Remediation of MTBE from drinking water: air stripping followed by off-gas adsorption

The widespread use of methyl tertiary butyl ether (MTBE) as an oxygenate in gasoline has resulted in the contamination of a large number of ground and surface water sources. Even though air stripping has been proven to be an effective treatment technology for MTBE removal, off-gas treatment often is required in conjunction with it. This study evaluated the combined treatment technologies of air stripping followed by off-gas adsorption on a pilot scale for the treatment of MTBE-contaminated water. The effect of air/water ratios on the treatment efficiency was studied, and the mass transfer coefficient was determined. Air/water ratios of 105:1, 151:1, 177:1, 190:1, 202:1, and 206:1 were used, and a treatment efficiency of >99% was achieved for all the runs conducted. The depth of packing required to achieve maximum treatment efficiency decreased with increasing air/water ratio. Relative humidity (RH) impacts on the MTBE adsorption capacity of a granular activated carbon (GAC) and carbonaceous resin were determined from pilot plant studies. Breakthrough profiles obtained from the pilot plant studies conducted at 20, 30, and 50% RH indicated that GAC has a higher adsorptive capacity than resin. The adsorptive capacity of GAC decreased with increasing RH, whereas RH did not impact the resin adsorptive capacity.     

Dioxin incinerator emissions exposure study Times Beach, Missouri

PURPOSE: To determine whether living in the vicinity of a hazardous waste incinerator that was burning material contaminated with 2,3,7,8-tetrachlorodibenzo-p-dioxin (TCDD) increased TCDD and toxicity equivalencies (TEQ) in individuals living near the incinerator. METHODS: Participants were randomly chosen from an area close to the incinerator and compared to participants outside of the exposure area. TCDD and related compounds were measured in blood serum before incineration, four months after incineration started, and at the end of incineration. RESULTS: Lipid adjusted serum levels of TCDD and TEQ decreased from pre-incineration to four months after incineration, and decreased further by the end of incineration. CONCLUSION: Incineration of TCDD did not result in any measurable exposure to the population surrounding the incinerator.     

Napropamide residues in runoff and infiltration water from pepper production

A field study was conducted on a Lowell silty loam soil of 2.7% organic matter at the Kentucky State University Research Farm, Franklin County, Kentucky. Eighteen universal soil loss equation (USLE) standard plots (22 x 3.7 m each) were established on a 10% slope. Three soil management practices were used: (i) class-A biosolids (sewage sludge), (ii) yard waste compost, each mixed with native soil at a rate of 50 ton acre(-1) on a dry-weight basis, and (iii) a no-mulch (NM) treatment (rototilled bare soil), used for comparison purposes. Devrinol 50-DF "napropamide" [N,N-diethyl-2-(1-naphthyloxy) propionamide] was applied as a preemergent herbicide, incorporated into the soil surface, and the plots were planted with 60-day-old sweet bell pepper seedlings. Napropamide residues one hour following spraying averaged 0.8, 0.4, and 0.3 microg g(-1) dry soil in sewage sludge, yard waste compost, and no-mulch treatments, respectively. Surface runoff water, runoff sediment, and napropamide residues in runoff were significantly reduced by the compost and biosolid treatments. Yard waste compost treatments increased water infiltration and napropamide residues in the vadose zone compared to sewage sludge and NM treatments. Total pepper yields from yard waste compost amended soils (9187 lbs acre(-1)) was significantly higher (P < 0.05) than yield from either the soil amended with class-A biosolids (6984 lbs acre(-1)) or the no-mulch soil (7162 lbs acre(-1)).     

Integrated manufacturing,empowerment, and company performance

There is controversy over whether integrated manufacturing (IM), comprising advanced manufacturing technology, just‐in‐time inventory control and total quality management, empowers or deskills shop floor work. Moreover, both IM and empowerment are promoted on the assumption that they enhance competitiveness. We examine these issues in a study of 80 manufacturing companies. The extent of use of IM was positively associated with empowerment (i.e., job enrichment and employee skill enhancement), but, with the minor exception of AMT, bore little relationship with subsequent company performance. In contrast, the extent of empowerment within companies predicted the subsequent level of company performance controlling for prior performance, with the effect on productivity mediating that on profit. Copyright © 2004 John Wiley & Sons, Ltd.     

Toward estimation of map accuracy without a probability test sample

The time and effort required of probability sampling for accuracy assessment of large-scale land cover maps often means that probability test samples are not collected. Yet, map usefulness is substantially reduced without reliable accuracy estimates. In this article, we introduce a method of estimating the accuracy of a classified map that does not utilize a test sample in the usual sense, but instead estimates the probability of correct classification for each map unit using only the classification rule and the map unit covariates. We argue that the method is an improvement over conventional estimators, though it does not eliminate the need for probability sampling. The method also provides a new and simple method of constructing accuracy maps. We illustrate some of problems associated with accuracy assessment of broad-scale land cover maps, and our method, with a set of nine Landsat Thematic Mapper satellite image-based land cover maps from Montana and Wyoming, USA.     

