interpretation of air quality data with respect to the national ambient air quality standards

San Diego Gas &; Electric has developed a quality assurance program for continuous emission monitors (CEM). Extractive, rather than in situ, monitors were selected as a result of an in-house evaluation program. Two extractive systems have been certified and a good operating and maintenance record has been established on these systems. A successful program requires the involvement and support of all affected personnel. It is desirable to have one or two key personnel coordinate the development of the program. It is also highly desirable to have good in-house source testing capabilities.     

The Need for Representative Ambient Air Carbon Monoxide Sampling

Recent investigations have indicated that ambient air CO measurements may not reflect population exposure to CO. The lack of correlation may be due to improper siting of CO instruments, improper interpretation of air quality data, or both. Studies of population carboxy-hemoglobin levels are evaluated and compared with ambient air data.,

No significant correlation was found between median population COHb levels and reductions in CO concentrations required to meet ambient air standards when calculations used to estimate reductions were based on the second highest 8 hour average. However, calculated reductions based on annual average concentrations and a trend analysis technique correlated significantly with COHb levels in five cities from which both CAMP and COHb data were available.

Studies to determine the nature of the relationship between ambient air CO concentrations and population COHb levels are needed. The differences between the Occupational Safety and Health Act Regulations and the National Ambient Air Standards for carbon monoxide should be scrutinized to determine if a redefinition of the standards or their applicability is warranted. A reevaluation of the controls necessary to make reductions in population COHb burden may be necessary.     

Characterization of Particulates from Power Plants

The emphasis on participate control from industrial processes has been shifted recently towards fine particulates, having diameters less than 3 microns. There exists an urgent need for more scientific information of fine particle characterization.^1,2 Coal and oil fired power plants are among the largest anthropogenic point sources of particulate matter.³ Limited knowledge is available on particle size distribution and trace metal composition in power plant emissions.^4-7 The morphological properties of particle emissions have been largely neglected. In this report we present some information on particle characteristics for an oil-fired and coal-fired power plant.     

Heavy Duty Diesel Particulate Emission Factors

For the past several years, EPA has been measuring particulate emissions from a variety of heavy-duty diesel engines through contracts with Southwest Research Institute. Particulate emissions samples have been collected using an exhaust splitter to divert a fraction of the engine exhaust into a standard dilution tunnel. A small fraction of the diluted exhaust from the tunnel is pulled through a filter from which particulate mass and, in some cases, organic content of the particulate is determined. This paper discusses the sampling system and gives particulate emission factors that have been computed from truck and bus fuel consumption data as well as average truck and bus speed data from New York and Los Angeles (freeway and nonfreeway usage). Average particulate emission test results (steady state tests) for 2-stroke engines were 4.74 g/kg fuel and for 4-stroke engines were 2.64 g/kg fuel. Using average particulate emissions results, a particulate emission factor range of 0.8 to 1.3 g/km was computed. Nationwide diesel particulate emissions were calculated to be 88,000 metric tons per year.     

An Overview of EPA’s Quality Assurance Program

Quality Assurance has been defined in many different ways to express concern for the “quality” of the output of some operation or function. For the purpose of this presentation, quality assurance is defined as the sum of those activities within an environmental monitoring or measurement program which are primarily for the purpose of documenting the precision, accuracy, representativeness, and completeness of the data that are produced. Further, we view quality assurance as a management tool which encompasses both administrative and technical functions which generally fall into three categories: (1) Prevention which includes those activities carried out prior to the proper placement and operation of the measurement system; (2) Evaluation which includes the continuous overview and checks on the performance of the systems and operators; and (3) Correction which includes changes made to improve or stabilize the capability and performance of the system.     

Blast Furnace Casthouse Control Technology and Recent Emissions Test Data

By the fall of 1980, three new and seven retrofit casthouse emission control systems had been installed in North America. A number of prototype systems are being evaluated by steel companies and regulatory agencies. By 1981, the U.S. steel industry had made commitments to install controls on at least 58 additional casthouses in the U.S.

This paper describes the current status of casthouse control technology in the U.S. and Canada as of the spring of 1981, addresses future trends, and presents emissions test data collected in 1980 and 1981. Mass emissions and inhalable particulate test results from sampling at DOFASCO’s No. 3 blast furnace casthouse are presented. Roof monitor visible emissions data are also provided to describe performance of installed and demonstration systems including three J&L plants, Wheeling-Pittsburgh and Bethlehem Steel, and Inland’s new furnace.     

