Temperature dependence of secondary organic aerosol

Temperature was found to have a dramatic effect on secondary organic aerosol formation from two ozonolysis systems, cyclohexene and α-pinene. Isothermal experiments were conducted for both systems where the lowest temperature, 278 K, formed approximately 2.5–3 times and 5–6 times the SOA formed at 300 K and 318 K, respectively. Changing the cyclohexene system temperature to a different isothermal experimental set point after completion of SOA formation did not lead to sufficient condensation/evaporation to reproduce the SOA formation at other temperature set points. When the system temperature was cycled between two set points at the end of an experiment, the α-pinene system showed reversibility between the initial temperature 318 K and 300 K. For temperature cycles between the initial temperature of 300 K–318 K, an irreversible loss of mass is observed after the first heating cycle with reversibility observed between subsequent temperature cycles. The SOA formed at 278 K was reversible over a 22 K range but was unable to evaporate sufficiently to match the SOA mass formed at 300 K. Hygroscopicity measurements, taken after the completion of SOA formation, indicate that hygroscopicity of the aerosol is also a function of temperature and that the aerosol does not continue to be oxidized after initial growth is complete. The differing hygroscopicity of the semi-volatile component of the aerosol is evident during system temperature changes after completion of the experiment.     

Atmospheric nitrogen deposition in south-east Scotland: Quantification of the organic nitrogen fraction in wet,dry and bulk deposition

Water soluble organic nitrogen (WSON) compounds are ubiquitous in precipitation and in the planetary boundary layer, and therefore are a potential source of bioavailable reactive nitrogen. This paper examines weekly rain data over a period of 22 months from June 2005 to March 2007 collected in 2 types of rain collector (bulk deposition and “dry + wet” deposition) located in a semi-rural area 15 km southwest of Edinburgh, UK (N55°51′44″, W3°12′19″). Bulk deposition collectors are denoted in this paper as “standard rain gauges”, and they are the design used in the UK national network for monitoring precipitation composition. “Dry + wet” deposition collectors are flushing rain gauges and they are equipped with a rain detector (conductivity array), a spray nozzle, a 2-way valve and two independent bottles to collect funnel washings (dry deposition) and true wet deposition. On average, for the 27 weekly samples with 3 valid replicates for the 2 types of collectors, dissolved organic nitrogen (DON) represented 23% of the total dissolved nitrogen (TDN) in bulk deposition. Dry deposition of particles and gas on the funnel surface, rather than rain, contributed over half of all N-containing species (inorganic and organic). Some discrepancies were found between bulk rain gauges and flushing rain gauges, for deposition of both TDN and DON, suggesting biological conversion and loss of inorganic N in the flushing samplers.     

Effects of post-sampling conditions on ambient carbon aerosol filter measurements

Ambient carbonaceous material collected on quartz filters is prone to measurement artifacts due to material gained or lost during post-sampling field latency, shipping, and storage. In seventeen sampling events over a one year period, ambient PM_2.5 aerosols were collected on quartz filters (without denuders) and subjected to various filter treatments to assess the potential for and extent of artifacts. The filter treatments simulated post-sampling environments that filters may be exposed to and included: storage at 40 °C for up to 96 h, storage at ?16 °C for 48 h, and storage at room temperature (～21 °C) for 48 h. Carbon mass on the filters was measured using a thermal-optical method. The total carbon (TC), total organic carbon (TOC) and total elemental carbon (TEC) as well as carbon thermal fraction masses were obtained. Statistical analyses were performed to identify significant differences in carbon fraction concentrations between filters analyzed immediately after sampling and after being subjected to treatment.TOC and TC concentrations decreased by on average 15 ± 5% and 10 ± 4%, respectively, for filters maintained at 40 °C for 96 h but did not change for filters stored at room temperature or frozen for 48 h. TEC did not change for any of the filter treatments. The mass concentration for the organic carbon thermal fraction that evolves at the lowest temperature step (OC1) decreased with increasing storage time at 40 °C with average losses of 70 ± 7% after 96 h. Therefore, OC1 is not a stable measurement due to post-sampling conditions that may be encountered. This work demonstrates that TOC and TC can have substantial measurement artifacts on filters subjected to field latency and other non-temperature controlled post-sampling handling, compared to the carbon loadings on the filter at the end of the sampling period.     

