Spiroplasma infection causes either early or late male killing in <Emphasis Type="Italic">Drosophila</Emphasis>, depending on maternal host age

Symbiont-induced male-killing phenotypes have been found in a variety of insects. Conventionally, these phenotypes have been divided into two categories according to the timing of action: early male killing at embryonic stages and late male killing at late larval stages. In Drosophila species, endosymbiotic bacteria of the genus Spiroplasma have been known to cause early male killing. Here, we report that a spiroplasma strain normally causing early male killing also induces late male killing depending on the maternal host age: male-specific mortality of larvae and pupae was more frequently observed in the offspring of young females. As the lowest spiroplasma density and occasional male production were also associated with newly emerged females, we proposed the density-dependent hypothesis for the expression of early and late male-killing phenotypes. Our finding suggested that (1) early and late male-killing phenotypes can be caused by the same symbiont and probably by the same mechanism; (2) late male killing may occur as an attenuated expression of early male killing; (3) expression of early and late male-killing phenotypes may be dependent on the symbiont density, and thus, could potentially be affected by the host immunity and regulation; and (4) early male killing and late male killing could be alternative strategies adopted by microbial reproductive manipulators.     

Body mass estimations for <Emphasis Type="Italic">Plateosaurus engelhardti</Emphasis> using laser scanning and 3D reconstruction methods

Both body mass and surface area are factors determining the essence of any living organism. This should also hold true for an extinct organism such as a dinosaur. The present report discusses the use of a new 3D laser scanner method to establish body masses and surface areas of an Asian elephant (Zoological Museum of Copenhagen, Denmark) and of Plateosaurus engelhardti, a prosauropod from the Upper Triassic, exhibited at the Paleontological Museum in Tübingen (Germany). This method was used to study the effect that slight changes in body shape had on body mass for P. engelhardti. It was established that body volumes varied between 0.79 m³ (slim version) and 1.14 m³ (robust version), resulting in a presumable body mass of 630 and 912 kg, respectively. The total body surface areas ranged between 8.8 and 10.2 m², of which, in both reconstructions of P. engelhardti, ∼33% account for the thorax area alone. The main difference between the two models is in the tail and hind limb reconstruction. The tail of the slim version has a surface area of 1.98 m², whereas that of the robust version has a surface area of 2.73 m². The body volumes calculated for the slim version were as follows: head 0.006 m³, neck 0.016 m³, fore limbs 0.020 m³, hind limbs 0.08 m³, thoracic cavity 0.533 m³, and tail 0.136 m³. For the robust model, the following volumes were established: 0.01 m³ head, neck 0.026 m³, fore limbs 0.025 m³, hind limbs 0.18 m³, thoracic cavity 0.616 m³, and finally, tail 0.28 m³. Based on these body volumes, scaling equations were used to assess the size that the organs of this extinct dinosaur have.     

Conditions controlling the onset of breeding migration of the Japanese mountain stream frog, <Emphasis Type="Italic">Rana sakuraii</Emphasis>

I studied the conditions controlling the timing of breeding migration of the Japanese mountain stream frog Rana sakuraii, an explosive breeder, over 9 years (1992, 1993 and 1999–2005). I analysed two factors: the daily cumulative temperature (DCT) during hibernation and the triggering temperature on the day of migration onset. Frogs hibernated in shallow running water in streams in December. A total of 53,155 breeding migrating adults were captured by traps. Every year, breeding migration was induced by a rise in daily maximum water temperature to about 5°C. However, its date was limited to 1 February at the earliest, and the onset needed a DCT (from 20 January, using 3°C as the threshold for daily effective temperature) of at least about 15°C. Earlier (e.g. in mid- or late January), even if the maximum temperature rose to 5–8°C, migration did not begin. Moreover, even in early February, if the maximum temperature rose to 5°C, if it had been too cold in January and the DCT was low, migration would not begin until mid- or late February. Thus, the earliest date of readiness for migration varied from 1 February to mid-February, depending on the winter DCT. Logistic regression analyses showed that both factors, the DCT and the daily temperature, were significant. I propose that in temperate-zone amphibian explosive breeders, both the passing of an essential number of days and an essential DCT during hibernation are prerequisites for the onset of breeding migration before the daily temperature rises to the threshold.     