R&D Activities,Operating Experience Discussed at Fabric Alternatives Forum

ABSTRACT

Previously reported volatile organic compounds (VOC) radiocarbon (¹⁴C) measurements for 1992 summertime Atlanta, GA, have been compared with chromatographic data and emissions inventory predictions. The chromatographic approach that was used provided a more comprehensive VOC characterization than typically achieved, and the emissions inventory was research-grade level (date-, site-, and time-specific). The comparisons are in general agreement that biogenic emissions contribute only modestly (<10%) to the VOC content of the particular ambient samples that were collected and measured. The choices of sampling site (near city-center) and times (early morning and late evening) are major influences on the results, which consequently should not be regarded as representing the average VOC biogenic impact for the Atlanta area.     

A Pilot Indoor-Outdoor Study of Organic Particulate Matter and Particulate Mutagenicity

Abstract

Many large metropolitan areas experience elevated concentrations of ground-level ozone pollution during the summertime “smog season”. Local environmental or health agencies often need to make daily air pollution forecasts for public advisories and for input into decisions regarding abatement measures and air quality management. Such forecasts are usually based on statistical relationships between weather conditions and ambient air pollution concentrations. Multivariate linear regression models have been widely used for this purpose, and well-specified regressions can provide reasonable results. However, pollution-weather relationships are typically complex and nonlinear—especially for ozone—properties that might be better captured by neural networks. This study investigates the potential for using neural networks to forecast ozone pollution, as compared to traditional regression models. Multiple regression models and neural networks are examined for a range of cities under different climate and ozone regimes, enabling a comparative study of the two approaches. Model comparison statistics indicate that neural network techniques are somewhat (but not dramatically) better than regression models for daily ozone prediction, and that all types of models are sensitive to different weather-ozone regimes and the role of persistence in aiding predictions.     

Projecting Climate Change Effects on Forest Net Primary Productivity in Subtropical Louisiana,USA

This study projected responses of forest net primary productivity (NPP) to three climate change scenarios at a resolution of 5 km × 5 km across the state of Louisiana, USA. In addition, we assessed uncertainties associated with the NPP projection at the grid and state levels. Climate data of the scenarios were derived from Community Climate System Model outputs. Changes in annual NPP between 2000 and 2050 were projected with the forest ecosystem model PnET-II. Results showed that forest productivity would increase under climate change scenarios A1B and A2, but with scenario B1, it would peak during 2011–2020 and then decline. The projected average NPP under B1 over the years from 2000 to 2050 was significantly different from those under A1B and A2. Forest NPP appeared to be primarily a function of temperature, not precipitation. Uncertainties of the NPP projection were due to large spatial resolution of the climate variables. Overall, this study suggested that in order to project effects of climate change on forest ecosystem at regional level, modeling uncertainties could be reduced by increasing the spatial resolution of the climate projections.     

Importance of heterocylic aromatic compounds in monitored natural attenuation for coal tar contaminated aquifers: A review

NSO heterocycles (HET) are typical constituents of coal tars. However, HET are not yet routinely monitored, although HET are relatively toxic coal tar constituents. The main objectives of the study is therefore to review previous studies and to analyse HET at coal tar polluted sites in order to assess the relevance of HET as part of monitored natural attenuation (MNA) or any other long-term monitoring programme. Hence, natural attenuation of typical HET (indole, quinoline, carbazole, acridine, methylquinolines, thiophene, benzothiophene, dibenzothiophene, benzofuran, dibenzofuran, methylbenzofurans, dimethylbenzofurans and xanthene) were studied at three different field sites in Germany. Compound-specific plume lengths were determined for all main contaminant groups (BTEX, PAH and HET). The results show that the observed plume lengths are site-specific and are above 250m, but less than 1000m. The latter, i.e. the upper limit, however mainly depends on the level of investigation, the considered compound, the lowest measured concentration and/or the achieved compound-specific detection limit and therefore cannot be unequivocally defined. All downstream contaminant plumes exhibited HET concentrations above typical PAH concentrations indicating that some HET are generally persistent towards biodegradation compared to other coal tar constituents, which results in comparatively increased field-derived half-lives of HET. Additionally, this study provides a review on physicochemical and toxicological parameters of HET. For three well investigated sites in Germany, the biodegradation of HET is quantified using the centre line method (CLM) for the evaluation of bulk attenuation rate constants. The results of the present and previous studies suggest that implementation of a comprehensive monitoring programme for heterocyclic aromatic compounds is relevant at sites, if MNA is considered in risk assessment and for remediation.