铁氧化物多孔陶粒生物滴滤塔净化硫化氢气体

采用装有凹凸棒石基铁氧化物多孔陶粒作为填料的生物滴滤塔,进行了长期实验室H2S脱臭实验。结果表明,该生物滴滤塔H2S的进气浓度低于500 mg/m3时,循环营养液喷淋量高于1.5 L/h,气体最佳停留时间为54.9 s,去除率在95%以上。代谢产物以SO2-4为主,转化速率在52.42 g/(m3·d)左右。该滴滤塔系统可稳定而有效运行。生物相观察表明,滴滤塔填料表面附着大量微生物,铁氧化物陶粒具有化学和生物惰性,有利于微生物的附着。     

A comparison of CH4, N2O and CO2 emissions from three different cover types in a municipal solid waste landfill

High-density polyethylene (HDPE) membranes are commonly used as a cover component in sanitary landfills, although only limited evaluations of its effect on greenhouse gas (GHG) emissions have been completed. In this study, field GHG emission were investigated at the Dongbu landfill, using three different cover systems: HDPE covering; no covering, on the working face; and a novel material-Oreezyme Waste Cover (OWC) material as a trial material. Results showed that the HDPE membrane achieved a high CH₄ retention, 99.8% (CH₄ mean flux of 12 mg C m^-2 h^-1) compared with the air-permeable OWC surface (CH4 mean flux of 5933 mg C m^-2 h^-1) of the same landfill age. Fresh waste at the working face emitted a large fraction of N₂O, with average fluxes of 10 mg N m^-2 h^-2, while N₂O emissions were small at both the HDPE and the OWC sections. At the OWC section, CH₄ emissions were elevated under high air temperatures but decreased as landfill age increased. N₂O emissions from the working face had a significant negative correlation with air temperature, with peak values in winter. A massive presence of CO₂ was observed at both the working face and the OWC sections. Most importantly, the annual GHG emissions were 4.9 Gg yr^-1 in CO₂ equivalents for the landfill site, of which the OWC-covered section contributed the most CH₄ (41.9%), while the working face contributed the most N₂O (97.2%). HDPE membrane is therefore, a recommended cover material for GHG control.

Implications: Monitoring of GHG emissions at three different cover types in a municipal solid waste landfill during a 1-year period showed that the working face was a hotspot of N₂O, which should draw attention. High CH₄ fluxes occurred on the permeable surface covering a 1- to 2-year-old landfill. In contrast, the high-density polyethylene (HDPE) membrane achieved high CH₄ retention, and therefore is a recommended cover material for GHG control.     

Remediation of polycyclic aromatic hydrocarbon and metal-contaminated soil by successive methyl-β-cyclodextrin-enhanced soil washing–microbial augmentation: a laboratory evaluation

Polycyclic aromatic hydrocarbon (PAH) and metal-polluted sites caused by abandoned coking plants are receiving wide attention. To address the associated environmental concerns, innovative remediation technologies are urgently needed. This study was initiated to investigate the feasibility of a cleanup strategy that employed an initial phase, using methyl-β-cyclodextrin (MCD) solution to enhance ex situ soil washing for extracting PAHs and metals simultaneously, followed by the addition of PAH-degrading bacteria (Paracoccus sp. strain HPD-2) and supplemental nutrients to treat the residual soil-bound PAHs. Elevated temperature (50 °C) in combination with ultrasonication (35 kHz, 30 min) at 100 g MCD L^?1 was effective in extracting PAHs and metals to assist soil washing; 93 % of total PAHs, 72 % of Cd, 78 % of Ni, 93 % of Zn, 84 % of Cr, and 68 % of Pb were removed from soil after three successive washing cycles. Treating the residual soil-bound PAHs for 20 weeks led to maximum biodegradation rates of 34, 45, 36, and 32 % of the remaining total PAHs, 3-ring PAHs, 4-ring PAHs, and 5(+6)-ring PAHs after washing procedure, respectively. Based on BIOLOG Ecoplate assay, the combined treatment at least partially restored microbiological functions in the contaminated soil. The ex situ cleanup strategy through MCD-enhanced soil washing followed by microbial augmentation can be effective in remediating PAH and metal-contaminated soil.     

臭氧—活性炭技术处理石油微污染地下水*

在实验室及中试条件下研究了臭氧-活性炭技术对石油微污染地下水的处理效果。通过石油类和高锰酸盐指数两个指标,考察了臭氧投加量、pH值、过滤速率等操作参数对污染物的去除效果。结果表明:臭氧投加量和活性炭过滤速率是最主要的影响因素,pH值对处理效果影响不显著。中试条件下适宜的臭氧投加量应为8mg/L左右,最佳过滤速率在10m/h附近。采用臭氧氧化与活性炭过滤组合工艺,当进水石油类浓度在1.5mg/L以下时,出水石油类低于0.3mg/L,高锰酸盐指数低于3.0mg/L。     

