Anaerobic biotransformation of dinitrotoluene isomers by Lactococcus lactis subsp. lactis strain 27 isolated from earthworm intestine

Dinitrotoluenes are widely used as solvents and are intermediates in the synthesis of dyes, explosives, and pesticides. Environmental concerns regarding DNTs have increased due to their widespread use and their discharge into the environment. In this study, the anaerobic biodegradation of four dinitrotoluene isomers, 2,3-, 2,4-, 2,6- and 3,4-DNT, was investigated using Lactococcus lactis subsp. lactis strain 27, which was isolated from the intestines of earthworms. Liquid chromatography/mass spectrometry and NMR spectroscopy showed that L. lactis strain 27 non-specifically reduced the nitro groups on the tested dinitrotoluenes to their corresponding aminonitrotoluenes. L. lactis strain 27, however, did not reduce either sequentially or simultaneously two nitro groups of the dinitrotoluenes, resulting in the formation of the corresponding diaminotoluenes. In vitro formation of dinitroazoxytoluenes suggested the presence of oxygen-sensitive hydroxylaminonitrotoluenes. L. lactis strain 27 was capable of reducing 2,4-, 2,6-, 2,3-, and 3,4-dinitrotoluenes up to 173.6, 66.6, 287.1, and 355 microM, respectively in 12 h incubation. A relatively rapid reduction was observed in the case of the 2,3-, and 3,4-dinitrotoluenes, which have vicinal nitro groups on their arene structure. Non-specific anaerobic reduction of dinitrotoluenes by the intestinal bacterium L. lactis strain 27 differentiated the extent of reduction of DNTs according to the substitutional position of the nitro groups and produced in vitro more toxic dinitroazoxytoluenes, suggesting that anaerobic biotransformation of dinitrotoluenes could increase environmental risk.     

Precipitation of swine and cattle manure phosphorous using limestone dust

The effectiveness of SPS and PULPRO, fine limestone dusts, in precipitating swine and dairy manure phosphorous (P) was determined in the laboratory. Both manures were sieved before being treated with limestone, to reproduce the treatment of mechanically separated manure and to observe the precipitation effect of limestone without that of the large manure solid particles. P precipitation was optimized by varying precipitation conditions (propeller blade speeds, mixing time and limestone levels) and limestone particle size. P precipitation was optimized using a propeller blade mixing speed of 0.3 m s(-1) for at least 5 minutes, using 3% limestone (dry limestone mass over wet manure mass). In terms of particle size, PULPRO 20 (limestone with a particle size of 0.02 mm) produced the most P precipitation and the smallest volume and mass of sludge, as compared to PULPRO 10, PULPRO 3 and SPS (limestone with a particle size of 0.01, 0.003 and 0.3 to 0.003 mm, respectively). For both 9.5% TS (total solids) dairy and 8.8% TS swine manure, mechanical separation followed by limestone precipitation concentrated 90% of manure TS and TP in a sludge volume representing 45% of the initial raw manure mass.     

An intercalibration study on organobromine compounds: Results on polybrominated diphenylethers and related dioxin-like compounds