Monitoring the Multi-Year Carbon Balance of a Subarctic Palsa Mire with Micrometeorological Techniques

This article reports a dataset on 8 years of monitoring carbon fluxes in a subarctic palsa mire based on micrometeorological eddy covariance measurements. The mire is a complex with wet minerotrophic areas and elevated dry palsa as well as intermediate sub-ecosystems. The measurements document primarily the emission originating from the wet parts of the mire dominated by a rather homogenous cover of Eriophorum angustifolium. The CO₂/CH₄ flux measurements performed during the years 2001–2008 showed that the areas represented in the measurements were a relatively stable sink of carbon with an average annual rate of uptake amounting to on average ?46 g C m^?2 y^?1 including an equally stable loss through CH₄ emissions (18–22 g CH₄–C m^?2 y^?1). This consistent carbon sink combined with substantial CH₄ emissions is most likely what is to be expected as the permafrost under palsa mires degrades in response to climate warming.     

The herbicide paraquat induces alterations in the elemental and biochemical composition of non-target microalgal species

Huge quantities of pesticides are dispersed in the environment, affecting non-target organisms. Since paraquat affects the photosynthetic process, the biochemical composition of affected species should be altered. The effect of paraquat on Chlamydomonas moewusii, a freshwater non-target species, was studied. After 48 h of herbicide exposure, growth rate, dry weight, and chlorophyll a and protein content were affected by paraquat concentrations above 0.05 μM. C/N ratio was also affected due to a decrease in nitrogen content in the dry biomass, while the carbon content remained constant for all paraquat concentrations assayed. Enzymes involved in nitrogen assimilation were affected by paraquat, being nitrate reductase activity more sensitive to paraquat than nitrite reductase. Based on the results obtained in the present study, paraquat exerts adverse effects upon a common freshwater green microalga, thus the application of this herbicide for weed control must be carried out very carefully, so that any disturbance affecting algae will have severe repercussions on higher trophic levels and on the elemental biogeochemical cycles.     

Air pollutant concentrations near three Texas roadways, part II: Chemical characterization and transformation of pollutants

Spatial gradients of vehicular emitted air pollutants were measured in the vicinity of three roadways in the Austin, Texas area: (1) State Highway 71 (SH-71), a heavily traveled arterial highway dominated by passenger vehicles; (2) Interstate 35 (I-35), a limited access highway north of Austin in Georgetown; and (3) Farm to Market Road 973 (FM-973), a heavily traveled surface roadway with significant truck traffic. A mobile monitoring platform was used to characterize the gradients of CO and NO_x concentrations with increased distance from each roadway, while concentrations of carbonyls in the gas-phase and fine particulate matter mass and composition were measured at stationary sites upwind and at one (I-35 and FM-973) or two (SH-71) downwind sites. Regardless of roadway type or wind direction, concentrations of carbon monoxide (CO), nitric oxide (NO), and oxides of nitrogen (NO_x) returned to background levels within a few hundred meters of the roadway. Under perpendicular wind conditions, CO, NO and NO_x concentrations decreased exponentially with increasing distance perpendicular to the roadways. The decay rate for NO was more than a factor of two greater than for CO, and it comprised a larger fraction of NO_x closer to the roadways than further downwind suggesting the potential significance of near roadway chemical processing as well as atmospheric dilution. Concentrations of most carbonyl species decreased with distance downwind of SH-71. However, concentrations of acetaldehyde and acrolein increased farther downwind of SH-71, suggesting chemical generation from the oxidation of primary vehicular emissions. The behavior of particle-bound organic species was complex and further investigation of the size-segregated chemical composition of particulate matter (PM) at increasing downwind distances from roadways is warranted. Fine particulate matter (PM_2.5) mass concentrations, polycyclic aromatic hydrocarbons (PAHs), hopanes, and elemental carbon (EC) concentrations generally exhibited concentrations that decreased with distance downwind of SH-71. Concentrations of organic carbon (OC) increased from upwind concentrations immediately downwind of SH-71 and continued to increase further downwind from the roadway. This behavior may have primarily resulted from condensation of semi-volatile organic species emitted from vehicle sources with transport downwind of the roadway.     

