Greenhouse gas scenarios for Austria: a comparison of different approaches to emission trends

In the present paper, national and externally organized projections of greenhouse gas emissions for Austria were compared to gain insight on the underlying scenario data assumptions. National greenhouse gas emission trends extend until 2030, an assessment of European Union (EU) countries to 2050. In addition, data for 2000–2100 was extracted from the global emission database described by the Representative Concentration Pathways (RCP). By identifying trends in these projections, it was possible to produce (a) a long-term assessment of national scenarios until 2100, (b) an assessment of the ambition level toward national climate strategies, and (c) a standardized method to compare trends across countries. By extracting RCP data, Austrian’s methane, nitrous oxide, and carbon dioxide emissions up to 2100 could be projected for all sources as well as specific sectors. With respect to the RCP scenario emission data, national projections did not seem to employ the mitigation potentials available for the most stringent RCP scenario, RCP2.6. Comparing projections that supported the EU Climate Strategy 2030 with national projections revealed similar trends. Because RCP2.6 is the only scenario consistent with a 2 °C global warming target, and it is much more ambitious than any of the national or European projections, further measures will be required if Austria is to adequately contribute to this widely accepted policy goal.     

Assessment of heavy metal levels in sediment samples of Kapulukaya Dam Lake (Kirikkale) and lower catchment area

In this study, the concentrations of 13 elements (Al, Fe, Mn, Cr, Ni, Zn, Co, As, Pb, Cu, Mo, Hg, and Cd) were determined in the sediments of three different sites in the Kapulukaya Dam Lake between May 2007 and November 2008. They ranged from 1.47 to 4.64 for Al, 0.92 to 3.48 for Fe (in percent), 326.60 to 1053.00 for Mn, 98.00 to 1,116.00 for Cr, 24.70 to 127.10 for Ni, 14.80 to 124.20 for Zn, 11.0 to 43.20 for Co, 5.00 to 29.30 for Cu, 9.10 to 69.70 for As, 8.60 to 34.00 for Pb, 2.50 to 5.20 for Mo, 1.00 to 1.60 for Hg, and 0.50 to1.80 for Cd in microgram per gram dry weight sediment. The contamination degree of the sediment was assessed on the basis of enrichment factor and corresponding sediment quality guideline. The calculated enrichment factors (EF, measured metal vs. background concentrations) indicated that the effect of man-made activities on the occurrence of concentrations could be accounted for the majority of heavy metals namely Mn, As, Ni, Cu, Zn, Cr, Co, Mo, and Cd, whereas such affect was not detected for Hg and Pb. The maximum values of the EF were represented by As, minimum values by Hg at all sites. Mean EF values were 36.60 and 0.70 for As and Hg, respectively. This study has clearly assessed a certain level of heavy metal pollution in the region, based particularly on the findings from sediment.     

Effects of life‐history requirements on the distribution of a threatened reptile

Survival and reproduction are the two primary life‐history traits essential for species’ persistence; however, the environmental conditions that support each of these traits may not be the same. Despite this, reproductive requirements are seldom considered when estimating species’ potential distributions. We sought to examine potentially limiting environmental factors influencing the distribution of an oviparous reptile of conservation concern with respect to the species’ survival and reproduction and to assess the implications of the species’ predicted climatic constraints on current conservation practices. We used ecological niche modeling to predict the probability of environmental suitability for the alligator snapping turtle (Macrochelys temminckii). We built an annual climate model to examine survival and a nesting climate model to examine reproduction. We combined incubation temperature requirements, products of modeled soil temperature data, and our estimated distributions to determine whether embryonic development constrained the northern distribution of the species. Low annual precipitation constrained the western distribution of alligator snapping turtles, whereas the northern distribution was constrained by thermal requirements during embryonic development. Only a portion of the geographic range predicted to have a high probability of suitability for alligator snapping turtle survival was estimated to be capable of supporting successful embryonic development. Historic occurrence records suggest adult alligator snapping turtles can survive in regions with colder climes than those associated with consistent and successful production of offspring. Estimated egg‐incubation requirements indicated that current reintroductions at the northern edge of the species’ range are within reproductively viable environmental conditions. Our results highlight the importance of considering survival and reproduction when estimating species’ ecological niches, implicating conservation plans, and benefits of incorporating physiological data when evaluating species’ distributions.     

