Statistical apportionment and risk assessment of selected metals in sediments from Rawal Lake (Pakistan)

The present study was carried out in order to evaluate the statistical apportionment and risk assessment of selected metals (Ca, Cd, Co, Cr, Cu, Fe, K, Li, Mg, Mn, Na, Pb, Sr, and Zn) in freshly deposited sediments in Rawal Lake, Pakistan. Composite sediment samples were collected, oven-dried, grounded, homogenized, and processed to assess the water-soluble and acid extractable concentrations of the metals in the water extract and acid extract of the sediments using flame atomic absorption spectrophotometer. Statistical methods were used to identify the possible sources of the metals. Sediment quality guidelines and potential acute toxicity were used to evaluate the ecotoxicological sense of selected metals. Non-carcinogenic health risk assessment was also carried out to determine the potential adverse health risks to the inhabitants. Relatively higher concentration was noted for Ca, Fe, Mg, Na, K, Mn, and Sr in the sediment samples. Principal component analysis and cluster analysis revealed anthropogenic contributions of Cd, Pb, Cr, Mn, Fe, and Li in the sediments. Enrichment factors of the metals in sediments showed severe to moderate enrichment of Cd, Pb, Ca, Fe, Li, Mn, and Sr. Geoaccumulation indices and contamination factors evidenced significant contamination by Cd and Pb, although, on the whole, low degree of contamination was noted. The levels of some metals exceeded the sediment quality guidelines, which revealed frequently adverse biological effects to the dwelling biota in the aquatic ecosystem. The sediments were found to be significantly contaminated by Cd, Pb, Cr, Mn, Fe, and Li.     

Environment polluting conventional chemical control compared to an environmentally friendly IPM approach for control of diamondback moth, <Emphasis Type="Italic">Plutella xylostella</Emphasis> (L.), in China: a review

The diamondback moth, Plutella xylostella, is recognized as a widely distributed destructive insect pest of Brassica worldwide. The management of this pest is a serious issue, and an estimated annual cost of its management has reached approximately US$4 billion. Despite the fact that chemicals are a serious threat to the environment, lots of chemicals are applied for controlling various insect pests especially P. xylostella. An overreliance on chemical control has not only led to the evolution of resistance to insecticides and to a reduction of natural enemies but also has polluted various components of water, air, and soil ecosystem. In the present scenario, there is a need to implement an environmentally friendly integrated pest management (IPM) approach with new management tactics (microbial control, biological control, cultural control, mating disruption, insecticide rotation strategies, and plant resistance) for an alternative to chemical control. The IPM approach is not only economically beneficial but also reduces the environmental and health risks. The present review synthesizes published information on the insecticide resistance against P. xylostella and emphasizes on adopting an alternative environmentally friendly IPM approach for controlling P. xylostella in China.     

Nitrogen fertility and abiotic stresses management in cotton crop: a review

This review outlines nitrogen (N) responses in crop production and potential management decisions to ameliorate abiotic stresses for better crop production. N is a primary constituent of the nucleotides and proteins that are essential for life. Production and application of N fertilizers consume huge amounts of energy, and excess is detrimental to the environment. Therefore, increasing plant N use efficiency (NUE) is important for the development of sustainable agriculture. NUE has a key role in crop yield and can be enhanced by controlling loss of fertilizers by application of humic acid and natural polymers (hydrogels), having high water-holding capacity which can improve plant performance under field conditions. Abiotic stresses such as waterlogging, drought, heat, and salinity are the major limitations for successful crop production. Therefore, integrated management approaches such as addition of aminoethoxyvinylglycine (AVG), the film antitranspirant (di-1-p-menthene and pinolene) nutrients, hydrogels, and phytohormones may provide novel approaches to improve plant tolerance against abiotic stress-induced damage. Moreover, for plant breeders and molecular biologists, it is a challenge to develop cotton cultivars that can tolerate plant abiotic stresses while having high potential NUE for the future.     

Nanocatalyzed biodiesel synthesis from the oily contents of Marine brown alga Dictyota dichotoma

This research article demonstrates biodiesel synthesis through the methanolysis of the oily contents (4.02 ± 0.27% w/w on dried basis) of Dictyota dichotoma collected from the coast of Hawksbay, Pakistan. The metal oxides (CaO, MgO, ZnO, and TiO₂) used as nanocatalysts were refluxed (5% K₂SO₄), calcinated (850 °C) and characterized by Atomic Force Microscopy (AFM) which produced 93.2% w/w FAME (biodiesel) at relatively mild condition (5% catalyst, 65 °C, 3 h, 18:1 molar ratio) using CaO. Whereas, MgO, ZnO, and TiO₂ produced 92.4%, 72.5%, and 31.8% w/w FAME, respectively at elevated condition (225 °C). Thus, CaO was considered to be the best catalyst among the others. This tri-phase reaction require continuous fast mixing and the yield depends on the reaction parameters like catalyst amount, temperature, reaction time and molar ratio (methanol: oil). The reusability of these heterogeneous catalysts simplified the purification step, reduced the waste generation and make the final product technically and economically viable.     