Effects of wave-induced lightflecks in the intertidal zone on photosynthesis in the macroalgae Postelsia palmaeformis and Hedophyllum sessile (Phaeophyceae)

Intertidal algae are exposed to a highly variable photic regime because of crashing waves. We measured photosynthetic rate of whole fronds of the seaweeds Postelsia palmaeformis (Ruprecht) (at Bodega Marine Laboratory, 1991) and Hedophyllum sessile (Setchell) (Phaeophyceae) (at Friday Harbor Laboratories, 1990) in flashing and steady-state photosynthetically active radiation (PAR) of equal irradiance, using a recirculating metabolism chamber designed to minimize the thickness of diffusional boundary layers on the surfaces of algal tissues. The dimensionless ratio of photosynthetic rate under flecking PAR (P_fleck) and the sum of photosynthetic rate under steady state PAR (P_s) of high and low irradiance was computed for lightfleck periods from 0.2 to 100 s. P_fleck:P_s is a measure of the light-flash utilization-efficiency in flashing light, and was greater than unity at periods between lighflecks of 2 to 30 s, with a peak at 10 s. We used a novel optical fiber irradiance meter to measure PAR incident on fronds of P. palmaeformis as they were washed about by waves breaking in the intertidal zone, and compared the light records to that obtained by a stationary sensor under the canopy. PAR flashing period was closely correlated with the period of breaking waves in stands of P. palmaeformis. We estimated the seasonal spectrum of period between light flashes in stands of this species by examining the spectral density of ocean waves at Bodega Marine Laboratory, Bodega Bay, California. The wave spectrum peaks at a period (10 s) where light-flashes may theoretically enhance the light-flash utilization-efficiency of seaweeds. We calculate that the enhanced light-flash utilization-efficiency wrought by wave-induced light-flashes may contribute to significant gains in primary productivity of these macroalgae under some conditions.     

Handling of dioxin measurement data in the presence of non-detectable values: overview of available methods and their application in the Seveso chloracne study

Exposure measurements of concentrations that are non-detectable or near the detection limit (DL) are common in environmental research. Proper statistical treatment of non-detects is critical to avoid bias and unnecessary loss of information. In the present work, we present an overview of possible statistical strategies for handling non-detectable values, including deletion, simple substitution, distributional methods, and distribution-based imputation. Simple substitution methods (e.g., substituting 0, DL/2, DL/ radical2, or DL for the non-detects) are the most commonly applied, even though the EPA Guidance for Data Quality Assessment discouraged their use when the percentage of non-detects is >15%. Distribution-based multiple imputation methods, also known as robust or "fill-in" procedures, may produce dependable results even when 50-70% of the observations are non-detects and can be performed using commonly available statistical software. Any statistical analysis can be conducted on the imputed datasets. Results properly reflect the presence of non-detectable values and produce valid statistical inference. We describe the use of distribution-based multiple imputation in a recent investigation conducted on subjects from the Seveso population exposed to 2,3,7,8-tetrachlorodibenzo-p-dioxin (TCDD), in which 55.6% of plasma TCDD measurements were non-detects. We suggest that distribution-based multiple imputation be the preferred method to analyze environmental data when substantial proportions of observations are non-detects.     

An analysis of the yearly changes in sulfur concentrations at various national parks in the United States, 1980-1996

An apparent increasing trend in the summer concentrations of particulate sulfur at Shenandoah (for the time period 1982-1995) and at Great Smoky Mountains (for the time period 1984-1995) has been pointed out by some researchers. Others have suggested that these increasing trends may be an analytical artifact resulting from the switch from the Stacked Filter Units (SFU) measurement system to the IMPROVE (Interagency Monitoring of Protected Visual Environments) measurement system that occurred during the winter of 1987. To obtain a better understanding of the effect of the protocol change, we investigate the changes in the seasonal averages of sulfur concentrations for successive pairs of years for the period 1980-1996 for about 20 national park sites in the United States. For the period 1980-1987, we use sulfur data from the old (SFU) database and for the period 1988-1996, we use the IMPROVE database. Changes from one year to the next similar to that between 1987 and 1988 occurred during other years and seasons suggesting that chance causes alone could perhaps explain it, the degree to which chance could have caused the changes was measured using the permutation test for matched. At the very least, additional information such as side by side readings using SFU and IMPROVE measurement methods, may be needed to better understand any systematic effect in the sulfur measurements that may be ascribable to the protocol change.