Hazardous substances in indoor dust emitted from waste TV recycling facility

Various hazardous substances contained in waste TV sets might be released into environment via dust during recycling activities. Two brominated flame retardants (BFRs), polybrominated diphenyl ethers (PBDEs), and tetrabromobisphenol A (TBBPA), and five kinds of heavy metals (Cu, Pb, Cd, Cr, and Ni) were detected in indoor dust collected from two workshops (TV dismantling workshop and subsequent recycling workshop). PBDEs concentrations in dust from waste wires recycling line (722,000 ng/g) were the highest among the studied sites, followed by those in manual dismantling–sorting line (117,000 ng/g), whereas TBBPA concentrations were the highest in manual dismantling–sorting line (557 ng/g) and printed circuit board (PCB) recycling line (428 ng/g). For heavy metals, Cu and Pb were the most enriched metals in all dust samples. The highest concentration of Pb (22,900 mg/kg) was found in TV dismantling workshop-floor dust. Meanwhile, Cu was the predominant metal in dust from the PCB recycling line, especially in dust collected from electrostatic separation area (42,700 mg/kg). Occupational exposure assessment results showed that workers were the most exposed to BDE-209 among the four PBDE congeners (BDE-47, BDE-99, BDE-153, and BDE-209) in both workshops. The hazard quotient (HQ) indicated that noncancerous effects were unlikely for both BFRs and heavy metals (HQ?<?1), and carcinogenic risks for Cd, Cr, and Ni (risk?<?10^?6) on workers in two workshops were relatively low.     

The combined effects of urea application and simulated acid rain on soil acidification and microbial community structure

Our aim was to test the effects of simulated acid rain (SAR) at different pHs, when applied to fertilized and unfertilized soils, on the leaching of soil cations (K, Ca, Mg, Na) and Al. Their effects on soil pH, exchangeable H⁺ and Al³⁺ and microbial community structure were also determined. A Paleudalfs soil was incubated for 30 days, with and without an initial application of urea (200 mg N kg^?1soil) as nitrogen (N) fertilizer. The soil was held in columns and leached with SAR at three pH levels. Six treatments were tested: SAR of pH 2.5, 4.0 and 5.6 leaching on unfertilized soil (T1, T2 and T3), and on soils fertilized with urea (T4, T5 and T6). Increasing acid inputs proportionally increased cation leaching in both unfertilized and fertilized soils. Urea application increased the initial Ca and Mg leaching, but had no effect on the total concentrations of Ca, Mg and K leached. There was no significant difference for the amount of Na leached between the different treatments. The SAR pH and urea application had significant effects on soil pH, exchangeable H⁺ and Al³⁺. Urea application, SAR treated with various pH, and the interactions between them all had significant impacts on total phospholipid fatty acids (PLFAs). The highest concentration of total PLFAs occurred in fertilized soils with SAR pH5.6 and the lowest in soils leached with the lowest SAR pH. Soils pretreated with urea then leached with SARs of pH 4.0 and 5.6 had larger total PLFA concentrations than soil without urea. Bacterial, fungal, actinomycete, Gram-negative and Gram-positive bacterial PLFAs had generally similar trends to total PLFAs.     

基于白碳黑的水化硅酸钙制备及其磷回收特性简

以白碳黑、硅灰、硅藻土和硅胶筛选硅质原料,并与钙质原料电石渣制备了水化硅酸钙。借助XRF、BET、FTIR等表征手段,通过多次重复除磷实验,研究了硅质原料特性对水化硅酸钙回收磷性能的影响。结果表明,白碳黑具有极高的反应活性,因此可作为制备具有磷回收特性的水化硅酸钙的硅质原料。结合XRD等表征发现,白碳黑的有效利用率是影响水化硅酸钙回收磷性能的关键,该利用率取决于白碳黑与电石渣的摩尔配比以及水热反应温度。当电石渣与白碳黑的摩尔比为1.6：1,反应温度为170℃时,白碳黑具有最佳的利用效率。该条件制备的水化硅酸钙可作为晶种,在其表面结晶形成羟基磷灰石,从而达到磷回收的目的,磷回收后固体物质中的磷含量为19.05%。     

MCM-41介孔分子筛的合成及其对铜离子的吸附性能简

以微硅粉为硅源,CTAB和PEG-6000为模板剂,合成MCM-41介孔分子筛。采用XRD、N₂吸附-脱附曲线、FTIR以及TEM表征了其结构、比表面积、孔径分布及晶体形貌,并且以该样品为吸附剂,对含Cu²⁺的溶液进行了静态吸附实验。结果表明,以微硅粉为硅源成功合成了具有典型六方排列孔道结构的MCM-41,其比表面积为869.5 m²/g,孔容为0.97 cm³/g,平均孔径为3.3 nm;溶液pH为5~6时,MCM-41对Cu²⁺的去除效果最好;MCM-41对Cu²⁺的最大吸附吸附容量36.3 mg/g;MCM-41对Cu²⁺的吸附性能符合Langmuir吸附方程的特征。动力学研究表明,该过程符合准二级动力学模型。     

