Forecasting COH Levels at Six Outlying Sampling Stations in Allegheny County Using Statistical Correlations Derived from the Downtown Station

Verification of forecasts of COH levels at the Downtown Sampling Station using our objective forecast method developed in conjunction with the Allegheny County Bureau of Air Pollution Control gave excellent results. The next step was to expand the area of forecast coverage.

COH data taken from July 1968 through June 1969 from six sampling stations located roughly in a large concentric arc around the Downtown Station were studied. Three of the stations are located in river valleys near large industrial plants and the other three are located on higher terrain in suburban areas.

COH levels of Low, Moderate, High, and Very High (where Low = 0–0.9, Moderate = 1.0–1.9, High = 2.0–3.0, and Very High = >3.0) were used.

The total number of occurrences of High and Very High COHS at the Downtown Station was 10.7% of the total data sample. This was more than twice the frequency of any of the outlying stations.

An evaluation of the statistical frequencies indicate the Downtown Station can safely be used as a “control station” in forecasting Low or Moderate COH levels for the six surrounding stations. However, the occurrence of High or Very High COH levels at the six outlying stations do not occur with a high enough statistical consistency to be predicted by using the forecast value of the Downtown Station.

The valley stations exhibit the characteristics of separate sub air basins particularly during a period in which morning inversions occur for two or more consecutive days and the average daily wind speed does not exceed 4 m/sec.

The results show it is possible to forecast only Low or Moderate COH levels for each of the six outlying stations by using statistical correlations derived from the Downtown Station. Separate objective forecasts which relate the pollution buildup in each valley sub air basin must be used when High or Very High COHS are forecast at the Downtown Station.     

Automotive Exhaust Emission Levels by Geographic Area and Vehicle Make A Nationwide Survey

Gross average automotive exhaust emissions data collected by the Atlantic Richfield Clean Air Caravan during the summer of 1970 showed only slight geographical variations when the specific makes were ignored. When considering specific makes, significant differences were found on an average emissions basis. Vehicle population—emission distributions showed wide variations in the 50% population levels and in the percent of vehicles with emissions greater than specified values. Hydrocarbon (HC) and carbon monoxide (CO) data are given on a gross basis for the 1970, 1968-69, 1966-67, and pre-1966 model year group vehicles. Average HC and CO emissions and vehicle population-Idle emissions distribution curves are included for specific make vehicles in selected areas.     

Emissions from Slash Burning and the Influence of Flame Retardant Chemicals

Pollutants sampled during the burning of 30 lb ponderosa pine fuel beds yielded emission factors for CO, hydrocarbon gases, and par-ticulate matter of 146, 8.4, and 9.1 lb/ton of fuel, respectively. When similar beds were treated with diammonium phosphate flame retardant, these factors increased to 166, 11.7, and 19.3 lb/ton of fuel, respectively.

Gas chromatographic analysis of hydrocarbon gases showed that 15-40% of this material was composed of methane and eth-ylene. Ethane and acetylene were the next most abundant materials, with photochemically important materials constituting minor portions of this gaseous component. Fuel beds treated with flame retardant produced more oiefins, and this production lasted throughout the smoldering phase of burning.

These tests showed that the smoldering phase of combustion is of major importance to air pollutant production during slash burning. The initial 80% of the fuel burned accounted for only 20-30% of HC and CO emissions. This suggests that a rapid mop-up of slash burns could substantially reduce air pollutant production.     

Applicability of the Mass Concentration Standards for Particulate Matter in Alaskan Areas

The so-called “Six Month Study” of the air toxics problem in the United States was initiated in November 1983 by the U.S. Environmental Protection Agency. The study focused on the magnitude, nature, and distribution of the problem—three major issues that were felt to be most useful to policy makers as they attempted to define the scope and direction of a national program for controlling toxic air pollutants. The following paper is based on a draft staff report on the study released for review in September 1984. The report has not been formally released by the U.S. EPA; a final report is due by late spring of 1985.     

