Aging and compressibility of municipal solid wastes

The expansion of a municipal solid waste (MSW) landfill requires the ability to predict settlement behavior of the existing landfill. The practice of using a single compressibility value when performing a settlement analysis may lead to inaccurate predictions. This paper gives consideration to changes in the mechanical compressibility of MSW as a function of the fill age of MSW as well as the embedding depth of MSW. Borehole samples representative of various fill ages were obtained from five boreholes drilled to the bottom of the Qizhishan landfill in Suzhou, China. Thirty-one borehole samples were used to perform confined compression tests. Waste composition and volume-mass properties (i.e., unit weight, void ratio, and water content) were measured on all the samples. The test results showed that the compressible components of the MSW (i.e., organics, plastics, paper, wood and textiles) decreased with an increase in the fill age. The in situ void ratio of the MSW was shown to decrease with depth into the landfill. The compression index, Cc, was observed to decrease from 1.0 to 0.3 with depth into the landfill. Settlement analyses were performed on the existing landfill, demonstrating that the variation of MSW compressibility with fill age or depth should be taken into account in the settlement prediction.     

TiO2催化高压脉冲放电等离子体降解2，4-二硝基苯酚

采用TiO2催化高压脉冲放电等离子体降解废水中的2,4-二硝基苯酚,对反应进行了动力学研究.研究结果表明,在高压脉冲放电等离子体及TiO2催化高压脉冲放电等离子体反应中,2,4-二硝基苯酚的降解过程均符合表观一级反应动力学方程.加入TiO2催化剂、提高放电电压均可提高2,4-二硝基苯酚的降解反应速率常数.在TiO2加入量为0.15%、放电电压为16 kV时,2,4-二硝基苯酚的降解率为87.4%,TiO2的催化效应增强因子为1.55.     

Ru/γ-Al_2O_3和Ru/AC催化剂的制备及其对氨氧化反应的催化性能

分别以γ-Al_2O_3和活性炭(AC)为载体,采用浸渍法制备了Ru质量分数均为2.0%的Ru/γ-Al_2O_3和Ru/AC催化剂,并用X射线衍射仪和透射电子显微镜等方法对催化剂结构进行了表征.实验结果表明:Ru/AC中Ru沉积在AC表面,分散度较低;而Ru/γ-Al_2O_3中Ru进入到γ-Al_2O_3内部,形成了一种高度分散体系.Ru/γ-Al_2O_3对氨的催化活性高于Ru/AC,氨在Ru/γ-Al_2O_3和Ru/AC上的起活温度分别为200 ℃和266 ℃,T_(90)(氨去除率达90%时的反应温度)分别为267℃和320 ℃.随混合气体空速增大,Ru/γ-Al_2O_3催化剂的T_(90)逐渐升高,气体空速分别为3 600,4 800,5 400 h~(-1)时,T_(90)分别为235,266,303 ℃.随反应前混合气体中氨质量分数增加,氨的去除率降低.     

学龄儿童肺功能水平影响因素的研究

用逐步回归分析方法对与室内、外空气污染和机体状况等有关的因素对广州市学龄儿童肺功能 (FVC、FEV1 、PEFR和 FEF2 5～ 75 )水平的影响进行研究。结果提示 ,影响肺功能水平的主要因素是内因 ,身高的影响最明显 ,呼吸系统疾病或症状发生与肺功能水平下降有关 ;室外空气污染使肺功能水平下降 ,SO2 、NOx 和 PM2 .5 的影响明显 ,PM2 .5 的影响明显大于 PM1 0 和 TSP;居室或厨房通风不良、家庭烹饪用不洁燃料对儿童肺功能的生长不利 ;被动吸烟对女性儿童肺功能有不利影响。对各种影响因素 ,PEFR和 FEF2 5～ 75 比 FVC和 FEV1 更为敏感     

Landfill leachate treatment using a rotating biological contactor and an upward-flow anaerobic sludge bed reactor

This paper describes the feasibility of an aerobic system (rotating biological contactor, RBC) and a biological anaerobic system (upward-flow anaerobic sludge bed reactor) at small scale for the treatment of a landfill leachate. In the first phase of the aerobic system study, a cyclic-batch RBC system was used to select perforated acetate discs among three different acetate disc configurations. These discs were chosen on the basis of high COD removal (65%) and biological stability. In the second phase, the RBC system (using four stages) was operated continuously at different hydraulic retention times (HRT), at different rotational speeds, and with varying organic concentrations of the influent leachate (2500-9000mgL(-1)). Forty percent of the total surface area of each perforated disc was submerged in the leachate. A COD removal of about 52% was obtained at an HRT of 24h and a rotational speed of 6rpm. For the anaerobic system, the reactor was evaluated with a volumetric organic load of 3273g-COD m(-3) day(-1) at an HRT of 54, 44, 39, 24 and 17h. At these conditions, the system reached COD removal efficiencies of 62%, 61%, 59%, 44% and 24%, respectively.     