Treatment of Basic Red 29 dye solution using iron-aluminum electrode pairs by electrocoagulation and electro-Fenton methods

The aim of this study is the treatment of Basic Red 29 (BR29) dye solution using hybrid iron-aluminum electrodes by electrocoagulation and electro-Fenton methods. The effect of current density, initial pH, supporting electrolyte, H₂O₂, and initial dye concentration on dye removal efficiency was investigated, and the best experimental conditions were obtained. Time-coarse variation of UV-Vis spectra and toxicity and chemical oxygen demand (COD) removal were also examined at the best experimental conditions. Both systems were found very successful for the removal of BR29 dye. The removal efficiency of >95 % for BR29 dye solution was reached easily in a short time. At the best experimental conditions, for the initial BR29 concentration of 100 mg/L, >95 % BR29 dye and 71.43 % COD removal were obtained after 20 and 40 min of electrolysis, respectively. Additionally, toxicity results for electro-Fenton treatment of 100 mg/L BR29 were also very promising. According to the results obtained, although electro-Fenton is more effective, both systems can be used successfully to treat textile wastewater including dyes.     

Sex ratio estimations of loggerhead sea turtle hatchlings by histological examination and nest temperatures at Fethiye beach, Turkey

Hatchling sex ratios in the loggerhead turtle (Caretta caretta) were estimated by placing electronic temperature recorders in 21 nests at Fethiye beach during 2000–2002. Over the seasons, the mean temperature in the middle third of the incubation period ranged from 26.7 to 32.1°C, and incubation periods ranged from 49 to 67 days. Based on the mean temperatures during the middle third of the incubation period, and on histologically sexed dead hatchlings, the sex ratios of hatchlings at Fethiye beach were roughly equal, i.e. 60–65% of the hatchlings were females. This contrasts with the highly female-skewed sex ratios in loggerhead turtles elsewhere; Fethiye has a relatively high proportion of male hatchlings. For endangered sea turtles, the knowledge of hatchling sex ratios at different beaches, coupled with appropriate conservation measures, can make an important contribution to their survival.     

Real-Time PCR Detection of Norovirus in Mussels Collected from the Bosphorus in Istanbul,Turkey

Norovirus (NoV) is recognised as one of the most common causes of foodborne infections, and shellfish are a well-documented source of this virus. The presence of NoV in shellfish has not previously been investigated in Turkey, and hence the aim of this study was to determine the frequency of human NoV genogroups I and II in mussels collected from the Bosphorus, Istanbul, Turkey. A total of 320 mussels representing 110 samples originating along the Bosphorus coast were collected from fish distributors. RNA was extracted using the RNeasy Mini Kit and real-time RT–PCR performed using primers specific for NoV genogroup I and II. Amongst the 110 samples, 5 (4.5%) were found to be positive for NoV genogroup II by SYBR Green assay; no genogroup I was detected. A positive signal was obtained by SYBR Green for NoV Genogroup II in mussels collected in October, November and December 2008, and February and July 2009. Only four out of five SYBR Green positive samples could be confirmed by the use of a NoV GII probe-based real-time RT–PCR. The average count and SD of Enterobactericaeae, E. coli and sulphide reductase anaerobic bacteria in PCR positive mussels were 3.56 log ± 0.96 log, 2.32 log ± 0.77 log and 1.70 log ± 0.56 log, respectively. This study shows that NoV Genogroup II is present in mussels collected from the Bosphorus, Istanbul, and may constitute a risk to human health.     

Developing and Implementing Multiple-Use Forest Management Planning in Turkey

This paper explains briefly the conceptual framework of an ecosystem-based multiple-use forest management planning focusing on biodiversity conservation and participation. Some results from a case study were documented to realize the implementation of the concept. A strong liaison between the related institutions and major stakeholders and the effective use of Geographic Information System (GIS) and Remote Sensing (RS) are necessary. Effective participation is evident only with the involvement of enthusiastic and skillful stakeholders. A case study of ??neada, Turkey, supported the idea that participation as communication has better possibilities to promote multiple-use forest management than participation as information gathering. Primary challenges relate to the effectiveness of conservation program, availability of coherent biodiversity data, capacity building; awareness, training, and common understanding of biodiversity and protected area concept; coordination among the related institutions and stakeholders; and willingness and enthusiasm of authorities to accept and implement the concept.     

