Invasion costs,impacts, and human agency: response to Sagoff 2020

Article impact statement: In an era of profound biodiversity crisis, invasion costs, invader impacts, and human agency should not be dismissed.     

Physical characterization of the fine particle emissions from commercial aircraft engines during the Aircraft Particle Emissions eXperiment (APEX) 1–3

The fine particulate matter (PM) emissions from nine commercial aircraft engine models were determined by plume sampling during the three field campaigns of the Aircraft Particle Emissions Experiment (APEX). Ground-based measurements were made primarily at 30 m behind the engine for PM mass and number concentration, particle size distribution, and total volatile matter using both time-integrated and continuous sampling techniques. The experimental results showed a PM mass emission index (EI) ranging from 10 to 550 mg kg^?1 fuel depending on engine type and test parameters as well as a characteristic U-shaped curve of the mass EI with increasing fuel flow for the turbofan engines tested. Also, the Teflon filter sampling indicated that ～40–80% of the total PM mass on a test-average basis was comprised of volatile matter (sulfur and organics) for most engines sampled. The number EIs, on the other hand, varied from ～10¹⁵ to 10¹⁷ particles kg^?1 fuel with the turbofan engines exhibiting a logarithmic decay with increasing fuel flow. Finally, the particle size distributions of the emissions exhibited a single primary mode that were lognormally distributed with a minor accumulation mode also observed at higher powers for all engines tested. The geometric (number) mean particle diameter ranged from 9.4 to 37 nm and the geometric standard deviation ranged from 1.3 to 2.3 depending on engine type, fuel flow, and test conditions.     

Comparison of SOC estimates and uncertainties from aerosol chemical composition and gas phase data in Atlanta

In the Southeastern US, organic carbon (OC) comprises about 30% of the PM_2.5 mass. A large fraction of OC is estimated to be of secondary origin. Long-term estimates of SOC and uncertainties are necessary in the evaluation of air quality policy effectiveness and epidemiologic studies. Four methods to estimate secondary organic carbon (SOC) and respective uncertainties are compared utilizing PM_2.5 chemical composition and gas phase data available in Atlanta from 1999 to 2007. The elemental carbon (EC) tracer and the regression methods, which rely on the use of tracer species of primary and secondary OC formation, provided intermediate estimates of SOC as 30% of OC. The other two methods, chemical mass balance (CMB) and positive matrix factorization (PMF) solve mass balance equations to estimate primary and secondary fractions based on source profiles and statistically-derived common factors, respectively. CMB had the highest estimate of SOC (46% of OC) while PMF led to the lowest (26% of OC). The comparison of SOC uncertainties, estimated based on propagation of errors, led to the regression method having the lowest uncertainty among the four methods. We compared the estimates with the water soluble fraction of the OC, which has been suggested as a surrogate of SOC when biomass burning is negligible, and found a similar trend with SOC estimates from the regression method. The regression method also showed the strongest correlation with daily SOC estimates from CMB using molecular markers. The regression method shows advantages over the other methods in the calculation of a long-term series of SOC estimates.     

Association patterns among male and female spotted hyenas (Crocuta crocuta) reflect male mate choice

Although female animals tend to be choosier than males in selecting mates, sexual selection theory predicts that males should also be choosy when female fecundity varies. Reproductive success among female spotted hyenas varies greatly with social rank. Our goals were therefore to determine whether male hyenas preferentially associate with high-ranking females, and whether male preferences are affected by female reproductive state. Interactions between adult males and females were observed intensively, and association indices calculated for all male-female pairs, over a 7-year period in one population of free-living hyenas. Males initiated most affiliative interactions with females, and males associated most closely with females that were likeliest to be fertile. High- and middle-ranking males associated most closely with high-ranking females, but low-ranking males associated equally closely with females in all rank categories. We used molecular markers to determine the paternity of cubs born during the study period, and found that sires associated more closely with the mothers of those cubs than did non-sires, particularly during the last months before conception. These association data indicate that male spotted hyenas do indeed exhibit selective mate choice, and that they prefer females likeliest to maximize male reproductive success.     