Waste polyvinylchloride derived pitch as a precursor to develop carbon fibers and activated carbon fibers

Polyvinylchloride (PVC) was successfully recycled through the solvent extraction from waste pipe with an extraction yield of ca. 86%. The extracted PVC was pyrolyzed by a two-stage process (260 and 410 degrees C) to obtain free-chlorine PVC based pitch through an effective removal of chlorine from PVC during the heat-treatment. As-prepared pitch (softening point: 220 degrees C) was spun, stabilized, carbonized into carbon fibers (CFs), and further activated into activated carbon fibers (ACFs) in a flow of CO2. As-prepared CFs show comparable mechanical properties to commercial CFs, whose maximum tensile strength and modulus are 862 MPa and 62 GPa, respectively. The resultant ACFs exhibit a high surface area of 1200 m2/g, narrow pore size distribution and a low oxygen content of 3%. The study provides an effective insight to recycle PVC from waste PVC and develop a carbon precursor for high performance carbon materials such as CFs and ACFs.     

Combustion characteristics of Malaysian municipal solid waste and predictions of air flow in a rotary kiln incinerator

Malaysia is in dire need of alternatives to landfilling for solid waste management. Recently, landfills have faced the problems of overfilling, overflowing of leachates leading to pollution of water resources, and uncontrolled dust emissions adversely affecting the local environment. With the rising cost of urbanization coupled with the high rate of waste generation, one possible method of waste treatment that is receiving particular attention by the government is incineration. Incineration of solid waste is rather new in Malaysia, with limited usage in handling small sources of waste generation such as the municipal solid waste (MSW) of resort islands; however, its potential in ameliorating the problems associated with solid waste treatment may make it an attractive alternative to landfill. This article presents the results of test runs conducted to investigate the performance of a locally designed and manufactured rotary kiln incinerator (RKI). The test runs were conducted using MSW collected from the Shah Alam municipality. The combustion efficiency was analyzed by looking at the temperature profiles and chemical species concentrations. To complement the combustion characteristics measurements, predictions of the air flow in the incinerator during the process were also investigated. The overall performance of the RKI suggests that it is suitable for treating MSW.     

Lysimeter Experiments to Investigate the Fate of Chemicals in Soils – Comparison of Five Different Lysimeter Systems

Several lysimeter scenarios and approaches exist to study the fate of agro-chemicals or contaminants from deposition in soil columns. In many systems just transport and leaching of the parent compound is followed, in some systems the leaching and transport of the metabolites is investigated as well. In more sophisticated lysimeter systems the volatilization and also the mineralization of the applied chemicals can be additionally monitored. Depending on the lysimeter system used and on the fact whether the applied chemicals are ¹⁴C-labeled or not, different results and various interpretations of the results might be achieved. Different lysimeter systems are described in this paper and a real dataset of a specific lysimeter experiment was transferred and evaluated in a virtual approach in the different lysimeter systems in order to show the advantages and disadvantages of the various systems.     

建筑火灾烟流运动特性网络模型的求解收敛性

分析了运用网络模型模拟建筑火灾烟流的计算过程,通过总结影响网络模型求解精度及收敛性的关键因素,改进了原烟流预测软件对建筑物各开口的净、正、负质量流量的算法。改进后的模型消除了振荡效应,模拟结果曲线平滑稳定,实现了运用网络模型对多室建筑物烟流特性的模拟计算。     

High-frequency measurements reveal spatial and temporal patterns of dissolved organic matter in an urban water conveyance

Stormwater runoff in urban areas can contribute high concentrations of dissolved organic matter (DOM) to receiving waters, potentially causing impairment to the aquatic ecosystem of urban streams and downstream water bodies. Compositional changes in DOM due to storm events in forested, agricultural, and urban landscapes have been well studied, but in situ sensors have not been widely applied to monitor stormwater contributions in urbanized areas, leaving the spatial and temporal characteristics of DOM within these systems poorly understood. We deployed fluorescent DOM (FDOM) sensors at upstream and downstream locations within a study reach to characterize the spatial and temporal changes in DOM quantity and sources within an urban water conveyance that receives stormwater runoff. Baseflow FDOM decreased over the summer season as seasonal flows upstream transported less DOM. FDOM fluctuated diurnally, the amplitude of which also declined as the summer season progressed. During storms, FDOM concentrations were rapidly elevated to values orders of magnitude greater than baseflow measurements, with greater concentrations at the downstream monitoring site, revealing high contributions from stormwater outfalls between the two locations. Observations from custom, in situ fluorometers resembled results obtained using laboratory methods for identifying DOM source material and indicated that DOM transitioned to a more microbially derived composition as the summer season progressed, while stormwater contributions contributed DOM from terrestrial sources. Deployment of a mobile sensing platform during varying flow conditions captured spatial changes in DOM concentration and composition and revealed contributions of DOM from outfalls during stormflows that would have otherwise been unobserved.