Prenatal cannibalism in an insect

Host selection and infection strategies of parasitoids often correlate with high parental investment and low numbers of progeny. In this study, we investigate how additional internal mechanisms might shape brood size and fitness of the offspring. Emblemasoma auditrix is a parasitoid fly in which about 38 larvae hatch simultaneously in utero. After host location, a single larva is deposited into the host, where it rapidly develops and pupates after about 5 days. The search for hosts can take several weeks, and during that time, the larvae arrest their development and remain in the first larval instar. Nevertheless, the larvae increase in weight within the uterus, and this growth correlates to a decrease in the number of larvae, although no larvae are deposited. Thus, our data indicate a first case of prenatal cannibalism in an invertebrate with larvae feeding on each other within the uterus of the adult.     

A new THOR shoulder design: a comparison with volunteers, the Hybrid III, and THOR NT

OBJECTIVE: Since the shoulders are rarely seriously injured in frontal or oblique collisions, they have been given low priority in the development of frontal impact crash test dummies. The shoulder complex geometry and its kinematics are of vital importance for the overall dummy kinematics. The shoulder complex also influences the risk of the safety belt slipping off the shoulder in oblique forward collisions. The first aim of this study was to develop a new 50th percentile male THOR shoulder design, while the second was to compare the new shoulder, mounted on a THOR NT dummy, with volunteer, THOR NT, and Hybrid III range of motion and stiffness data. The third aim was to test the repeatability of the new shoulder during dynamic testing and to see how the design behaves with respect to belt slippage in a 45 degrees far-side collision. METHODS: The new 50th percentile THOR shoulder design was developed with the aid of a shell model of the seated University of Michigan Transportation Research Institute (UMTRI) 50th percentile male with coordinates for joints and bony landmarks (Schneider et al., 1983). The new shoulder design has human-like bony landmarks for the acromion and coracoid processes. The clavicle curvature and length are also made similar to that of a male human, as is the range of motion in the anterior-posterior, superior-inferior, and medial-lateral directions. The new shoulder design was manufactured and tested under the same conditions that T?rnvall et al. (2005b) used to compare the shoulder range of motion for the volunteers, Hybrid III, and THOR Alpha. The new design was also tested in two dynamic test configurations: the first was a 0 degrees full-frontal test and the second was a 45 degrees far-side test. The dummy tests were conducted with an R-16 seat with a three-point belt, the Delta V was 27.0+/-0.5 km/h and the maximum peak acceleration was approximately 14.6+/-0.5 g for each test. RESULTS: A new shoulder design with geometry close to that of humans was developed to be retrofitted to the THOR NT dummy. The results showed that the range of motion for the new shoulder complex during static loading was larger by at least a factor of three, for the maximum load (200 N/arm), than that of either the Hybrid III or the THOR NT; this means it was more similar to the volunteers' range of motion. It was observed that the THOR NT with the new shoulder did not slide out of the shoulder belt during a far-side collision. The performance of the new shoulder was reasonably repeatable and stable during both the static tests and the sled tests. CONCLUSION: A new shoulder for the THOR NT has been designed and developed, and data from static range of motion tests and sled tests indicate that the new shoulder complex has the potential to function in a more human-like manner on the THOR dummy.     

