Classification and comparison of municipal solid waste based on thermochemical characteristics

Municipal solid waste (MSW) has been normally sorted into six categories, namely, food residue, wood waste, paper, textiles, plastics, and rubber. In each category, materials could be classified further into subgroups. Based on proximate and ultimate analysis and heating value, statistical methods such as analysis of variance (ANOVA) and cluster analysis were applied to analyze the characteristics of MSW in every subgroup and to try to distinguish their relative properties. The chemical characteristics analysis of MSW showed that polyethylene (PE), polypropylene (PP), and polystyrene (PS) had the highest volatile matter content, with almost no ash and fixed carbon, while polyethylene terephthalate (PET) had high carbon content but low hydrogen content. Bones and vegetables had the highest ash content, while nutshells and rubber had the highest fixed carbon content. Paper and starch food had the highest oxygen content, and wool and bones had the highest nitrogen and sulfur content. Polyvinyl chloride (PVC) had the highest chlorine content at about 55%. PE, PP, and PS had the highest heating value, followed by chemical products such as rubber and chemical fiber. Conversely, paper, vegetables and bones had the lowest heating value. The results of cluster analysis of MSW components showed that fruit peel, weeds, wood, bamboo, leaves and nutshells could be classified as the lignocellulose category; starch food, cotton, toilet paper, printing paper and cardboard could be classified as the glucose monomer category; wood and chemical fiber could be classified as the high nitrogen and sulfur category; and PE, PP, and PS could be cluster as the polyolefin category.

Implications: The yield of municipal solid waste (MSW) is constantly increasing and waste to energy (WTE) has been used extensively all over the world. During the processes of incineration, pyrolysis, or gasification, the impact of physical and chemical properties of MSW is of great significance. However, the traditional classification of MSW is too general to provide more detailed information in many investigations. It is necessary to perform the investigation of characteristics of combustible MSW to distinguish different categories of MSW and find out their subclassification.     

添加天然沸石和石灰对土壤镉形态转化的影响

采用土壤培养实验,研究镉污染土壤中添加沸石、石灰及两者配施对土壤pH值和土壤镉形态变化的影响。结果表明,土壤pH值随沸石用量的增加而增加,随培养时间呈现先增加后下降并逐渐趋于稳定的趋势,但均高于对照。高剂量石灰的处理对土壤pH的影响最大,与对照相比土壤pH提高了3.33个单位。在土壤5~50 d培养过程中,石灰处理的土壤交换态镉含量呈现先逐渐降低而后略有升高的趋势,其余处理均呈下降趋势。培养50 d后,高剂量的沸石、石灰及高剂量沸石与石灰配施处理的土壤交换态镉含量从5 d时的67.54、61.95和55.56 mg/kg降低至54.65、49.93和45.96mg/kg。相关分析表明,不同培养时期交换态镉含量与土壤pH值呈负相关关系。在10个处理中,L2Z3(石灰2 g/kg土和沸石60 g/kg土)组合处理效果最好,使土壤交换态镉含量下降了34.68%,碳酸盐结合态镉含量上升了4.30%,铁锰氧化结合态镉含量上升了16.97%,有机结合态镉含量上升了1.31%,残渣态镉含量上升了12.11%。     

柴油机微粒中可溶性有机成分的真空干燥条件

柴油机碳烟颗粒(PM)中可溶性有机组分(SOF)含量是其重要的特性参数,而真空干燥法可方便、高效、可靠地分析颗粒SOF含量,对其干燥条件的探索具有重要的研究意义和应用价值。首先采用模拟的柴油机颗粒,分析不同的干燥条件对模拟SOF(柴油、润滑油)挥发率的影响规律,得出模拟的SOF分析的最佳干燥条件;在此基础上,探索了真实柴油机颗粒SOF分析的最佳干燥条件为:干燥温度220℃、干燥时间3 h、真空度98 kPa,得知SOF组分干燥的难易程度介于柴油和润滑油之间;同时,根据此干燥条件,分析了排气管末端采集的真实碳烟颗粒的SOF含量特性。     

雅砻江流域湿地景观格局变化分析

应用ArcGIS软件,对雅砻江流域湿地1986和2000年遥感数据进行解译、矢量化处理,用Apack软件进行湿地景观格局指数计算,研究了近15 a雅砻江流域景观空间格局特征及其变化。结果表明：（1）近15 a雅砻江流域湿地景观面积减少,减少量为49404 hm2,占2000年湿地总面积的0506%;（2）两个时期内湿地斑块密度保持不变,湿地景观的聚集度都很高,均在099以上,湿地景观集中分布,破碎化水平低;（3）雅砻江流域湿地景观的多样性指数水平和均匀度水平较低,而且两指数在两个个时期内没有发生太大的变化,且各类湿地景观比例差异相对较大,沼泽湿地景观控制的程度较高;（4）雅砻江流域的5类湿地景观分布质心基本上未发生变化,但总体格局分布质心向南偏移001°,再向西偏移023°,整体上向西南方向偏移了2532 km     

