Adsorption of basic dye from aqueous solution onto fly ash

The fly ash treated by H₂SO₄ was used as a low-cost adsorbent for the removal of a typical dye, methylene blue, from aqueous solution. An increase in the specific surface area and dye-adsorption capacity was observed after the acid treatment. The adsorption isotherm and kinetics of the treated fly ash were studied. The experimental results were fitted using Langmuir and Freundlich isotherms. It shows that the Freundlich isotherm is better in describing the adsorption process. Two kinetic models, pseudo-first order and pseudo-second order, were employed to analyze the kinetic data. It was found that the pseudo-second-order model is the better choice to describe the adsorption behavior. The thermodynamic study reveals that the enthalpy (ΔH⁰) value is positive (5.63 kJ/mol), suggesting an endothermic nature of the adsorption.     

Cadmium stress alters gene expression of DNA mismatch repair related genes in Arabidopsis seedlings

Cadmium (Cd) is a non essential element, and is a widespread environmental pollutant. Exposure to Cd can result in a variety of adverse health effects in plant and humans. In the current study, Arabidopsis seedlings were used as a bio-indicator of Cd pollution. Seedlings were grown on MS media containing 0-6.0 mg L(-1) Cd for 18 days, and the gene expression patterns were used to link increased Cd exposure with progressive biological effects. Reduction of total soluble protein content in shoots of the Arabidopsis seedlings occurred with increase in Cd concentrations. For the gene expression patterns, seven genes known to be involved in cell division and DNA mismatch repair (MMR) system were investigated by semi-quantitative RT-PCR, and normalized using 18S rRNA gene expression. Expression of the proliferating cell nuclear antigen 2 (atPCNA 2), MutS 3 homolog (atMSH 3) and MutL1 homolog (atMLH1) genes in shoots of Arabidopsis was strongly induced by exposure to 0.75 mg L(-1) Cd, but were repressed by other Cd concentrations whereas exposure to 0.75-6 mg L(-1) of Cd resulted in a decreased expression of atPCNA1, atMSH 2, 6 and 7 genes independently of any observable biological effects, including survival, fresh weight and chlorophyll level of shoots. This work demonstrated that specific gene expression changes could serve as useful molecular biomarkers indicative of Cd exposure and related biological effects.     

基于BP神经网络的垃圾焚烧过程故障诊断

应用BP神经网络方法,建立了垃圾焚烧过程故障诊断的模型.该方法采用梯度下降法训练网络权值,利用最优停止法对网络进行了优化,避免了过拟合现象.提高了BP神经网络的训练速度和泛化能力.并以实际焚烧过程工况数据进行性能检验,检验结果表明了该BP网络具有较高的诊断精度.     

山梨酸废水在ABR中的基质降解行为

稳态条件下,采用厌氧折流板反应器(anaerobic baffled reactor,ABR)处理山梨酸废水并进行基质降解动力学研究.实验表明,在污泥负荷为0.54～1.63 kg COD/(kg VSS·d)的范围内,COD去除率随着负荷的增加从85%降到55%.各隔室出水COD沿程递减,前3个隔室承担了去除COD的重要作用,但随着污泥负荷的增加,后部承担的COD去除率比例增大.基于各串联隔室完全混合的假定,推导ABR中山梨酸废水的基质降解动力学方程,并通过实验确定相关动力学参数及相应的动力学方程.实测值与预测值基本吻合.     

污泥龄对LSP & PNR污泥减量新工艺运行效能的影响

通过研究分析污泥龄(SRT)对富磷污水除磷的LSP&PNR污泥减量新工艺运行效果的影响,结果发现,延长污泥龄有利于提高系统的厌氧释磷能力,但不影响其总的除磷率,同时磷的回收比例增大,当SRT=50 d时,磷回收率取得最大值70.4%;LSP&PNR系统污泥龄增加,还有利于污泥产率的降低.试验还发现,排富磷污水除磷的长污泥龄LSP&PNR系统的除磷效率与污泥产率之间不存在制约关系,即系统可以同时获得优异的污泥减量与生物除磷效果,当SRT=50 d时,每降解1 kg COD仅产生0.143 kg污泥,而除磷率达最高值92.8%;LSP&PNR系统中SRT、DO与SVI之间存在一定的相关性,在供氧充足(DO=0.8～1.5 mg/L)条件下,SRT增加,SVI越高,但对于SRT为50 d的LSP&PNR系统,稳定运行时没有污泥膨胀之虞.     

地震救灾过渡安置点避雷针的布设选点及安装要求

"5.12"汶川8级大地震波及范围很大,给陕西省部分地方造成了不小的损失.灾后,汉中、宝鸡的地震救灾过渡安置点由于缺乏防雷电保护,打雷时有遭受雷电灾害的可能,亟需要对其采取防雷电保护措施.对救灾过渡安置点采用独立避雷针进行防护,该措施安全可靠、简便易行,就成为首选,其布设选点要科学、规范,可使其效益最大化,避雷针的制作和安装应符合技术标准要求,做到牢固可靠,在施工中要因地制宜.综合考虑,始终把安全和牢靠放在首位.     

单体滑坡灾害风险预测

以重庆市万州区农机技校滑坡为例,讨论了单体滑坡灾害的风险预测方法。提出采用Monte-Carlo方法预测滑坡发生的概率,利用能量守恒原理和谢德格尔公式推算滑程;结合滑坡裂缝的展布方位,预测出滑坡灾害发生后的影响范围;根据承灾体自身特点和相对于滑坡所处的位置,确定出滑坡灾害影响范围内承灾体的易损性;利用GIS对空间数据的图形叠加功能,将滑坡危险性和灾害易损性叠加,并在考虑库区水位动态变化的基础上,动态预测滑坡灾害导致的经济损失,定量预测滑坡灾害风险大小。结果表明,该滑坡在坝前145m水位和50年一遇暴雨工况下可能的经济损失值最大为10260万元;而在滑坡危险性最大的工况下,滑坡灾害风险不一定最大。所得结果可为滑坡灾害防治工程或土地规划立项提供依据,使政府决策部门在防灾减灾工作中更有针对性。     

建筑火灾烟流运动特性网络模型的求解收敛性

分析了运用网络模型模拟建筑火灾烟流的计算过程,通过总结影响网络模型求解精度及收敛性的关键因素,改进了原烟流预测软件对建筑物各开口的净、正、负质量流量的算法。改进后的模型消除了振荡效应,模拟结果曲线平滑稳定,实现了运用网络模型对多室建筑物烟流特性的模拟计算。     

火灾高温下CFRP加固钢筋混凝土梁温度场分析

综合国外CFRP加固混凝土结构抗火试验相关研究,总结了CFRP的高温热工性能参数。用ANSYS软件对火灾高温下不同情况(无防火保护层和有防火保护层)和不同工况(防火涂料涂抹形式)下CFRP加固后的钢筋混凝土梁进行了温度场数值模拟研究。结果表明,防火涂料厚40 mm时,梁耐火极限可达2.5小时以上,且底面和两侧面全面涂抹防火涂料的防火效果最好。本文研究有助于进一步深入认识CFRP加固钢筋混凝土结构在高温下的力学性能和耐火极限,且对CFRP加固后的结构防火设计具有一定的指导意义。