水泥窑共处置过程中水泥生料对砷的吸附/冷凝特性

针对水泥生料开展了氮吸附与SEM测试分析,研究了水泥生料的比表面积,孔径结构和微观表面积。同时,利用管式回转炉和控温立式炉联用装置研究了砷元素在水泥生料上的吸附冷凝特性。结果表明,水泥生料的比表面积很小,微观表面结构致密无孔,砷元素主要是冷凝在生料表面上。进入吸附冷凝炉的重金属可以分为3部分,第1部分冷凝在管壁上,占80%左右;第2部分吸附/冷凝在生料上,占10%左右;第3部分随烟气释放到空气中,不到10%。水泥生料对砷的吸附冷凝量随时间的增加而增加,随温度的升高而降低。水泥生料对砷的吸附冷凝特性可用双常数速率方程拟合,拟合效果较好,计算得表观活化能在6~7 kJ/mol之间。此外,砷的初始浓度对水泥生料的吸附冷凝特性影响很小。     

改性壳聚糖复合凹凸棒土絮凝油漆废水

将壳聚糖、阳离子淀粉和二甲基二烯丙基氯化铵(DMDAAC)进行三元接枝共聚,制备了三元接枝改性壳聚糖(CTS-DMDAAC-CS),通过红外光谱和扫描电镜对其结构进行了表征。并且将三元接枝改性壳聚糖与凹凸棒土进行优化复配,对油漆废水进行了絮凝实验,得出了当pH=12,沉降时间为20 min,复合絮凝剂投加量为0.2 g,三元接枝共聚物∶凹凸棒土=1∶10时,该复合絮凝剂对油漆去除率最佳能够达到89.3%,并且絮凝效果好,是一种新型绿色环保的有机-无机复合絮凝剂。     

CdIn2S4/复合材料的制备及光降解罗丹明B

利用高压静电纺丝技术,制得含有羧基的导电聚合物纤维(聚偏氟乙烯/苯乙烯-马来酸酐共聚物/纳米石墨),高温水热条件下在纤维表面制备CdIn2S4颗粒,得到CdIn2S4/导电聚合物纤维复合材料。运用扫描电子显微镜(SEM)、X射线衍射仪(XRD)、紫外-可见吸收光谱仪(UV-Vis)和热失重分析仪(TGA)对复合材料的结构进行表征。并利用350 W氙灯模拟太阳光进行光催化降解罗丹明B。结果发现,CdIn2S4/导电聚合物纤维复合材料的降解效率高于CdIn2S4粉体和Degussa P25 TiO2粉体,光催化降解3 h,罗丹明B的降解率为96.2%。     

甲苯对UASB反应器中溶解性微生物产物的影响

以乙酸钠为外加碳源,考察了UASB反应器内甲苯对可溶性微生物产物（SMP）的影响。实验结果表明：低质量浓度（20~70 mg/L）的甲苯对微生物有刺激作用,使得污泥增殖速率变小,SMP的质量浓度也逐渐减少,经过一段时间的驯化后,系统COD和TOC的去除率分别达到93%和94%以上,下降趋势较小;较高质量浓度（70~200 mg/L）的甲苯对微生物有抑制作用,污泥活性下降,反应器运行状况开始恶化,SMP的质量浓度也逐渐增大,经过一段时间的驯化后,系统COD和TOC的去除率分别维持在81%和83%以上;当甲苯质量浓度超过200 mg/L时,表现为污泥活性严重下降,对COD的去除效果极差。     

假单胞菌好氧降解四溴双酚A的特性

为了解四溴双酚A(TBBPA)的好氧降解特性,采用选择富集法从活性污泥中分离出一株能够高效降解四溴双酚A的菌株。根据其形态、生理生化特性及16S rDNA核苷酸序列分析,该菌株被鉴定为假单胞菌属(Pseudomonas sp.)。研究结果表明,该菌株可通过好氧共代谢方式实现四溴双酚A的降解,葡萄糖是四溴双酚A降解的最佳碳源,其最优降解条件为葡萄糖8 g/L,牛肉膏0.5 g/L,pH值为7.0,培养温度为35℃,摇床转速为150 r/min。在该条件下其生物降解过程符合一级动力学模型,6 d后的降解率高达95.6%。LC-MS结果表明,四溴双酚A在好氧降解过程中会生成异丙苯酚类物质。     

酸性矿井水中和沉淀法除铁优化

针对山西某煤矿高矿化度、高铁酸性矿井水除铁效果差、出水容易返色等问题,采用NaOH中和调pH、曝气及化学氧化等处理工艺进行酸性矿井水中和沉淀法除铁优化实验研究。结果表明,采用NaOH中和沉淀法除铁时,投加中和剂使出水pH达6.7以上时,出水中铁含量低于10 mg/L,满足排放要求。对于本实验废水NaOH所需投加量为2.8 g/L,铁的去除率可达到99.75%;以H2O2对原水进行氧化处理,可迅速将Fe(Ⅱ)氧化成Fe(Ⅲ),其用量与原水中Fe(Ⅱ)的含量成正比。当其用量为1.6 mL/L时,可将原水中的Fe(Ⅱ)完全转化为Fe(Ⅲ),投加中和剂使出水pH达到4.5以上时,能使出水中铁含量满足排放要求。对于实验废水所需的NaOH投加量为2.0 g/L,比直接中和沉淀所需的NaOH用量要节省28.6%。曝气处理对原水中Fe(Ⅱ)的氧化效果不明显。