Remediation of contaminated agricultural soils near a former Pb/Zn smelter in Austria: batch, pot and field experiments

Metal contaminated crops from contaminated soils are possible hazards for the food chain. The aim of this study was to find practical and cost-effective measures to reduce metal uptake in crops grown on metal contaminated soils near a former metal smelter in Austria. Metal-inefficient cultivars of crop plants commonly grown in the area were investigated in combination with in-situ soil amendments. A laboratory batch experiment using 15 potential amendments was used to select 5 amendments to treat contaminated soil in a pot study using two Barley (Hordeum vulgare L.) cultivars that differed in their ability to accumulate cadmium. Results from this experiment identified 3 of these amendments for use in a field trial. In the pot experiment a reduction in ammonium nitrate extractable Cd (<41%) and Pb (<49%) compared to the controls was measured, with a concurrent reduction of uptake into barley grain (Cd<62%, Pb<68%). In the field extractable fractions of Cd, Pb, and Zn were reduced by up to 96%, 99%, and 99%, respectively in amended soils.     

Seasonal and spatial patterns of metals at a restored copper mine site II. Copper in riparian soils and Bromus carinatus shoots

Soil and plants were sampled throughout winter and spring near a perennial stream traversing a restored mine site in a winter-rainy climate. Within 1m of an acidic reach of the stream, soil had pH 3-5 and 50-100 microg/g "bioavailable" copper (extractable with 0.01 M CaCl2). Soil 2-3 m from the stream had pH 5-8 and lower (less than 3 microg/g) bioavailable copper. "Oxide-bound" copper (extractable with 2N HCl) was 50-100 microg/g at most locations. Copper concentrations in the shoots of field-collected Bromus carinatus declined from 20 microg/g in winter to 2 microg/g in spring at all sampling sites. A similar temporal pattern was found in plants grown under controlled conditions. Thus B. carinatus has a developmental program for control of shoot copper concentration, causing a seasonally-varying pattern of copper phytoaccumulation over a large range of copper availability in the soil.     

State of energy consumption and CO2 emission in Bangladesh

Carbon dioxide (CO2) is one of the most important gases in the atmosphere, and is necessary for sustaining life on Earth. It is also considered to be a major greenhouse gas contributing to global warming and climate change. In this article, energy consumption in Bangladesh is analyzed and estimates are made of CO2 emission from combustion of fossil fuel (coal, gas, petroleum products) for the period 1977 to 1995. International Panel for Climate Change guidelines for national greenhouse gas inventories were used in estimating CO2 emission. An analysis of energy data shows that the consumption of fossil fuels in Bangladesh is growing by more than 5% per year. The proportion of natural gas in total energy consumption is increasing, while that of petroleum products and coal is decreasing. The estimated total CO2 release from all primary fossil fuels used in Bangladesh amounted to 5072 Gigagram (Gg) in 1977, and 14 423 Gg in 1995. The total amounts of CO2 released from petroleum products, natural gas, and coal in the period 1977-1995 were 83 026 Gg (50% of CO2 emission), 72 541 Gg (44% of CO2 emission), and 9545 Gg (6% CO2 emission), respectively. A trend in CO2 emission with projections to 2070 is generated. In 2070, total estimated CO2 emission will be 293 260 Gg with a current growth rate of 6.34% y . CO2 emission from fossil fuels is increasing. Petroleum products contribute the majority of CO2 emission load, and although the use of natural gas is increasing rapidly, its contribution to CO2 emission is less than that of petroleum products. The use of coal as well as CO2 emission from coal is expected to gradually decrease.     

Influences of macroalga-derived dissolved organic carbon on the aquatic toxicity of copper and cadmium

In this study, the effect of dissolved organic carbon (DOC) derived from macroalga (Sargassum) on the acute toxicity of copper (Cu) and cadmium (Cd) to a freshwater cladoceran (Daphnia magna) was investigated. Potassium-loaded macroalga was incubated with ultrapure water to extract macroalgal DOC, which was then spiked with the constituents of the Elendt M7 hard water media. The 48 h median lethal concentration of Cu increased linearly with DOC levels but that of Cd was relatively independent of DOC levels (0-44 mg l(-1)). The independence of Cd toxicity on DOC level might be due to the competitive effect of high calcium concentrations in the media with Cd for the binding sites of DOC. The decreased Cu toxicity was a result of reduced Cu uptake as evidenced in a separate accumulation test. Also, the capability of the macroalgal DOC on reducing Cu toxicity was found to be comparable to DOC tested in other studies. Therefore, the present study suggested that the biosorption treatment process using macroalgae should consider the effect of DOC release from the biomass as a step of modifying the metal toxicity as well as influencing metal biosorption capacity.     

