未来气候变化对武夷山自然保护区毛竹异戊二烯排放速率的影响

采用全球气候模式Nor ESM1-M产生的RCP2.6、RCP4.5、RCP6.0和RCP8.5气候变化情景数据和植物异戊二烯排放计算模型,模拟分析了未来气候变化对武夷山自然保护区毛竹(Phyllostachys pubescens)异戊二烯排放速率的影响.结果显示,气候变化下武夷山自然保护区气温上升,年降水量和辐射强度波动较大,呈增加或下降趋势.毛竹异戊二烯平均日排放速率在未来气候变化情景下比基准情景下高约30μg·g~(-1)·d~(-1),在RCP8.5情景下比基准情景下高约48μg·g~(-1)·d~(-1);毛竹异戊二烯日排放速率在未来气候变化情景与基准情景下的差异在1~90 d和301~365 d较小,在91~300 d差异较大;相比基准情景,未来气候变化情景下毛竹异戊二烯日排放速率在1~190 d(平均增加15%以上)和271~365 d(平均增加20%)增幅较大,在191~270 d增幅较小,在RCP8.5情景下增幅最大(平均增加17%).另外,毛竹异戊二烯年排放速率在未来气候变化情景下比基准情景下约高10000μg·g~(-1)·a~(-1)以上,在RCP8.5情景下比基准情景下约高13%.研究表明,未来气候变化将使毛竹异戊二烯排放速率增加.     

表面活性剂增强修复地下水中PCE的砂箱实验及模拟

在石英砂充填的二维砂箱中开展表面活性剂（Tween 80）冲洗四氯乙烯（PCE）的修复实验,基于图像分析技术监测不同污染源区结构条件下NAPL相的去除过程.由于实验条件限制,实验中缺乏溶解相浓度数据.为此进一步基于UTCHEM数值模拟方法来理解NAPL相和溶解态之间的质量传输过程,并探讨表面活性剂浓度、注入速率等因素对修复效率的影响.综合砂箱实验和数值模拟结果表明：介质均质和非均质条件下会形成不同类型DNAPL污染源区结构,表现为离散状PCE与池状PCE体积比（GTP）差异.由于离散状污染物与表面活性剂的接触面积更大,更易被优先去除;初始GTP值越高,污染物的修复速率和修复效率也越高.增大表面活性剂浓度或提高表面活性剂的注入速率,虽然能提高DNAPL的修复速率,但会明显降低表面活性剂的修复效率,实验过程中修复效率降幅可达93%.线性驱动溶解模型可以有效地模拟表面活性剂修复DNAPLs过程,基于数值模拟方法选择合适的表面活性剂配比可有效的节省实际污染场址修复经费和时间成本.     

双区静电除尘器的数值模拟研究

采用数模拟的方法研究了双区静电除尘器内流场分布、颗粒荷电及颗粒运动等难以直接测量的物理过程,构建了双区静电除尘过程完整的数值模型.采用泊松方程、电流连续性方程和匀强电场方程描述电场,采用N-S方程和雷诺应力标准湍流模型描述流场,采用拉格朗日法描述颗粒运动轨迹.通过截面风速与颗粒去除率的模拟值与实验值的对比,验证了数值模型在模拟内部流场和颗粒运动时的准确性.数值模拟结果表明：双区静电除尘器内部流场分布对入口风速的变化非常敏感;颗粒荷电方式占比由颗粒粒径决定;荷电区内颗粒向极板的趋近过程由流体曳力和电场力共同完成,收尘区内的趋近过程则由电场力主导;入口流速通过改变颗粒前进速度和内部流场形态来影响颗粒运动轨迹.     

塘库沉积的137Cs法断代测定三峡库区小流域产沙量

本文以三峡库区重庆忠县黄冲子小流域和工农沟小流域为研究区域,依据塘库修建时间(1955年)、退耕还林工程启动时间(2000年)和~(137)Cs示踪技术,确定了小流域不同时期产沙量及产沙模数,并分析比较了不同小流域的塘库沉积物~(137)Cs含量和产沙模数。研究结果表明,黄冲子小流域和工农沟小流域1955~1963年、1963~2000年、2001~2014年的产沙模数均呈下降趋势,库区小流域生态环境得到明显改善;黄冲子小流域不同时期产沙模数均大于工农沟小流域,工农沟塘库沉积物1963年~(137)Cs峰值和表层泥沙~(137)Cs浓度均小于黄冲子塘库,主要与小流域的土地利用类型以及侵蚀方式有关。在以后的研究中,应该加强库区小流域沟道侵蚀产沙量的定量估算,为长江经济带生态环境建设提供参考依据。     

