Leachability of automotive shredder residues burned in a fluidized bed system

This paper presents the results of the study of a combustible fraction of automotive shredder residues (CASRs) and the corresponding ashes generated by combustion on a fluidized bed pilot with the aim to understand the influence of thermal treatment regarding properties for final disposal, such as landfilling. The chemical composition was evaluated and the leachability behaviour of ashes and CASR was investigated using the three more commonly used tests: the European Standard EN 12457, the US TCLP-EPA 1311 and the Dutch availability test EA NEN 7371. Different results were obtained depending on the specific conditions of the methods employed. It was found that both the CASR and the ashes contained large amounts of toxic metals and other undesirable elements, such as Cl and S. For the CASR, in addition to the leachability of organic matter above the limit set for hazardous materials, the release of heavy metals, either under alkaline and acidic conditions was significant, revealing the serious risks associated to the landfilling practices still being undertaken worldwide. Release of organic matter from ashes was insignificant, but solubility of sulphates increased and chlorides exceed the hazardous limits in the case of fly ashes. Toxic metals were found to leach from the ashes only under acidic conditions, except Pb and Cu which also leached from finer ashes at alkaline pH. Cr also leached from ashes at alkaline pH values. Both the Dutch availability and TCLP revealed much higher leaching intensities than the European Standard due to the acidity of leachants. However, it was found that ashes may be more resistant to acidification because they exhibit much higher acid neutralization capacity (ANC) than the untreated CASR. The study undertaken shows that thermal valorisation of the combustible fraction of ASR may avoid the risks associated with their landfilling; however, care has to be taken with the ashes because they also behave as hazardous residues. Although, the mass reduction provided by thermal treatment may make landfilling less expensive, a more profitable reutilization of the ashes should be developed.     

A net water production model for ultrafiltration including flow direction reversal and chemically assisted backwashing.

Flow direction reversal (FDR) was proposed as a novel method to increase net water production (NWP) during cross-flow ultrafiltration. The design of the pilot-plant study allowed measurement of specific flux recovery after each chemically assisted backwash (BW) combined with FDR and after each FDR at the midpoint of each BW/FDR cycle. The percent recovery of specific flux was higher following FDR (55%) than combined BW and FDR (53%) at lower chemical dosages; however, the percent increase in specific flux recovery by FDR was much lower (20%) when the chemical dose was doubled. A mathematical model was developed to predict the NWP achieved by any combination ofBW/ FDR and FDR frequency. For example, the advantage of introducing FDR was demonstrated at the lower chlorine dose, whereby the percent increase in NWP by alternating 15-minute intervals of BW/FDR with FDR over BW/ FDR alone was 10% for 30-minute BW/FDR intervals and 2% for 15-minute BW/FDR intervals.     

Microbial fuel cell-induced production of fungal laccase to degrade the anthraquinone dye Remazol Brilliant Blue R

Environmental Chemistry Letters - The anthraquinone dye Remazol Brilliant Blue R is largely used in the textile industry. However, its removal from wastewaters is costly and complex. Many methods...     

Monitoring and modeling of long-term settlements of an experimental landfill in Brazil

Settlement evaluation in sanitary landfills is a complex process, due to the waste heterogeneity, time-varying properties and influencing factors and mechanisms, such as mechanical compression due to load application and creep, and physical–chemical and biological processes caused by the wastes decomposition. Many empirical models for the analysis of long-term settlement in landfills are reported in the literature. This paper presents the results of a settlement monitoring program carried out during 6 years in Belo Horizonte experimental landfill. Different sets of field data were used to calibrate three long-term settlement prediction models (rheological, hyperbolic and composite). The parameters obtained in the calibration were used to predict the settlements and to compare with actual field data. During the monitoring period of 6 years, significant vertical strains were observed (of up to 31%) in relation to the initial height of the experimental landfill. The results for the long-term settlement prediction obtained by the hyperbolic and rheological models significantly underestimate the settlements, regardless the period of data used in the calibration. The best fits were obtained with the composite model, except when 1 year field data were used in the calibration. The results of the composite model indicate settlements stabilization at larger times and with larger final settlements when compared to the hyperbolic and rheological models.     

Study on the mechanical and environmental properties of concrete containing cathode ray tube glass aggregate

Cathode ray tube (CRT) glass is considered a hazardous material due to its lead toxicity. In addition, current disposal practices are being phased out due to their adverse environmental impacts. In this project, CRT glass was used as a fine aggregate replacement in concrete. Life-cycle material characterization was conducted by evaluating the durability and strength of the CRT-Concrete. Leaching tests were also conducted to investigate whether the material meets drinking water limits for Pb. Test results show that the plastic state of the CRT-Concrete was affected by the angularity of the glass particles. Moreover, the compressive strength of CRT-Concrete met and exceeded that of the control specimen. However, CRT-Concrete was susceptible to expansive alkali-silica reactions when more than 10% CRT replacement was used. Environmental leaching results show that lead concentrations from CRT-Concrete are below the drinking water limits depending on the CRT volume replacement and if biopolymers are used.     