The Nationwide Program for Maintenance of Air Quality

The initial state implementation plans concentrated on attainment of the ambient air quality standards in the relatively polluted areas of the country. Many of these plans must now be modified to ensure that the ambient standards will be maintained for the foreseeable future, and to ensure that significant deterioration of air quality in clean areas of the country is prevented.

The existing implementation plans currently contain many measures which are applicable to the maintenance and deterioration efforts, but additional measures must also be developed. Many of these additional measures will involve future planning activities—most common of which will be land use planning activities.

The point is made that, after existing sources have reduced their emissions to the lowest practical level, further air pollution control can only be accomplished by implementing rational planning procedures for management of any new sources of air pollution. This will require extensive cooperation among the air pollution control community; regional, state, and local planning agencies; state and local governments; and the general public in order to ensure that future land use plans include appropriate air quality considerations.     

Stack Sampling of Hygroscopic Particulates In an Entrained Water Environment

Reference methods for the determination of mercury emissions from stationary sources typically include collection of mercury by solutions which are acidic and oxidizing. In the presence of high levels of SO₂ the oxidizing capacity of these absorbing solutions will be degraded and the collection efficiency for mercury compromised. This seriously limits the usefulness of the reference methods as they apply to the mining and smelting industries. In the present work peroxide is used to remove SO₂ and acidic permanganate is used to collect mercury. At a mean sampling rate of 10 L/min concentrations of at least 12 mg/m³ mercury can be satisfactorily collected in the presence of up to 20,000 ppm SO₂.     

interpretation of air quality data with respect to the national ambient air quality standards

San Diego Gas &; Electric has developed a quality assurance program for continuous emission monitors (CEM). Extractive, rather than in situ, monitors were selected as a result of an in-house evaluation program. Two extractive systems have been certified and a good operating and maintenance record has been established on these systems. A successful program requires the involvement and support of all affected personnel. It is desirable to have one or two key personnel coordinate the development of the program. It is also highly desirable to have good in-house source testing capabilities.     

Methylcyclopentadienyl Manganese Tricarbonyl as an Antiknock: Composition and Fate of Manganese Exhaust Products

Methylcyclopentadienyl manganese tricarbonyl (MMT) has been marketed as a combustion improver for fuel oil and turbine fuel. Use concentrations for this purpose are about 0.025 g manganese/gal in fuel oil and 0.08 to 0.5 g/gal in turbine fuels. In addition, it has been used to a small extent in gasoline.     

The Need for Representative Ambient Air Carbon Monoxide Sampling

Recent investigations have indicated that ambient air CO measurements may not reflect population exposure to CO. The lack of correlation may be due to improper siting of CO instruments, improper interpretation of air quality data, or both. Studies of population carboxy-hemoglobin levels are evaluated and compared with ambient air data.,

No significant correlation was found between median population COHb levels and reductions in CO concentrations required to meet ambient air standards when calculations used to estimate reductions were based on the second highest 8 hour average. However, calculated reductions based on annual average concentrations and a trend analysis technique correlated significantly with COHb levels in five cities from which both CAMP and COHb data were available.

Studies to determine the nature of the relationship between ambient air CO concentrations and population COHb levels are needed. The differences between the Occupational Safety and Health Act Regulations and the National Ambient Air Standards for carbon monoxide should be scrutinized to determine if a redefinition of the standards or their applicability is warranted. A reevaluation of the controls necessary to make reductions in population COHb burden may be necessary.     

Emission Control in Coking Operations By Use of Stage Charging

At the Clairton Coke Works of the United States Steel Corporation (the world’s largest coke plant), with coal charges of about 30,000 net tons per day, a system designated as “stage charging” has been developed for charging coal into the coke oven chamber without emissions to the atmosphere. The principles of the system are based on controlled sequential flow of the coal from the charging hoppers, during which the oven chamber is maintained under a very slight negative pressure condition by use of steam aspiration in the offtakes for on-the-main charging. The techniques are basic but require knowledge of the coal characteristics, adequate and properly maintained aspirating systems, including clean offtake piping, control of coal volume in the individual hoppers, and last, and probably most important, adherence by the operating crew to specific charging and leveling practices.