Reclaimed Mineland Curve Number Response to Temporal Distribution of Rainfall1

Warner, Richard C., Carmen T. Agouridis, Page T. Vingralek, and Alex W. Fogle, 2010. Reclaimed Mineland Curve Number Response to Temporal Distribution of Rainfall. Journal of the American Water Resources Association (JAWRA) 46(4): 724-732. DOI: 10.1111/j.1752-1688.2010.00444.x Abstract: The curve number (CN) method is a common technique to estimate runoff volume, and it is widely used in coal mining operations such as those in the Appalachian region of Kentucky. However, very little CN data are available for watersheds disturbed by surface mining and then reclaimed using traditional techniques. Furthermore, as the CN method does not readily account for variations in infiltration rates due to varying rainfall distributions, the selection of a single CN value to encompass all temporal rainfall distributions could lead engineers to substantially under- or over-size water detention structures used in mining operations or other land uses such as development. Using rainfall and runoff data from a surface coal mine located in the Cumberland Plateau of eastern Kentucky, CNs were computed for conventionally reclaimed lands. The effects of temporal rainfall distributions on CNs was also examined by classifying storms as intense, steady, multi-interval intense, or multi-interval steady. Results indicate that CNs for such reclaimed lands ranged from 62 to 94 with a mean value of 85. Temporal rainfall distributions were also shown to significantly affect CN values with intense storms having significantly higher CNs than multi-interval storms. These results indicate that a period of recovery is present between rainfall bursts of a multi-interval storm that allows depressional storage and infiltration rates to rebound.     

Analytical Solutions to the Linearized Boussinesq Equation for Assessing the Effects of Recharge on Aquifer Discharge1

Boggs, Kevin G., Robert W. Van Kirk, Gary S. Johnson, Jerry P. Fairley, and P. Steve Porter, 2010. Analytical Solutions to the Linearized Boussinesq Equation for Assessing the Effects of Recharge on Aquifer Discharge. Journal of the American Water Resources Association (JAWRA) 46(6):1116–1132. DOI: 10.1111/j.1752-1688.2010.00479.x Abstract: There is a need to develop a general understanding of how variations in aquifer recharge are reflected in discharge. Analytical solutions to the linearized Boussinesq equation governing flow in an unconfined aquifer provide a unified mathematical framework to quantify relationships among lag time, attenuation and distance between aquifer recharge and discharge and the effect of an up-gradient no-flow boundary. We applied this framework to three types of recharge: (1) instantaneous, (2) periodic, and (3) constant rate for a finite duration. When the temporal scale of recharge exceeds the diffusive aquifer time scale, recharge will be reflected in discharge quickly and with little attenuation. When aquifer time scale is large, most recharge events are shorter in scale than that of the aquifer, resulting in large attenuation. Attenuation is more sensitive to boundary effects than lag time, and boundary effects increase as recharge time scale increases. Boundary effects can often be ignored when the recharge source is farther than 1/3 of the domain length away from the no-flow boundary. We illustrate analytical results with application to the economically critical Eastern Snake River Plain Aquifer in Idaho. In this aquifer, detectable annual and decadal cycles in discharge can result from recharge no farther than 20 and 60 km away from the discharge point, respectively. The effects of more distant, long-term recharge can be detected only after a time lag of several decades.     

An Aquifer Classification System and Geographical Information System-Based Analysis Tool for Watershed Managers in the Western U.S.1

Payne, Scott M. and William W. Woessner, 2010. An Aquifer Classification System and Geographical Information System-Based Analysis Tool for Watershed Managers in the Western U.S. Journal of the American Water Resources Association (JAWRA) 46(5):1003-1023. DOI: 10.1111/j.1752-1688.2010.00472.x Abstract: Aquifers and groundwater systems can be classified using a variety of independent methods to characterize geologic and hydraulic properties, the degree of connection with surface water, and geochemical conditions. In light of a growing global demand for water, an approach for classifying groundwater systems at the watershed scale is needed. A comprehensive classification system is proposed that combines recognized methods and new approaches. The purpose of classification is to provide groundwater professionals, policy makers, and watershed managers with a widely applicable and repeatable system that reduces sometimes cumbersome complex databases and analyzes to straightforward terminology and graphical representations. The proposed classification system uses basin geology, aquifer productivity, water quality, and the degree of groundwater/surface water connection as classification criteria. The approach is based on literature values, reference databases, and fundamental hydrologic and hydrogeologic principles. The proposed classification system treats dataset completeness as a variable and includes a tiered assessment protocol that depends on the quality and quantity of data. In addition, it assembles and catalogs groundwater information using a consistent set of nomenclature. It is designed to analyze and display results using Geographical Information System mapping tools.     