A comparative study for the sorption of Cd(II) by K-feldspar and sepiolite as soil components, and the recovery of Cd(II) using rhamnolipid biosurfactant

This study investigated the sorption characteristics and recovery of selected heavy metal Cd(II) from K-feldspar and sepiolite, representative soil components, using rhamnolipid biosurfactant. Although the proposed technique was classified as a soil bioremediation process, it can also be applied to treatment of waste waters containing Cd(II) ions with minor modifications. The effect of initial Cd(II) concentration on sorption capacity was characterized by determining the sorption isotherms. Of the four models examined, the Freundlich model showed the best fit for the sorption of Cd(II) on K-feldspar, whereas the Langmuir-model was used successfully to characterize the sorption of Cd(II) on sepiolite. Although a high Cd(II) uptake of 7.49 mmol/kg by K-feldspar was obtained, sepiolite was a superior Cd(II) accumulater, with a maximum Cd(II) uptake of 24.66 mmol Cd(II)/kg. The presence of Cd(II) in the sepiolite or K-feldspar prior to addition of the rhamnolipid generally resulted in less rhamnolipid sorption to sepiolite or K-feldspar. The maximum Cd(II) desorption efficiency by rhamnolipid from K-feldspar was substantially higher than that of sepiolite and determined to be 96% of the sorbed Cd(II), whereas only 10.1% of the sorbed Cd(II) from sepiolite was recovered by rhamnolipid solution.     

Kinetic of carbonaceous substrate in an upflow anaerobic sludge sludge blanket (UASB) reactor treating 2,4 dichlorophenol (2,4 DCP)

The performance of an upflow anaerobic sludge blanket (UASB) reactor treating 2,4 dichlorophenol (2,4 DCP) was evaluated at different hydraulic retention times (HRTs) using synthetic wastewater in order to obtain the growth substrate (glucose-COD) and 2,4 DCP removal kinetics. Treatment efficiencies of the UASB reactor were investigated at different hydraulic retention times (2-20 h) corresponding to a food to mass (F/M) ratio of 1.2-1.92 g-COD g(-1) VSS day(-1). A total of 65-83% COD removal efficiencies were obtained at HRTs of 2-20 h. In all, 83% and 99% 2,4 DCP removals were achieved at the same HRTs in the UASB reactor. Conventional Monod, Grau Second-order and Modified Stover-Kincannon models were applied to determine the substrate removal kinetics of the UASB reactor. The experimental data obtained from the kinetic models showed that the Monod kinetic model is more appropriate for correlating the substrate removals compared to the other models for the UASB reactor. The maximum specific substrate utilization rate (k) (mg-COD mg(-1) SS day(-1)), half-velocity concentration (K(s)) (mg COD l(-1)), growth yield coefficient (Y) (mg mg(-1)) and bacterial decay coefficient (b) (day(-1)) were 0.954 mg-COD mg(-1) SS day(-1), 560.29 mg-COD l(-1), 0.78 mg-SS g(-1)-COD, 0.093 day(-1) in the Conventional Monod kinetic model. The second-order kinetic coefficient (k(2)) was calculated as 0.26 day(-1) in the Grau reaction kinetic model. The maximum COD removal rate constant (U(max)) and saturation value (K(B)) were calculated as 7.502 mg CODl(-1)day(-1) and 34.56 mg l(-1)day(-1) in the Modified Stover-Kincannon Model. The (k)(mg-2,4 DCP mg(-1) SS day(-1)), (K(s)) (mg 2,4 DCPl(-1)), (Y) (mg SS mg(-1) 2,4 DCP) and (k(d)) (day(-1)) were 0.0041 mg-2,4 DCP mg(-1) SS day(-1), 2.06 mg-COD l(-1), 0.0017 mg-SS mg(-1) 2,4 DCP and 3.1 x 10(-5) day(-1) in the Conventional Monod kinetic model for 2,4 DCP degradation. The second-order kinetic coefficient (k(2)) was calculated as 0.30 day(-1) in the Grau reaction kinetic model. The maximum 2,4 DCP removal rate constant (U(max)) and saturation value (K(B)) were calculated as 0.01 mg COD l(-1) day(-1) and 9.8 x 10(-3) mg l(-1) day(-1) in the Modified Stover-Kincannon model.