High frequency monitoring of the coastal marine environment using the MAREL buoy

The MAREL Iroise data buoy provides physico-chemical measurements acquired in surface marine water in continuous and autonomous mode. The water is pumped 1.5 m from below the surface through a sampling pipe and flows through the measuring cell located in the floating structure. Technological innovations implemented inside the measuring cell atop the buoy allow a continuous cleaning of the sensor, while injection of chloride ions into the circuit prevents biological fouling. Specific sensors for temperature, salinity, oxygen and fluorescence investigated in this paper have been evaluated to guarantee measurement precision over a 3 month period. A bi-directional link under Internet TCP-IP protocols is used for data, alarms and remote-control transmissions with the land-based data centre. Herein, we present a 29 month record for 4 parameters measured using a MAREL buoy moored in a coastal environment (Iroise Sea, Brest, France). The accuracy of the data provided by the buoy is assessed by comparison with measurements of sea water weekly sampled at the same site as part of SOMLIT (Service d'Observation du Milieu LIToral), the French network for monitoring of the coastal environment. Some particular events (impact of intensive fresh water discharges, dynamics of a fast phytoplankton bloom) are also presented, demonstrating the worth of monitoring a highly variable environment with a high frequency continuous reliable system.     

Analysis of BTEX and other substituted benzenes in water using headspace SPME-GC-FID: method validation

The analysis of BTEX and other substituted benzenes in water samples using solid phase microextraction (SPME) and quantification by gas chromatography with flame ionization detection (GC-FID) was validated. The best analytical conditions were obtained using PDMS/DVB/CAR fibre using headspace extraction (HS-SPME) at 50 [degree]C for 20 min without stirring. The linear range for each compound by HS-SPME with GC/FID was defined. The detection limits for these compounds obtained with PDMS/DVB/CAR fibre and GC/FID were: benzene (15 ng L(-1)), toluene (160 ng L(-1)), monochlorobenzene (54 ng L(-1)), ethylbenzene (32 ng L(-1)), m-xylene (56 ng L(-1)), p-xylene (69 ng L(-1)), styrene (35 ng L(-1)), o-xylene (42 ng L(-1)), m-dichlorobenzene (180 ng L(-1)), p-dichlorobenzene (230 ng L(-1)), o-dichlorobenzene (250 ng L(-1)) and trichlorobenzene (260 ng L(-1)). This headspace SPME-GC-FID method was compared with a previously validated method of analysis using closed-loop-stripping analysis (CLSA). The headspace SPME-GC-FID method is suitable for monitoring the production and distribution of potable water and was used, in field trials, for the analysis of samples from main intakes of water (surface or underground) and from the water supply system of a large area (Lisbon and neighbouring municipalities).     

Sharing the geo-Referenced Results of Climate Change Impact Research

The Prairie Adaptation Research Collaborative (PARC) has implemented an Internet Map Server (IMS) at the PARC web site (www.parc.ca) to 1) disseminate the geo-referenced results of PARC sponsored research on climate change impacts and adaptation, and 2) address data, information and knowledge management within the PARC network of researchers and partners. PARC facilitates interdisciplinary research on adaptation to the impacts of climate change in the Canadian Prairie Provinces. The web site is intended as a platform for sharing information and encouraging discussion of climate change impacts and adaptation. The IMS enables scientists and stakeholders to apply simple climate change scenarios to geo-referenced biophysical and social data, and dynamically create maps that display the geographic distribution of potential impacts of climate change. With a limited capacity for spatial analysis, most geo-processing and the climate impact modeling is done offline within a GIS environment. The IMS will serve the output from climate impact models, such that the model results can be customized by the web site user and be most readily applied to the planning and analysis of adaptation strategies.     

Application of the benthic index of biotic integrity to environmental monitoring in Chesapeake Bay

The Chesapeake Bay benthic index of biotic integrity (B-IBI) was developed to assess benthic community health and environmental quality in Chesapeake Bay. The B-IBI provides Chesapeake Bay monitoring programs with a uniform tool with which to characterize bay-wide benthic community condition and assess the health of the Bay. A probability-based design permits unbiased annual estimates of areal degradation within the Chesapeake Bay and its tributaries with quantifiable precision. However, of greatest interest to managers is the identification of problem areas most in need of restoration. Here we apply the B-IBI to benthic data collected in the Bay since 1994 to assess benthic community degradation by Chesapeake Bay Program segment and water depth. We used a new B-IBI classification system that improves the reliability of the estimates of degradation. Estimates were produced for 67 Chesapeake Bay Program segments. Greatest degradation was found in areas that are known to experience hypoxia or show toxic contamination, such as the mesohaline portion of the Potomac River, the Patapsco River, and the Maryland mainstem. Logistic regression models revealed increased probability of degraded benthos with depth for the lower Potomac River, Patapsco River, Nanticoke River, lower York River, and the Maryland mainstem. Our assessment of degradation by segment and water depth provided greater resolution of relative condition than previously available, and helped define the extent of degradation in Chesapeake Bay.     