Ambient TSP concentration and dustfall in major cities of China: Spatial distribution and temporal variability

Based on environmental monitoring data in 93 major cities and meteorological records at 398 weather stations in China from 1981 to 2007, total suspended particle (TSP) concentration, the intensity of dustfall, and sand and dust storm frequency (F_d) were analysed. During the past 27 years, the annual average TSP concentration (C_TSP) in 93 cities was 402 μg m^?3. Annual average C_TSP decreased from the north to the south and from inland to the coast areas with a peak value of 628.8 μg m^?3 in Lanzhou. In the 1980s, 1990s and 2000s, annual average C_TSP was 628.7, 319.2, and 250.1 μg m^?3, respectively. Annual average intensity of dustfall (I_d) was 240.5 t km^?2 a^?1, decreased from northern to southern China and from inland to the coast areas with the maximum value of 717.2 t km^?2 a^?1 in Baotou. In the 1980s, 1990s and 2000s, annual average I_d was 334.8, 220.9, 146 t km^?2 a^?1 respectively. Annual average I_d in the Loess Plateau region was commonly higher than 200 t km^?2 a^?1. The annual average F_d decreased from arid regions in northwestern China to humid areas in southeastern China with two sand and sand storm centers existing in Xinjiang Taklamakan Desert and western Inner Mongolia. The annual average F_d in the 1980s, 1990s, 2000s was 16, 8, 6 days respectively, decreased steadily from 18 days in 1981–5 days in 2007. Annual average I_d had a positive linear relation to annual average C_TSP (R² = 0.96). Annual average F_d had a positive relation with annual average C_TSP (R² = 0.97) as well as annual average I_d (R² = 0.94). TSP was the chief pollutant influencing Air Pollution Index (API) in northern China in spring and winter seasons. Sand and dust storm might be a major factor affecting the temporal variability and spatial distribution of TSP and dustfall in China.     

Flux measurements of volatile organic compounds by the relaxed eddy accumulation method combined with a GC-FID system in urban Houston,Texas

A tall tower flux measurement setup was established in metropolitan Houston, Texas, to measure trace gas fluxes from emission sources in the urban surface layer. We describe a new relaxed eddy accumulation (REA) system combined with a dual-channel GC-FID used for VOC flux measurements, focusing on benzene, toluene, ethylbenzene and xylenes (BTEX) results. Ambient air sampled from 60 m above the ground next to a sonic anemometer was subsampled by a membrane pump and pushed into an REA valve system with two Teflon bag reservoirs, then transferred to two preconcentration units for thermal desorption. We discuss the performance of our system and the selected BTEX measurement results using approximately 8 weeks of data (May 22–July 22, 2008), presenting diurnal variations of concentrations and fluxes of these traffic tracers. The measured values exhibited diurnal cycles with dominant morning and midday peaks during weekdays related to rush hour traffic and additional weekday daytime toluene and xylenes emissions. Local evaporative emissions, likely from solvent usage, significantly contributed to the measured fluxes. We upscaled measured emissions to the county level using a high resolution land cover data set and compared the results with EPA’s National Emission Inventory (NEI).     

Chemical mass balance source apportionment for combined PM2.5 measurements from U.S. non-urban and urban long-term networks

The Minnesota Particulate Matter 2.5 (PM_2.5) Source Apportionment Study was undertaken to explore the utility of PM_2.5 mass, element, ion, and carbon measurements from long-term speciation networks for pollution source attribution. Ambient monitoring data at eight sites across the state were retrieved from the archives of the Interagency Monitoring of Protected Visual Environments (IMPROVE) and the Speciation Trends Network (STN; part of the Chemical Speciation Network [CSN]) and analyzed by an Effective Variance – Chemical Mass Balance (EV-CMB) receptor model with region-specific geological source profiles developed in this study. PM_2.5 was apportioned into contributions of fugitive soil dust, calcium-rich dust, taconite (low grade iron ore) dust, road salt, motor vehicle exhaust, biomass burning, coal-fired utility, and secondary aerosol. Secondary sulfate and nitrate contributed strongly (49–71% of PM_2.5) across all sites and was dominant (≥60%) at IMPROVE sites. Vehicle exhausts accounted for 20–70% of the primary PM_2.5 contribution, largely exceeding the proportion in the primary PM_2.5 emission inventory. The diesel exhaust contribution was separable from the gasoline engine exhaust contribution at the STN sites. Higher detection limits for several marker elements in the STN resulted in non-detectable coal-fired boiler contributions which were detected in the IMPROVE data. Despite the different measured variables, analytical methods, and detection limits, EV-CMB results from a nearby IMPROVE-STN non-urban/urban sites showed similar contributions from regional sources – including fugitive dust and secondary aerosol. Seasonal variations of source contributions were examined and extreme PM_2.5 episodes were explained by both local and regional pollution events.     

