Spectrophotometric determination of sulphur dioxide

Sulphur dioxide, an important industrial gas and air pollutant, is usually estimated using mercury salts. The authors have developed a method in which hazardous mercury salts are avoided. Sulphur dioxide is trapped in aqueous morpholine and mixed with the excess of dichromate solution in acidic medium. The hexavalent chromium in dichromate is reduced to trivalent chromium by sulphur dioxide and the excess of hexavalent chromium is determined with diphenylcarbazide which yields a soluble red-violet complex with an absorption maximum at 540 nm. The decrease in the absorbance values of the red-violet complex formed after reduction, when compared to that of a reagent control, is proportional to the concentration of sulphur dioxide used for reduction. Beer's law operates between 0.4 and 4 microg ml(-1) concentration of sulphur dioxide in solution.     

Characterization of biomass pyrolysis vapors with molecular beam, single photon ionization time-of-flight mass spectrometry

A single photon ionization, molecular beam sampling, reflectron time-of-flight mass spectrometer (SPI/MBTOFMS) has been developed and used to study pyrolysis products from a selection of biomass materials. Spectra are characterized by high resolution and decreased fragmentation compared to electron-impact ionization mass spectra from related molecular beam mass spectrometer systems equipped with quadrupole mass analyzers.     

Reactive transport modeling of processes controlling the distribution and natural attenuation of phenolic compounds in a deep sandstone aquifer

Reactive solute transport modeling was utilized to evaluate the potential for natural attenuation of a contaminant plume containing phenolic compounds at a chemical producer in the West Midlands, UK. The reactive transport simulations consider microbially mediated biodegradation of the phenolic compounds (phenols, cresols, and xylenols) by multiple electron acceptors. Inorganic reactions including hydrolysis, aqueous complexation, dissolution of primary minerals, formation of secondary mineral phases, and ion exchange are considered. One-dimensional (1D) and three-dimensional (3D) simulations were conducted. Mass balance calculations indicate that biodegradation in the saturated zone has degraded approximately 1-5% of the organic contaminant plume over a time period of 47 years. Simulations indicate that denitrification is the most significant degradation process, accounting for approximately 50% of the organic contaminant removal, followed by sulfate reduction and fermentation reactions, each contributing 15-20%. Aerobic respiration accounts for less than 10% of the observed contaminant removal in the saturated zone. Although concentrations of Fe(III) and Mn(IV) mineral phases are high in the aquifer sediment, reductive dissolution is limited, producing only 5% of the observed mass loss. Mass balance calculations suggest that no more than 20-25% of the observed total inorganic carbon (TIC) was generated from biodegradation reactions in the saturated zone. Simulations indicate that aerobic biodegradation in the unsaturated zone, before the contaminant entered the aquifer, may have produced the majority of the TIC observed in the plume. Because long-term degradation is limited to processes within the saturated zone, use of observed TIC concentrations to predict the future natural attenuation may overestimate contaminant degradation by a factor of 4-5.     

Variability of pesticide residues in cauliflower units collected from a field trial and market places in Greece

To estimate the variability of pesticide residue levels present in cauliflower units, a total of 142 samples were collected from a field trial of a cooperative farmer, and 120 samples were collected from different market places in Thessaloniki, Greece. The collected samples were extracted using the quick, easy, cheap, effective, rugged, and safe (QuEChERS) extraction technique, and the residues were determined by liquid chromatography–tandem mass spectrometry. The developed method was validated by evaluating the accuracy, precision, linearity, limit of detection (LOD), and limit of quantification (LOQ). The average recoveries for all the analytes, derived from the data of control samples fortified at 0.01, 0.05, 0.1, and 0.2 mg/kg, ranged from 74 to 110% with a relative standard deviation of ≤8%. The correlation coefficient (R²) was ≥0.997 for all the analytes using matrix-matched calibration standards. The LOD values ranged from 0.001 to 0.003 mg/kg, and the LOQ was determined at 0.01 mg/kg for all the sought analytes. The matrix effect was found to be at a considerable level, especially for cypermethrin and deltamethrin, amounting to +90% and +145%, respectively. For the field samples, the unit-to-unit variability factors (VFs) calculated for cypermethrin and deltamethrin were 2.38 and 2.32, respectively, while the average VF for the market basket samples was 5.11. In the market basket samples, residues of cypermethrin, deltamethrin, chlorpyrifos, and indoxacarb were found at levels ≥LOQ and their respective VFs were 7.12, 5.67, 5.28, and 2.40.     

