Challenges in quantifying biosphere-atmosphere exchange of nitrogen species

Recent research in nitrogen exchange with the atmosphere has separated research communities according to N form. The integrated perspective needed to quantify the net effect of N on greenhouse-gas balance is being addressed by the NitroEurope Integrated Project (NEU). Recent advances have depended on improved methodologies, while ongoing challenges include gas-aerosol interactions, organic nitrogen and N(2) fluxes. The NEU strategy applies a 3-tier Flux Network together with a Manipulation Network of global-change experiments, linked by common protocols to facilitate model application. Substantial progress has been made in modelling N fluxes, especially for N(2)O, NO and bi-directional NH(3) exchange. Landscape analysis represents an emerging challenge to address the spatial interactions between farms, fields, ecosystems, catchments and air dispersion/deposition. European up-scaling of N fluxes is highly uncertain and a key priority is for better data on agricultural practices. Finally, attention is needed to develop N flux verification procedures to assess compliance with international protocols.     

Comparison between the accumulation capacity of four lichen species transplanted to a urban site

The capacity to accumulate trace elements from the atmosphere of the lichens Hypogymnia physodes, Parmelia sulcata, Pseudevernia furfuracea and Usnea gr. hirta transplanted to an urban site of N Italy was compared. Twenty-nine elements (Al, As, Br, Ca, Cd, Ce, Cl, Co, Cr, Cs, Cu, Fe, Hg, I, K, La, Mg, Mn, Ni, Pb, Rb, Sb, Sc, Se, Sm, Th, Ti, V, Zn) were analyzed by Instrumental Neutron Activation Analysis (INAA) and Electro-Thermal Atomic Absorption Spectroscopy (ET-AAS). The ratio between the concentrations of each element in exposed samples to that of control samples (exposed-to-control ratio and EC ratio) was used to investigate the accumulation rates of lichen thalli. The results showed that in general elements did not exhibit well defined trends, but rather showed fluctuations, and indicated that H. physodes, P. furfuracea and U. gr. hirta have a similar accumulation capacity, while that of P. sulcata is lower.     

Seasonal Variation of Toxic Benzene Emissions in Petroleum Refinery

Petroleum refineries are largest chemical industries that are responsible for the emission of several pollutants into the atmosphere. Benzene is among the most important air pollutants that are emitted by petroleum refineries, since they are involved in almost every refinery process. Volatile organic compounds (VOCs) are a major group of air pollutants, which play a critical role in atmospheric chemistry. These contribute to toxic oxidants, which are harmful to ecosystem, human health and atmosphere. The variability of pollutants is an important factor in determining human exposure to these chemicals. The ambient air concentrations of benzene were measured in several sites around the Digboi petroleum refinery, near the city of Gowahati in northeast India, during winter and summer 2004. The seasonal and spatial variations of the ambient air concentrations of this benzene were investigated and analyzed. An estimation of the contribution of the refinery to the measured atmospheric levels of benzene was also performed. The ambient air mixing ratios of benzene in a large area outside the refinery was generally low, in ppbv range, much lower than the ambient air quality standards. This article presents the temporal and spatial variation of air pollution in and around petroleum refinery and showed that no health risk due to benzene is present in the areas adjacent to the refinery.     

Investigation of heavy metal contaminations in the lower Sakarya river water and sediments

In this work, water and sediment samples were collected from three different stations located along the Sakarya river between May and September 2003. Lead, copper, chromium, zinc, nickel and cadmium concentrations were determined by using solvent extraction and flame atomic absorption spectrometric method. The results show that differences based upon sampling times, regions, sediment and water samples were observed. The mean levels of copper, nickel, chromium, lead, cadmium, zinc for sediment samples are; 4.630 μg g⁻¹, 13.520 μg g⁻¹, 8.780 μg g⁻¹, 2.550 μg g⁻¹, 9.990 μg g⁻¹ and for water samples are; 0.851 μg g⁻¹, 1.050 μg g⁻¹, 0.027 μg g⁻¹, 1.786 μg g⁻¹, 0.236 μg g⁻¹, 0.173 μg g⁻¹, respectively.     

