Analysis of Trace Metal Particulates in Atmospheric Samples Using X-Ray Fluorescence

Trace metals collected on filter paper by a hi-volume air sampler for 24 hours were analyzed using the X-ray fluorescence method. A gamma ray exciting source (²⁴¹Am) and a bremsstrahlung exciting source (¹⁴⁷Pm) were both used to produce the X-rays, the latter being more efficient. For the samples collected in Dayton, several metals were detected, viz.: Ti, Fe, Cu, Zn, Pb, Cd, and Sn. Elements in the periodic table between Ti and Cs were seen to have a sensitivity limit of 0.5 micrograms/m³ of air.     

Size Distribution of Participates Emitted from a Horizontal Spike Soderberg Aluminum Reduction Cell

Aerosol size distributions were measured in the air exhausted from a horizontal spike Soderberg aluminum reduction cell at the Kaiser Aluminum and Chemical Corporation plant in Tacoma, Wash. The particle size distributions were measured with the University of Washington cascade impactor, developed specifically for source testing. The particle mass concentrations and size distributions were found to vary significantly with changes in the cell process operations. For a typical aerosol size distribution at the exit of the cell hood the mass mean particle diameter was 5.5 microns and the particle size standard geometric deviation was 25.     

Low Emissions from Controlled Combustion for Automotive Rankine Cycle Engines

Rankine cycle engines have a high potential for meeting the emission levels established by the 1970 amendment to the Federal Clean Air Act for the 1975-76 automobile. This paper discusses a Solar research and development program sponsored by EPA/APCO which demonstrates a full scale 2 million Btu per hour working model of a Rankine cycle engine combustor and controls which can surpass the emission goals established.

Special features of the combustor are the unique methods of precisely controlling both the fuel and air to provide optimum flame performance at any engine power level. This paper discusses the special requirements of the Rankine cycle engine and shows why the very wide range of fuel flow required necessitates use. of special techniques in fuel atomization, fuel and air control, and aerodynamics. Sufficient discussion is included to show the design methods that are necessary, in general, to achieve low emissions in continuous flow combustion systems. Emphasis is placed on the importance of interfacing a combustion system with other engine parts if a successful low emission, wide turndown ratio combustor working model is to be achieved. Sufficient discussion on combustion kinetics is included to advise on approaches necessary to minimize NO formation in external combustion systems while maintaining high efficiency and low CO and unburned hydrocarbons.     

Determination of Sulfur Oxides in the Flue Gases of the Pulping Processes

The body of information presented in this paper is directed to the operating personnel and process engineers employed in the power and recovery departments of a chemical pulping operation. The proper evaluation of the total analytical and sampling system (TASS), to be used in the determination of sulfur oxides is as important as a proper analytical and recording system (ARS). The presence of other sulfur gaseous compounds and particulates could greatly influence the results of the determination.

The analytical method employed determines sulfur dioxide and trioxide from an aliquot of the trapping solution, 3% hydrogen peroxide and 8 0% isopropyl alcohol respectively. The aliquot is titrated with barium perchlorate in the presence of Thorin indicator. The results of evaluating the method indicated negligible interference from the presence of hydrogen sulfide, mercaptans and nitrogen oxides. A blank correction of 15 parts per million (ppm) is recommended whenever 100 ppm of hydrogen sulfide or more are simultaneously present in the gas stream. Particulaies are shown to interfere either by addition or subtraction. Sulfate particulates that will add to the determination must be removed, but in doing so, care must be exerted to avoid surface-contacting conditions that promote reaction between carbonates and the sulfur oxides. The integrated method of sampling and analysis will permit determinations from a flue gas with sulfur oxides concentrations of 30 ppm and above. The relative standard deviation improves from 10% at 100 ppm SO₂ to 2.6% at 1000 ppm SO₂. In both cases, sulfides were present.     