小流域综合治理新设计研究——猪沼果模式

近年来,小流域综合治理的主旨思想改变了,其工作重心在于巩固和发展治理开发的成果,提升综合治理的科技含量,增加治理带来的经济效益。于是将小流域的治理与生产联系起来成为了当前科研人员的研究方向。文章对目前部分地区大力推广的"猪-沼-果"模式在小流域治理方面的概念、发展及综合效益等方面做了一些综述。总的来说,猪沼果模式能够增加农村的能源,增加农民收入,并保护绿植,促进小流域治理。     

等离子体处理的时效性对芳Ⅲ/双马复合材料耐湿热性能的影响

目的考察等离子体处理前后及其时效性对芳Ⅲ/双马复合材料弯曲强度、界面性能及耐湿热性能的影响。方法用低温射频耦合等离子体处理芳纶纤维表面,分别将未处理的、等离子体刚处理过的和等离子体处理后在空气中放置三天后的纤维通过溶液预浸渍工艺制备芳Ⅲ/双马复合材料预浸料,再经过高温模压成形技术制备芳Ⅲ/双马复合材料单向板。采用万能材料试验机对水煮前后复合材料的弯曲强度和层间剪切强度进行测试,利用扫描电子显微镜对复合材料层间剪切破坏形貌进行观察。结果等离子体处理后,复合材料的吸水率由未处理时的0.51%下降到0.33%,复合材料层间剪切强度由49.4 MPa提高到62.9 MPa。等离子体处理时效后复合材料的吸水率增加到0.69%,复合材料的层间剪切强度下降到56.0 MPa。结论等离子体处理提高了复合材料界面性能,但等离子体处理的时效后,复合材料的界面性能及其耐湿热性能有所下降。等离子体处理及时效性对复合材料的弯曲强度和耐湿热性能变化不大。     

Analysing the sensitivity behaviour of two hydrology models

Recently, the New Morris Method has been presented as an effective sensitivity analysis tool for mathematical models. The New Morris Method estimates the sensitivity of an output parameter to a given set of input parameters (first-order effects) and the extent these parameters interact with each other (second-order effects). This method requires the specification of two parameters (runs and resolution) that control the sampling of the output parameter to determine its sensitivity to various inputs. The criteria for these parameters have been set on the analysis of a well-behaved analytical function (see Cropp and Braddock, Reliab. Eng. Syst. Saf. 78:77–83, 2002), which may not be applicable to other physical models that describe complex processes. This paper will investigate the appropriateness of the criteria from (Cropp and Braddock, 2002) and hence the effectiveness of the New Morris Method to determine the sensitivity behaviour of two hydrologic models: the Soil Erosion and Deposition System and Griffith University Representation of Urban Hydrology. In the first case, this paper will separately analyse the sensitivity of an output parameter on a set of input parameters (first- and second-order effects) for each model and discuss the physical meaning of these sensitivities. This will be followed by an investigation into the sampling criteria by exploring the convergence of the sensitivity behaviour for each model as the sampling of the parameter space is increased. By comparing these trends to the convergence behaviour from Cropp and Braddock (2002), we will determine how well the New Morris Method estimates the sensitivity for each model and whether the sampling criteria are appropriate for these models. It will be shown that the New Morris Method can provide additional insight into the functioning of these models, and that, under a different metric, the sensitivity behaviour of these models does converge confirming the sampling criteria set by Cropp and Braddock.     

锌、铝的激光-时间分辨荧光测定

本文报道了以７碘８羟基喹啉５磺酸作荧光增强剂的Ｚｎ、Ａｌ激光时间分辨荧光测定方法。方法检出限分别为２５μｇ／Ｌ和１０μｇ／Ｌ。用牛肝粉标准品（ＮＢＳ１５７７ａ）进行了验证     

Mathematical balance models for monitoring the state of Lake Baikal

The global cycles of man-produced pollutants entering the natural environment are reflected in changes of pollutant cycles, even in background regions.The system of mathematical balance simulation models of inorganic pollutant distribution and circulation (some heavy metals and pesticides included in the priority list for integrated background monitoring) has been developed for the Lake Baikal drainage basin. The system consists of the following units: (1) inventory and classification of regional sources of pollutants entering the atmosphere, natural waters and soils; (2) computation of the global atmospheric transfer and depositions; (3) regional spreading with atmospheric fluxes and deposition onto the underlying surfaces; (4) transport with waterflows feeding Lake Baikal; (5) transport with the lake currents and balance in the lake.The models developed have enabled improvement of existing programmes and systems of observations, in particular to substantiate the large-scale snow sampling and analysis network, and to develop the programme of integrated surveys of the state of Lake Baikal. Since 1981 these actions have been included in the operational network observations within the Lake Baikal Monitoring System.     

滤纸法测定悬浮物的干扰及其消除

提出了滤纸法测定悬浮物时，水样的酸碱度，取样量的多少对悬浮物测定有直接的影响。通过实验验证，对于偏酸，偏碱的水样用酸碱中和后再过滤即可消除影响，取样量应根据悬浮物的不同而定。