一种新型Fenton-流化床催化剂的制备及表征

非均相Fenton-流化床体系主要使用石英砂作为催化剂载体,该技术的实际应用由于催化剂活性寿命低、制备困难等原因而受到限制.提出了一种新型的Fenton-流化床催化剂——负载氧化铁陶粒.使用循环浸泡法制备的负载陶粒对苯甲酸模拟废水的处理效果良好.表征结果分析表明,载体表面铁含量大幅度上升,负载的氧化铁紧紧包裹在陶粒表面,且表面有大量缝隙,利于增加反应比表面积,而密度变化不大.该催化剂的催化活性重复性良好,重复使用4次后对苯甲酸模拟废水依然有较好的处理效果.使用该催化剂进行垃圾渗滤液的降解实验能在一定程度上减少亚铁的投加量,具有较好的实际应用前景.     

Influences of adding easily degradable organic waste on the minimization and humification of organic matter during straw composting

To find a better composting process with low greenhouse gas emission and high humus production, the effect of adding kitchen waste on reduction and humification of organic matter during straw composting was studied. Three processes were compared, consisting of different ratios of straw and kitchen waste (1:2, 1:1, and 2:1). At four time points over a 62-d incubation, the reduction and humification of compost was evaluated by measuring the total mass, carbon content, and humic material content of the compost. Treatment 1 (straw/kitchen waste ratio of 1:2) reduced the total mass of compost the most. Treatment 2 (straw/kitchen waste ratio of 1:1) reduced the total carbon content the most, reflecting the highest emission of greenhouse gas. Treatment 3 produced the most humic acid material and released the lowest amount of carbon. Hence, from the point of view of reducing greenhouse gas emissions and increasing stable organic matter such as humus and humic acid during composting, treatment #3 was optimal. The three treatments resulted in significant differences in microbial biomass and enzyme activity during composting. The highest amount of active microbial biomass was associated with the largest reduction in compost mass (treatment 1). Higher proportions of straw (treatments 2 and 3), which contains more lignin, were associated with greater β-glycosidase activity, which may generate more humus that can improve soil quality. Dehydrogenase activity seemed to be the most important microbial factor in organic carbon catabolism or humification.     

江苏省地理标志概况与价值评估体系构建研究

以江苏省43个地理标志为研究对象,根据国家地理标志的分类方法对其进行分类,构建价值评估体系,探讨地理标志产品的内在价值及发展重点。研究表明,江苏省地理标志类型较为单一,分布均匀;开发程度不同,可分为开发匮乏型、有待开发型和开发成熟型。通过价值体系评价可见,江苏省应重点挖掘产品的自身特色,发展价值意义突出的地理标志。     

上海市青浦区PM10污染状况及其与气象要素的关系

利用2006-2010年上海市青浦区PM10和同期地面气象要素的监测资料,定量分析PM10的季节变化规律以及PM10与降雨量、大气湿度和风速之间的关系。分析结果表明:PM10浓度在夏季处于低值,冬季处于高值;5mm/d以上的降雨对PM10有显著的清除作用,且春夏季降雨的清除作用大于秋冬季节。PM10浓度与大气湿度基本呈负相关关系。风速在一定范围内有利于PM10的扩散但不至造成扬尘,春夏季节的适宜风速是1.5～3.5m/s,冬季的适宜风速是1.5～2.5m/s。     