Changes in amino acid profile and metal content in seeds of Cicer arietinum L. (chickpea) grown under various fly-ash amendments

Seeds of Cicer arietinum L. plants are edible and a valuable source of protein. Accumulation of toxic metals in the edible part of the plant, grown in fields close to fly-ash (FA) landfills, may pose a threat to human health. In the present study, the effects of FA and its amendments with different ameliorants viz., garden soil (GS), press mud (PM) and saw dust (SD), on total soluble protein contents, amino acid composition and metal accumulation in seeds were investigated in var. CSG-8962 and var. C-235 of C. arietinum. Plants accumulated adequate amounts of essential metals viz. Fe, Cu, Zn in seeds, while the toxic metals such as Cd and Cr were taken up in smaller quantities. The accumulation of Cr and Cd was less in var. C-235 than var. CSG-8962. Amendment of FA with PM enhanced the amount of soluble protein and amino acids in both varieties and was found to be superior among all tested ameliorants. Both quantitative and qualitative analysis of amino acids showed better response in var. C-235 as compared to var. CSG-8962. Thus var. C-235 seems to be suitable for cultivation in FA contaminated areas due to more accumulation of essential metals and less accumulation of toxic metals in seeds. Application of PM may further improve the growth of plants and nutritional quality of seeds.     

Effect of farmyard manure application on boron adsorption-desorption characteristics of some soils

Boron (B) availability to crop plants depends on soil properties as well as management practices like liming, fertilization and use of organic manures. To assess the effect of farmyard manure (FYM) application on availability of added B, adsorption-desorption of B was investigated in five different soils receiving varying doses of FYM (0, 5 and 10 g FYM kg(-1) soil). Two surfaces Freundlich model was found best to account for B adsorption-desorption data of all soils. Application of FYM increased B adsorption capacities pertaining to low (K1) and high (K2) concentration ranges in all soils, except Soil C (Alfisol) having a pH of 9.8, in which the higher rate of FYM decreased the value of K2. Application of FYM did not change B desorption capacities of soils corresponding to low B concentration range (K(1)(1)) significantly, however, it increased B desorption capacity pertaining to high B concentration (K(1)(2)) in all soils, except Soils C (Alfisol) and E (Entisol) having pH of 9.8 and 5.1, respectively. Application of FYM increased the desorption slope factor applicable to low concentration range (1/n(1)(1)) in Soil A (Inceptisol), but decreased it in Soil E (Entisol). The 1/n(1)(2) (desorption slope factor applicable to high concentration range) decreased with FYM application in all soils except Soil E (Entisol), where it was increased. Boron desorption index (slope(ads)/slope(des)) decreased with FYM application in low B concentration range, but increased in high concentration range for all soils except soil E (Entisol, pH 5.1), in which a reverse trend was observed. Application of FYM increased the retention of added B in soils and may help reducing the leaching losses.     

Bagasse-assisted bioremediation of ammonia from shrimp farm wastewater.

Development of new economically feasible ecofriendly products from agricultural wastes or byproducts for shrimp farm wastewater treatment is the objective of our continued research. Ammonia is a nitrogenous toxicant, which is commonly found in wastewater from shrimp farms. In the present study, we explored the possibility of the use of simply and inexpensively prepared bagasse products so that this abundant crop byproduct could be used to remove ammonia from shrimp farm wastewater. Bagasse, a natural highly fibrous lignocellulosic byproduct of sugarcane, was converted into five different products. Experimental results have shown that ammonia is efficiently removed from wastewater by four bagasse products with a dose of 1 to 6 g/L within 24 hours. The effect of bagasse products on other water quality parameters and growth kinetics of biofilm bacteria onto bagasse fiber have also been studied. Efficacies of products were compared by using statistical analysis. Products developed from bagasse are useful and economical.     