Using Lichen Chemistry to Assess Airborne Tungsten and Cobalt in Fallon, Nevada

This paper describes the use of lichen chemistry to assess airborne tungsten and cobalt in Fallon, Nevada, where a cluster of childhood leukemia has been on going since 1997. Lichens and their rock substrates were collected from Rattlesnake Hill within Fallon as well as from four different rock outcrops located north, east, south, and west of Fallon and at least 20 km away from the town center. In the lichens themselves, W and Co are significantly higher within Fallon than in the combined control site outside of Fallon. In the rock substrates of the lichens, no differences exist in W and Co. The W and Co differences in lichens cannot be attributed to substrate geochemistry. Fallon is distinctive in west central Nevada for high airborne W and Co, and given its cluster of childhood leukemia, it stands to reason that additional biomedical research is in order to test directly the leukogenicity of combined airborne W and Co.     

Estimated Variability of National Atmospheric Deposition Program/Mercury Deposition Network Measurements Using Collocated Samplers

The National Atmospheric Deposition Program/Mercury Deposition Network (MDN) provides long-term, quality-assured records of mercury in wet deposition in the USA and Canada. Interpretation of spatial and temporal trends in the MDN data requires quantification of the variability of the MDN measurements. Variability is quantified for MDN data from collocated samplers at MDN sites in two states, one in Illinois and one in Washington. Median absolute differences in the collocated sampler data for total mercury concentration are approximately 11% of the median mercury concentration for all valid 1999–2004 MDN data. Median absolute differences are between 3.0% and 14% of the median MDN value for collector catch (sample volume) and between 6.0% and 15% of the median MDN value for mercury wet deposition. The overall measurement errors are sufficiently low to resolve between NADP/MDN measurements by ±2 ng·l⁻¹ and ±2 μg·m⁻²·year⁻¹, which are the contour intervals used to display the data on NADP isopleths maps for concentration and deposition, respectively.     

A near real-time system for continuously monitoring airborne subtilisin-type enzymes in the industrial atmosphere

We describe the development and validation of a portable system comprising an air sampler coupled to an automated flow injection analysis device. The system is able to monitor airborne concentrations of subtilisin-type enzymes in the workplace atmosphere on a continuous basis. Sampling is in two stages: using a sampling head that is designed to mimic human respiration at approx. 1 m s(-1) at a sampling rate of 600 l min(-1). In the second stage, the captured particles are deposited by impaction from the air stream onto the inner surface of a cyclone that is continuously washed with a jet of buffer solution. Deposited particles are then washed into a reservoir from which samples are taken every 5-6 min and injected automatically into a continuous flow injection analysis system. Proteolytic enzyme in the sample passes through a bioreactor maintained at about 40 degrees C. This contains a cellulose solid phase matrix on which is covalently immobilised Texas Red-labelled gelatin as substrate. The passing enzyme partially digests the substrate releasing fluorophore that is detected down stream in a flow cell coupled to a fluorimeter. The system is calibrated using enzyme standards and the intensity of the resulting peaks from the ex-air samples is converted to airborne concentrations using a mathematical model programmed into a PC. The system has a limit of detection of 4.8 ng m(-3) and a dynamic range of 5-60 ng m(-3). The within assay precision (RSD) is 6.3-9.6% over this range. The within batch precision is 20.3% at 20 ng m(-3) and the corresponding between batch value is 19.5%. The system has been run for periods up to 8 h in the laboratory and for up to 4 h at a factory site and the values obtained compared with time-averaged values obtained from a conventional Galley sampler and in-house analysis when reasonable agreement of the results was observed. The stability of the system over 21 days of continuous use with standards injected periodically was studied. Linearity was observed for all the standard plots throughout. At the end of 21 days, after a total exposure equivalent to 2395 ng ml(-1) of Savinase, the signal due to the 5.0 ng ml(-1) standard was still easily detectable.     

Growth performance and biochemical responses of three rice (Oryza sativa L.) cultivars grown in fly-ash amended soil

