Application of lime and calcium hypochlorite in the dephenolisation and discolouration of olive mill wastewater

The application of hypochlorite for the removal of soluble COD, phenolic and polyphenolic like compounds, and other organic compounds responsible for the olive mill wastewater (OOWW) colour has been experimentally studied. After the OOWW filtration on a sand column, the effluent was subjected to a fast liming under optimal conditions. Lime application reduced polyphenols, COD and SS contents to half of their initial values but an important blackening of the treated OOWW was observed, especially when adding high concentrations of lime (10% (W/V) and 15% (W/V)).A second stage of treatment was applied using calcium hypochlorite. In this stage, removal of the studied compounds reached as much as 95% at higher concentrations, and particularly the colouring of OOWW which is generally difficult to eliminate was greatly reduced. The OOWW hypochloration acted through coagulation–flocculation and a rapid oxidation of the organic matter proceeded from the first 5 min. The kinetic study of the degradation of the waste polluting compounds from liming showed that Ca(ClO)₂ reacts similarly in the elimination of organic compounds, polyphenols, SS and colouration. The analysis of the organochloride compounds generated by the reaction between hypochlorite and the organic compounds showed that DDD, DDT and the heptachlor contents exceeded the values recommended by the International and European drinking water standards.     

Efficiency of perchlorate consumption in road flares, propellants and explosives

When an explosive detonates or a propellant or flare burns, consumption of the energetic filler should be complete but rarely is, especially in the presence of large amounts of non-combustible materials. Herein we examine three types of perchlorate-containing devices to estimate their potential as sources of contamination in their normal mode of functioning. Road flares, rocket propellants and ammonium nitrate (AN) emulsion explosives are potentially significant anthropogenic sources of perchlorate contamination. This laboratory evaluated perchlorate residue from burning of flares and propellants as well as detonations of ammonium nitrate emulsion explosives. Residual perchlorate in commercial products ranged from 0.094 mg perchlorate per gram material (flares) to 0.012 mg perchlorate per gram material (AN emulsion explosives). The rocket propellant formulations, prepared in this laboratory, generated 0.014 mg of perchlorate residue per gram of material.     

Assessing water use and quality through youth participatory research in a rural Andean watershed

Water availability, use and quality in a rural watershed of the Colombian Andes were investigated through participatory research involving local youth. Research included the quantification of disaggregated water use at the household level; comparison of water use with availability; monitoring water quality of streams, community water intakes and household faucets; and the determination of land use – water quality interactions. Youth were involved in all aspects of the research from design to implementation, dissemination of results and remediation options. Quantification of domestic and on-farm water use, and water availability indicated that water availability was sufficient during the study period, but that only an 8% decrease in dry season supply would result in shortages. Elevated conductivity levels in the headwaters were related to “natural” bank erosion, while downstream high conductivity and coliform levels were associated with discharges from livestock stalls and poorly maintained septic tanks in the stream buffer zone. Through the involvement of youth as co-investigators, the knowledge generated by the research was appropriated at the local level. Community workshops led by local youth promoted water conservation and water quality protection practices based on research, and resulted in broader community participation in water management. The approach involving youth in research stimulated improved management of both land and water resources, and could be applied in small rural watersheds in developed or developing countries.     

Constraints to Watershed Planning: Group Structure and Process1

Floress, Kristin, Jean C. Mangun, Mae A. Davenport, and Karl W.J. Williard, 2009. Constraints to Watershed Planning: Group Structure and Process. Journal of the American Water Resources Association (JAWRA) 45(6):1352‐1360. Abstract: The roles that agencies and other partners play in collaborative watershed management are not always clearly identified. Key factors contributing to group‐level outcomes in watershed groups include both structural and procedural elements. Structural elements include membership systems, project partners, and funding, while procedural elements include leadership, shared vision, and mission development. The current research reports on a case study conducted with a Midwestern watershed group that received Clean Water Act Section 319 funds to undertake a watershed planning process. Data come from focus groups, interviews, public comments, and meeting observation, and were analyzed using grounded theory. Findings of this study indicate that homogenous skill set, discord over group and partner roles, and failed problem identification contributed to the organizational inertia experienced by the watershed group. Implications of this research for groups receiving 319 funds are provided.     

Influence of content and particle size of waste pet bottles on concrete behavior at different w/c ratios

The goal of this work was to study the mechanical behavior of concrete with recycled Polyethylene Therephtalate (PET), varying the water/cement ratio (0.50 and 0.60), PET content (10 and 20 vol%) and the particle size. Also, the influence of the thermal degradation of PET in the concrete was studied, when the blends were exposed to different temperatures (200, 400, 600 °C). Results indicate that PET-filled concrete, when volume proportion and particle size of PET increased, showed a decrease in compressive strength, splitting tensile strength, modulus of elasticity and ultrasonic pulse velocity; however, the water absorption increased. On the other hand, the flexural strength of concrete-PET when exposed to a heat source was strongly dependent on the temperature, water/cement ratio, as well as on the PET content and particle size. Moreover, the activation energy was affected by the temperature, PET particles location on the slabs and water/cement ratio.     