Major ionic compositions of fine particulate matter in an animal feeding operation facility and its vicinity

Animal feeding operations (AFOs) produce particulate matter (PM) and gaseous pollutants. Investigation of the chemical composition of PM_2.5 inside and in the local vicinity of AFOs can help to understand the impact of the AFO emissions on ambient secondary PM formation. This study was conducted on a commercial egg production farm in North Carolina. Samples of PM_2.5 were collected from five stations, with one located in an egg production house and the other four located in the vicinity of the farm along four wind directions. The major ions of NH₄⁺, Na⁺, K⁺, SO₄^2?, Cl^?, and NO₃^? were analyzed using ion chromatography (IC). In the house, the mostly abundant ions were SO₄^2?, Cl^?, and K⁺. At ambient stations, SO₄^2?, and NH₄⁺ were the two most abundant ions. In the house, NH₄⁺, SO₄^2?, and NO₃^? accounted for only 10% of the PM_2.5 mass; at ambient locations, NH₄⁺, SO₄^2?, and NO₃^? accounted for 36–41% of the PM_2.5 mass. In the house, NH₄⁺ had small seasonal variations indicating that gas-phase NH₃ was not the only major force driving its gas–particle partitioning. At the ambient stations, NH₄⁺ had the highest concentrations in summer. In the house, K⁺, Na⁺, and Cl^? were highly correlated with each other. In ambient locations, SO₄^2? and NH₄⁺ had a strong correlation, whereas in the house, SO₄^2? and NH₄⁺ had a very weak correlation. Ambient temperature and solar radiation were positively correlated with NH₄⁺ and SO₄^2?. This study suggests that secondary PM formation inside the animal house was not an important source of PM_2.5. In the vicinity, NH₃ emissions had greater impact on PM_2.5 formation.

ImplicationsThe chemical composition of PM_2.5 inside and in the local vicinity of AFOs showed the impact of the AFO emissions on ambient secondary PM_2.5 formation, and the fate and transport of air pollutants associated with AFOs. The results may help to manage in-house animal facility air quality, and to develop regional air quality control strategies and policies, especially in animal agriculture-concentrated areas.     

Characterization of Fine Particulate Matter Produced by Combustion of Residual Fuel Oil

ABSTRACT

Combustion experiments were carried out on four different residual fuel oils in a 732-kW boiler. PM emission samples were separated aerodynamically by a cyclone into fractions that were nominally less than and greater than 2.5 |j.m in diameter. However, examination of several of the samples by computer-controlled scanning electron microscopy (CCSEM) revealed that part of the PM_2.5 fraction consists of carbonaceous cenospheres and vesicular particles that range up to 10 |j.m in diameter. X-ray absorption fine structure (XAFS) spectroscopy data were obtained at the S, V, Ni, Fe, Cu, Zn, and As K-edges and at the Pb L-edge. Deconvolution of the X-ray absorption near edge structure (XANES) region of the S spectra established that the dominant molecular forms of S present were sulfate (26-84% of total S) and thiophene (13-39% of total S). Sulfate was greater in the PM_2.5 samples than in the PM₂₅₊ samples. Inorganic sulfides and elemental sulfur were present in lower percentages. The Ni XANES spectra from all of the samples agreed fairly well with that of NiSO₄, while most of the V spectra closely resembled that of vanadyl sulfate (VO?SO₄?xH₂O). The other metals investigated (i.e., Fe, Cu, Zn, and Pb) also were present predominantly as sulfates. Arsenic was present as an arsen-ate (As⁺⁵). X-ray diffraction patterns of the PM_2.5 fraction exhibit sharp lines due to sulfate compounds (Zn, V, Ni, Ca, etc.) superimposed on broad peaks due to amorphous carbons. All of the samples contain a significant organic component, with the loss on ignition (LOI) ranging from 64 to 87% for the PM_2.5 fraction and from 88 to 97% for the PM_2.5+ fraction. Based on ¹³C nuclear magnetic resonance (NMR) analysis, the carbon is predominantly condensed in graphitic structures. Aliphatic structure was detected in only one of seven samples examined.     

