Laboratory evaluation of thermophilic-anaerobic digestion to produce Class A biosolids. 1. Stabilization performance of a continuous-flow reactor at low residence time.

There is increasing interest in the United States in producing biosolids from municipal wastewater treatment that meet the criteria for Class A designation established by the U.S. Environmental Protection Agency. Class A biosolids are intended to be free of pathogens and also must meet requirements for reduction of the vector-attraction potential associated with untreated sludge. High-temperature processes are considered to produce Class A biosolids if the combination of operating temperature and treatment time exceeds minimum criteria, but this option is not applicable to mixed, continuous-flow reactors. Such reactors, or any combination of reactors that does not meet the holding time requirement at a specific temperature, must be demonstrated to inactivate pathogens to levels consistent with the Class A criteria. This study was designed to evaluate pathogen inactivation by thermophilic anaerobic digestion in a mixed, continuous-flow reactor followed by batch or plug-flow treatment. In this first of a two-part series, we describe the performance of a continuous-flow laboratory reactor with respect to physical and chemical operating parameters; microbial inactivation in the combined continuous-flow and batch treatment system is described in the second part. Sludges from three different sources were treated at 53 degrees C, while sludge from one of the sources was also treated at 55 and 51 degrees C. Relatively short hydraulic retention times (four to six days) were used to represent a conservative operating condition with respect to pathogen inactivation. Treatment of a fermented primary sludge led to an average volatile-solids (VS) destruction efficiency of 45%, while VS destruction for the other two sources was near or below 38%, the Class A criterion for vector attraction reduction. Consistent with other studies on thermophilic anaerobic digestion of sludges at short residence times, effluent concentrations of volatile fatty acids (VFAs) were relatively high. Also consistent with other studies, the most abundant VFA in the effluent was propionate. Gas production ranged from 0.3 to 0.5 m3/kg VS fed and from 0.8 to 1.3 m3/kg VS destroyed.     

Laboratory evaluation of thermophilic-anaerobic digestion to produce Class A biosolids. 2. Inactivation of pathogens and indicator organisms in a continuous-flow reactor followed by batch treatment.

Thermophilic-anaerobic digestion in a single-stage, mixed, continuous-flow reactor is not approved in the United States as a process capable of producing Class A biosolids for land application. This study was designed to evaluate the inactivation of pathogens and indicator organisms in such a reactor followed by batch treatment in a smaller reactor. The combined process was evaluated at 53 degrees C with sludges from three different sources and at 51 and 55 degrees C with sludge from one of the sources. Feed sludge to the continuous-flow reactor was spiked with the pathogen surrogates Ascaris suum and vaccine-strain poliovirus. Feed and effluent were analyzed for these organisms and for indigenous Salmonella spp., fecal coliforms, Clostridium perfringens spores, and somatic and male-specific coliphages. No viable Ascaris eggs were observed in the effluent from the continuous reactor at 53 or 55 degrees C, with greater than 2-log removals across the digester in all cases. Approximately 2-log removal was observed at 51 degrees C, but all samples of effluent biosolids contained at least one viable Ascaris egg at 51 degrees C. No viable poliovirus was found in the digester effluent at any of the operating conditions, and viable Salmonella spp. were measured in the digester effluent in only one sample throughout the study. The ability of the continuous reactor to remove fecal coliforms to below the Class A monitoring limit depended on the concentration in the feed sludge. There was no significant removal of Clostridium perfringens across the continuous reactor under any condition, and there also was limited removal of somatic coliphages. The removal of male-specific coliphages across the continuous reactor appeared to be related to temperature. Overall, at least one of the Class A pathogen criteria or the fecal coliform limit was exceeded in at least one sample in the continuous-reactor effluent at each temperature. Over the range of temperatures evaluated, the maximum time required to meet the Class A criteria by batch treatment of the continuous-reactor effluent was 1 hour for Ascaris suum and Salmonella spp. and 2 hours for fecal coliforms.     