不同态二氧化钛处理模拟印染废水的研究

以普通载玻片为基底材料,负载态和悬浮态的纳米二氧化钛/普通二氧化钛被用于处理甲基红模拟印染废水,实验结果表明:纳米二氧化钛的脱色效果明显优于普通的二氧化钛,适当增加负载量和处理时间,负载态的处理效果与悬浮态相当。首次提出了由光源决定的纳米光催化活性激发理论,解释了不同光源辐照时脱色率变化曲线差异的问题,并发现纳米TiO2光催化氧化模拟印染废水的脱色反应,主要由吸附过程控制的表面反应机理;150 mL模拟印染废水中,加入3块纳米TiO2负载量1 mg/cm2的普通载玻片,3~5 mL ClO2或H2O2,紫外光照60 min后,脱色率达到99.2%。     

连续培养酱油曲霉(Aspergillus sojae)产微生物絮凝剂的研究

为了利用廉价材料规模化生产微生物絮凝剂,以味精废水作为廉价培养基质,对酱油曲霉的摇瓶连续培养和发酵罐连续培养进行了研究。摇瓶中以5%的接种量进行连续培养,最适温度在30~33℃之间,每6 h替换一次新鲜废水培养基,5次替换新鲜废水培养基后最大絮凝率仍达到97.8%。在发酵罐扩大连续培养中以5%的接种量接种后经过9 h预培养达到稳定生产絮凝剂后,以4 mL/min的补料流量进行连续培养,生产的絮凝剂产量达到2.392 g/L,且最大絮凝率为98.1%。生产36 h后对发酵系统中菌体进行稀释,使菌体量保持在50~200 g/L之间可持续进行生产。     

小型燃油锅炉NO_x的排放特征与管理控制

以68台燃油锅炉(≤10.5 MW)NO_x排放实测数据为基础,通过统计分析方法,研究了NO_x的排放特征;通过对比分析,探讨了我国燃油锅炉NO_x排放控制与管理现状,讨论了进一步加强我国燃油锅炉NO_x排放管理控制的可能性与可行性,并提出了相应的管理控制建议。结果表明,NO_x平均排放浓度为318.2 mg/m~3,基于燃料消耗量的平均排放因子为4.4 kg/t,基于燃料发热量的平均排放因子为102.8 ng/J,基于燃料氮含量的平均排放因子为2.1 mg/mg;建议采取分阶段控制的方式,逐步提高NO_x排放限制,从而实现控源减排目标。     

Production of Activated Carbons from Pyrolysis of Waste Tires Impregnated with Potassium Hydroxide

ABSTRACT

Activated carbons were produced from waste tires using a chemical activation method. The carbon production process consisted of potassium hydroxide (KOH) impregnation followed by pyrolysis in N₂ at 600-900 °C for 0-2 hr. The activation method can produce carbons with a surface area (SA) and total pore volume as high as 470 m²/g and 0.57 cm³/g, respectively. The influence of different parameters during chemical activation, such as pyrolysis temperature, holding time, and KOH/tire ratio, on the carbon yield and the surface characteristics was explored, and the optimum preparation conditions were recommended. The pore volume of the resulting carbons generally increases with the extent of carbon gasified by KOH and its derivatives, whereas the SA increases with degree of gasification to reach a maximum value, and then decreases upon further gasification.     

Capability of novel ZnFe₂O₄ nanotube arrays for visible-light induced degradation of 4-chlorophenol

Highly ordered ZnFe₂O₄ nanotube arrays were successfully prepared by anodic aluminum oxide templates from sol-gel solution. The results from environmental scanning electron microscopy and X-ray photoemission spectroscopy indicated that the as-prepared samples were vertically aligned spinel ZnFe₂O₄ nanotube arrays, and the nanotubes were uniform along the axial direction with an average diameter of approximately 200 nm. The absorption edge of ZnFe₂O₄ nanotube arrays shifted to a higher energy in the UV-Vis absorption spectrum compared with that of ZnFe₂O₄ nanoparticles film. The synthesized ZnFe₂O₄ nanotube arrays exhibited excellent photocatalytic capability for degradation of 4-chlorophenol under visible-light irradiation. The main intermediate degradation species of 4-chlorophenol identified by liquid chromatography-mass technique were benzoquinone, hydroquinone, hydroxybenzoquinone and 2-peroxy-o-dihydroxybenzene. The degradation pathways of 4-chlorophenol under visible-light irradiation was derived and discussed by interpreting the observations of the intermediate species in the photocatalytic reactions.     

褐煤活性炭吸附处理焦化废水

研究褐煤活性炭吸附处理焦化废水的性能,为褐煤活性炭用于废水处理提供理论依据和技术指导。以河南某气化厂的焦化废水为吸附原水,进行褐煤活性炭对酚吸附性能的静态和动态实验。静态实验表明,褐煤活性炭对酚的吸附性能符合弗兰德里希（Freundlich）吸附方程式。在室温条件下,对于150 mL焦化废水,当活性炭的用量为10 g,吸附反应时间为1 h,酚的去除率可达92%以上。动态实验研究表明,当进水酚浓度为3 800 mg/L,吸附1.5 h,活性炭的吸附容量可达21.38 mg/g。水处理的实验研究表明,利用褐煤制备的活性炭,对焦化废水具有良好的处理效果。