Biosurfactant-enhanced solubilization of NAPL mixtures

Remediation of nonaqueous phase liquids (NAPLs) by conventional pump-and-treat methods (i.e., water flushing) is generally considered to be ineffective due to low water solubilities of NAPLs and to mass-transfer constraints. Chemical flushing techniques, such as surfactant flushing, can greatly improve NAPL remediation primarily by increasing the apparent solubility of NAPL contaminants. NAPLs at hazardous waste sites are often complex mixtures. However, the equilibrium and nonequilibrium mass-transfer characteristics between NAPL mixtures and aqueous surfactant solutions are not well understood. This research investigates the equilibrium solubilization behavior of two- and three-component NAPL mixtures (containing akylbenzenes) in biosurfactant solutions. NAPL solubilization is found to be ideal in water (i.e., obeys Raoult's Law), while solubilization in biosurfactant solutions was observed to be nonideal. Specifically, the relatively hydrophobic compounds in the mixture experienced solubility enhancements that were greater than those predicted by ideal enhanced solubilization theory, while the solubility enhancements for the relatively hydrophilic compounds were less than predicted. The degree of nonideality is shown to be a nonlinear function of the NAPL-phase mole fraction. Empirical relationships based on the NAPL-phase mole fraction and/or micelle-aqueous partition coefficients measured in single-component NAPL systems are developed to estimate values for the multicomponent partition coefficients. Empirical relationships that incorporate both the NAPL-phase mole fraction and single-component partition coefficients yield much improved estimates for the multicomponent partition coefficient.     

Chlorinated hydrocarbon contaminants in Hong Kong surficial sediments.

Twenty surficial sediments were sampled from nearshore Hong Kong waters during 1997-1998, and analyzed for a range of chlorinated pesticides and polychlorinated biphenyls (PCBs). Results showed that concentrations (on a dry weight basis) of total HCHs were in the range 0.1-16.7 ng g-1, and total DDTs 0.3-14.8 ng g-1. PCBs, measured as an Aroclor 1242, 1248, 1254, 1260 (1:1:1:1) mixture, were found to be in a range of 0.5-97.9 ng g-1, and were at highest concentrations in Victoria Harbour. Results indicated that chlorinated pesticides and PCBs in Hong Kong nearshore sediments were most likely derived from waste discharge from a variety of sources, including agricultural, sewage, industrial waste disposal and shipping-related activities. In addition, as the north and west sides of Hong Kong are subject to influence from the Pearl River (due mainly to agricultural activities in the Pearl River Delta, and to a lesser extent developments around the Shenzhen Special Economic Zone), these inputs are also thought to be likely sources of contamination.     

高温/中温两相厌氧消化反应中有机酸的变化

为了深入考察高温／中温两相厌氧消化的反应器系统用以处理混合基质时有机酸的变化特性,采用蒸馏－滴 测定挥发有机酸总量,并在系统达到相对稳定时用色质联机确定有机酸的组成及各自含量。研究结果表明,混合基质经高温消化后挥发有机酸含量有所增加,平均在３４６－５５２９ｍｌ／Ｌ,进一步经中国消化且系统达到稳定后其含量平均为４３－４３３ｍｇ／Ｌ,乙酸,丙酸,丁酸和戊酸是进料混合基质和高温消化后基质中主要有机酸种类     

LOW-HEAD HYDROPOWER IMPACTS ON STREAM DISSOLVED OXYGEN1

ABSTRACT: A method to evaluate the effect of hydropower development on downstream dissolved oxygen (DO) is presented for a low head dam. Water, previously aerated during release over spillways and under gates, is diverted through the hydropower facility without further aeration. The oxygen transfer that occurs as a result of air entrainment at the various release points of a dam is measured. Oxygen transfer efficiencies are calculated and incorporated into an oxygen transfer model to predict average release DO concentrations. This model is used to systematically determine the effect of hydropower operation on downstream DO. Operational alternatives are investigated and a simple operational guide is developed to mitigate the effects of hydropower operation. Combinations of reduced generation and optimal releases from the dam allow the hydropower facility to operate within DO standards.     

Emission strength validation using four-dimensional data assimilation: application to primary aerosol and precursors to ozone and secondary aerosol.

Three-dimensional air quality models (AQMs) represent the most powerful tool to follow the dynamics of air pollutants at urban and regional scales. Current AQMs can account for the complex interactions between gas-phase chemistry, aerosol growth, cloud and scavenging processes, and transport. However, errors in model applications still exist due in part to limitations in the models themselves and in part to uncertainties in model inputs. Four-dimensional data assimilation (FDDA) can be used as a top-down tool to validate several of the model inputs, including emissions inventories, based on ambient measurements. Previously, this FDDA technique was used to estimate adjustments in the strength and composition of emissions of gas-phase primary species and O3 precursors. In this paper, we present an extension to the FDDA technique to incorporate the analysis of particulate matter (PM) and its precursors. The FDDA approach consists of an iterative optimization procedure in which an AQM is coupled to an inverse model, and adjusting the emissions minimizes the difference between ambient measurements and model-derived concentrations. Here, the FDDA technique was applied to two episodes, with the modeling domain covering the eastern United States, to derive emission adjustments of domainwide sources of NO., volatile organic compounds (VOCs), CO, SO2, NH3, and fine organic aerosol emissions. Ambient measurements used include gas-phase inorganic and organic species and speciated fine PM. Results for the base-case inventories used here indicate that emissions of SO2 and CO appear to be estimated reasonably well (requiring minor revisions), while emissions of NOx, VOC, NH3, and organic PM with aerodynamic diameter less than 2.5 microm (PM2.5) require more significant revision.