MTBE oxidation byproducts from the treatment of surface waters by ozonation and UV-ozonation

In recent years, there has been considerable concern over the release of methyl tert-butyl ether (MTBE), a gasoline additive, into the aquifers used as potable water sources. MTBE readily dissolves in water and has entered the environment via gasoline spills and leaking storage tanks. In this paper, we investigate ozonation and UV-ozonation for treatment of MTBE in contaminated drinking water sources. We report the test protocol and results of using solid-phase microextraction (SPME) to determine the level of MTBE and its oxidation byproducts in samples drawn from laboratory-scale ozone and UV-ozone reactors being evaluated at a US EPA research facility. Analysis of a prepared MTBE standard indicated a detection limit on the order of 0.1 microgl(-1) with a repeatability of +/-0.4%. Results show that the overall rate of removal of MTBE via UV-ozonation in a relatively turbid surface water (15 ntu) is twice that of ozonation alone. In addition, GC-MS analysis of decomposition products showed that tert-butyl formate (TBF), methyl acetate, butene, acetone, and acetaldehyde were produced by both processes. TBF and butene reach similar maximum yields from the two processes, but are more efficiently degraded by UV-ozonation treatment. This indicates that these treatment processes also degrade these byproducts. In contrast, the remaining byproducts (methyl acetate, acetone, and acetaldehyde) are formed at similar levels during treatment, but are not degraded once formed. These byproducts may be resistant to hydrogen abstraction by hydroxyl radical.     

Occurrence of UV filter compounds from sunscreens in surface waters: regional mass balance in two Swiss lakes

Consumer care products often contain UV filters, organic compounds which absorb ultraviolet light. These compounds may enter surface waters directly (when released from the skin during swimming and bathing) or indirectly via wastewater treatment plants (when released during showering or washed from textiles). Predicted and measured UV filter concentrations were compared in a regional mass balance study for two Swiss lakes: Lake Zurich, a typical midland lake which is also an important drinking water resource, and Hüttnersee, a small bathing lake. Both lakes are extensively used for recreational activities and considerable direct input of UV filters is thus expected. This input was estimated from the number of visitors at swimming areas around the lakes and a survey of the usage of sunscreen products among these visitors. Possible additional indirect input via wastewater treatment plants was not considered in this study. The quantitatively most important UV filters, as indicated by the survey data, ethylhexyl methoxycinnamate, octocrylene, 4-methylbenzylidene camphor, butyl methoxydibenzoylmethane, and benzophenone-3, all lipophilic compounds, were selected for analysis by gas chromatography-mass spectrometry. Concentrations of individual UV filters in water from Lake Zurich were low, ranging from <2 ng l(-1) (detection limit) to 29 ng l(-1), and somewhat higher at Hüttnersee, ranging from <2 to 125 ng l(-1), with the highest concentrations found in summer, consistent with direct inputs to the lakes during this time. The concentrations were clearly lower than predicted from input estimates based on the surveys. This may be in part due to (i) an overestimation of these inputs (e.g. less than the 50% wash-off of UV filters assumed to occur during swimming), and (ii) some removal of these compounds from the lakes by degradation and/or sorption/sedimentation. UV filters were also detected in semipermeable membrane devices (SPMDs) deployed at Lake Zurich and Greifensee, another midland lake, at concentrations of 80-950 ng SPMD(-1), confirming the presence of the compounds in surface waters and indicating a certain potential for bioaccumulation. SPMD-derived water concentrations were in the range of 1-10 ng l(-1) and thus corresponded well with those determined in water directly. No UV filters were detected above blank levels in SPMDs deployed at a remote mountain lake used for background measurements.     

Assessing the impact of ambient ozone on growth and productivity of two cultivars of wheat in India using three rates of application of ethylenediurea (EDU)

Three rates of ethylenediurea were used to assess the impact of ambient ozone on growth and productivity of wheat (Triticum aestivum L) cultivars "Malviya 533" (M 533) and "Malviya 234" (M 234) at a suburban site near Varanasi, India, beginning in December. Wheat plants were treated with EDU at 0, 150, 300 and 450 ppm as soil drenches at 10-day intervals. EDU treatment affected plant growth, with effects varying with cultivar, age, and EDU concentration. Seed yield was improved for M 533 at 150 ppm EDU, while yield improved for M 234 at 300 and 450 ppm EDU. M 533 appears to be more resistant to ozone than M 234. Overall results confirmed that EDU is very useful in assessing the effect of ambient ozone in India.     

Prediction of Pb speciation in concentrated and dilute nutrient solutions

Despite the presence of numerous studies in the literature examining the phytotoxicity of Pb, there is a lack of precise quantitative data on limiting concentrations of Pb for plant growth. Using the PhreeqcI chemical equilibrium model, simulations were conducted to examine the speciation of Pb in concentrated and dilute nutrient solutions. Due to the higher P concentration of Hoagland's solution (1000microM), precipitation of chloropyromorphite (Pb5(PO4)3Cl) was predicted to occur at lower pH values, and at lower Pb concentrations, than for a dilute nutrient solution (2microM P). Although nutrient solutions prepared in the glasshouse were supersaturated (and Pb concentrations were substantially higher than predicted by modeling), they confirmed the importance of the P concentration in influencing the precipitation of Pb. Given the low solubility of Pb-phosphates, nutrient solutions with low P concentrations should be utilized, and plant growth should be related to measured Pb concentrations rather than to the quantity of Pb initially added.