Physical resuspension and vertical mixing of sediments on a high energy continental margin (Sydney, Australia)

Four sediment cores from the continental margin adjacent to Sydney were analyzed for 210Pb, 137Cs, trace metals (Ag, Cd, Co, Cu, Mn, Ni, Pb, Zn), iron, dry bulk density, mud and moisture content. The concentrations of trace metals in the total sediment are low at all sites, although slightly elevated concentrations of Ag, Cu, Pb and Zn are present in the fine fraction of sediment (< 62.5 microns) near a major ocean outfall. Concentrations of trace metals in the fine fraction of sediment are similar in the upper 10-15 cm, indicating strong vertical mixing of the sediments, whereas an upward coarsening grain size in the upper 1-3 cm of sediment supports physical resuspension during storms. Sediment accumulation rates on the middle shelf adjacent to Sydney were estimated from downcore profiles of 210Pb and 137Cs and range between 0.2 and 0.4 cm yr-1. Although the mass fluxes of Cu, Pb and Zn within a distance of 2 km from the outfall (up to 36.1, 30.8 and 86.2 micrograms cm-2 yr-1, respectively) are greater than 20 km north of the outfall (< 23.5 micrograms cm-2 yr-1), the low concentrations of trace metals in sediments near the outfall support an efficient dispersal of anthropogenic contaminants on this continental margin.     

Decolorization of Remazol Black-B using a thermotolerant yeast, Kluyveromyces marxianus IMB3

The ability of Kluyveromyces marxianus IMB3 to decolorize Remazol Black-B dye was investigated. The effect of environmental conditions, such as pH and temperature were examined. No noticeable effects on decolorization were observed when pH varied from 3.0-5.5. Maximum colour removal, 98%, was achieved at 37 degrees C. Little or no colour removal was detected when K. marxianus IMB3 was incubated under anaerobic conditions. Further investigation, in which decolorization was monitored under extreme temperatures and low pH (to inhibit growth) and using ten fold dense inoculum, revealed that decolorization was due to biosorption to the yeast cells and not due to a metabolic reaction.     

The use of ultra filtration in trace metal speciation studies in sea water

During this work, size fractionation technique "ultra filtration" is used in speciation studies of trace elements in the coastal sea water. Filtration is the most commonly used method to fractionate trace metal species, but often only "dissolved" and "particulate" fraction. The purpose of the present study is to determine colloidal and suspended particulate concentrations of Fe, Zn, Cu, Ni, and Mn in sea water. Suspended particulate matter were separated in three different size groups namely (>2.7 microm, <2.7->0.45 microm and <0.45->0.22 microm) by suction filtration using cellulose acetate and nitrate filter membranes. Thereafter to concentrate the solution with colloidal particle <0.22 microm-1.1 nm (0.5 k Nominal Molecular Weight cut-off Limit {NMWL}), the solution obtained from filtration through <0.22 microm, is sequentially passed through the ultra-filtration membranes having pore diameters of 14 nm (300 k NMWL), 3.1 nm (50 k NMWL), 2.2 nm (30 k NMWL), 1.6 nm (10 k NMWL) and 1.1 nm (0.5 k NMWL) by using Stirred Ultra-filtration Cells, operating in concentration mode. The concentration of Fe, Zn, Cu, Ni, and Mn were measured in suspended and dissolved fraction by ion chromatography, ICP-AES and Atomic Absorption Spectrometer. The salinity of the solution in various dissolved fractions of sequential filtration varies between 30.89-34.22 parts per thousand. The maximum concentrations of colloidal Zn, Cu, Ni and Mn in dissolved fraction were in <2.2->1.6 nm fraction. In case of Fe, colloidal fractions <2.2->1.6 nm and <1.6-<1.1 nm shows higher concentration. The concentration of Zn, Cu, Ni and Mn increase with decrease in size in suspended particulate matter, while the reverse is observed in case of Fe. This size separation data that specifies the partitioning of metals between dissolved and suspended solid phases is necessary for developing physically based models of metal transport in aquatic system.     

Carbon emission reduction and cost–benefit of methane digester systems on hog farms in China

Three different sizes of hog farms were selected to analyze the carbon emissions reduction and the cost–benefit of three methane digester systems. The sizes of the digesters are 2,200, 2,200 and 800 m³, respectively. The sales of slaughter hogs from them are 50,000, 35,000 and 10,000 head, respectively. The carbon emissions reductions were 5,237, 4,017, and 1,334 tons, respectively. The results show that while the methane digester systems have a significant effect on carbon emissions reduction, it is difficult to operate the systems sustainably. If the carbon emissions reduction can be traded at high enough prices in the carbon offset markets, then the systems will be profitable and sustainable. Newly established China's domestic carbon offset market could provide this possibility, but more government support is needed. In addition, this study shows that scale economies make the digester adoption relatively more profitable for larger farms than smaller ones.     