Numerical Investigation of Boundary-Layer Evolution and Nocturnal Low-Level Jets: Local versus Non-Local PBL Schemes

Numerical simulations of the evolution of the planetary boundary layer (PBL) and nocturnal low-level jets (LLJ) have been carried out using MM5 (version 3.3) with four-dimensional data assimilation (FDDA) for a high pollution episode in the northeastern United States during July 15–20, 1999. In this paper, we assess the impact of different parameterizations on the PBL evolution with two schemes: the Blackadar PBL, a hybrid local (stable regime) and non-local (convective regime) mixing scheme; and the Gayno–Seaman PBL, a turbulent kinetic energy (TKE)-based eddy diffusion scheme. No FDDA was applied within the PBL to evaluate the ability of the two schemes to reproduce the PBL structure and its temporal variation. The restriction of the application of FDDA to the atmosphere above the PBL or the lowest 8 model levels, whichever is higher, has significantly improved the predicted strength and timing of the LLJ during the night. A systematic analysis of the PBL evolution has been performed for the primary meteorological fields (temperature, specific humidity, horizontal winds) and for the derived parameters such as the PBL height, virtual potential temperature, relative humidity, and cloud cover fraction. There are substantial differences between the PBL structures and evolutions simulated by these two different schemes. The model results were compared with independent observations (that were not used in FDDA) measured by aircraft, RASS and wind profiler, lidar, and tethered balloon platforms during the summer of 1999 as part of the NorthEast Oxidant and Particle Study (NE-OPS). The observations tend to support the non-local mixing mechanism better than the layer-to-layer eddy diffusion in the convective PBL.     

Numerical Investigation of the Effects of Boundary-Layer Evolution on the Predictions of Ozone and the Efficacy of Emission Control Options in the Northeastern United States

This paper examines the effects of two different planetary boundary-layer (PBL) parameterization schemes – Blackadar and Gayno–Seaman – on the predicted ozone (O₃) concentration fields using the MM5 (Version 3.3) meteorological model and the MODELS-3 photochemical model. The meteorological fields obtained from the two boundary-layer schemes have been used to drive the photochemical model to simulate O₃ concentrations in the northeastern United States for a three-day O₃ episodic period. In addition to large differences in the predicted O₃ levels at individual grid cells, the simulated daily maximum 1-h O₃ concentrations appear at different regions of the modeling domain in these simulations, due to the differences in the vertical exchange formulations in these two PBL schemes. Using process analysis, we compared the differences between the different simulations in terms of the relative importance of chemical and physical processes to O₃ formation and destruction over the diurnal cycle. Finally, examination of the photochemical model's response to reductions in emissions reveals that the choice of equally valid boundary-layer parameterizations can significantly influence the efficacy of emission control strategies.     

Measurement of organic contaminants and biological effects in Scottish waters between 1999 and 2005

Concentrations of organic contaminants were determined in sediment and fish collected annually at six sites around Scotland between 1999 and 2005, as part of the UK National Marine Monitoring Programme. Polycyclic aromatic hydrocarbons (PAHs) and chlorobiphenyls (CBs) were measured in sediment, while CBs and ethoxyresorufin-O-deethylase (EROD) activities were measured in the fish. Highest PAH concentrations in sediment were found at sites where higher coastal influences would be expected (e.g., Clyde and Solway) and four of the six sites gave PAH concentrations above OSPAR background assessment concentrations (BACs). A significant downward trend in the median total PAH concentrations, normalised to total organic carbon (TOC), was found at one of the six sites (Minches). The PAH profiles at all sites were consistent over the 6 year period, indicating that the sites are relatively stable and PAH sources are not changing. There was an indication of a greater petrogenic input on the west coast, with sediment from the Clyde, Solway and Minches having a greater proportion of 2- and 3-ring PAHs and a lower proportion of 5-ring PAHs. CB concentrations at all sites were low compared with UK estuarine sites and similar to sediment from more remote areas: however, BACs were exceeded. No significant trends were detected in either the sediment CB concentrations or patterns at any of the six sites. CB concentrations were significantly higher in fish liver collected from the Clyde. Concentrations at the other five sites were low, with the majority of samples having concentrations for the ICES7 CBs of <500 microg kg(-1) lipid weight. However, individual CB concentrations were still above the BACs. Hepatic EROD activities were measured in male plaice from 2002-2005 and were generally low (<10 pmol min(-1) mg protein(-1)). No temporal trends were detected in either CB concentrations or the EROD activity.     