Ammonium, nitrate and nitrite nitrogen and nitrate reductase enzyme activity in groundnut (Arachis hypogaea L.) fields after diazinon, imidacloprid and lindane treatments

Impacts of diazinon (O,O-diethyl O-2-isopropyl-6-methylpyrimidin-4-yl phosphorothioate), imidacloprid [1-(6-chloro-3-pyridylmethyl)-N-nitroimidazolidin-2-ylideneamine] and lindane (1,2,3,4,5.6-hexachlorocyclohexane) treatments on ammonium, nitrate, and nitrite nitrogen and nitrate reductase enzyme activities were determined in groundnut (Arachis hypogaea L.) field for three consecutive years (1997 to 1999). Diazinon was applied for both seed- and soil-treatments but imidacloprid and lindane were used for seed treatments only at recommended rates. Diazinon residues persisted for 60 days in both the cases. Average half-lives (t1/2) of diazinon were found 29.3 and 34.8 days respectively in seed and soil treatments. In diazinon seed treatment, NH4(+), NO3(-), and NO2(-) nitrogen and nitrate reductase activity were not affected. Whereas, diazinon soil treatment indicated significant increase in NH4(+)-N in a 1-day sample, which continued until 90 days. Some declines in NO3(-)N were found from 15 to 60 days. Along with this decline, significant increases in NO2(-)N and nitrate reductase activity were found between 1 and 30 days. Imidacloprid and lindane persisted for 90 and 120 days with average half-lives (t1/2) of 40.9 and 53.3 days, respectively. Within 90 days, imidacloprid residues lost by 73.17% to 82.49% while such losses for lindane residues were found 78.19% to 79.86 % within 120 days. In imidacloprid seed-treated field, stimulation of NO3(-)N and the decline in NH4+NO2(-)-N and nitrate reductase enzyme activity were observed between 15 to 90 days. However, lindane seed treatment indicated significant increases in NH4(+)-N, NO2(-)-N and nitrate reductase activity and some adverse effects on NO3(-)N between 15 and 90 days.     

Evaluating the role of desorption in bioavailability of sediment-associated contaminants using oligochaetes, semipermeable membrane devices and Tenax extraction

The success of the rapidly desorbing fraction as an available fraction was challenged by using sediment ingesting and non-ingesting oligochaetes (Lumbriculus variegatus) together with passive samplers (semipermeable membrane devices, SPMDs) in accumulation and kinetic modelling exercises for carbon-14 labelled model compounds (pyrene, benzo[a]pyrene and 3,4,3',4'-tetrachlorobiphenyl). Passive samplers clearly produced lower uptake rate constants and steady state factors than either of the oligochaete treatments when residue concentrations were based on animal lipid or total SPMD weight. The rapidly desorbing chemical fractions in sediments did not show a significant relationship with the biota sediment accumulation factors or SPMD accumulation factors. A distinctly better relationship was observed between the accumulation factors and the desorption rate constants. The results support the assumption that desorption plays an important role in bioavailability, although animal behaviour and the diffusional limitations of hydrophobic contaminants in sediment together probably affect the actual available pool.     

Stable hydrogen,carbon and chlorine isotope measurements of selected chlorinated organic solvents

Stable hydrogen isotopes of two chlorinated solvents, trichloroethylene (TCE) and 1,1,1-trichloroethane (TCA), provided by five different manufacturers, were determined and compared to their carbon and chlorine isotopic signatures. The isotope ratio for delta2H of different TCEs ranged between +466.9 per thousand and +681.9 per thousand, for delta13C between -31.57 per thousand and -27.37 per thousand, and for delta37Cl between -3.19 per thousand and +3.90 per thousand. In the case of the TCAs, the isotope ratio for delta2H ranged between -23.1 per thousand and +15.1 per thousand, for delta13C between -27.39 per thousand and -25.84 per thousand, and for delta37Cl between -3.54 per thousand and +1.39 per thousand. As well, a column experiment was carried out to dechlorinate tetrachloroethylene (PCE) to TCE using iron. The dechlorination products have completely different hydrogen isotope ratios than the manufactured TCEs. Compared to the positive values of delta2H in manufactured TCEs (between +466.9 per thousand and +681.9 per thousand), the dechlorinated products had a very depleted delta2H (less than -300 per thousand). This finding has strong implications for distinguishing dechlorination products (PCE to TCE) from manufactured TCE. In addition, the results of this study show the potential of combining 2H/1H analyses with 13C/12C and 37Cl/35Cl for isotopic fingerprinting applications in organic contaminant hydrogeology.