Preimplantation genetic diagnosis for familial amyloidotic polyneuropathy (FAP)

Preimplantation genetic diagnosis (PGD) was developed more than a decade ago to offer an alternative to prenatal diagnosis for couples at risk of transmitting an inherited disease to their offspring. Portuguese-type familial amyloidotic polyneuropathy (FAP type I), is an autosomal dominant disease presenting an inherited mutation in the gene encoding the plasma protein transthyretin (TTR). We here report the first protocol for single-cell detection of the Met30 mutation in FAP type I and its application to PGD. A nested PCR reaction for exon 2 of the TTR gene was developed. The PCR product was then analysed by restriction enzyme analysis and SSCP allowing the detection of the point mutation. Ten clinical cycles were performed in seven couples. From the 93 metaphase II (MII) injected oocytes, 82 were normally fertilized and 78 were biopsied. A positive signal in the nested PCR reaction was obtained in 61 blastomeres, corresponding to a DNA amplification efficiency of 78.2%. No allele dropout (ADO) or contamination were detected. A biochemical pregnancy was obtained in three cases and a clinical pregnancy in one couple is actually in normal evolution. Copyright © 2001 John Wiley & Sons, Ltd.     

Simulation and life cycle assessment of process design alternatives for biodiesel production from waste vegetable oils

This study uses the process simulator ASPEN Plus^® and Life Cycle Assessment (LCA) to compare three process design alternatives for biodiesel production from waste vegetable oils that are: the conventional alkali-catalyzed process including a free fatty acids (FFAs) pre-treatment, the acid-catalyzed process, and the supercritical methanol process using propane as co-solvent. Results show that the supercritical methanol process using propane as co-solvent is the most environmentally favorable alternative. Its smaller steam consumption in comparison with the other process design alternatives leads to a lower contribution to the potential environmental impacts (PEI’s). The acid-catalyzed process generally shows the highest PEI’s, in particular due to the high energy requirements associated with methanol recovery operations.     

Anaerobic degradation of hexachlorocyclohexane isomers in liquid and soil slurry systems

Gamma-hexachlorocyclohexane (gamma-HCH or lindane), one of the most commonly used insecticides, has been mainly used in agriculture. Organochloride compounds are known to be highly toxic and persistent, causing serious water and soil pollution. The objective of the present study is the evaluation of the anaerobic degradation of alpha-, beta-, gamma-, delta-HCH in liquid and slurry cultures. The slurry system with anaerobic sludge appears as an effective alternative in the detoxification of polluted soils with HCH, as total degradation of the four isomers was attained. While alpha- and gamma-HCH disappeared after 20-40d, the most recalcitrant isomers: beta- and delta-HCH were only degraded after 102d. Intermediate metabolites of HCH degradation as pentachlorocyclohexane (PCCH), tetrachlorocyclohexene (TCCH), tri-, di- and mono-chlorobenzenes were observed during degradation time.     

Sequential removal of heavy metals ions and organic pollutants using an algal-bacterial consortium

The residual algal-bacterial biomass from photosynthetically supported, organic pollutant biodegradation processes, in enclosed photobioreactors, was tested for its ability to accumulate Cu(II), Ni(II), Cd(II), and Zn(II). Salicylate was chosen as a model contaminant. The algal-bacterial biomass combined the high adsorption capacity of microalgae with the low cost of the residual biomass, which makes it an attractive biosorbent for environmental applications. Cu(II) was preferentially taken-up from the medium when the metals were present both separately and in combination. There was no observed competition for adsorption sites, which suggested that Cu(II), Ni(II), Cd(II), and Zn(II) bind to different sites and that active Ni(II), Cd(II) and Zn(II) binding groups were present at very low concentrations. Therefore, special focus was given to Cu(II) biosorption. Cu(II) biosorption by the algal-bacterial biomass was characterized by an initial fast cell surface adsorption followed by a slower metabolically driven uptake. pH, Cu(II), and algal-bacterial concentration significantly affected the biosorption capacity for Cu(II). Maximum Cu(II) adsorption capacities of 8.5+/-0.4 mg g-1 were achieved at an initial Cu(II) concentration of 20 mg l-1 and at pH 5 for the tested algal-bacterial biomass. These are consistent with values reported for other microbial sorbents under similar conditions. The desorption of Cu(II) from saturated biomass was feasible by elution with a 0.0125 M HCl solution. Simultaneous Cu(II) and salicylate removal in a continuous stirred tank photobioreactor was not feasible due to the high toxicity of Cu(II) towards the microbial culture. The introduction of an adsorption column, packed with the algal-bacterial biomass, prior to the photobioreactor reduced Cu(II) concentration, thereby allowing the subsequent salicylate biodegradation in the photobioreactor.     

