOF modes of actual, low-pass (periods longer than one month) and high-pass (periods shorter than one month) exposure rate series were similar to each other.     

Remediation of petroleum-contaminated soils by fluidized thermal desorption

A novel type of fluidized bed desorber was developed for the remediation of petroleum-contaminated soils at low temperature with high efficiency. Cahn balance® was utilized to investigate the thermal desorption behavior of soils contaminated by various hydrocarbons. The performance of the fluidized-bed desorber was investigated at different operating modes. Batch operation of the fluidized-bed desorber exhibited 99.9% desorption efficiency at temperatures of ca. 300°C within a half hour. Continuous operation of the fluidized-bed indicated that Q/F (the ratio of the mass flow rate of fluidizing gas to feeding rate of contaminated soils) is less important at higher temperature (>300°C), if proper fluidization is ensured. The periodic operation of the fluidized bed desorber shows the possibility to reduce off-gas volume significantly.