Geopolymerisation of silt generated from construction and demolition waste washing plants

Recycling plants that size, sort and wash construction and demolition waste can produce high quality aggregate. However, they also produce up to 80ton per hour of filter cake waste containing fine (<63mum) silt particles that is classified as inert waste and normally landfilled. This research investigated the potential to form geopolymers containing silt, which would allow this problematic waste to be beneficially reused as aggregate. This would significantly improve the economic viability of recycling plants that wash wastes. Silt filter cakes have been collected from a number of aggregate washing plants operating in the UK. These were found to contain similar aluminosilicate crystalline phases. Geopolymer samples were produced using silt and silt mixed with either metakaolin or pulverised fuel ash (PFA). Silt geopolymers cured at room temperature had average 7-day compressive strengths of 18.7MPa, while partial substitution of silt by metakaolin or PFA increased average compressive strengths to 30.5 and 21.9MPa, respectively. Curing specimens for 24h at 105 degrees C resulted in a compressive strength of 39.7MPa and microstructural analysis confirmed the formation of dense materials. These strengths are in excess of those required for materials to be used as aggregate, particularly in unbound applications. The implications of this research for the management of waste silt at construction and demolition waste washing plants are discussed.     

Influences of chemical activators on incinerator bottom ash

This research has applied different chemical activators to mechanically and thermally treated fine fraction (<14 mm) of incinerator bottom ash (IBA), in order to investigate the influences of chemical activators on this new pozzolanic material. IBA has been milled and thermally treated at 800 degrees C (TIBA). The TIBA produced was blended with Ca(OH)(2) and evaluated for setting time, reactivity and compressive strength after the addition of 0.0565 mole of Na(2)SO(4), K(2)SO(4), Na(2)CO(3), K(2)CO(3), NaOH, KOH and CaCl(2) into 100g of binder (TIBA+Ca(OH)(2)). The microstructures of activated IBA and hydrated samples have been characterized by X-ray diffraction (XRD) and thermogravimetry (TG) analysis. Thermal treatment is found to produce gehlenite (Ca(2)Al(2)SiO(7)), wollastonite (CaSiO(3)) and mayenite (Ca(12)Al(14)O(33)) phases. The thermally treated IBA samples are significantly more reactive than the milled IBA. The addition of Na(2)CO(3) can increase the compressive strength and calcium hydroxide consumption at 28-day curing ages. However, the addition of Na(2)SO(4), K(2)SO(4), K(2)CO(3), NaOH and KOH reduces the strength and hydration reaction. Moreover, these chemicals produce more porous samples due to increased generation of hydrogen gas. The addition of CaCl(2) has a negative effect on the hydration of TIBA samples. Calcium aluminium oxide carbonate sulphide hydrate (Ca(4)Al(2)O(6)(CO(3))(0.67)(SO(3))(0.33)(H(2)O)(11)) is the main hydration product in the samples with activated IBA, except for the sample containing CaCl(2).     

Methane generation in tropical landfills: simplified methods and field results

This paper deals with the use of simplified methods to predict methane generation in tropical landfills. Methane recovery data obtained on site as part of a research program being carried out at the Metropolitan Landfill, Salvador, Brazil, is analyzed and used to obtain field methane generation over time. Laboratory data from MSW samples of different ages are presented and discussed; and simplified procedures to estimate the methane generation potential, Lo, and the constant related to the biodegradation rate, k are applied. The first order decay method is used to fit field and laboratory results. It is demonstrated that despite the assumptions and the simplicity of the adopted laboratory procedures, the values Lo and k obtained are very close to those measured in the field, thus making this kind of analysis very attractive for first approach purposes.     

Bench-scale composting of source-separated human faeces for sanitation

In urine-diverting toilets, urine and faeces are collected separately so that nutrient content can be recycled unmixed. Faeces should be sanitized before use in agriculture fields due to the presence of possible enteric pathogens. Composting of human faeces with food waste was evaluated as a possible method for this treatment. Temperatures were monitored in three 78-L wooden compost reactors fed with faeces-to-food waste substrates (F:FW) in wet weight ratios of 1:0, 3:1 and 1:1, which were observed for approximately 20 days. To achieve temperatures higher than 15 degrees C above ambient, insulation was required for the reactors. Use of 25-mm thick styrofoam insulation around the entire exterior of the compost reactors and turning of the compost twice a week resulted in sanitizing temperatures (>or=50 degrees C) to be maintained for 8 days in the F:FW=1:1 compost and for 4 days in the F:FW=3:1 compost. In these composts, a reduction of >3 log(10) for E. coli and >4 log(10) for Enterococcus spp. was achieved. The F:FW=1:0 compost, which did not maintain >or=50 degrees C for a sufficiently long period, was not sanitized, as the counts of E. coli and Enterococcus spp. increased between days 11 and 15. This research provides useful information on the design and operation of family-size compost units for the treatment of source-separated faeces and starchy food residues, most likely available amongst the less affluent rural/urban society in Uganda.