基于控制单元的水环境容量核算研究——以锦江流域为例

水环境容量核算是流域水环境容量总量分配的重要依据,关系到流域水质目标的实现。控制单元作为流域水环境管理的一个基本实施单位,以其为基础开展水环境容量核算,对于科学制定控制单元容量总量分配具有重要意义。以江西省锦江流域为例,根据水环境容量核算的基本原理,结合锦江流域的污染状况、水质现状和水环境功能区划,对流域各控制单元COD和氨氮的水环境容量进行分析,结果表明,控制单元的水环境容量与其内排污口的分布及功能区水质目标密切相关,COD的水环境容量以高安控制单元的最大,为 21 811 t/a;其次为上宜控制单元,为 21 168 t/a;再次为新丰控制单元,为 14 493 t/a;万载控制单元的最小,为 7 607 t/a。氨氮的水环境容量在各控制单元的分布特征与COD的略有不同,以上宜控制单元的最大,为790 t/a;其次为高安控制单元,为664 t/a;再次为新丰控制单元,为462 t/a;万载控制单元的最小,为303 t/a     

基于数值模拟的台风危险性分析综述(Ⅱ)——随机抽样模拟与极值风速预测

台风危险性分析是台风损失估计及防灾减灾的基础。对基于数值模拟的台风危险性分析所采用的随机台风概率模型、随机抽样模拟方法和极值风速预测进行了回顾与评述,包括台风关键参数概率模型及其相关性、台风路径模型、台风登陆衰减和海陆风速转换模型以及台风极值风速概率模型,并针对我国东南沿海地区台风危险性分析数值模拟采用的相关模型给出了相关建议。     

基于MODIS的渍害田和正常农田遥感特性对比研究

渍害田在我国南方地区分布广泛,严重影响农业生产。以四湖流域洪湖地区为实验区,基于渍害田的物理及生态特性来探讨渍害田遥感识别特性。利用2002～2011年MODIS产品,辅以土壤图、土地覆被数据,对比分析了正常农田及渍害田在反照率、增强型植被指数（EVI）、地表夜温、地表温差和表观热惯量的时相差异;并结合相关研究成果加以解释和验证。结果表明：一年中大部分时段,正常农田的反照率、EVI、地表温差都大于渍害田,而地表夜温、表观热惯量都低于渍害田;各指标的多年平均值也具有类似差别;渍害田的EVI在6、7月份比正常农田高, 可能是由于渍害田在雨、热、肥条件同时良好时比正常农田生长的更快。研究结果可为进一步准确识别渍害田空间分布及其动态变化     

若尔盖近55年热量资源分析

利用1957～2011 年若尔盖气象观测站的逐日气温资料,分析了该地区日平均气温稳定通过0℃的初日、终日、持续日数、活动积温的年际变化, 对活动积温进行突变检验。研究表明：若尔盖≥0℃的初日提前的趋势并不明显;终日呈显著延后趋势;持续日数呈明显增加趋势。活动积温变化呈十分显著的增加趋势,1997年为积温增加的突变年,1998～2011年是热量和持续日数增加幅度最大的时期。1998～2011年若尔盖≥0℃的各不同保证率对应的持续日数均大于1957～1997年对应的持续日数,即初日提前,终日推迟,活动积温也明显增加     

Air Quality in Selected Megacities

Abstract

About half of the world's population now lives in urban areas because of the opportunity for a better quality of life. Many of these urban centers are expanding rapidly, leading to the growth of megacities, which are often defined as metropolitan areas with populations exceeding 10 million inhabitants. These concentrations of people and activity are exerting increasing stress on the natural environment, with impacts at urban, regional and global levels. In recent decades, air pollution has become one of the most important problems of megacities. Initially, the main air pollutants of concern were sulfur compounds, which were generated mostly by burning coal. Today, photochemical smog—induced primarily from traffic, but also from industrial activities, power generation, and solvents—has become the main source of concern for air quality, while sulfur is still a major problem in many cities of the developing world. Air pollution has serious impacts on public health, causes urban and regional haze, and has the potential to contribute significantly to global climate change. Yet, with appropriate planning megacities can efficiently address their air quality problems through measures such as application of new emission control technologies and development of mass transit systems.

This review is focused on nine urban centers, chosen as case studies to assess air quality from distinct perspectives: from cities in the industrialized nations to cities in the developing world. This review considers not only megacities, but also urban centers with somewhat smaller populations, for while each city—its problems, resources, and outlook—is unique, the need for a holistic approach to complex environmental problems is the same. There is no single strategy to reduce air pollution in megacities; a mix of policy measures will be needed to improve air quality. Experience shows that strong political will coupled with public dialogue is essential to effectively implement the regulations required to address air quality.     

三峡库区香溪河流域非点源营养盐输出变化的试验研究

综合三峡库区香溪河流域土地利用结构和水系特点,在三大支流出口处设置常规水质监测断面,于干流响滩处设置水文控制断面,通过断面水质水量监测,利用数字滤波法解析径流多源和污染多源,研究上游来流点源和非点源营养盐输出负荷变化。结果表明：受农业非点源污染影响,TN是高岚河（0788 mg/L）＞古夫河（0712 mg/L）＞南阳河（0567 mg/L）;南阳河受磷矿企业点源输入的影响,TP是南阳河（0323 mg/L）＞高岚河（0074 mg/L）＞古夫河（0053 mg/L）;断面流量与降雨量的相关系数〖WTBX〗R〖WTBZ〗2=0720 2;TN和TP非点源年负荷输出分别占总量的61%和40%的, 20100607次降雨径流监测分析发现此次降雨汇流期间营养盐TN和TP输出的非点源贡献率分别达752%和709%;营养盐负荷主要受径流量影响,TN和TP输出负荷与流量的相关系数分别是0963 6和0978 9