Substance-related environmental monitoring

Background  Due to the requirements of the EU Water Framework Directive and other legal regulations (e.g., national laws like the German Federal Soil Protection Act), but also due to the implementation of the new EU chemicals management system REACH, environmental monitoring will gain increasing importance for the surveillance of environmental quality as well as for the assessment of chemicals. Against this background, the Work Group on ‘Environmental Monitoring’ of the Division of ‘Environmental Chemistry and Ecotoxicology’ within the German Chemical Society has compiled a position paper on substance-related environmental monitoring. Scope  Core elements of this position paper are the definitions of important terms like monitoring, exposure monitoring, effect monitoring, and integrated monitoring. Moreover, temporal and spatial aspects (monitoring of spatial distributions, trend monitoring, and retrospective monitoring) and their applications are discussed. The main focus of this position paper is the coverage of aspects which have to be observed for the preparation and implementation of a monitoring program. Essential is the clear specification of the targets of the monitoring which determine the development of the monitoring concept and its realization, e.g., if environmental media (compartments) or organisms are most appropriate as samples for the aim of the study. Of course, also the properties of the target substances are important (e.g., lipophilicity/bioaccumulation as pre-requisite for an exposure monitoring with organisms). Finally, the monitoring phases of sample planning, sampling, storage and transport of samples, selection of analytical methods, quality assurance measures as well as reporting are discussed. Perspectives  An important issue for the future is to link the quantification of chemicals in environmental compartments (exposure and pollution monitoring) more closely to the study of biological effects (effect monitoring) than has been the case up to now. Furthermore, by inclusion of a spatial differentiation, a comprehensive evaluation of the state of an ecosystem can be obtained and the relevance of the results improved. Practical examples of monitoring studies which illustrate various aspects covered in this position paper will be presented in a series of publications by members of the Work Group in the following issues of this journal.

Evaluation of effectiveness of EDTA and sodium thiosulfate in removing metal toxicity toward sea urchin embryo-larval applying the TIE

Since the development of the TIE (Toxicity Identification and Evaluation) in 1988 it has been assumed that the capacity of EDTA and sodium thiosulfate to complex some metals, and thus remove their toxicity, can be applied to both freshwater and seawater ecotoxicological tests and the results subsequently interpreted. However, it is now known that there is a wide variability in the extent of this complexation. In this context, the removal of toxicity caused by the presence of Hg²⁺, Cd²⁺, Cu²⁺, Cr⁶⁺, Zn²⁺, Ni²⁺, Pb²⁺, Ag¹⁺ and Se²⁺, through metal complexation by EDTA and sodium thiosulfate, in relation to the performance of embryo-larval tests with the sea urchin Arbacia lixula was investigated. It was observed that EDTA was capable of removing the toxicity of Pb²⁺, Zn²⁺ and Cu²⁺ while sodium thiosulfate only reduced the toxicity of Ag¹⁺. Compared to the complexation observed in freshwater ecotoxicological tests, the complexing agents used in this study (EDTA and sodium thiosulfate) have a lower capacity to complex metals in the marine ecotoxicological test with A. lixula.     

Characterization of silver release from commercially available functional (nano)textiles

Silver, both in the nano as well as in other forms, is used in many applications including antimicrobial textiles. Washing of such textiles has already been identified as an important process that results in the release of silver into wastewater. This study thus investigated the release of silver from eight different commercially available silver-textiles during a washing and rinsing cycle. The silver released was size-fractionated and characterized using electron microscopy. In addition, the antimicrobial functionality of the textiles was tested before and after washing. Three of the textiles contained nanosized silver (labeled or confirmed by manufacturers’ information), another used a metallic silver wire and four contained silver in undeclared form. The initial silver content of the textiles was between 1.5 and 2925 mg Ag/kg. Only four of the investigated textiles leached detectable amounts of silver, of which 34-80% was in the form of particles larger than 450 nm. Microscopic analysis of the particles released in the washing solutions identified Ti/Si-AgCl nanocomposites, AgCl nanoparticles, large AgCl particles, nanosilver sulfide and metallic nano-Ag, respectively. The nanoparticles were mainly found in highly agglomerated form. The identified nanotextiles showed the highest antimicrobial activity, whereas some of the other textiles, e.g. the one with a silver wire and the one with the lowest silver content, did not reduce the growth of bacteria at all. The results show that different silver textiles release different forms of silver during washing and that among the textiles investigated AgCl was the most frequently observed chemical form in the washwater.     

Nonideal transport of contaminants in heterogeneous porous media: 10. Impact of co-solutes on sorption by porous media with low organic-carbon contents

The impact of co-solutes on sorption of tetrachloroethene (PCE) by two porous media with low organic-carbon contents was examined by conducting batch experiments. The two media (Borden and Eustis) have similar physical properties, but significantly different organic-carbon (OC) contents. Sorption of PCE was nonlinear for both media, and well-described by the Freundlich equation. For the Borden aquifer material (OC = 0.03%), the isotherms measured with a suite of co-solutes present (1,2-dichlorobenzene, bromoform, carbon tetrachloride, and hexachloroethane) were identical to the isotherms measured for PCE alone. These results indicate that there was no measurable impact of the co-solutes on PCE sorption for this system. In contrast to the Borden results, there was a measurable reduction in sorption of PCE by the Eustis soil (OC = 0.38%) in the presence of the co-solutes. The organic-carbon fractions of both media contain hard-carbon components, which have been associated with the manifestation of nonideal sorption phenomena. The disparity in results observed for the two media may relate to relative differences in the magnitude and geochemical nature of these hard-carbon components.