Effects of nutrient and temperature on degradation of petroleum hydrocarbons in contaminated sub-Antarctic soil

Mesocosm studies using sub-Antarctic soil artificially contaminated with diesel or crude oil were conducted in Kerguelen Archipelago (49 degrees 21' S, 70 degrees 13' E) in an attempt to evaluate the potential of a bioremediation approach in high latitude environments. All mesocosms were sampled on a regular basis over six months period. Soils responded positively to temperature increase from 4 degrees C to 20 degrees C, and to the addition of a commercial oleophilic fertilizer containing N and P. Both factors increased the hydrocarbon-degrading microbial abundance and total petroleum hydrocarbons (TPH) degradation. In general, alkanes were faster degraded than polyaromatic hydrocarbons (PAHs). After 180 days, total alkane losses of both oils reached 77-95% whereas total PAHs never exceeded 80% with optimal conditions at 10 degrees C and fertilizer added. Detailed analysis of naphthalenes, dibenzothiophenes, phenanthrenes, and pyrenes showed a clear decrease of their degradation rate as a function of the size of the PAH molecules. During the experiment there was only a slight decrease in the toxicity, whereas the concentration of TPH decreased significantly during the same time. The most significant reduction in toxicity occurred at 4 degrees C. Therefore, bioremediation of hydrocarbon-contaminated sub-Antarctic soil appears to be feasible, and various engineering strategies, such as heating or amending the soil can accelerate hydrocarbon degradation. However, the residual toxicity of contaminated soil remained drastically high before the desired cleanup is complete and it can represent a limiting factor in the bioremediation of sub-Antarctic soil.     

Feral swine disturbance at important archaeological sites

Feral swine are well known as environmentally destructive invasive animals in many areas around the world, where they degrade native habitats, harm rare plant and animal species, damage agricultural interests, and spread disease. We provide the first quantification of their potential as agents of disturbance at archaeological sites. Our study was conducted in south-central Florida at Avon Park Air Force Range, a base comprising over 40,000 ha and containing many archaeological sites. To determine the identifiable prevalence of feral swine disturbance, we examined 36 sites registered with the Florida State Historic Preservation Office and also eligible for inclusion in the National Register of Historic Places (NRHP). Moreover, we evaluated the extent of swine disturbance at a prehistoric site of extraordinary significance to Florida’s prehistory, “Dead Cow.” Fifteen of the 36 NRHP-eligible sites (42 %) had some level of swine disturbance, including 14 of 30 (47 %) sites known to have artifacts within 20 cm of the surface (well within swine rooting depths). At the Dead Cow site, we documented disturbance at 74 % of shovel test points. Sites with shallow artifact depositions appeared highly vulnerable to disturbance by feral swine, threatening destruction of artifact stratigraphy and provenience. Our observations likely are a minimal representation of accumulated damage. These irreplaceable sites tell the area’s land use story across the millennia. That they are under threat from feral swine should serve broad notice of potential threats that feral swine may pose to archaeological sites globally, making effective swine management imperative for site protection.     

The effects of perennial ryegrass and alfalfa on microbial abundance and diversity in petroleum contaminated soil

Enhanced rhizosphere degradation uses plants to stimulate the rhizosphere microbial community to degrade organic contaminants. We measured changes in microbial communities caused by the addition of two species of plants in a soil contaminated with 31,000 ppm of total petroleum hydrocarbons. Perennial ryegrass and/or alfalfa increased the number of rhizosphere bacteria in the hydrocarbon-contaminated soil. These plants also increased the number of bacteria capable of petroleum degradation as estimated by the most probable number (MPN) method. Eco-Biolog plates did not detect changes in metabolic diversity between bulk and rhizosphere samples but denaturing gradient gel electrophoresis (DGGE) analysis of PCR-amplified partial 16S rDNA sequences indicated a shift in the bacterial community in the rhizosphere samples. Dice coefficient matrices derived from DGGE profiles showed similarities between the rhizospheres of alfalfa and perennial ryegrass/alfalfa mixture in the contaminated soil at week seven. Perennial ryegrass and perennial ryegrass/alfalfa mixture caused the greatest change in the rhizosphere bacterial community as determined by DGGE analysis. We concluded that plants altered the microbial population; these changes were plant-specific and could contribute to degradation of petroleum hydrocarbons in contaminated soil.     