Production,respiration and net ecosystem metabolism in U.S. estuaries

Primary production, respiration, and net ecosystem metabolism (NEM) are useful indicators of ecosystem level trophic conditions within estuaries. In this study, dissolved oxygen data collected every half hour between January 1996 to December 1998 by the National Estuarine Research Reserve System Wide Monitoring Program were used to calculate primary production, respiration, and net ecosystem metabolism. Data from two sites at each of 14 Reserves were analyzed. On average, three quarters of the data available could be used to calculate metabolic rates. Data from two of the Reserves were used to evaluate the assumption of homogeneity of water masses moving past the oxygen sensor. Temperature was the single most important factor controlling metabolic rates at individual sites, although salinity was also important at about half the sites. On an annual basis, respiration exceeded gross primary production demonstrating that all but 4 of the 28 sites were heterotrophic.     

Incorporating natural capital into economy-wide impact analysis: a case study from Alberta

Traditionally, decision-makers have relied on economic impactestimates derived from conventional economy-wide models. Conventional models lack the environmental linkages necessary for examining environmental stewardship and economic sustainability, and in particular the ability to assess the impact of policies on natural capital. This study investigatesenvironmentally extended economic impact estimation on a regionalscale using a case study region in the province of Alberta knownas the Foothills Model Forest (FMF). Conventional economic impactmodels are environmentally extended in pursuit of enhancingpolicy analysis and local decision-making. It is found that theflexibility of the computable general equilibrium (CGE) modelingapproach offers potential for environmental extension, with a solid grounding in economic theory. The CGE approach may be the tool of the future for more complete integrated environment andeconomic impact assessment.     

Competitive Retention of Lead and Cadmium on an Agricultural Soil

Lead and cadmium contamination of an agricultural soil has been studied using batch and column experiments. Thermodynamics of theretention phenomena may be represented by a Langmuir isotherm foran aqueous metal concentration up to 100 mg L^-1. First order kinetics with respect to the solid phase yield good predictabilityfor both batch and column experiments. Kinetics and thermodynamics of lead retention predominate over those ofcadmium. As a consequence, lead is preferentially retainedand can even displace sorbed cadmium. In the event of anspill involving both metals, cadmium would move further inthe soil and its aqueous concentration downstream could beeven higher than that of the influent solution, increasingpotential risks. A two-region model has been used to fit all the experimental results. Satisfactory predictions for column experiments are obtained with parameters which are consistent with those obtained for the batch experiments, for which sorption is described by a Langmuir isotherm including competitive retention.     

Distribution of Iron, Manganese, Zinc and Atrazine in Groundwater in Parts of Palar and Cheyyar River Basins, South India

A study was carried out in a part of Palar and Cheyyar river basin to evaluate the current status of iron, manganese, zinc and atrazine concentrations, their origin and distribution in groundwater. Groundwater samples were collected during post-monsoon (March 1998 and February 1999) and pre-monsoon (June 1999) periods from 41 sampling wells distributed throughout the study area. The groundwater samples were analyzed for trace metals using AAS and atrazine using HPLC. The concentration of the trace elements in groundwater is predominant during pre-monsoon period. Distribution pattern indicates that the concentration of these elements increases from west to northeast and towards Palar river. Lower concentrations in the central part may be due to recharge of fresh water from the lakes located here. During most of the months, as there is no flow in Palar river, the concentrations of trace elements in groundwater are high. Drinking water standards indicate that Mn and Zn cross the permissible limit recommended by EPA during the pre-monsoon period. A comparison of groundwater data with trace element chemistry of rock samples shows the abundance of trace elements both in the rock and water in the order of Fe > Mn > Zn and Fe > Zn > Mn. This indicates that iron in groundwater is derived from lithogenic origin. Further, Fe, Mn and Zn have good correlation in rock samples, while it is reverse in the case of water samples, indicating the non-lithogenic origin of Mn and Zn. Atrazine (a herbicide) was not detected in any of the groundwater samples in the study area, perhaps due to low-application rate and adsorption in the soil materials.     

Bioindicator organisms: Heavy metal pollution evaluation in the Ionian Sea (Mediterranean Sea—Italy)

Trace metal concentrations of mercury, cadmium, lead and chromium in Patella caerulea, and Mullus barbatus were investigated to provide information on pollution of Ionian Sea, since these metals have the highest toxic potential. High chromium levels (0.47–0.97 g g^–1 ww) were registered in limpet samples collected from two station near the Gulf of Taranto, while elevated concentration of mercury (0.31–1.50 g g^–1 ww) were found in mullet specimens from Sicily. The metal concentrations recorded at the clean stations may be considered as useful background levels to which to refer for comparison within the Mediterranean area. On the contrary, the high levels of chromium and mercury found respectively in the areas near the Gulf of Taranto and at Capo Passero being of concern in terms of environmental health need frequent monitoring.