NUTRIENT LOAD CHARACTERIZATION FROM INTEGRATED SOURCE DATA FOR THE LOWER MISSISSIPPI RWER1

ABSTRACT: Nutrient data from all available sources for the lower Mississippi River were examined for potential differences among sampling agencies and geographic locations for the period between 1960 and 1998. Monthly means grouped by parameter, sampling location and agency, were calculated and compared as paired sets, excluding those months where data were not available for both sets. Some significant differences were found between various agencies collecting nutrient data on the river, as well as between various stretches of river, especially in the case of phosphorus nutrient data. Results were used to synthesize data sets from which a history of nutrient loading in the Mississippi River was determined. General trends in nitrate+nitrite, total Kjeldahl nitrogen, orthophosphate, total phosphorus and silica loads, as well as changes in nutrient proportions and the specific limiting nutrient (by month) are reported. This study provides a useful summary of contemporary and historical nutrient data that may assist in the evaluation of Mississippi River water quality and its potential effect on the Gulf of Mexico.     

Sources of polycyclic aromatic hydrocarbons (PAHs) in sediments of the Biobio River in south central Chile

Polycyclic aromatic hydrocarbons (PAHs) are ubiquitous in the environment; there are concerns about them due to their toxic properties. Human activities could significantly contribute to the total PAH burden in river sediments. In this work, we document the analysis of PAHs in sediments taken in the middle stretch of the Biobio River in south central Chile. This river is a principal system, draining more than 24,000 km² and subjected to a diverse variety of human-made stressors (pulp mill and urban effluents, agricultural drainage systems, etc). During 2003, several sediment samples were taken in more than 45 sampling sites located in the river’s middle stretch. Due to the granulometric characteristics (mainly sandy sediments), only 17 samples were analyzed, taking into consideration the presence of a fine section within the sediment sample. Using HPLC with fluorescence detection, 15 EPA priority PAHs and perylene were analyzed. The composition of PAHs in the sediment samples is rather similar between sites and levels averaged 104 ± 78 ng g⁻¹ d.w. The highest levels were detected downstream from an industrial discharge. A good correlation was observed between PAH levels and organic carbon content in the tested sediments; however, concentrations above 134 ng g⁻¹ d.w. did not indicate correlation. The samples PAH ratios (Flu/Pyr and Chr/B(a)A) reveal a strong pyrolytic PAH pattern in the sediments tested, supporting evidence indicating that PAHs come mainly from pyrolytic sources. This result contrasts with previous records that have shown a natural influence in the upper basin and a petrogenic pattern near the mouth.     

Interpretation of analytical data on n-alkanes and polynuclear aromatic hydrocarbons in Arbacia lixula from the coasts of Tenerife (Canary Islands, Spain) by multivariate data analysis

The hydrocarbons contents (n-alkanes, polycyclic aromatic hydrocarbons) were determined in the sea urchin Arbacia lixula. Multivariate data analysis as principal component analysis, factor analysis and, cluster analysis were applied to elucidate sources of pollution. PCA and FA were performed to establish the relationships between variables (hydrocarbons), samples (sea urchin) and sources of pollution.     

Environmental impact of unleaded gasolines in the bay of Cádiz (Spain)

Given the strategic situation of the José León de Carranza bridge, which spans the Bay of Cádiz (in the SW of Spain) and carries very heavy motor traffic, together with knowledge of the currents and tidal flows in the zone, we have used a technique of radioactive dating of sediments to study the temporal evolution presented by contamination from lead in the sediment column. This has allowed us to observe the environmental impact, in terms of the concentration of Pb in the sea bed sediments, that has been produced in the zone by the introduction of unleaded gasolines as substitutes for traditional automobile fuels that employ organic forms of tetra methyl lead as an antidetonant agent in the fuel.     

Uranium-238 and thorium-232 series concentrations in soil, radon-222 indoor and drinking water concentrations and dose assessment in the city of Aldama, Chihuahua, Mexico

High-resolution gamma spectrometry was used to determine the concentration of 40K, 238U and 232Th series in soil samples taken from areas surrounding the city of Aldama, in Chihuahua. Results of indoor air short-time sampling, with diffusion barrier charcoal detectors, revealed relatively high indoor radon levels, ranging from 29 to 422 Bq/m3; the radon concentrations detected exceeded 148 Bq/m3 in 76% of the homes tested. Additionally, liquid scintillation counting showed concentrations of radon in drinking water ranging from 4.3 to 42 kBq/m3. The high activity of 238U in soil found in some places may be a result of the uranium milling process performed 20 years ago in the area. High radon concentrations indoor and in water may be explained by assuming the presence of uranium-bearing rocks underneath of the city, similar to a felsic dike located near Aldama. The estimated annual effective dose of gamma radiation from the soil and radon inhalation was 3.83 mSv.     

Stabilization/solidification of ashes in clays used in the manufacturing of ceramic bricks.

This paper presents the results of the lixiviation of metals from different mixtures of fly and bottom ashes that have been stabilized and solidified in clays used in the manufacture of bricks. The ashes used for this study were obtained from a Hoffmann-type brick furnace adapted for the incineration of municipal solid waste during the manufacturing of ceramic bricks. The ashes were stabilized in clay in different proportions of clay:ash mix (99:1, 95:5, 90:10, 80:20 and 60:40). Such mixes were used to manufacture bricks that were calcined at a temperature ranging from 50 to 1100 degrees C. The clay, ashes and manufactured bricks were characterized using X-ray diffraction, fluorescent X-ray, thermogravimetry, differential thermal analysis, atomic absorption spectroscopy and scanning electronic microscopy. In addition, toxicity characteristic leaching procedure lixiviation tests were performed according to the EPA 1311 method for the determination of heavy metals. The results showed an affinity between clay and ash, and also that the bricks manufactured with these mixtures present low lixiviation levels. The tests also showed the highest decrease in the concentration of arsenic, nickel, chromium, zinc and silver for 99:1 mixtures. The 95:5 mixture was found to be the most favourable for the stabilization (greater concentration decrease) of lead and cadmium. Selenium was the metal with the lowest concentration change whereas arsenic, nickel, chromium, zinc and cadmium showed the greatest concentration change in all mixtures, with the exception of cadmium in the mixture 99:1.