Distribution coefficients of potentially toxic elements in soils from the eastern Amazon

The solid-solution distribution or partition coefficient (Kd) is a measure of affinity of potentially toxic elements (PTE) for soil colloids. Kd plays a key role in several models for defining PTE guideline values in soils and for assessing environmental risks, and its value depends on edaphic and climatic conditions of the sites where the soils occur. This study quantified Kd values for Cd, Co, Cr, Cu, Hg, Ni, Pb, and Zn from representative soil samples from Brazil’s eastern Amazon region, which measures 1.2 million km². The Kd values obtained were lower than those set by both international and Brazilian environmental agencies and were correlated with the pH, Fe and Mn oxide content, and cationic exchange capacity of the soils. The following order of decreasing affinity was observed: Pb?>?Cu?>?Hg?>?Cr?>?Cd?≈?Co?>?Ni?>?Zn.     

Catalytic combustion of soot over ceria-zinc mixed oxides catalysts supported onto cordierite

Modified substrates as outer heterogeneous catalysts was employed to reduce the soot generated from incomplete combustion of diesel or diesel/biodiesel blends, a process that harms the environment and public health. The unique storage properties of ceria(CeO2) makes it one of the most efficient catalysts available to date. Here, we proposed that ceria-based catalysts can lower the temperature at which soot combustion occurs; more specifically, from 610℃ to values included in the diesel exhausts operation range(300–450℃). The sol-gel method was used to synthesize mixed oxide-based catalysts(CeO2:ZnO); the resulting catalysts were deposited onto cordierite substrates. In addition, the morphological and structural properties of the material were evaluated by XRD, BET, TPR-H2, and SEM. Thermogravimetric(TG/DTA) analysis revealed that the presence of the catalyst decreased the soot combustion temperature by 200℃ on average, indicating that the oxygen species arise at low temperatures in this situation, promoting highly reactive oxidation reactions. Comparative analysis of soot emission by diffuse reflectance spectroscopy(DRS) showed that catalyst-impregnated cordierite samples efficiently oxidized soot in a diesel/biodiesel stationary motor: soot emission decreased by more than 70%.     

Degradation and decolorization of a biodegradable-resistant polymeric dye by chelator-mediated Fenton reactions

Chelator-mediated Fenton reactions (CMFRs) were used to decolorize a biodegradable-resistant polymeric dye (Poly R-478). Screening of different iron chelators was performed on Fe(3+)-reduction activity. All chelators showed Fe(3+)-reduction activity over a wide range of pH (2-7) and each mol of catecholate chelators (3,4-dihydroxiphenilacetic acid--DOPAC and 2,3-dihydroxibenzoic acid--DHBA) reduced about 5-6 moles of Fe(3+) whereas hydroxamate chelators (acetohydroxamic acid-AHA and desferrioxamine B-DFB) reduced Fe(3+) stoichiometrically. The most effective decolorization of Poly R-478 was achieved by CMFR using catecholate chelators. In addition, a 2(4) factorial design was performed with the aim of evaluating the effects of the variables considered in this study (pH, [DOPAC], [Fe(3+)] and [H(2)O(2)]) and optimizing the dye decolorization, using response surface methodology. Statistical analysis of results showed that, in the range studied, except for Fe(3+), all variables have a significant effect on dye decolorization. A second-order model is proposed to represent the Poly R-478 decolorization. At optimum conditions, complete decolorization of the dye (degradation of the chromophoric group) and also complete chemical degradation of the dye was observed.     

Comparison of European national legislation efficiency on the reduction of air pollutant emissions

Since 1995, the Institute for Environment and Development in Portugal has obtained >300 stack samples from various point sources of Portuguese industries. A coherent database was made with the collected results. The limit values fixed by several European legal documents consulted, Portuguese, Spanish, French, Italian, and Dutch emission legislation, were applied to the Institute for Environment and Development stack sampling inventory (from 1995 to 2000) to evaluate the efficiency of these standards in promoting the control and reduction of atmospheric pollutants emissions, especially regarding nitrogen oxides, sulfur dioxide, and particulate matter. The conclusion was that the original Portuguese legislation was not restrictive enough and not very efficient regarding emissions reduction. In contrast, the Dutch and Italian legislations are quite restrictive but very efficient concerning emission control for the three pollutants analyzed. One of the outcomes of this study was the publication of a new law in Portugal regulating the emissions of atmospheric pollutants. The strategy of this emissions control law follows the conclusions found in this study including the concept of a mass flow threshold and different approaches depending on source dimension.