Grain size partitioning of platinum-group elements in road-deposited sediments: implications for anthropogenic flux estimates from autocatalysts

Twelve road-deposited sediment samples were analyzed for platinum-group elements (PGEs) and Pb in the <63 microm fraction of an urban watershed in Hawaii. Three samples were further fractionated into five size classes, from 63-125 microm to 1000-2000 microm, and these were analyzed for PGEs and Pb. Concentrations in the <63 microm fraction reached 174 microg/kg (Pt), 101 microg/kg (Pd), 16 microg/kg (Rh), and 1.3 microg/kg (Ir). Enrichment ratios followed the sequence Rh>Pt=Pd>Ir. Iridium was geogenic in origin, while the remaining PGEs indicated significant anthropogenic contamination. Palladium, Pt and Rh concentrations and enrichment signals were consistent with PGE bivariate ratios and PGE partitioning in three-way catalysts. Size partitioning indicated that the <63 microm fraction had the lowest PGE concentrations and mass loading percentages. These data suggest that autocatalyst PGE flux estimates into the environment will be significantly underestimated if only a fine grain size fraction is analyzed.     

A Simple Technique for Stack Design in Complex Terrain

The main objective of this study is to apply neutral electrolyzed water (NEW) spraying to inactivate bioaerosols. We evaluated the inactivation efficiency of NEW applied to inactivate two airborne bacterial Escherichia coli and Bacillus subtilis aerosols inside an environmental-controlled chamber in the study. Generated with electrolyzing 6.15 M sodium chloride brine, the NEW with free available chlorine (FAC) concentration 50, 100, and 200 ppm was pumped with an air pressure of 70 kg/cm² through nozzle into the chamber to inactive E. coli and B. subtilis aerosols precontaminated air (initial counts of 3?×?10⁴ colony-forming units [CFU]/m³). Bacterial aerosols were collected and cultured from chamber before and after NEW spray. The air exchange rate (ACH, hr^?1) of the chamber was set to simulate fresh air ventilating dilution of indoor environment. First-order concentration decaying coefficients (Ka, min^?1) of both bacterial aerosols were measured as an index of NEW inactivation efficiency. The result shows that higher FAC concentration of NEW spray caused better inactivation efficiency. The Ka values under ACH 1.0 hr^?1 were 0.537 and 0.598 for E. coli of FAC 50 and 100 ppm spraying, respectively. The Ka values of FAC 100 ppm and 200 ppm spraying for B. subtilis were 0.063 and 0.085 under ACH 1.0 hr^?1, respectively. The results indicated that NEW spray is likely to be effective in inactivation of bacterial airborne contamination. Moreover, it is observed in the study that the increase of ventilation rate and the use of a larger orifice-size nozzle may facilitate the inactivation efficiency.

Implications: Bacterial aerosols have been implicated in deterioration of air quality and occupational health. Effective, safe, and economic control technology is highly demanded, especially for agricultural and food industries. In the study, NEW mist spraying performed effectively in controlling E. coli and B. subtilis modeling bioaerosols contamination. The NEW revealed its potential as an alternative airborne disinfectant worth being discovered for improving the environmental quality in the future.     

Microbial consortia increase thermal tolerance of corals

This study examined the response of a coral holobiont to thermal stress when the bacterial community was treated with antibiotics. Colonies of Pocillopora damicornis were exposed to broad and narrow-spectrum antibiotics targeting coral-associated α and γ-Proteobacteria. Corals were gradually heated from the control temperature of 26 to 31 °C, and measurements were made of host, zooxanthellar and microbial condition. Antibiotics artificially reduced the abundance and activity of bacteria, but had minimal effect on zooxanthellae photosynthetic efficiency or host tissue protein content. Heated corals without antibiotics showed significant declines in F _V /F _M , typical of thermal stress. However, heated corals treated with antibiotics showed severe tissue loss in addition to a decline in F _V /F _M . This study demonstrated that a disruption to the microbial consortium diminished the resilience of the holobiont. Corals exposed to antibiotics under control temperature did not bleach, suggesting that temperature may be an important factor influencing the activity, diversity and ecological function of the holobiont bacterial community.     

MODELING RUNOFF FROM VARIABLE SOURCE AREAS IN HUMID,SHALLOW WATER TABLE ENVIRONMENTS1

ABSTRACT: Variable Source Areas (VSAs) are zones with water saturated soils in forested wetlands fringing streams and creeks. Runoff from these areas is generated by saturation excess after a shallow water table rises and inundates the ground surface. In humid regions, like Florida and the Southeast, VSAs are believed to produce most of the runoff in shallow water table environments. Modeling the spatial extent and temporal fluctuation of a VSA is difficult because the formation of a VSA depends on a number of hydrological and morphological factors like rainfall intensity, soil texture, water table depth, and topographic attributes of the terrain. In this paper, we couple a digital elevation model with a two‐dimensional variable saturation model to illustrate the formation of a VSA at the hillside scale. The topography derived from the digital elevation model forms the upper domain geometry for the two‐dimensional finite element simulations of variable saturated flow. The objectives are: (1) to model the spatial and dynamic fluctuation of a VSA, and (2) to understand the roles of rainfall variability and terrain attributes on the formation of a VSA. Results show that hillsides with shallow water table depths, low saturated hydraulic conductivity, mild slopes, and concave slope curvature were more susceptible to runoff from a variable source. Runoff from a variable source showed little sensitivity to rainfall intensity. In general, landscapes with steep slopes generated a small VSA and a seepage face that vanished rapidly with time. In contrast, flat terrains are more amenable to VSA and retain ground surface inundation for longer periods of time.