Exporting natural capital: the foreign eco-footprint on Costa Rica and implications for sustainability

As the world economy ‘globalizes’, trade has become a major mechanism by which much of the human population supports its needs. While trade in resource commodities (natural income) can increase the well-being of people in both exporting and importing countries, it can also lead to depletion of natural capital and the loss of ecosystems integrity. In recent years, various researchers have attempted to address this problem using a consumption-based perspective on ecological change. Their work shows that the loss of ecosystem integrity in almost any region of the world can be attributed to both local and international consumer demand. This paper illustrates the utility of modified eco-footprint analysis in assessing export-related ecological change in Costa Rica. We quantify ecological footprint of consumers around the world on the productive ecosystems of Costa Rica, document the changing character of this footprint and highlight some of the linkages between production for export in Costa Rica and ecological degradation. We then discuss the implications of the increasing trade-based entanglement of nations for ecosystems and global sustainability.     

Plant availability of bound anilazine residues in a degraded loess soil

Abstract

The relative biological availability of [benzene ring‐U‐¹⁴C] and Ctriazine‐U‐¹⁴C] anilazine for maize plants was studied in a degraded loess soil in a standardized microecosystem. The total uptake of radiocarbon in the course of the 4‐week experiment was 3.1 and 4 % respectively of the radioactivity applied if anilazine was uniformly mixed into the soil immediately before beginning the experiment. However, if anilazine was subjected to a degradation at 65 % of the maximum water holding capacity of the soil and temperatures varying daily between 16 and 27°C for 100 days before the plant experiment then the uptake was reduced to 0.4 or 0.7 % respectively. The uptake from soil with non‐extractable (bound) anilazine residues was similarly low. The mineralization rate of aged and bound anilazine residues was below 0.1 % of the radioactivity applied. Up to 2/3 of the radioactivity present in the soil after the plant experiment remained in the humic fraction.     

Diflubenzuron residue and persistence on an oak forest after aerial application

Abstract

A twenty hectare forest block in central Pennsylvania was aerially sprayed with diflubenzuron (Dimilin 25W®) at the dose of 33.23g A.I./ha in 9.4 litres/ha. Leaf samples were collected from the upper and lower canopies of 27 oaks and understory within this block on the day of spray, May 29, 1991. Canopy leaves were also collected on May 31, June 10, July 29 and September 26, 1991.

Recovery of diflubenzuron residues on fortified canopy‐leaf and litter‐leaf samples using analytical techniques employed in this study averaged 87.4% (SE = 7.5%) and 66.2% (SE = 8.2%), respectively.

On the day of spray, diflubenzuron residues on the upper canopy, lower canopy and understory averaged 81.18, 39.65 and 8.35 ng/cm², respectively. Diflubenzuron residues on canopy‐leaf samples collected 2, 12, 61 and 120 days post‐spray averaged 14.83 (SE = 10.19), 16.75 (SE = 9.95), 12.84 (SE = 8.25) and 11.20 (SE = 7.52) ng/cm², respectively. Diflubenzuron residues on litter‐leaf samples collected after leaf senescence ‐ 169 and 323 days post spray contained measurable amounts of diflubenzuron in 51 and 59% of the samples, respectively. Of the samples with measurable amounts of diflubenzuron, residues averaged 1.36 (SE = 2.44) and 0.65 ng/cm² (SE = 0.73) respectively.     

Evaluation of C18 solid‐phase extraction cartridges for the isolation of select pesticides and metabolites

Abstract

Nine different C₁₈ solid‐phase extraction (SPE) cartridges were evaluated for their efficiency at extracting nine pesticides and two s‐triazine metabolites from spiked deionized water samples. The SPE cartridges were found to contain nitrogen (N) and/or phosphorus (P) contaminants and varied in their extraction efficiency for certain pesticides and metabolites. Four of the nine SPE cartridges gave acceptable (70 to 120%) pesticide and metabolite recovery percentages, while five cartridges had marginal (50 to 70%) to poor (< 50%) recoveries. Statistical analyses showed that the poor to marginal recoveries found for three compounds could not be explained by considering several indigenous chemical and physical traits of the cartridge. It is suggested that proper SPE cartridge selection for pesticide recovery should be evaluated using several different cartridges.