The disposal of fly-ash (FA) from coal-fired power stations causes significant economic and environmental problems. Use of such contaminated sites for crop production and use of contaminated water for irrigation not only decreases crop productivity but also poses health hazards to humans due to accumulation of toxic metals in edible grains. In the present investigation, three rice cultivars viz., Saryu-52, Sabha-5204, and Pant-4 were grown in garden soil (GS, control) and various amendments (10%, 25%, 50%, 75% and 100%) of FA for a period of 90 days and effect on growth and productivity of plant was evaluated vis-a-vis metal accumulation in the plants. The toxicity of FA at higher concentration (50%) was reflected by the reduction in photosynthetic pigments, protein and growth parameters viz., plant height, root biomass, number of tillers, grain and straw weight. However, at lower concentrations (10-25%), FA enhanced growth of the plants as evident by the increase of studied growth parameters. The cysteine and non-protein thiol (NP-SH) content showed increase in their levels up to 100% FA as compared to control, however, maximum content was found at 25% FA in Saryu-52 and Pant-4 and at 50% FA in Sabha-5204. Accumulation of Fe, Si, Cu, Zn, Mn, Ni, Cd and As was investigated in roots, leaves and seeds of the plants. Fe accumulation was maximum in all the parts of plant followed by Si and both showed more translocation to leaves while Mn, Zn, Cu, Ni and Cd showed lower accumulation and most of the metal was confined to roots in all the three cultivars. As was accumulated only in leaves and was not found to be in detectable levels in roots and seeds. The metal accumulation order in three rice cultivars was Fe > Si > Mn > Zn > Ni > Cu > Cd > As in all the plant parts. The results showed that rice varieties Saryu-52 and Sabha-5204 were more tolerant and could show improved growth and yield in lower FA application doses as compared to Pant-4. Thus, Sabha-5204 and Saryu-52 are found suitable for cultivation in FA amended agricultural soils for better crop yields.     

Removal of added nitrate in the single, binary, and ternary systems of cotton burr compost, zerovalent iron, and sediment: Implications for groundwater nitrate remediation using permeable reactive barriers

Recent research has shown that carbonaceous solid materials and zerovalent iron (Fe(0)) may potentially be used as media in permeable reactive barriers (PRBs) to degrade groundwater nitrate via heterotrophic denitrification in the solid carbon system, and via abiotic reduction and autotrophic denitrification in the Fe(0) system. Questions arise as whether the more expensive Fe(0) is more effective than the less expensive carbonaceous solid materials for groundwater nitrate remediation, and whether there is any synergistic effect of mixing the two different types of materials. We carried out batch tests to study the nature and rates of removal of added nitrate in the suspensions of single, binary, and ternary systems of cotton burr compost, Peerless Fe(0), and a sediment low in organic carbon. Cotton burr compost acted as both organic carbon source and supporting material for the growth of indigenous denitrifiers. Batch tests showed that cotton burr compost alone removed added nitrate at a greater rate than did Peerless Fe(0) alone on an equal mass basis with a pseudo-first-order rate constant k=0.0830+/-0.0031 h(-1) for cotton burr compost and a k=0.00223+/-0.00022 h(-1) for Peerless Fe(0); cotton burr compost also removed added nitrate at a faster rate than did cotton burr compost mixed with Peerless Fe(0) and/or the sediment. Furthermore, there was no substantial accumulation of ammonium ions in the cotton burr compost system, in contrast to the systems containing Peerless Fe(0) in which ammonium ions persisted as major products of nitrate reduction. It is concluded that cotton burr compost alone may be used as an excellent denitrification medium in a PRB for groundwater nitrate removal. Further study is needed to evaluate performance of its field applications.     

Sorption of organic contaminants by biopolymers: role of polarity, structure and domain spatial arrangement

Sorption behavior of hydrophobic organic contaminants (HOCs) (i.e., pyrene, phenanthrene and naphthalene) by native and chemically modified biopolymers (lignin, chitin and cellulose) was examined. Lignins (native and treated) showed nonlinear sorption for all compounds studied, emphasizing their glassy character. Chitins and celluloses had linear isotherms for phenanthrene and naphthalene, illustrating the dominance of partitioning, while pyrene yielded nonlinear isotherms. Sorption capacity (K(oc)) of HOCs was negatively correlated with the polarity [(O+N)/C] of the biopolymers. Aromatic and alkyl+aromatic C percentages, rather than alkyl C content, demonstrated a better correlation with K(oc) values, indicating the importance of aromatic structures for HOC affinity. Hydrophobicity (K(ow))-normalized K(oc) values decreased sharply with increasing percentage of O-alkyl C versus total aliphatic C (O-alkyl C/total aliphatic C) or with polar C/(alkyl+aromatic C) ratio of the biopolymers until their values reached 80% and 4, respectively, illustrating the effect of surrounding polar groups on reducing affinity for HOCs. Overall, the results of this study highlight the role of spatial arrangement of domains within biopolymers in sorption of HOCs, and point to sorbent properties, such as functionality, polarity and structure, jointly regulating the sorption of HOCs in biopolymers.