First Castorid (Mammalia,Rodentia) from the Middle Miocene of Southeast Asia

Today and in the Tertiary, the geographical distribution of castorids is limited throughout all of the northern continents. Fossils of the Castoridae genus Steneofiber are abundant in many localities of Eurasia from the late Oligocene to Pliocene period. Recently, Steneofiber fossils were discovered in two localities of northern Thailand, Mae Moh and Chiang Muan coal mines, in layers of late middle Miocene age. These discoveries represent the first records of castorids from Southeast Asia and correspond to their southernmost known range. The focus of this study is to describe this new Thai species of Steneofiber and to define its wear stages from the molar occlusal surfaces by using micro-CT scan analysis. The CT scan technique permits the analysis of the virtual occlusal surface changes from wear, allowing easier comparison to related species of Steneofiber cheek teeth without destroying the teeth. The new species, Steneofiber siamensis n. sp., can be distinguished from the other species of Steneofiber by several distinct characters, longer mesostriid on p4, presence of premesostria and metastria on P4, which are smaller than most of the other known species. The occurrence of this new castorid also supports a subtropical to tropical paleoclimate for these two localities of northern Thailand.     

An individual and a sex odor signature in kittiwakes? Study of the semiochemical composition of preen secretion and preen down feathers

The importance of olfaction in birds’ social behavior has long been denied. Avian chemical signaling has thus been relatively unexplored. The black-legged kittiwake provides a particularly appropriate model for investigating this topic. Kittiwakes preferentially mate with genetically dissimilar individuals, but the cues used to assess genetic characteristics remain unknown. As in other vertebrates, their body odors may carry individual and sexual signatures thus potentially reliably signaling individual genetic makeup. Here, we test whether body odors in preen gland secretion and preen down feathers in kittiwakes may provide a sex and an individual signature. Using gas chromatography and mass spectrometry, we found that male and female odors differ quantitatively, suggesting that scent may be one of the multiple cues used by birds to discriminate between sexes. We further detected an individual signature in the volatile and nonvolatile fractions of preen secretion and preen down feathers. These results suggest that kittiwake body odor may function as a signal associated with mate recognition. It further suggests that preen odor might broadcast the genetic makeup of individuals, and could be used in mate choice to assess the genetic compatibility of potential mates.     

Distribution of nuclear bomb Pu in Nishiyama area, Nagasaki, estimated by accurate and precise determination of 240Pu/239Pu ratio in soils

Plutonium isotopes in forest soils collected in Nishiyama area, Nagasaki, were successfully determined by high resolution inductively coupled plasma mass spectrometry after the treatment with a microwave decomposition system. The (240)Pu/(239)Pu atom ratios observed in the samples in the Nishiyama area were obviously lower than the range of the global fallout. The low ratios (minimum 0.032) observed in Nishiyama area indicated the influence of detonation of the Pu nuclear weapon in 1945. Since the area is contaminated also by global fallout, the (240)Pu/(239)Pu atom ratio can be more sensitive indicator of bomb-derived Pu than Pu activity concentration.     

Impact of gamma irradiation on the transformation efficiency for extracellular plasmid DNA

Extracellular DNA is omnipresent in aquatic environments and is thought to be a genetic material for horizontal gene transformation between microorganisms. We studied the impact of gamma irradiation on the transformation efficiency (transformants number per ng of DNA per ml) of extracellular DNA. Plasmid pEGFP as a model extracellular DNA was irradiated by gamma rays. The transformation efficiency decreased with the increase in radiation dose. A total dose of 10Gy is normally not lethal for microorganisms but certainly affects the transformation efficiency of extracellular DNA. The decrease in the efficiency would be induced by strand breaks of extracellular DNA because the yield of both single-strand breaks (SSBs) and double-strand breaks (DSBs) increased with the increase in radiation dose. The relative transformation efficiency of SSBs and DSBs to that of covalently closed circles (CCCs) was 30.3% and 0.2%, respectively. This impact on natural transformation suggests an inability of microorganisms to acquire new characteristics which should be normally acquired.     

Probabilistic risk assessment for long-range atmospheric transport of radionuclides

A simplified means of probabilistic risk assessment (PRA) for long-range atmospheric transport based on a K-diffusion model is presented. In a case study, model parameters are estimated by comparing with the results of long-range atmospheric dispersion model calculations using one-year numerical weather prediction model data. It is found that the estimated ensemble mean provides a reasonable first approximation to the total dry and wet deposition from the one-year continuous release.