促进江湖联系的闸口调度对策及影响区管理机制

我国传统的修堤建闸、抵御洪水的治河理念,阻断了江湖联系,造成湿地的生态萎缩。为改善湿地的生态环境,保护湿地的生物多样性,提出了新的多目标闸口调度机制,替代传统的、以防洪抗旱为目的的调度机制,力求促进江湖联系,增加湿地活力;为保障该机制的运行和实施,提出了闸口调度影响区的管理办法;并以涨渡湖为例进行了讨论。     

1株脱氮除磷菌的筛选及其特性研究

采用YG培养基,结合蓝白斑筛选、异染粒染色及好氧除磷能力检测等实验,从城市生活污水处理厂好氧生化池的活性污泥中分离出7株好氧除磷菌;再经硝酸盐还原产气和缺氧培养实验,筛选出1株高效脱氮除磷菌;通过16S rRNA基因同源性比较和生理生化鉴定,初步将其鉴定为Pseudomonas grimontii,命名为C18.菌株C18在好氧培养24h后,培养基中上清液磷浓度从38.7mg/L降低到2.28mg/L,除磷率达94.1%.C18在缺氧培养24h后,培养基中上清液磷浓度从44.5mg/L降低到5.21mg/L,除磷率达88.3%;上清液硝酸盐氮浓度从184.2mg/L降低到30.6mg/L,脱氮率达83.4%.菌株C18最适脱氮除磷温度为30℃;最适脱氮除磷pH为7.5.     

生物活性炭去除水中挥发性苯系物的基础研究

采用连续流生物活性炭(BAC)工艺处理水中挥发性苯系物(BTEX,包括苯、甲苯、乙苯、二甲苯),评价进水负荷、活性炭炭型等因素对于BAC处理性能的影响.研究表明,在40d的处理时间内,除苯之外,其余BTEX的BAC出水中均未检出苯系物(进水为6mg/L).为了检验BAC在高BTEX负荷情况时的处理效果,将进水浓度设定为19~32mg/L左右,在EBCT为1.2min条件下同样只有苯的出水浓度上升至10mg/L(C/Cin为0.45),然后略有下降,最终保持在5~10mg/L(C/Cin为0.3以下),其余苯系物出水浓度均一直保持小于5mg/L.这表明BAC可以有效地处理高负荷BTEX(8.68~12.9kgTOC/(m3·d))的进水.生物活性炭对于活性炭吸附容量的恢复有比较明显的作用,煤质炭和椰壳炭的生物再生效率分别为53.6%和26.6%,煤质炭再生效率高的原因可能是其具备更多的大型中孔和大孔.     

半干法脱硫配套布袋除尘器的特殊要求

由于半干法脱硫工艺对布袋除尘器的特殊要求,使得其配套的布袋除尘器构造不同于以往常规的布袋除尘器.从布袋除尘器的过滤风速、滤料选择、沉降室设置、布风均匀性、灰斗特性、旁路系统的要求做详细的说明.     

己内酰胺生产废水的铁碳微电解深度处理与机理研究

采用铁碳微电解方法对己内酰胺生产废水进行深度处理,探讨了pH值、停留时间、铁碳质量比对处理效果的影响。在pH为4、停留时间为120 min、铁碳质量比为4的最佳处理条件下,COD去除率可达57.8%,色度去除率可达68.4%。微电解对己内酰胺废水的作用主要通过铁的絮凝作用,处理过程中的酸性条件、微电解的氧化还原和电场作用,从而提高其去除效率。     

低温水解酸化-A~2/O（PACT）-混凝沉淀处理印染废水

低温条件下对水解酸化-A2/O（PACT）-混凝沉淀组合工艺处理印染废水进行了中试研究。考察印染废水中COD和色度去除效果,结果表明：低温对工艺负面影响较大,未加粉末活性炭时好氧段COD和色度的去除率分别为42.6%和58.9%;投加粉末活性炭后,去除率分别达55.8%和65.4%,提高了13.2%和6.5%,显示出低...     

Visible light responsive N-F-codoped TiO2 photocatalysts for the degradation of 4-chlorophenol

Visible light responsive N-F-codoped TiO₂ photocatalysts exhibit a higher catalytic activity than N-doped TiO₂ for the degradation of 4-chlorophenol due to the synergistic effect of nonmetal elements.     

Structural and electrochemical properties of annealed La1-xYxNi3.55Mno.4Alo.3Coo.75 hydrogen storage alloys

The effects of the annealing and partial substitution of Y for La on the structural and electrochemical properties of La_1-xY_xNi_3.55Mn_o.4Al_o.3Cr_o.75 (x = 0, 0.1 and 0.2) alloys were reported in the present work. The single-phased CaCu₅-type structure was retained after La was partially substituted by Y. However, the increase of Y content leads to decrease of the lattice parameters and the unit-cell volume. The annealed La_o.9Y_o.1Ni_3.55Mn_o.4Al_o.3Co_o.75 alloys shows typical isometric microstructure, indicating that the composition segregation is improved by annealing. Y substitution for La in the alloys is effective to improve the electrochemical properties at both room temperature and high temperature. A critical substitution content of Y is found at x = 0.1.     

Decolorization of dye solutions with Ruditapes philippinarum conglutination mud and the isolated bacteria

Application of Ruditapes Philippinarum conglutination mud (RPM) for decolorizing synthetic dye solutions was studied. RPM showed good activity for decolorization of Methylene Blue, Crystal Violet, Malachite Green, and Ink Blue. The amount of the RPM had great effect on the decoloration rate of the dye solutions. However, the decoloration rate did not continue to increase when the amount of mud exceeded the optimum dose. The temperature of the dye solution had a remarkable effect on the decolorization rate of Ink Blue solution, but had little effect on the other three dye solutions. The initial pH of the dye solutions evidently affected the decolorization rate of Malachite Green solution, but had less effect on the other three. The decolorization rate of the dye solutions increased significantly with treatment time within 8 hr, but tended to be steady after 8 hr for Methylene Blue, Crystal Violet and Malachite Green solutions, and after 12 hr for Ink Blue solution. The decolorization efficiencies for the four dye solutions under the optimum conditions were all above 90%. Seventeen strains screened from RPM showed flocculation ability for kaolin clay suspension. Out of them, the flocculation rate of strain ZHT3-9 and strain ZHT4-13 were up to 88.14% and 86.01%, respectively. ZHT3-9 was studied, and its decolorization rate for Methylene Blue, Crystal Violet, and Malachite Green reached 90.02%, 89.21%, and 80.29%, respectively. By morphological, physiological and biochemical characteristics analysis and 16S rRNA sequencing, the strain ZHT3-9 was identified as Arthrobacter sp.