Augmenting Watershed Model Calibration with Incorporation of Ancillary Data Sources and Qualitative Soft Data Sources

Watershed simulation models such as the Soil & Water Assessment Tool (SWAT) can be calibrated using “hard data” such as temporal streamflow observations; however, users may find upon examination of model outputs, that the calibrated models may not reflect actual watershed behavior. Thus, it is often advantageous to use “soft data” (i.e., qualitative knowledge such as expected denitrification rates that observed time series do not typically exist) to ensure that the calibrated model is representative of the real world. The primary objective of this study is to evaluate the efficacy of coupling SWAT‐Check (a post‐evaluation framework for SWAT outputs) and IPEAT‐SD (Integrated Parameter Estimation and Uncertainty Analysis Tool‐Soft & hard Data evaluation) to constrain the bounds of soft data during SWAT auto‐calibration. IPEAT‐SD integrates 59 soft data variables to ensure SWAT does not violate physical processes known to occur in watersheds. IPEAT‐SD was evaluated for two case studies where soft data such as denitrification rate, nitrate attributed from subsurface flow to total discharge ratio, and total sediment loading were used to conduct model calibration. Results indicated that SWAT model outputs may not satisfy reasonable soft data responses without providing pre‐defined bounds. IPEAT‐SD provides an efficient and rigorous framework for users to conduct future studies while considering both soft data and traditional hard information measures in watershed modeling.     

Institutional Constraints on Cost‐Effective Water Management: Selenium Contamination in Colorado's Lower Arkansas River Valley

Ground and surface water selenium (Se) contamination is problematic throughout the world, leading to harmful impacts on aquatic life, wildlife, livestock, and humans. A groundwater reactive transport model was applied to a regional‐scale irrigated groundwater system in the Lower Arkansas River Basin in southeastern Colorado to identify management practices that remediate Se contamination. The system has levels of surface water and groundwater Se concentrations exceeding the respective chronic standard and guidelines. We evaluate potential solutions by combining the transport model with an assessment of the cost to employ those practices. We use a framework common in economics and engineering fields alike, the Pareto frontier, to show the impact of four different best management practices on the tradeoffs between Se and cost objectives. We then extend that analysis to include institutional constraints that affect the economic feasibility associated with each practice. Results indicate that although water‐reducing strategies have the greatest impact on Se, they are the hardest for farmers to implement given constraints common to western water rights institutions. Therefore, our analysis shows that estimating economic and environmental tradeoffs, as is typically done with a Pareto frontier, will not provide an accurate picture of choices available to farmers where institutional constraints should also be considered.     

Governing sustainability: a dialogue between Local Agenda 21 and transition management

Since the 1990s, the local level of governance has become increasingly important in addressing the challenge of sustainable development. In this article, we compare two approaches that seek to address sustainability locally, namely Local Agenda 21 and transition management. Discussing both approaches along six dimensions (history, aim, kind of change, governance understanding, process methodologies, and actors), we formulate general insights into the governance of sustainability in cities, towns, and neighbourhoods. This dialogue illustrates two related modes of thinking about sustainability governance. We touch upon the importance of an integrated perspective on sustainability transitions through which sustainability is made meaningful locally in collaborative processes. We suggest that the explicit orientation towards radical change is a precondition for governing sustainability in a way that addresses the root causes of societal challenges. Governing sustainability should address the tensions between aiming for radical change and working with status quo-oriented actors and governing settings. We conclude that governing sustainability should be about finding creative ways for opening spaces for participation, change, and experimentation, that is, for creating alternative ideas, practices, and social relations. These spaces for innovation encourage a reflexive stance on ways of working and one's own roles and attitudes, thereby preparing a fertile terrain for actors to engage in change from different perspectives.     

Household food waste: the implications of consumer choice in food from purchase to disposal

Food and food-related waste is a high priority in terms of waste minimisation in New Zealand. Over the summer of 2012–2013, a survey of 147 participants was conducted on a range of views and practices related to environmental challenges and understandings. The survey, undertaken in Palmerston North, New Zealand, captured a wide socio-demographic. This article focuses on respondents’ food practices from purchase, to plate, to disposal and the environmental implications of these practices. The survey data have allowed an enriched understanding of both individual and structural level challenges as well as incentives towards improving environmental practices in relation to household food waste minimisation. The results indicated that, in keeping with other research in this area, food waste increases according to the number of individuals in a household, and in particular the number of younger people. Also, while the majority of participants were at least “somewhat concerned” about their households’ environmental impact, over three quarters of participant households put food waste into their rubbish bin. Some solutions and directions to further progress research, policy, and practice in this area are offered, and include the need for more direct and personalised communication regarding waste minimisation, along with the provision of kerbside food waste collections. It is clear that individual- or household-level changes are important and must be supported systemically by both local body and state level legislation and initiatives, if there is to be any substantial decline in food waste going to landfill.