Future year ozone source attribution modeling study using CMAQ-ISAM

ABSTRACT

To achieve the current United States National Ambient Air Quality Standards (NAAQS) attainment level for ozone or particulate matter, current photochemical air quality models include tools to determine source apportionment and/or source sensitivity. Previous studies by the authors have used the Ozone and Particulate Matter Source Apportionment Technology and Higher-order Decoupled Direct Method probing tools in CAMx to investigate these source-receptor relationships for ozone. The recently available source apportionment for CMAQ, referred to as the Integrated Source Apportionment Method (ISAM), was used in this study to conduct future year (2030) source attribution modeling. The CMAQ-ISAM ozone source attribution results for selected cities across the U.S. showed boundary conditions were the dominant contributor to the future year highest July maximum daily 8-hour average (MDA8) ozone concentrations. Point sources were generally larger contributors in the eastern U.S. than in the western U.S. The contributions of on-road mobile emissions were around 5 ppb at most of the cities selected for analysis. Off-road mobile source contributions were around 20 ppb or nearly 30%. Since boundary conditions play an important role in future year ozone levels, it is important to characterize future year boundary conditions accurately. The current implementation of ISAM in CMAQ 5.0.2 requires significant computing resources for ozone source attribution, making it difficult to conduct long-term simulations for large domains. The computing requirements for PM source attribution are even more onerous. CMAQ 5.2 was released after this study was completed, and does not include ISAM. If an efficient version of ISAM becomes available, it could be used in long-term ozone and PM2.5 studies. Implications: Ozone source attribution results provide useful information on important emission source contribution categories and provide some initial guidance on future emission reduction strategies. This study explains a new source apportionment technique, CMAQ-ISAM, and compares it to CAMx OSAT. The techniques have similar results: ozone’s highest source contributor is boundary conditions, followed by point sources, then off-road mobile sources. The current version of ISAM in CMAQ 5.0.2 requires significant computing resources for ozone source attribution, while the computing requirements for PM source attribution are even more onerous. CMAQ 5.2 was released after this study was completed, and does not include ISAM.     

Production and Purification of Poly(3-hydroxybutyrate-co-3-hydroxyvalerate) Degrading Enzyme from Streptomyces sp. AF-111

A poly(3-hydroxybutyrate-co-3-hydroxyvalerate) (PHBV) degrading bacterial strain designated as AF-111 was isolated from sewage sludge sample. The bacterium was identified by 16S rRNA gene sequencing. The results revealed that strain AF-111 showed 99 % similarity with Streptomyces althioticus strain NRRL B-3981 and designated as Streptomyces sp. strain AF-111. An extracellular PHBV depolymerase enzyme was produced under optimized conditions and purified through ammonium sulphate fractionation and column chromatography. The enzyme was purified to homogeneity, indicated by sodium dodecyl sulfate–polyacrylamide gel electrophoresis and molecular weight was found to be approximately 51 kDa. Effect of temperature, pH, metal ions and inhibitors on the PHBV depolymerase activity was determined. The enzyme was stable at wide range of temperature (35–55 °C) and pH (6–8). PHBV depolymerase was stable in the presence of different metal ions except iron and zinc which had inhibitory effect on depolymerase activity. Both ethylenediamine teteracetic acid and phenylmethyl sulphonyl fluoride strongly inhibited enzyme activity which indicates that this enzyme belongs to the serine hydrolase family like other polyhydroxyalkanoate depolymerases. The results show that a depolymerase from strain AF-111 can effectively degrade PHBV, therefore, it can be applied in the process of biochemical monomer recycling.     

Canada shows the way

Editorial

Canada shows the way     

Mobilising social energy against environmental challenge: understanding the groundwater recharge movement in western India

This paper explores a large-scale and growing popular movement to augment groundwater recharge in the Saurashtra region of western India, an area that has been facing acute water scarcity and other associated problems. As a social phenomenon, the movement is at an early stage of its development. However, it is interesting to study it for many reasons. First, even a decade after it began, it is still growing in scale and following. Second, it is entirely spontaneous and internally driven, necessitating no public resources or support. Third, early indications are that its social and ecological impacts are beneficial and highly significant. Fourth, the movement was catalysed and spearheaded by spiritual and religious institutions, which made ingenious use of non-economic messages and motivators in forging a new natural resource ethic based on a broad, collective rationality among movement members. It appears, however, that beyond a threshold, the movement acquired a logic and energy of its own which might fuel its future sustainability and growth. Finally, the movement has important lessons to offer because mobilising social energy on such a scale and intensity can perhaps be one of most effective responses to many of the environmental challenges the world faces today.