Analysis of PM10, PM2.5, and PM2 5-10 concentrations in Santiago, Chile, from 1989 to 2001

Daily particle samples were collected in Santiago, Chile, at four urban locations from January 1, 1989, through December 31, 2001. Both fine PM with da < 2.5 microm (PM2.5) and coarse PM with 2.5 < da < 10 microm (PM2.5-10) were collected using dichotomous samplers. The inhalable particle fraction, PM10, was determined as the sum of fine and coarse concentrations. Wind speed, temperature and relative humidity (RH) were also measured continuously. Average concentrations of PM2.5 for the 1989-2001 period ranged from 38.5 microg/m3 to 53 microg/m3. For PM2.5-10 levels ranged from 35.8-48.2 microg/m3 and for PM10 results were 74.4-101.2 microg/m3 across the four sites. Both annual and daily PM2.5 and PM10 concentration levels exceeded the U.S. National Ambient Air Quality Standards and the European Union concentration limits. Mean PM2.5 levels during the cold season (April through September) were more than twice as high as those observed in the warm season (October through March); whereas coarse particle levels were similar in both seasons. PM concentration trends were investigated using regression models, controlling for site, weekday, month, wind speed, temperature, and RH. Results showed that PM2.5 concentrations decreased substantially, 52% over the 12-year period (1989-2000), whereas PM2.5-10 concentrations increased by approximately 50% in the first 5 years and then decreased by a similar percentage over the following 7 years. These decreases were evident even after controlling for significant climatic effects. These results suggest that the pollution reduction programs developed and implemented by the Comisión Nacional del Medio Ambiente (CONAMA) have been effective in reducing particle levels in the Santiago Metropolitan region. However, particle levels remain high and it is thus imperative that efforts to improve air quality continue.     

Development and laboratory performance evaluation of a personal cascade impactor

This paper presents the design and laboratory evaluation of a personal cascade impactor. The system is compact, lightweight, and uses a single battery-operated sampling pump. It operates at a flow rate of 5 L/min and consists of four impaction stages, each equipped with slit-shaped acceleration nozzles, and a backup filter. The impactor was calibrated using polydisperse particles. The 50% cut points of the four stages were 9.6, 2.6, 1.0, and 0.5 microm, respectively. The backup filter is placed downstream of the fourth stage and is used to collect the particles with an aerodynamic diameter smaller than 0.5 microm (dp < 0.5 microm). The major feature of this novel sampler is its ability not only to fractionate the particles with an aerodynamic diameter smaller than 10 microm to the various size fractions, but also to collect them onto relatively small polyurethane foam substrates without using adhesives. Although the impaction substrates are not coated with adhesives such as grease or mineral oil, particle bounce and re-entrainment losses were found to be insignificant. Interstage losses of particles smaller than 0.5 microm were less than 10%; for fine particles, less than 5%; and for coarse particles, less than 12%. The pressure drop across the four stages and the backup filter were 0.015 kPa (0.153 cm H2O),0.025 kPa (0.255 cm H2O), 0.274 kPa (2.794 cm H2O), 0.323 kPa (3.294 cm H2O), and 0.370 kPa (3.773 cm H2O), respectively. Particles can be easily recovered from the foam substrates using aqueous extraction.     

Fluopyram removal from agricultural equipment rinsing water using HSF pilot-scale constructed wetlands

Fluopyram is a novel broad-spectrum fungicide with nematocidal activity, and as an extensively used pesticide, it could cause toxicity in nontarget organisms. The aim of this study was to explore the efficiency of five horizontal subsurface flow (HSF) constructed wetlands (CWs) to remove fluopyram from rinsing water produced during the cleaning of pesticide spraying equipment. Four CWs, namely WG-R, WG-R-P, WG-C, and WG-U, contained fine gravel as porous media. WG-R and WG-R-P were planted with Phragmites australis, WG-C with Typha latifolia, and WG-U was left unplanted. Bioaugmentation with plant growth-promoting rhizobacteria was conducted in WG-R-P unit. The fifth unit (WGZ-R) planted with Phragmites australis and contained gravel and zeolite as porous media. All of CWs were loaded on a daily basis from December 2019 to January 2021 with water fortified with fluopyram. The removal rate follows the pattern of WG-R-P (70.67%) > WGZ-R (62.06%) > WG-C (59.98%) > WG-R (36.10%) > WG-U (25.09%). The most important parameters affecting the fluopyram removal were bioaugmentation, zeolite presence in porous media, and plant species. The WG-R-P unit showed higher fluopyram removal in comparison to the WG-R (increase about 96%), the zeolite increased the fluopyram removal by 72%, and the WG-C unit showed 66% higher fluopyram removal than the WG-R unit.

     

Production of hydroxytyrosol rich extract from Olea europaea leaf with enhanced biological activity using immobilized enzyme reactors

Environmental Science and Pollution Research - As olive leaves constitute the main by-product of the olive oil industry with important environmental and economic impact, there is an increasing...