Interpretation of heavy metal data from mussel by use of multivariate classification techniques

Different strategies of multivariate analysis of metals concentrations (Mn, Fe, Ni, V, Co, Cu, Cd, Hg, Pb, Na, K) in mussel samples from different spanish markets are used to interpret a data base and identify differences between species and origin of the samples. Principal Component Analysis and Potential curves are applied to properly classify unknown samples from representative mussels samples (Mytilus edulis and Perna canaliculus). Also, Principal Components Analysis is used as display method to visualize the relation between the variables and objects of interest.     

Anaerobic incorporation of the radiolabeled explosive TNT and metabolites into the organic soil matrix of contaminated soil after different treatment procedures

Four bioreactor designs were performed to evaluate the level of incorporation of 14C-labeled 2,4,6-trinitrotoluene (TNT) and metabolites into the organic soil matrix of different anaerobically treated contaminated soils. The contaminated soils were amended with molasses slivers (80:20% per weight) as auxiliary substrate to enhance microbial activity. After 5 weeks (bioreactors 1 and 2), 8 weeks (bioreactor 3) and 12 weeks (bioreactor 4) of anaerobic incubation, we determined 41%, 58%, 72%, and 54%, respectively, of the initially applied radioactivity immobilized in various soil fractions. After alkaline hydrolyses of the solvent-extracted soils, low quantities of radiolabel were found in the humic and fulvic acid fractions, whereas the bulk of 14C activity was found to be strongly bound to the humin fraction (solid soil residues). The amounts of solvent extractable radioactivity were 53%, 40%, 16%, and 29% for bioreactors 1, 2, 3, and 4, respectively. The level of TNT transformation at the end of the experiments was within 90-94%. Regarding the results presented in this study, we can assume that there is the possibility of high incorporation levels of TNT metabolites into the soil organic matrix mediated by microbial cometabolism under strictly anoxic conditions.     

Determination of organochlorine and organophosphate pesticide residues in fruits, vegetables and sediments.

A method is described for the determination of organochlorine and organophosphate pesticide residues in fruits, vegetables and sediments. The concentrated solvent extract was sealed in a polymeric membrane tube, dialysed in cyclohexane and the solvent replaced with hexane. The organophosphates were analysed on a specific thermionic detector without further clean-up. For the organochlorine pesticides the extract was eluted through 3 g of alumina and analysed on GC/ECD. The clean-up for sediment extract was carried out on a 10 g alumina column with 100 mL hexane containing 5% acetone and the eluate was concentrated to 5 mL. The detection limit for organophosphates on a 40 g sample and a final volume of 10 mL was on the average 0.01 mg/kg. The detection limit for organochlorine pesticides, with the final volume of 25 mL, was 0.005 mg/kg for all pesticides except for p,p'-DDT and endosulfan sulphate, which was 0.01 mg/kg. The detection limit for organochlorine pesticides in sediment, with the final volume of 2 mL, was less than 1 microgram/kg and for organophosphate pesticides less than 10 micrograms/kg when the final volume was made to 0.5 mL. At the detection limits the method produced a very high coefficient of variation for both organochlorine and organophosphate pesticides.     

Distribution in Portugal of some pollutants in the lichen Parmelia sulcata

During the months of July and August 1993 a lichen (Parmelia sulcata Taylor) collection campaign was held in Portugal where samples were obtained from olive tree bark at 228 sites, following a grid of 10 x 10 km along the Atlantic coast and 50 x 50 km in the interior of the country. The samples were analysed by instrumental neutron activation analysis and proton induced X-ray emission techniques. Concentration data patterns for the pollutants As, Cr, Hg, Ni, Pb, S, Sb, Se, and V were obtained for the whole country surface by making use of an extinction rule of 1/r(3), preventing any cut-off distance from being artificially introduced. Some pollution sources were identified: (1) oil-powered plants on the Lisbon-Setúbal axis (V, Ni), (2) coal-power plants in Porto and Sines (S, Se), (3) traffic in the northern area and the Lisbon-Setúbal axis (Pb), (4) a chemical industry south of Porto (Hg, As), and (5) soil influence (Cr, Sb). Arsenic and chromium results largely exceed, in a few areas, the concentrations acceptable to plants, and in a few spots also Hg, Ni, and Pb data.