An intercalibration study on organobromine compounds has been conducted to evaluate the accuracy and reliability in the analysis of brominated flame retardants (BFRs) such as polybrominated diphenyl ethers (PBDEs) and their related compounds like polybrominated and monobromo-polychlorinated dibenzodioxins and -furans (PBDDs/DFs, MoBPCDDs/DFs). This paper reports the results for these compounds in 'Mixed Standard Solutions' and 'Air-Dried Sediment'. The relative standard deviations (RSDs) for PBDEs, PBDDs/DFs and MoBPCDDs/DFs in mixed standard solutions ranged from 9% to 24%, 4% to 20% and 8% to 27%, respectively. The results of this study are better than those reported in earlier international interlaboratory studies due to general improvement in analytical methods and an increasing number of available authentic standards, particularly for PBDEs. In the analysis for higher brominated compounds such as octabromodibenzodioxin, the participants were advised to optimize the calibration curves befitting the range of concentrations found in samples because variation of relative response factors was noted. The results for 'Air-Dried Sediment' were also reasonable with RSDs from 10% to 38% for PBDEs, 8% to 38% for PBDDs/DFs and 17% to 36% for MoBPCDDs/DFs. In the sediment sample, possible errors in the sample pretreatment and/or interference by other compounds/impurities were indicated. The concentrations of pentabromodiphenylether, BDE100, varied more than the other PBDE isomers due to its poor separation in some chromatographic conditions. In addition, interference by PBDEs was observed in the analysis for PBDFs. Potential degradation/secondary formulation of PBDEs and PBDFs during the Soxhlet extraction were suggested when copper powder was added into the sediment samples. Inspite of these observations, the results in this study are better than those reported in other interlaboratory studies due to the advice given to participants for improving the results. Compared with the results for PCDDs/DFs (5-23% RSDs) and Co-PCBs (6-24% RSDs), the RSDs for most of the organobromine compounds were high, indicating an immature QA/QC approach for the analysis of PBDEs and related compounds in comparison to common chlorinated dioxins.     

Butyltin residues in blue mussels (Mytilus edulis) and arkshells (Scapharca broughtonii) collected from Korean coastal waters

Butyltin compounds (BTs) including tributyltin (TBT) and its degradation products, di- (DBT) and mono-butyltin (MBT), were determined in bivalves such as blue mussels (Mytilus edulis) and arkshells (Scapharca broughtonii) collected from Korean coastal waters. BTs were detected in all the blue mussels and arkshells analyzed. The concentrations of total butyltin (sigmaBTs: MBT + DBT + TBT) in blue mussels and arkshells ranged from 49 to 2500 ng/g and 29 to 87 ng/g wet weight, respectively. Higher concentrations of BTs were found in blue mussels collected from Okpo and Kohyonsong Bays and Jangsengpo Harbor where large shipyards and harbors are located with dry-dock facilities. This suggested that maritime activities nearby the harbors play a major role as the source of BTs. Concentrations of TBT in mussels collected from Korea were one of the highest values reported, suggesting ongoing TBT contamination in Korea. Among BTs, TBT was the predominant compound both in blue mussels and arkshells collected from almost all the sampling locations, indicating the fresh input of TBT in Korean coastal waters. Smaller mussels tended to accumulate BTs at higher concentrations than larger ones, which may be due to higher filtration rate of small mussels and/or contact with surface microlayer in intertidal zones.     

Evaluation of SWAT sub-daily runoff estimation at small agricultural watershed in Korea

A study was undertaken for the prediction of runoff flow from 0.8 ha field-sized agricultural watershed in South Korea using Soil and Water Assessment Tool (SWAT) sub-daily. The SWAT model with sub-daily configuration predicted flow from the watershed within the range of acceptable accuracy. The SWAT sub-daily simulations were carried out for a total of 18 rainfall events, 9 each for calibration and validation. Overall trend and extent of matching simulated flow for the rainfall events in 2007-2008 with measured data during the calibration process were coefficient of determination (R²) value of 0.88 and Nash and Sutcliffe Efficiency (E_NS) value of 0.88. For validation, R² and E_NS values were 0.9 and 0.84, respectively. Whereas R² and E_NS values for simulation results using daily rainfall data were 0.79 and -0.01, respectively, that were observed to be out of acceptable limits for the model simulation. The importance of higher time resolution (hourly) precipitation records for flow simulation were evaluated by comparing R² and E_NS with 15 min, 2 h, 6 h and 12 h precipitation data, which resulted in lower statistics with increases in time resolution of precipitation data. The SWAT sub-daily sensitivity analysis was performed with the consideration of hydraulic parameter and was found as in the rank order of CN2 (curve number), ESCO (soil evaporation compensation factor), GW_DELAY (ground water delay time), ALPHA_BF ( base flow alpha factor), GWQMN ( a threshold minimum depth of water in the shallow aquifer required for return flow to occur) , REVAPMN (minimum depth of water in shallow aquifer for re-evaporation to occur) , LAT_TIME (lateral flow travel time) respectively. These sensitive parameters were evaluated at 10% higher and lower values of the parameters, corresponding to 70.5% higher and 23.2% lower in simulated flow out from the SWAT model. From the results obtained in this study, hourly precipitation record for SWAT sub-daily with Green-Ampt infiltration method was proven to be efficient for runoff estimation at field sized watershed with higher accuracies that could be efficiently used to develop site-specific Best Management Practices (BMPs) considering rainfall intensity, rather than simply using daily rainfall data.     