Identifying influencing factors on paved roads silt loading

The factors that influence the increase or decrease of silt loadings on paved roadways have not been fully quantitatively investigated. They were identified in this study based on the quarterly silt loading sampling data collected from 20 sites by the Clark County Department of Air Quality and Environmental Management in Southern Nevada for the period from 2000 to 2003. The silt loading and associated data collected over these years at one sampling site may inherently possess site-specific characteristics that can be better incorporated by using panel data models. The factors that are identified as significant are the presence of curbs and gutters, shoulder type, pavement conditions, and the presence of construction activities in the vicinity of roadways. The presence of curbs and gutters, stabilized shoulders, and good pavement conditions would result in decreased silt loadings. Conversely, the presence of construction activities within the immediate vicinity of sampled areas would result in increases of silt loadings on the roadway surfaces. Based on the analysis of the results, it was recommended that constructing curbs, gutters and stabilized shoulders, preventing or reducing construction track-out from construction activity, and improving pavement conditions be the preferred control measures to reduce silt loading on paved roadways.     

Comments On “Particulate Pollutants in the Air of the United States”

This study was undertaken to identify seasonal and source effects on the par-ticulate contaminants of the New York City atmosphere and ultimately to relate the concentrations of these contaminants to the tissue concentrations in residents of New York City. Continual weekly samples of particulates have been collected at three stations in the New York area on 8 by 10 in. glass fiber filters at a flow rate of 20 cfm.

The sample is ashed with a Tracerlab Low Temperature Asher and leached with nitric acid. Metals analyzed by the Atomic Absorption method include Pb, V, Cd, Cr, Cu, Mn, Ni, and Zn. Lead-210, total particulate, and benzene and acetone soluble organic material are also determined.

The data have been related to various meteorological parameters over a one year period to define significant seasonal and source influences, as well as site to site variations. Very significant inverse correlations to temperature are obtained for suspended particulates, vanadium, and nickel at both Manhattan and Bronx sites. Particulates show a less significant inverse correlation to temperature In lower Manhattan. Oil-fired space heating sources appear to account for as much as 50% of the particulates in the Bronx at the peak demand period.

Lead, copper, and cadmium show a general inverse correlation to average wind speed, and a direct correlation to temperature. The latter is most likely due to an inverse relation between wind speed and temperature. The heating season input for particulates, vanadium, and nickel is so great as to overcome most of the dilution effect due to winds. The other elements having more constant nonseasonal inputs, definitely reflect the effects of the wind.

The most significant site effect occurs with cadmium, which has a concentration in lower Manhattan three times that of the Bronx over a period of six to seven months in the summer and fall. The differences observed for cadmium and particulates may be explained by emission source factors which have not as yet been studied.     

Effects of Design and Fuel Moisture on Incinerator Effluents

The particle and gas properties that profoundly affect design and performance of fly ash precipitators are discussed and evaluated in this section. Relation of the coal burned to these properties and to the precipitator gas cleaning problem is broadly examined. The need for a high order of technology consistently applied to cope successfully with the wide and often uncertain variations in coal and ash properties encountered in precipitation practices is emphasized.