Dissipation of DDT in a heavily contaminated soil in Mato Grosso, Brazil

After the prohibition of organochlorine-pesticide use in Brazil for controlling insect vector diseases, Mato Grosso State gathered the exceeding DDT and stored it irregularly in an open air area that belongs to the National Health Foundation, causing soil contamination. This study aimed to evaluate the contamination level and dissipation of p,p'-DDT and p,p'-DDE in this area. For that, surface soil samples were collected on 19 September 2000, 15 December 2000, 4 April 2001 and soil samples 30-40 cm; 60-70 cm and 90-100 cm deep were taken from five points in the studied area on 17 July 2001. The contaminants were determined by a small scale method which consists on extraction and clean-up steps combined into one step by transferring soil samples mixed with neutral alumina to a chromatographic column prepacked with neutral alumina and elution with hexane:dichloromethane (7:3 v:v). The eluate was concentrated and the analytes were quantified by gas chromatography with an electron-capture detector. p,p'-DDT at surface soil ranged from 3,800 to 7,300 mg kg(-1). 30-40 cm deep soil sample concentrations varied from 0.036 to 440 mg kg(-1) while 90-100 cm deep samples varied from 0.069 to 180 mg kg(-1). Volatilization is probably the main dissipation process. The p,p'-DDT is moving slowly downward in the soil profile, however, the levels of this contaminant are high enough to present risk to underground waters.     

Geochemical variations in aeolian mineral particles from the Sahara-Sahel Dust Corridor

The Sahara-Sahel Dust Corridor runs from Chad to Mauritania and expels huge amounts of mineral aerosols into the Atlantic Ocean. Data on samples collected from Algeria, Chad, Niger, and Western Sahara illustrate how corridor dust mineralogy and chemistry relate to geological source and weathering/transport history. Dusts sourced directly from igneous and metamorphic massifs are geochemically immature, retaining soluble cations (e.g., K, Na, Rb, Sr) and accessory minerals containing HFSE (e.g., Zr, Hf, U, Th) and REE. In contrast, silicate dust chemistry in desert basins (e.g., Bodélé Depression) is influenced by a longer history of transport, physical winnowing (e.g., loss of Zr, Hf, Th), chemical leaching (e.g., loss of Na, K, Rb), and mixing with intrabasinal materials such as diatoms and evaporitic salts. Mineral aerosols blown along the corridor by the winter Harmattan winds mix these basinal and basement materials. Dusts blown into the corridor from sub-Saharan Africa during the summer monsoon source from deeply chemically weathered terrains and are therefore likely to be more kaolinitic and stripped of mobile elements (e.g., Na, K, Mg, Ca, LILE), but retain immobile and resistant elements (e.g., Zr, Hf, REE). Finally, dusts blown southwestwards into the corridor from along the Atlantic Coastal Basin will be enriched in carbonate from Mesozoic-Cenozoic marine limestones, depleted in Th, Nb, and Ta, and locally contaminated by uranium-bearing phosphate deposits.     

Phosphorus and sulfur in a tropical soil and their effects on growth and selenium accumulation in Leucaena leucocephala (Lam.) de Wit

Selenium (Se) is an essential metalloid element for mammals. Nonetheless, both deficiency and excess of Se in the environment are associated with several diseases in animals and humans. Here, we investigated the interaction of Se, supplied as selenate (Se⁺⁶) and selenite (Se⁺⁴), with phosphorus (P) and sulfur (S) in a weathered tropical soil and their effects on growth and Se accumulation in Leucaena leucocephala (Lam.) de Wit. The P-Se interaction effects on L. leucocephala growth differed between the Se forms (selenate and selenite) supplied in the soil. Selenate was prejudicial to plants grown in the soil with low P dose, while selenite was harmful to plants grown in soil with high P dose. The decreasing soil S dose increased the toxic effect of Se in L. leucocephala plants. Se tissue concentration and total Se accumulation in L. leucocephala shoot were higher with selenate supply in the soil when compared with selenite. Therefore, selenite proved to be less phytoavailable in the weathered tropical soil and, at the same time, more toxic to L. leucocephala plants than selenate. Thus, it is expected that L. leucocephala plants are more efficient to phytoextract and accumulate Se as selenate than Se as selenite from weathered tropical soils, for either strategy of phytoremediation (decontamination of Se-polluted soils) or purposes of biofortification for animal feed (fertilization of Se-poor soils).