Personal, indoor, and outdoor exposure to VOCs in the immediate vicinity of a local airport

This study measures the effect of emissions from an airport on the air quality of surrounding neighborhoods. The ambient concentrations of benzene, toluene, ethylbenzene, and o-, m-, and p-xylene (BTEX) were measured using passive samplers at 15 households located close to the airport (indoor, outdoor, and personal), at the end of airport runways and an out-of-neighborhood location. Measurements occurred over a 48-h period during summer 2006 and winter 2006?C2007. The average concentrations were 0.84, 3.21, 0.30, 0.99, and 0.34 ??g/m³ at the airport runways and 0.84, 3.76, 0.39, 1.22, and 0.39 ??g/m³ in the neighborhood for benzene, toluene, ethylbenzene, m-, p-, and o-xylene. The average neighborhood concentrations were not significantly different to those measured at the airport runways and were higher than the out-of-neighborhood location (0.48, 1.09, 0.15, 0.78, and 0.43 ??g/m³, each BTEX). B/T ratios were used as a tracer for emission sources and the average B/T ratio at the airport and outdoors were 0.20 and 0.23 for the summer and 0.40 and 0.42 for the winter, suggesting that both areas are affected by the same emission source. Personal exposure was closely related to levels in the indoor environment where subjects spent most of their time. Indoor/outdoor (I/O) ratios for BTEX ranged from 1.13 to 2.60 and 1.41 to 3.02 for summer and winter. The seasonal differences in I/O ratios reflected residential ventilation patterns, resulting in increased indoor concentrations of volatile organic compounds during winter.     

Effect of granular porous media on the composting of swine manure

This study investigated the feasibility of a bulking agent of granular porous media (GPM) for the composting of swine manure. Two lab-scale composting reactors were operated to evaluate the general performances and maturity parameters using GPM made of wastes from the Portland cement manufacturing processes as an alternative bulking agent. The overall volatile solid (VS) removal was 38.5% (dry basis). During the experiments, moisture content ranged between 41% and 53%, ensuring feasibility of microbial activity in composting. Cured compost showed proper maturity and low phytotoxicity, despite the slight decreases of CO(2) production and VS removal at the second batch operation. Various physico-chemical parameters of the cured compost met the regulatory standards reported elsewhere. The pH, carbon-to-nitrogen ratio, ammonia nitrogen and soluble organic carbon (SOC) of the cured compost were significantly correlated to the germination index (GI) using the seeds of Chinese cabbage and lettuce, indicating the progressive biodegradation of phytotoxins as well as organic matter. Consequently, the results obtained in this study demonstrate that GPM could contribute to the environmentally friendly and economical composting of problematic swine manure as a recyclable bulking agent.     

Prenatal diagnosis of congenital epulis by three-dimensional ultrasound and magnetic resonance imaging

Congenital epulis is a benign intraoral tumor that has rarely been diagnosed prenatally. We report a fetus with congenital epulis diagnosed by three-dimensional (3-D) ultrasound and fetal magnetic resonance imaging (MRI) at 35 weeks' gestation. We show an image of congenital epulis using a new ultrasound technique, the 3-D multislice view, which shows images similar to CT or MRI. This is a short case report of congenital epulis diagnosed prenatally by 3-D ultrasound using multislice view and MRI. Copyright © 2006 John Wiley & Sons, Ltd.