Phosphine in paddy fields and the effects of environmental factors

Ambient levels of phosphine (PH₃) in the air, phosphine emission fluxes from paddy fields and rice plants, and the distribution of matrix-bound phosphine (MBP) in paddy soils were investigated throughout the growing stages of rice. The relationships between MBP and environmental factors were analyzed to identify the principal factors determining the distribution of MBP. The phosphine ambient levels ranged from 2.368 ± 0.6060 ng m⁻³ to 24.83 ± 6.529 ng m⁻³ and averaged 14.25 ± 4.547 ng m⁻³. The highest phosphine emission flux was 22.54 ± 3.897 ng (m² h)⁻¹, the lowest flux was 7.64 ± 4.83 ng (m² h)⁻¹, and the average flux was 14.17 ± 4.977 ng (m² h)⁻¹. Rice plants transport a significant portion of the phosphine emitted from the paddy fields. The highest contribution rate of rice plants to the phosphine emission fluxes reached 73.73% and the average contribution was 43.00%. The average MBP content of 111.6 ng kg⁻¹fluctuated significantly in different stages of rice growth and initially increased then decreased with increasing depth. The peak MBP content in each growth stage occurred approximately 10 cm under the surface of paddy soils. Pearson correlation analyses and stepwise multiple regression analysis showed that soil temperature (Ts), acid phosphatase (ACP) and total phosphorus (TP) were the principal environmental factors, with correlative rankings of Ts > ACP > TP.     

双氰胺-甲醛聚合物-聚合氯化铝复合絮凝剂的合成及应用

以双氰胺、甲醛、氯化铝为主要原料,加入添加剂合成了双氰胺-甲醛聚合物（DF）-聚合氯化铝（PAC）复合絮凝剂。采用模拟印染废水考察了各种因素对DF—PAC复合絮凝剂混凝脱色性能的影响。实验结果表明,在双氰胺、甲醛、氯化铝、添加剂加入量分别为29．1,57．8,4．8,12．5g,反应温度（70±1）℃、反应时间2．5h的条件下制得的DF—PAC复合絮凝剂的絮凝脱色性能良好,COD去除率不小于90％,色度去除率不小于99％。与PAC和DF絮凝剂相比,DF—PAC复合絮凝剂对实际印染废水的絮凝脱色效果更好。     

固相微萃取-气相色谱/质谱联用法测定饮用水中苯类化合物

用固相微苹取(ＳＰＭＥ)－气相色谱/质谱联用法测定饮用水中苯类化合物,以１００μｍ ＰＤＭＳ(聚二甲基硅氧烷)萃取针提取、浓缩、分离与测定九种目标化合物．萃取时间经优化选定为８ｍｉｎ,而热解析时间设定为２ｍｉｎ． 本方法的相对标准偏差小于５%,线性范围宽(２０ｎｇ·ｍｌ－１－１００００ｎｇ·ｍｌ－１),多数化合物的检测限低于５μｇ·ｌ－１．饮用水样品检测显示,样品加标回收率范围在８４%至１１０%内．     

Joint Impact of Scaling and Hysteresis on NAPL Flow Simulation

The hysteresis of capillary pressure versus saturation (P–S) relation is an important constitutive relation in multiphase flow, since the P–S relation is widely used to predict P–S relations in the simulation of the non-aqueous phase liquids (NAPLs). This work examined the performance of the scaling rule on predicting the P–S relationship and then studied the joint impact of the scaling and hysteresis on the multiphase NAPL flow simulation. Various experimental P–S values of distinct fluid pairs were compared with the scaled P–S curves using the scaling rule. The comparison indicated that the prediction of P–S is more accurate when the water–air P–S curve is used to scale other P–S curves. The joint impact of the scaling and hysteresis on the NAPLs flow simulation was then investigated by numerical simulation studies. The NAPL simulator was used to simulate the outcome of several scenarios based on a system with water–NAPL–air in a hypothetical sand tank. For both gasoline and trichloroethylene, the difference of the injected NAPL volume between no hysteretic and hysteretic simulations over a given time period was the smallest when the water–air P–S curve was used to scale other P–S curves. Simulation results of this study are valuable references for predicting the distribution of NAPLs.     

PAN-S树脂富集钴的分光光度法测定研究

研究了PAN—S浸渍树脂对Co^2＋的吸附性能。Co^2＋吸附pH值范围为4．7—9．2,最佳pH值为5．4;达到最大吸附容量需25min,树脂对Co^2＋平衡吸附容量是98mg／g干树脂,达到最大吸附容量平衡时用0．1mol／L的HNO,洗脱,洗脱率达98％。该方法建立了PAN—S-树脂富集一分离钴离子的分光光度测定方法,结果令人满意。