Dissipation kinetics and effect of different decontamination techniques on the residues of emamectin benzoate and spinosad in cowpea pods

Dissipation and decontamination of the semisynthetic macrolide emamectin benzoate and the natural insecticide spinosad on cowpea pods were studied following field application at single and double doses of 11.0 and 22 and 73 and 146 g ai ha^?1, respectively. Residues of these naturalytes were estimated using LC-MS/MS. The initial deposit of 0.073 and 0.153 mg kg^?1 of emamectin benzoate dissipated below quantitation level on the fifth and seventh day at single and double dosage, respectively. For spinosad, the initial deposits of 0.94 and 1.90 mg kg^?1 reached below quantitation level on the 7th day and 15th day at single and double dosage, respectively. The half-life of emamectin benzoate and spinosad was 1.13–1.49 and 1.05–1.39 days with the calculated safe waiting period of 2.99–6.12 and 1.09–3.25 days, respectively, for single and double dosage. Processing of the harvestable pods with different decontamination techniques resulted in 33.82 to 100 % removal 2 h after the application of emamectin benzoate and 100 % removal 3 days after spraying, while the removal was 42.05 to 87.46 % 2 h after the application of spinosad and 38.05 to 68.08 % 3 days after application.     

Development of a Pollination Service Measurement (PSM) method using potted plant phytometry

The value of pollination to human society is not limited to agricultural production, but also in the sustainability of ecosystems and the services that they provide. Seed set can be used as a comparative measure of pollination effectiveness, with minimum variability expected when other resources are not limiting. Six species of self-incompatible fall asters (Symphyotrichum) were used to evaluate pollination service at 12 sites across a spectrum of expected levels of pollination. Seed set per inflorescence was generally lower at sites with lower pollinator numbers and diversity, although as expected pollinator assemblage characteristics were highly variable within and between sites. However, rankings of sites showed consistency of response across phytometer species and between years; the summed ranks across multiple species appears to have as the greatest value in Pollination Service Measurement (PSM). Abundance, richness, and Shannon diversity of pollinator assemblages were highly autocorrelated and showed variable relationships with seed set depending on plant species and temporal scale of pollinator assemblage assessment. Use of seed set to directly measure pollination service at a site was consistent and cost effective when compared to less certain and more labour-intensive methods of pollinator collection and identification, and shows promise for implementation in pollination monitoring and bioassessment practices.     

Future groundwater extraction scenarios for an aquifer in a semiarid environment: case study of Guadalupe Valley Aquifer,Baja California,Northwest Mexico

Semiarid northwestern Mexico presents a growing water demand produced by agricultural and domestic requirements during the last two decades. The community of Guadalupe Valley and the city of Ensenada rely on groundwater pumping from the local aquifer as its sole source of water supply. This dependency has resulted in an imbalance between groundwater pumpage and natural recharge. A two-dimensional groundwater flow model was applied to the Guadalupe Valley Aquifer, which was calibrated and validated for the period 1984–2005. The model analysis verified that groundwater levels in the region are subject to steep declines due to decades of intensive groundwater exploitation for agricultural and domestic purposes. The calibrated model was used to assess the effects of different water management scenarios for the period 2007–2025. If the base case (status quo) scenario continues, groundwater levels are in a continuous drawdown trend. Some wells would run dry by August 2017, and water demand may not be met without incurring in an overdraft. The optimistic scenario implies the achievement of the mean groundwater recharge and discharge. Groundwater level depletion could be stopped and restored. The sustainable scenario implies the reduction of current extraction (up to about 50 %), when groundwater level depletion could be stopped. A reduction in current extraction mitigates water stress in the aquifer but cannot solely reverse declining water tables across the region. The combination of reduced current extraction and an implemented alternative solution (such as groundwater artificial recharge), provides the most effective measure to stabilize and reverse declining groundwater levels while meeting water demands in the region.     

Agricultural practices in grasslands detected by spatial remote sensing

The major decrease in grassland surfaces associated with changes in their management that has been observed in many regions of the earth during the last half century has major impacts on environmental and socio-economic systems. This study focuses on the identification of grassland management practices in an intensive agricultural watershed located in Brittany, France, by analyzing the intra-annual dynamics of the surface condition of vegetation using remotely sensed and field data. We studied the relationship between one vegetation index (NDVI) and two biophysical variables (LAI and fCOVER) derived from a series of three SPOT images on one hand and measurements collected during field campaigns achieved on 120 grasslands on the other. The results show that the LAI appears as the best predictor for monitoring grassland mowing and grazing. Indeed, because of its ability to characterize vegetation status, LAI estimated from remote sensing data is a relevant variable to identify these practices. LAI values derived from the SPOT images were then classified based on the K-Nearest Neighbor (KNN) supervised algorithm. The results points out that the distribution of grassland management practices such as grazing and mowing can be mapped very accurately (Kappa index?=?0.82) at a field scale over large agricultural areas using a series of satellite images.